-
Dometic RM2454 - page 1
INST ALLA TION AND OPERATING INSTRUCTIONS REFRIGERA TOR FOR LP-GAS AND ELECTRIC OPERA TION RM2454 USA Corporate Office CANADA Service Office 2320 Industrial Parkway Elkhart, IN 46515 Dometic Distribution Inc. Dometic Corporation 866 Langs Drive 509 South Poplar S treet Cambridge, Ont ario LaGrange, IN 46761 For Service Center Assist ance N3H 2N7 Ca ...
-
Dometic RM2454 - page 2
...
-
Dometic RM2454 - page 3
3 Refrigerator control panel FIG. 2 ON OFF AC DC GAS AU TO CHECK COLD 1 2 3 4 5 COLDEST LEGEND 3-WAY AMES Model 1 . Main Power Button ON/OFF 2 . DC Mode Selector Button 3 . AUTO/GAS Mode Selector Button 4 . Temperature Selector Button A . DC Mode Indicator Lamp B . AC Mode Indicator Lamp C . GAS Mode Indicator Lamp D . AUTO Mode Indicator Lamp E . ...
-
Dometic RM2454 - page 4
4 INST ALLA TION GENERAL INSTRUCTION This appliance is designed for storage of foods and storage of frozen foods and making ice. This appliance is certified under the latest edition of ANSI Z21.19•CSA 1.4 Refrigerators using gas fuel. The installation must conform with local codes, or in absence of local codes, the following standards as ap- plic ...
-
Dometic RM2454 - page 5
5 VENTILA TION HEIGHTS Refer to FIG . 3 page 4. CLEARANCES Minimum clearances in inches to combustible materials are: G: Top 0 K: Side 0 L: Bottom 0 M: Rear 0 N: See NOTE: Clearance “N” below. NOTE: Clearance “M” is between the rearmost part of the refrigerator and the wall behind the refrigerator. NOTE: Clearance “N” is the distance be ...
-
Dometic RM2454 - page 6
6 INST ALLING REFRIGERA TOR IN ENCLOSURE NOTE: DO NOT install the appliance directly on carpeting. Carpeting must be removed or protected by a metal or wood panel beneath the appliance, which extends at least full width and depth of the appliance. NOTE: A wood strip must be in place across the upper opening of the enclosure. The top frame of the re ...
-
Dometic RM2454 - page 7
7 Replace the top decoration panel. Be careful not to pinch the wires behind the panel. Make sure the tabs snap back into the holes in the hinge plate. STEP 3: Two screws installed in the rear base. See FIG. 10. Failure to follow the sequence in securing the refrigerator in the enclosure can cause leakage between the frame and cabinet. Any space be ...
-
Dometic RM2454 - page 8
8 ELECTRICAL CONNECTION 120 V olt s AC Connection The refrigerator is equipped with a three-prong (ground- ing) plug for your protection against shock hazards and should be plugged directly into a properly grounded three-prong receptacle. DO NOT cut or remove the grounding prong from this plug. The free length of the cord is 2 feet and therefore re ...
-
Dometic RM2454 - page 9
9 DC MODE 1. Press the DC mode indicator button (2) to turn ON the DC lamp (A). 2. Press the TEMPERATURE SELECTOR button (4) until the lamp at the desired position is illuminated. THERMOSTAT The thermostat on the refrigerator, controls both the gas and electric operation, thereby eliminating the neces- sity of resetting each time a different energy ...
-
Dometic RM2454 - page 10
10 DESCRIPTION OF OPERA TING MODES AUTO MODE When operating in the AUTO mode, the AUTO mode indicator lamp (D) will illuminate. The control system will automatically select between AC and GAS operation with AC having priority over GAS. Either the AC indicator lamp (B) or the GAS indicator lamp (C) will illuminate depending on the energy source sele ...
-
Dometic RM2454 - page 11
11 ! W ARNING When all the frost has melted, dry the interior of the re- frigerator with a clean cloth. Replace all food and set the thermostat to the COLDEST temperature setting for a few hours. Then reset the thermostat to the desired set- ting, usually at mid setting. CLEANING THE REFRIGERA T OR Cleaning the refrigerator is usually done after it ...
-
Dometic RM2454 - page 12
12 MAINTENANCE & SERVICE The user should be aware of service that must be done on a regular schedule to keep the refrigerator operating properly . The service should only be per- formed by a qualified technician who is familiar with LP gas systems and refrigerators. 1. HEA TER The heat necessary for the operation of an absorption cooling unit i ...
-
Dometic RM2454 - page 13
13 C. Check the AMES control system by connecting/dis- connecting 120 volt AC power, start/stop the engine, etc. Compare the operation with the operation de- scribed in section Operating Instructions. D. The LP gas pressure should be checked and the main regulator readjusted if pressure is incorrect. The cor- rect operating pressure is 11 inches of ...
-
Dometic RM2454 - page 14
14 H. LP gas pressure low at burner . Set main regulator so pressure does not drop below 1 1 inches of water column at pressure test port. (See FIG . 12). I. Burner not located properly under flue tube. Relocate. J. Burner damaged. Replace. K. Odor from fumes. 1. Dislocated burner 2. Damaged burner 3. Dirty flue tube L. FUSES 1. Refrigerator contro ...
-
Dometic RM2454 - page 15
15 CERTIFIED VENT SYSTEM KITS REFRIGERATOR KIT MODEL NO. COMPONENTS PART NO. RM 2454 3A Roof Base 3103633.XXX* Roof Cover 3103634.XXX* Lower Side Vent 3109350.XXX* * Fill in “XXX” with color code numbers. For color codes, contact your supplier. For further information contact your dealer or distributor. 1 1 1 1 1 1 2 3 3 4 5 ...
-
Dometic RM2454 - page 16
16 MO-FO 0413 RM 2454 ...
Dometic RM2454についてご質問がありますか?
次のフォームを使用してください
見つけた説明書を読んでもDometic RM2454の問題を解決できない場合、下記のフォームを使用して質問をしましょう。ユーザーのどなたかがDometic RM2454で同様の問題を抱えていた場合、その解決方法を共有したいと考えるかもしれません。