-
Frymaster none - page 1
Frymaster, a member of th e Commercial Food Equi pment Service Association , recommends usin g CFES A Certi fied Te chnicia ns. Price: $6 .00 *8195931* 24-Hour Service H otline 1-800-5 51-8633 819-5931 April 2003 Heated Pass Through Installation, Operation, Servi ce, and Parts Manual ...
-
Frymaster none - page 2
HEATED PASS THROUGH INSTA LLA TION, OPERA TION , SERV ICE, A ND PA R TS 1 1. Parts Ordering and Service Infor mation Parts orders ma y be placed direct l y with your local Fr ymaster Factor y Authori zed S ervice Cent er (FASC)/Distributor . A list of Fryma ster FASC/ Distributors was inc luded with the unit when shipped from the factor y. Your nea ...
-
Frymaster none - page 3
HEATED PASS THROUGH INSTA LLA TION, OPERA TION , SERV ICE, A ND PA R TS 2 Power Requirements: • Voltage – 208 VAC • Frequency - 60 Hz • Single Pha se • 20 amp Service 4. Operation 1. Plug the unit into the power source. * 2. Press the ON/OFF r ocker switch to the ON position. 3. Place product in the HPT in accord ance with the restaurant? ...
-
Frymaster none - page 4
HEATED PASS THROUGH INSTA LLA TION, OPERA TION , SERV ICE, A ND PA R TS 3 5. Maintenance Daily 1. Remove all product and turn the unit off. 2. Allow the unit to cool. 3. Use a wet sanitized cloth to clean the heat ed su rfaces of the unit. Use a n ylon pot brush on hard to remove stains or food items. Monthly Remove the filter scre en and clean it ...
-
Frymaster none - page 5
HEATED PASS THROUGH INSTA LLA TION, OPERA TION , SERV ICE, A ND PA R TS 4 6.2 Replacing the T emperature Probe or High Limit The rmostat A. Disconnect the unit from the electrical powe r source. B. Turn the unit on its side. Remove th e five screws f rom the chassis bottom. C. Set the unit down on its base. D. Carefully lif t the cowl assembly upwa ...
-
Frymaster none - page 6
HEATED PASS THROUGH INSTA LLA TION, OPERA TION , SERV ICE, A ND PA R TS 5 G. Disconnect the plate ground wire from the push- on terminal on the back wall of the air tower. H. Using a thin, sharp knife inserted bet ween the plate and the HPT ch assis, carefull y cut the silicon adhesive between the plate and the sides of the chassis. I. Pry up one e ...
-
Frymaster none - page 7
HEATED PASS THROUGH INSTA LLA TION, OPERA TION , SERV ICE, A ND PA R TS 6 F. Cut the wire ties on the wirin g bundle and, on e at a time, disconnect the wires from the failed assembl y and connect the corres pondin g wire from the replacem ent motor. G. Position the replacement motor over the mountin g studs and secure it in place with the 5 ⁄ 16 ...
-
Frymaster none - page 8
HEATED PASS THROUGH INSTA LLA TION, OPERA TION , SERV ICE, A ND PA R TS 7 7. Wiring Diagram ...
-
Frymaster none - page 9
HEATED PASS THROUGH INSTA LLA TION, OPERA TION , SERV ICE, A ND PA R TS 8 8 Common Repair Parts List 7 1 2 3 4 5 6 8 9 10 11 12 ITEM PART # COMPONENT 1 826-1561 Pad, Leg (pkg of 4) 2 823-3922 Divider Assembl y 3 810-1724 Screen, HPT Filter 4 807-3308 Switch, Black ON/OFF Rocker 5 807-3533 Relay, 18-Amp Solid State 6 807-2820 Block, .25 X 1.25 2-pol ...
-
Frymaster none - page 10
NOTICE IF, DU RING THE WA RRA NTY PERI OD, THE CU STO MER USES A PART FOR THIS ENO DIS EQUI PMEN T OT HER THA N A N UNMO DIFI ED NEW O R RE CYCLE D PA RT PURC HA SED DIRE CTLY FROM FRYMASTER/DE AN, OR ANY OF ITS AUTHORIZ ED SERV ICE CENTERS , AND/OR TH E PART BEIN G USED IS MODIFIED FROM ITS ORIGIN AL CONFIGUR ATION, THIS WARRANTY WILL BE VO ID. FU ...
-
Frymaster none - page 11
THIS PAGE INTENTIONALLY LEFT BLANK ...
-
Frymaster none - page 12
Frymaster, L.L. C., 8700 Line Avenue, PO Bo x 51000, Sh reveport, Louisi ana 711 35-1000 Shipping Address: 8700 Line Avenue, Shreveport, Louisiana 711 06 TEL 1-318-865-171 1 FAX (Parts) 1-318-2 19-71 40 FAX (Tech Support) 1-318-219-713 5 Price: $6.00 PRINTED IN THE UNITED STATES SERVIC E HOTL INE 1-800-551- 8633 819-5931 A pril 2003 ...
Frymaster noneについてご質問がありますか？
次のフォームを使用してください
見つけた説明書を読んでもFrymaster noneの問題を解決できない場合、下記のフォームを使用して質問をしましょう。ユーザーのどなたかがFrymaster noneで同様の問題を抱えていた場合、その解決方法を共有したいと考えるかもしれません。