-
Schneider Electric C3419M-D (11/08) - page 1
INSTALLATION C3419M-D (11/08) In-Ceiling Back Box Heavy Duty Spectra ® IV Series ...
-
Schneider Electric C3419M-D (11/08) - page 2
2 C3419M-D (11/08) Installation BACK MOUNTING PLA TES MOUNTING RING CEILING NOT S UPPLIED 1 5 36 4 2 ...
-
Schneider Electric C3419M-D (11/08) - page 3
C3419M-D (11/08) 3 1. Locate the center point of the mounting location and insert the compass tool into the ceili ng. Draw a c ircle. 2. Cut out the circle. 3. Use the mounting ring as a template to mark the screw hole pattern onto th e mounting surface. Prepare the holes. 4. Install the mounting plat es. Use the eight 10-32 x 3-inch screws (suppl ...
-
Schneider Electric C3419M-D (11/08) - page 4
4 C3419M-D (11/08) 7 8 VIDEO UTP+ UTP- RX- RX+ TX+ TX- PWR- PWR+ GND AUX2 GND GND NO NC COM 7 6 5 4 3 2 1 ALARMS AUX1 ...
-
Schneider Electric C3419M-D (11/08) - page 5
C3419M-D (11/08) 5 7. Install the back box by compressing the sp ring clips and pushing t he back box through the hole. T ighten the sc rews until you he ar a clicki ng noise. 8. Connect the wiring to t he circuit b oard inside th e back box. Whe n finished, clo se the door to the back bo x and turn on the power . The green LED will glow. NOTES: ? ...
-
Schneider Electric C3419M-D (11/08) - page 6
6 C3419M-D (11/08) TRIM LEASH BALL STUD BALL STUD RECEIVER BARREL KEY LOCK SWITCH 1 AND 2 11 9 10 ...
-
Schneider Electric C3419M-D (11/08) - page 7
C3419M-D (11/08) 7 9. Configure D IP switches SW1 and SW2 located on the top of the dome drive. For DIP switch se ttings, refer to the labels located on the to p of the dome drive or to Switch Settings on page 8. NOTE: When connecting mo re than one Spectra ® dome to a single controller , te rminate the unit farthest fr om the controller . T o ter ...
-
Schneider Electric C3419M-D (11/08) - page 8
8 C3419M-D (11/08) Switch Settings WAR N I N G: If you are using Pelco D-type or P-t ype control, your system may not operat e if the baud rate and address swi tches are n ot set corr ectly . The swit ches are set at the fac tory at the d efaults fo r Pelco D- type contr ol (2400 baud and address 1). T able E. Switch Settings for SW2 Special System ...
-
Schneider Electric C3419M-D (11/08) - page 9
C3419M-D (11/08) 9 T able F . Switch Settings for SW1, P- T y pe Control NOTE: For Coaxitron con trols, SW1 is not used; se t all switch es to OFF . For D-type co ntrol systems, refer to T able G. T able G. Switch Settings for SW1, D-T y pe Control NOTE: For Coaxitron con trols, SW1 is not used ; set all switch es to OFF . For P-type control system ...
-
Schneider Electric C3419M-D (11/08) - page 10
10 C3419M-D (11/08) SPECTRA ADDRESS SWITCH SETTI NG SW1-1 SW1-2 SW1-3 SW1-4 SW1-5 SW1-6 SW1-7 SW1-8 71 ON ON ON OFF OFF OFF ON O FF 72 OFF OFF OFF ON OFF OFF ON OFF 73 ON OFF OFF ON OFF OFF ON OFF 74 OFF ON OFF ON OFF OFF ON OFF 75 ON ON OFF ON OFF OFF ON OFF 76 OFF OFF ON ON OFF OFF ON OFF 77 ON OFF ON ON OFF OFF ON OFF 78 OFF ON ON ON OFF OFF ON ...
-
Schneider Electric C3419M-D (11/08) - page 11
C3419M-D (11/08) 11 SPECTRA ADDRESS SWITCH SETTI NG SW1-1 SW1-2 SW1-3 SW1-4 SW1-5 SW1-6 SW1-7 SW1-8 151 ON ON ON OFF ON OFF OFF ON 152 OFF OFF OFF ON ON OFF OFF ON 153 ON OFF OFF ON ON OFF OFF ON 154 OFF ON OFF ON ON OFF OFF ON 155 ON ON OFF ON ON OFF OFF ON 156 OFF OFF ON ON ON OFF OFF ON 157 ON OFF ON ON ON OFF OFF ON 158 OFF ON ON ON ON OFF OFF ...
-
Schneider Electric C3419M-D (11/08) - page 12
12 C3419M-D (11/08) SPECTRA ADDRESS SWITCH SETTI NG SW1-1 SW1-2 SW1-3 SW1-4 SW1-5 SW1-6 SW1-7 SW1-8 223 ON ON ON ON ON OFF ON ON 224 OFF OFF OFF OFF OFF ON ON ON 225 ON OFF OFF OFF OFF ON ON ON 226 OFF ON OFF OFF OFF ON ON ON 227 ON ON OFF O FF OFF ON ON ON 228 OFF OFF ON OFF OFF ON ON ON 229 ON OFF ON OFF OFF ON ON ON 230 OFF ON ON OFF OFF ON ON O ...
-
Schneider Electric C3419M-D (11/08) - page 13
C3419M-D (11/08) 13 Specifications GENERAL Construction Back Box Aluminum Dome Drive Aluminum, thermoplasti c Lower Dome Clear polycarb onate, 0.090-inch thick Cage Thicknes s 0.12 x 0.30- inch cast sta inless steel Cage Color Black, for maximum discreetness Cable Entry (Back Box) 0.75-inch co nduit fitti ng Pan Movement 360° contin uous pan rotat ...
-
Schneider Electric C3419M-D (11/08) - page 14
14 C3419M-D (11/08) The materials used in the manufacture of this document and its co mponents are compliant to the requirements of Directive 2002/9 5/EC. This equipment contains electrical or electronic components that mu st be recycled properly to comply with Directive 2002/96/EC of the European Union regarding the disposal of waste electrical an ...
-
Schneider Electric C3419M-D (11/08) - page 15
PRODUCT W ARRANTY AND RETURN INFORMA TION WARRANTY Pelco will repair or repl ace, without c harge, any merc handise proved defective in material or workmanshi p for a period of one year after the date of shipment. Exceptions to this warranty are as noted b elow: • Five year s: – Fiber optic prod ucts – TW3000 Series unshield ed twisted pair ( ...
-
Schneider Electric C3419M-D (11/08) - page 16
Pelco, Inc. W orldwide Headquarters 3500 Pelco Way Clovis, California 93612 USA USA & Canada T el (800) 289-9100 Fax (800) 289-9150 International T el +1 (559) 29 2-1981 Fax +1 (559) 348-1120 www .pelco.com ...
Schneider Electric C3419M-D (11/08)についてご質問がありますか？
次のフォームを使用してください
見つけた説明書を読んでもSchneider Electric C3419M-D (11/08)の問題を解決できない場合、下記のフォームを使用して質問をしましょう。ユーザーのどなたかがSchneider Electric C3419M-D (11/08)で同様の問題を抱えていた場合、その解決方法を共有したいと考えるかもしれません。