-
Patton electronic 1185 - page 1
USER MANU AL MODEL 1184 & MODEL 1185 Kilolight ™ Single Fiber Modems SALES OFFICE (301) 975-1000 TECHNICAL SUPPORT (301) 975-1007 http://www .patton.com Part# 07M1 185-C Doc# 03501 1U-C Revised 08/16/99 An ISO-9001 Certified Company ...
-
Patton electronic 1185 - page 2
T ABLE OF CONTENTS Section Page 1.0 W arranty Information .............................................................2 1.1 Radio and TV Interference 1.2 CE Notice 1.3 Service 2.0 General Information ...............................................................4 2.1 Product Features 2.2 General Product Description 3.0 Configuration ............. ...
-
Patton electronic 1185 - page 3
1.3 SERVICE All warranty and non-warranty repairs must be returned freight prepaid and insured to Patton Electronics. All returns must have a Return Materials Authorization number on the outside of the shipping container . This number may be obtained from Patton Electronics T echnical Service at (301) 975-1007 , at our web site at http://www .patto ...
-
Patton electronic 1185 - page 4
Switch S1-1 through S1-4 (Model 1 184 :): Async/Sync Data Rate On Model 1 184 Switches S1-1, S1-2, S1-3 and S1-4 set two parameters: synchronous or asynchronous data rate and the maximum transmission distance between two Model 1 184s. Data Max. Distance S1-1 S1-2 S1-3 S1-4 Rate (kbps) in miles (km) On Off Off On 0-19.2 3.0 (4.8) Off On On Off 4.8 3 ...
-
Patton electronic 1185 - page 5
Switch S1-1 through S1-4 (Model 1 185) : Async/Sync Data Rate On Model 1 185 Switches S1-1, S1-2, S1-3 and S1-4 set two parameters: synchronous or asynchronous data rate and the maximum transmission distance between two Model 1 185s. Data Max Distance S1-1 S1-2 S1-3 S1-4 Rate (kbps) in miles (km) On Off Off On 0-19.2 3.0 (4.8) On Off Off Off 0-38.4 ...
-
Patton electronic 1185 - page 6
4.0 INST ALLA TION Once the Model 1 184 or 1 185 is properly configured, it is ready to connect to the fiber interface, to the serial port, and to the power source. This section tells you how to make these connections. 4.1 CONNECTION TO THE FIBER INTERF ACE The Model 1 184 supports communication between two terminal equipment at distances to 3 mile ...
-
Patton electronic 1185 - page 7
Installing the New QuickConnect™ Module 1) Make sure the power switch is off. Leave the power cord plugged into a grounded outlet to keep the unit grounded. 2) Hold the module with the faceplate toward you and align the module with the guide slots in the rear panel of the Model 1 184/1 185. 3) While keeping the module’s faceplate parallel with ...
-
Patton electronic 1185 - page 8
5.0 OPERA TION Once the 1 184 or 1 185 is properly configured and installed, it should operate transparently . This sections describes power-up, reading the LED status monitors, and using the built-in loopback tests . 5.1 POWER-UP T o apply power to the Model 1 184/1 185, first be sure that you have read Section 4.3 , and that the unit is connected ...
-
Patton electronic 1185 - page 9
5.3 DIAGNOSTICS Model 1 184 and 1 185 are equipped with V .54 diagnostics that may be used to to evaluate the condition of the local and remote units, as well as the twisted pair link between them: local loopback (LAL) and remote digital loopback (DL). 5.3.1 Local Analog Loopback The Local Analog Loopback (LAL) test checks the operation of the loca ...
-
Patton electronic 1185 - page 10
APPENDIX A SPECIFICA TIONS T ransmission: Asynchronous and Synchronous Clocking: Internal, external or derived from receive signal Distance: 3 miles maximum (4.8km) 1 184 Data Rates: Asynchronous: 0 to 19.2 kbps Synchronous: 4.8, 9.6, 14.4, 19.2, 28.8, 32.0, 56.0, 64.0, 128.0 kbps 1 185 Data Rates: Asynchronous: 2.4 to 38.4 kbps Synchronous: 2.4, 9 ...
-
Patton electronic 1185 - page 11
APPENDIX C V .35 Interface Pin Description M/34 Female Connector Pin # Signal B SGND (Signal Ground) C RTS (Request to Send) D CTS (Clear to Send) E DSR (Data Set Ready) F CD (Carrier Detect) H DTR (Data T ransfer Ready) L LLB (Local Line Loop) M TM (T est Mode) N DL (Remote Digital Loop) P TD(T ransmit Data) R RD (Receive Data) S TD/ (T ransmit Da ...
-
Patton electronic 1185 - page 12
APPENDIX C (cont) X.21 Interface Pin Description (DB-15 Female Connector) Pin # Signal 1 . . . . . . . . . . . . Frame Ground 2 . . . . . . . . . . . . T (T ransmit Data-A) 3 . . . . . . . . . . . . C (Control-A) 4 . . . . . . . . . . . . R (Receive Data-A) 5 . . . . . . . . . . . . I (Indication-A) 6 . . . . . . . . . . . . S (Signal Element T imi ...
Patton electronic 1185についてご質問がありますか?
次のフォームを使用してください
見つけた説明書を読んでもPatton electronic 1185の問題を解決できない場合、下記のフォームを使用して質問をしましょう。ユーザーのどなたかがPatton electronic 1185で同様の問題を抱えていた場合、その解決方法を共有したいと考えるかもしれません。