Emerson CF930ORB01の取扱説明書

20ページ 5.24 mb
ダウンロード

ページに移動 of 20

Summary
  • Emerson CF930ORB01 - page 1

    1 1 1 -1 1 ...

  • Emerson CF930ORB01 - page 2

    YL ...

  • Emerson CF930ORB01 - page 3

    Supplied l. T wo 60-watt candelabra bulbs ...

  • Emerson CF930ORB01 - page 4

    k l ...

  • Emerson CF930ORB01 - page 5

    5 Y our new ceiling fan will require a grounded electrical supply line of 120 volts AC, 60 Hz, 15 amp circuit. The outlet box must be securely anchored and capable of withstanding a load of at least 50 pounds. General Y our Emerson ceiling fan comes supplied with a Fan/Light W all Control which consists of a wall control (transmitter) and a remote ...

  • Emerson CF930ORB01 - page 6

    6 1. Remove the hanger ball by loosening the setscrew in the hanger ball until the ball falls freely down the downrod (Figure 1). Remove the clevis pin from the downrod, then remove the hanger ball. Retain the pin and hanger ball for reinstallation in step 5. 2. Loosen setscrew in motor coupling if necessary . Separate, untwist and unkink the three ...

  • Emerson CF930ORB01 - page 7

    ...

  • Emerson CF930ORB01 - page 8

    ...

  • Emerson CF930ORB01 - page 9

    9 2. Carefully lift the fan and seat the hanger ball/downrod assembly on the hanger bracket that was just attached to the outlet box (Figure 12). Be sure the groove in the ball is lined up with the tab on the hanger bracket (Figure 1 1). Hanger bracket must seat firmly against outlet box. If the outlet box is recessed, remove wall board until brack ...

  • Emerson CF930ORB01 - page 10

    10 SW101 F AN/LIGHT WALL CONTROL (SUPPLIED) BLACK BLACK WHITE RED BLACK WHITE HANGER BALL GREEN WIRE (GROUND) FROM HANGER BALL AND HANGER BRACKET TWO-CONDUCTOR CABLE (WITH GROUND) BLACK (HOT) WHITE GROUND TO 120- VOL T SUPPL Y WHITE BLUE WHITE BLUE EMERSON ® HI MED LOW FAN OFF LIGHT ON OFF Figure 14 Check to see that all connections are tight, inc ...

  • Emerson CF930ORB01 - page 11

    ...

  • Emerson CF930ORB01 - page 12

    Do not connect any neutral (white) wire to this control. Incorrect wiring will damage this control. ! W ARNING 12 Installation of W all Control SINGLE-POLE INST ALLA TION (Figure 19) 1. Disconnect power at circuit breaker or remove fuse. 2. Remove faceplate and screws from existing wall control. Pull control out from the wall box. Determine the “ ...

  • Emerson CF930ORB01 - page 13

    5. Connect one black wire of the wall control to both remaining traveler wires in the wall box and secure with wire connector supplied. NOTE: Retrofit 3-way installations are likely to include two traveler wires between the two wall boxes. In new construction, only one traveler wire Is required. 3-WA Y WIRlNG DIAGRAM: NEW CONSTRUCTION 6. Place wall ...

  • Emerson CF930ORB01 - page 14

    14 ST ANDARD WIRING FOR EXISTING 3-WA Y CONTROL: HOT BLK F AN/LIGHT WALL CONTROL BLK TRA VELER WIRES BLK BLK BLACK LOAD BLACK LOAD TRA VELER WIRES HOT BLK EXISTING WALL CONTROL EMERSON ® EMERSON ® HI MED LOW FAN OFF LIGHT ON OFF HI MED LOW FAN OFF LIGHT ON OFF Figure 22 Operating Y our Ceiling Fan IMPORT ANT Fan installation must be completed, in ...

  • Emerson CF930ORB01 - page 15

    1. Downrod Extension Kits (see store or catalog). 2. Ceiling Fan Controls (see store or catalog). 3. Blades (see store or catalog). 15 Do not use water when cleaning your ceiling fan. It could damage the motor or the blades and create the possibility of an electrical shock. ! W ARNING The use of any other control not specifically approved for this ...

  • Emerson CF930ORB01 - page 16

    ...

  • Emerson CF930ORB01 - page 17

    -1 -1 -1 762670-5 762670-5 762670-5 ...

  • Emerson CF930ORB01 - page 18

    18 T rouble Shooting TROUBLE PROBABLE CAUSE SUGGESTED REMEDY 1. Fan will not 1. Fuse or circuit breaker 1. Check main and branch start. blown. circuit fuses or circuit breakers. W ARNING: Make sure main power is turned off. 2. Loose power line 2. Check line power connections connections to the fan. to fan. 3. Fan/Light W all Control is OFF. 3. T ur ...

  • Emerson CF930ORB01 - page 19

    19 LIMITED WARRANTY What The W ar ranty Covers: This warranty covers the motor and the other components and accessories of your Emerson Electric Co. ceiling fan against all defects in workmanship and materials. Y ou must be the original purchaser or user of the product to be covered. What The Period Of Coverage Is: As it applies to the motor , this ...

  • Emerson CF930ORB01 - page 20

    -1 1 ...

メーカー Emerson カテゴリー Fan

Emerson CF930ORB01のメーカーから受け取ることができるドキュメントは、いくつかのグループに分けられます。その一部は次の通りです:
- #BRANDの図面#
- CF930ORB01の取扱説明書
- Emersonの製品カード
- パンフレット
- またはEmerson CF930ORB01の消費電力シール
それらは全部重要ですが、デバイス使用の観点から最も重要な情報は、Emerson CF930ORB01の取扱説明書に含まれています。

取扱説明書と呼ばれる文書のグループは、Emerson CF930ORB01の取り付け説明書、サービスマニュアル、簡易説明書、またはEmerson CF930ORB01のユーザーマニュアル等、より具体的なカテゴリーに分類されます。ご必要に応じてドキュメントを検索しましょう。私たちのウェブサイトでは、Emerson CF930ORB01の製品を使用するにあたって最も人気のある説明書を閲覧できます。

関連する取扱説明書

Emerson CF930ORB01デバイスの取扱説明書はどのようなものですか?
取扱説明書は、ユーザーマニュアル又は単に「マニュアル」とも呼ばれ、ユーザーがEmerson CF930ORB01を使用するのを助ける技術的文書のことです。説明書は通常、全てのEmerson CF930ORB01ユーザーが容易に理解できる文章にて書かれており、その作成者はその分野の専門家です。

Emersonの取扱説明書には、基本的な要素が記載されているはずです。その一部は、カバー/タイトルページ、著作権ページ等、比較的重要度の低いものです。ですが、その他の部分には、ユーザーにとって重要な情報が記載されているはずです。

1. Emerson CF930ORB01の説明書の概要と使用方法。説明書にはまず、その閲覧方法に関する手引きが書かれているはずです。そこにははEmerson CF930ORB01の目次に関する情報やよくある質問、最も一般的な問題に関する情報を見つけられるはずです。つまり、それらはユーザーが取扱説明書に最も期待する情報なのです。
2. 目次。Emerson CF930ORB01に関してこのドキュメントで見つけることができる全てのヒントの目次
3. Emerson CF930ORB01デバイスの基本機能を使うにあたってのヒント。 Emerson CF930ORB01のユーザーが使い始めるのを助けてくれるはずです。
4. トラブルシューティング。Emerson CF930ORB01に関する最も重要な問題を診断し、解決するために役立つ体系化された手続き
5. FAQ。よくある質問
6. 連絡先。一人では問題を解決できない場合に、その国におけるEmerson CF930ORB01のメーカー/サービスへの連絡先に関する情報。

Emerson CF930ORB01についてご質問がありますか?

次のフォームを使用してください

見つけた説明書を読んでもEmerson CF930ORB01の問題を解決できない場合、下記のフォームを使用して質問をしましょう。ユーザーのどなたかがEmerson CF930ORB01で同様の問題を抱えていた場合、その解決方法を共有したいと考えるかもしれません。

画像のテキストを入力してください

コメント (0)