English dropdown-ico

Manual Combi 8000 Series

18 pages 0.71 mb
Download

Go to site of 18

Summary
  • Combi 8000 Series - page 1

    Ty r o ™ 8000 Series Instruction Manual Ty r o ™ Infant Car Seat C MBI ® L A T C H L o w e r A n c h o r a n d T e t h e r f o r C H i l d r e n • Certified for use in motor vehicles and aircraft. • Meets or exceeds all applicable requirements of Federal Motor V ehicle Safety Standard 213. Para instrucciones en Español, llamar al: 1-800-9 ...

  • Combi 8000 Series - page 2

    Section 1. T able of Contents.................................................................................................... .................. 1 Section 2. W arnings............................................................................................................. ..................... 3 Section 3. Proper Use Check List............. ...

  • Combi 8000 Series - page 3

    • Proper use is required. Read and understand instructions and car seat labels. • Use this infant car seat rear-facing only . • Snugly adjust harness straps around child. • Securely install car seat with LA TCH System or vehicle seat belt as specified in this instruction manual. • Do not use this infant car seat in a front vehicle seating ...

  • Combi 8000 Series - page 4

    5 INF ANT CAR SEA T Shoulder Harness Slot Chest Clip Harness Adjuster Lever Crotch Strap Carry Handle Canopy Not Shown (see page 24) V ehicle Lap Belt Guide (Without Base) Shoulder Harness Strap Metal Crotch Strap Anchor V ehicle Shoulder Belt Guide Harness Adjuster Strap Shoulder Harness Strap Cover Infant Insert Metal Harness Strap Clips Red Rele ...

  • Combi 8000 Series - page 5

    3 1 Position harness to fit infant: - Shoulder harness straps must be through shoulder harness slots at or just below infant’ s shoulders. - Infant insert MUST be used for small infants. See “Operations and Adjustments” section to change position of harness. Loosen harness - while pressing on harness adjustment lever , pull harness straps out ...

  • Combi 8000 Series - page 6

    National Highway T raffic Safety Administration (NHTSA) alerts vehicle owners that according to accident statistics, children up to age 12 are safer when properly restrained in the rear seating positions rather than the front seating positions. Refer to vehicle owner ’ s manual for car seat installation instructions for your vehicle. - Use car se ...

  • Combi 8000 Series - page 7

    LA TCH System On This Car Seat: The LA TCH System on the T yro ™ Car Seat consists of a lower anchor belt with lower anchor connectors . The lower anchor connectors on the car seat connect to the LA TCH System in a vehicle. LA TCH System On Vehicles: Child restraint anchorage system or the LA TCH System in the vehicle consists of two lower anchor ...

  • Combi 8000 Series - page 8

    13 Attaching Infant Car Seat T o Base: V erify that there are no objects on top of base or between base and infant car seat. Lower car seat into base and push down on car seat to lock car seat into base (fig. b) . T est to be sure car seat is locked in base. Lift infant car seat at top of seat back (fig. c) and at front end. Carry handle can be mov ...

  • Combi 8000 Series - page 9

    15 Attach car seat to base. Adjust recline using recline indicator on the side of the car seat. Line of recline indicator MUST be in green striped zone (fig. e) . If line is not in green striped zone, adjust base (see “Base Adjustment” section), and recheck recline of car seat. Repeat until recline indicator is in green striped zone. If base ca ...

  • Combi 8000 Series - page 10

    17 Securing Base With V ehicle Seat Belt: Refer to vehicle owner ’ s manual to identify the seating locations which can be used with a car seat. Check for specific instructions for car seat use. After selecting a seating location, adjust vehicle seat back into most upright position. Place base with car seat attached rear-facing on vehicle seat wi ...

  • Combi 8000 Series - page 11

    Securing Infant Car Seat W ithout Base: Refer to vehicle owner ’ s manual to identify the seating location which can be used with a car seat. Check for specific instructions for car seat use. After selecting a seating location, adjust vehicle seat back into most upright position. Place car seat rear-facing on vehicle seat. Carry handle can be mov ...

  • Combi 8000 Series - page 12

    21 This infant car seat can only be used with COMBI stroller models to transport your infant. Check COMBI stroller information or the COMBI International website at www .combi-intl.com, for an updated list of stroller models. See stroller instructions for securing car seat and use information. Section 10 - Stroller or T ravel System Use Changing Ha ...

  • Combi 8000 Series - page 13

    23 Harness Use and Adjustment Harness Strap Adjustment: •T o tighten: Pull front adjuster strap (fig. a) . •T o loosen: While pressing harness adjuster lever , pull harness straps out. Chest Clip Operation: •T o open: Press tabs and pull apart (fig. b) . •T o close: Snap halves together . Make sure chest clip is locked by pulling out. Carry ...

  • Combi 8000 Series - page 14

    25 To provide a secure installation of the car seat: • Read the vehicle owner ’ s manual regarding car seat installation and vehicle seat belt use with car seat. • Follow all instruction labels on vehicle seat belt and car seat. If car seat does not stay tightly secured after following instructions in this manual, vehicle seat belt labels, an ...

  • Combi 8000 Series - page 15

    27 Lap belts with retractors (fig. d) may or may not hold a car seat securely . Follow these steps to determine if you have a retractor system that will hold car seat securely: a. Pull belt all the way out. b. Allow belt to retract about 6 inches (15 cm). c. Pull out on belt again. If belt is locked and you cannot pull the belt out any further , yo ...

  • Combi 8000 Series - page 16

    The vehicle lap belt must be tight around the car seat and must stay tight. Check for a secure installation - pull front to back and side to side. If the car seat is not tightly secured, remove the belt lock-off and repeat steps 1 and 2. If car seat cannot be held tightly , check vehicle owner ’ s manual, see “V ehicle Seat Belt” section or m ...

  • Combi 8000 Series - page 17

    31 Cleaning Seat: T o Remove Seat Pad: 1. Remove shoulder harness. 2. Slide seat pad from car seat by gently pulling it of f the top of car seat back. T o Launder Pad: 1. Machine wash separately in cold water - delicate cycle, no bleach, and drip dry . T o Reassemble Seat Pad: Reverse above steps for replacing seat pad and harness system. Cleaning ...

  • Combi 8000 Series - page 18

    C MBI ® Designed by Parents, for Parents Keep this instruction manual for future use. Store instruction manual inside LA TCH storage compartment located on front of lower base. COMBI International Corporation • 189-199 Easy St. • Carol Stream, IL 60188 • Customer Service T elephone 1-800-992-6624 • Se Habla Español 1-630-871-0404 • Fax ...

Manufacturer Combi Category Car Seat

Documents that we receive from a manufacturer of a Combi 8000 Series can be divided into several groups. They are, among others:
- Combi technical drawings
- 8000 Series manuals
- Combi product data sheets
- information booklets
- or energy labels Combi 8000 Series
All of them are important, but the most important information from the point of view of use of the device are in the user manual Combi 8000 Series.

A group of documents referred to as user manuals is also divided into more specific types, such as: Installation manuals Combi 8000 Series, service manual, brief instructions and user manuals Combi 8000 Series. Depending on your needs, you should look for the document you need. In our website you can view the most popular manual of the product Combi 8000 Series.

Similar manuals

A complete manual for the device Combi 8000 Series, how should it look like?
A manual, also referred to as a user manual, or simply "instructions" is a technical document designed to assist in the use Combi 8000 Series by users. Manuals are usually written by a technical writer, but in a language understandable to all users of Combi 8000 Series.

A complete Combi manual, should contain several basic components. Some of them are less important, such as: cover / title page or copyright page. However, the remaining part should provide us with information that is important from the point of view of the user.

1. Preface and tips on how to use the manual Combi 8000 Series - At the beginning of each manual we should find clues about how to use the guidelines. It should include information about the location of the Contents of the Combi 8000 Series, FAQ or common problems, i.e. places that are most often searched by users in each manual
2. Contents - index of all tips concerning the Combi 8000 Series, that we can find in the current document
3. Tips how to use the basic functions of the device Combi 8000 Series - which should help us in our first steps of using Combi 8000 Series
4. Troubleshooting - systematic sequence of activities that will help us diagnose and subsequently solve the most important problems with Combi 8000 Series
5. FAQ - Frequently Asked Questions
6. Contact detailsInformation about where to look for contact to the manufacturer/service of Combi 8000 Series in a specific country, if it was not possible to solve the problem on our own.

Do you have a question concerning Combi 8000 Series?

Use the form below

If you did not solve your problem by using a manual Combi 8000 Series, ask a question using the form below. If a user had a similar problem with Combi 8000 Series it is likely that he will want to share the way to solve it.

Copy the text from the picture

Captcha
New picture

Comments (0)