-
SOSpenders 33MSPT - page 1
DO NOT REMOVE PRIOR T O SALE! OWNER’S MANUAL for Model 33MSPT APPROV AL CONDITIONS AND CARRIAGE REGULA TIONS This inflatable PFD is approved by the U.S. Coast Guard for use as a T ype III Personal Flotation Device (PFD). It is not approved for water skiing or other high impact, high speed activities. This inflatable PFD was designed to be more co ...
-
SOSpenders 33MSPT - page 2
2 ...
-
SOSpenders 33MSPT - page 3
INFLA TED DONNING - Depress oral inflation tube valve located on left side of chamber until the chamber is mostly deflated. Don as described above and reinflate with the oral tube until firm. 1. Inspect arming mechanism and cylinder - if RED , service mechanism. Don like a jacket, with buckle centered in front, with “ Jerk to Inflate ” handle a ...
-
SOSpenders 33MSPT - page 4
4 II. INSTRUCTIONS FOR USE A. PRE-DONNING INSTRUCTIONS CHECK THE FOLLOWING BEFORE USING THIS PFD: 1. INSPECT PFD FOR DAMAGE 2. BE SURE A CYLINDER IS INSERTED INT O THE MECHANISM AND CYLINDER SEAL INDICA TOR IS GREEN READ BELOW FOR MORE DET AILED INFORMA TION! 1. Inspecting Y our PFD For Damage Make sure that the PFD is free from rips, tears or punc ...
-
SOSpenders 33MSPT - page 5
5 c. CO 2 Cylinders are made with a protective coating that may wear off after a period of use or exposure to the environment. When this co at ing is worn of f, the CO 2 Cylinder may start to show some signs of rusting. If this occurs, replace the CO 2 Cylinder . d. If a gram scale (such as a postal scale) is available, it is recommended to weigh t ...
-
SOSpenders 33MSPT - page 6
6 3. COLD INFLA TION - Oral Inflation may be required in addition to man ual inflation if chamber is not firm due to cold temperatures at or below 40° F (4°C). Inflation T ime using CO 2 gas will be longer at these temperatures. See FREEZING TEMPERA TURES on page 7. 4. OTHER INFLA TION PRECAUTIONS a. CAUTION - Do not fully inflate orally then man ...
-
SOSpenders 33MSPT - page 7
7 G. OTHER USE GUIDELINES 1. Always wear your PFD when underway unless you are inside a cabin. 2. If you need to jump from any height always fold arms over your chest to keep the PFD in place when entering the water . 3. Avoid all unnecessary activities that will be abrasive to the device. 4. Use extreme caution around sharp objects. 5. A void unne ...
-
SOSpenders 33MSPT - page 8
8 Cleaning - Damp wipe only with mild detergent recommended for sy n thetic fabrics. Remove grease and oil immediately . Always rinse well with fresh water . Read instructions provided on the device. • DO NOT MACHINE W ASH • DO NOT MACHINE DR Y • DO NOT DR Y CLEAN • DO NOT USE SOL VENT BASED CLEANERS • DO NOT BLEACH C. INSPECTION Certifie ...
-
SOSpenders 33MSPT - page 9
9 IV . IS YOUR PFD IN GOOD AND SERVICEABLE CONDITION? Check your PFD between outings to be sure that it is properly armed; that it is free of rips, tears or holes; that all seams are securely sewn; and that the fabric, straps and hardware are still strong. Inspect the inflatable portion of the PFD in accordance with Care and Maintenance Instruction ...
-
SOSpenders 33MSPT - page 10
10 HOW DO YOU TEST YOUR PFD USING THE MANUAL INFLA TOR? 1. T o test your inflatable PFD, you will need: • Y our fully armed PFD , and • Rearming kit approved for your PFD. 2. Put on the PFD. 3. Actuate the inflation system by jerking firmly downward on the Jerk to Inflate tab. The PFD should fully inflate within 5 seconds. 4. Get into shallow w ...
-
SOSpenders 33MSPT - page 11
11 HOW DO YOU TEST YOUR PFD USING THE ORAL INFLA TOR? 1. T o test your inflatable PFD, you will not need any spare parts or rearming kits . 2. Remove the CO 2 cylinder , to prevent inadvertent activation of the manual inflation system which could potentially damage the PFD. 3. Put on the PFD. 4. Get into shallow water , just deep enough that you ca ...
-
SOSpenders 33MSPT - page 12
12 VIII. HYPOTHERMIA Prolonged exposure to cold water causes a condition known as hypothermia - a substantial loss of body heat, which leads to exhaustion and unconsciousness. Most drowning victims first suffer from hypothermia. The following chart shows the effects of hypothermia: PFDs can increase survival time because they allow you to float wit ...
-
SOSpenders 33MSPT - page 13
13 Some Points to Remember About Hypothermia Protection: 1. Always wear your PFD. Even if you become incapacitated due to hypothermia, the PFD will keep you afloat and greatly improve your chances of rescue. 2. Do not attempt to swim unless it is to reach a nearby craft, fellow survivor , or a floating object on which you can lean or climb. Swimmin ...
-
SOSpenders 33MSPT - page 14
14 5. Do not alter your PFD. If it doesn’t fit properly , get one that does. An altered device is no longer Coast Guard approved. 6. Y our PFD is not intended for use as a fender or kneeling pad. 7. If your PFD is wet, allow it to dry thoroughly before storing it. Store it in a well-ventilated area. 8. Do not dry your PFD in front of a radiator o ...
-
SOSpenders 33MSPT - page 15
15 1. Deflate chamber completely , smoothing flat with all snaps open. TURN OVER CAP , PRESS DOWN ON ORAL TUBE 1 4. Connect snaps starting from the bottom up to the chest strap. 2. Re-Arm mechanism 3. Fold along lines A & B as marked on chamber . 4 A B 3 5. REPEA T for other side, lines C & D. 6. Fold tip of chamber back and snap to webbing ...
-
SOSpenders 33MSPT - page 16
16 Halkey-Roberts V86160 Manual Inflator ReArming/Status Indicator Instructions DISASSEMBL Y (see figure) Step 1 : Unpack or open the life vest so that the manual inflator is visible. Step 2 : Remove gas CO 2 cylinder by rotating cylinder counterclockwise then pull out. Discard cylinder . REARMING Note: Rearming must follow the sequence below . Ste ...
Do you have a question concerning SOSpenders 33MSPT?
Use the form below
If you did not solve your problem by using a manual SOSpenders 33MSPT, ask a question using the form below. If a user had a similar problem with SOSpenders 33MSPT it is likely that he will want to share the way to solve it.