-
Hotpoint WMEF 742 - page 1
1 GB English,1 GB W ASHING MACHINE Contents Installation, 2-3-4-5 Unpacking and levelling Connecting the electricity and water supplies The first wash cycle T echnical data Care and maintenance, 6 Cutting off the water and electricity supplies Cleaning the washing machine Cleaning the detergent dispenser drawer Caring for the door and drum of your ...
-
Hotpoint WMEF 742 - page 2
2 GB 2. If the floor is not perfectly level, compensate for any unevenness by tightening or loosening the adjustable front feet (see figure); the angle of inclination, measured accor ding to the worktop, must not exceed 2°. Levelling your appliance correctly will pr ovide it with stability and avoid any vibrations, noise and shifting during operat ...
-
Hotpoint WMEF 742 - page 3
3 GB Connecting the drain hose Connect the drain hose, without bending it, to a draining duct or a wall drain situated between 65 and 100 cm from the floor; The drain hose may be connected to an under-sink trap. Before connecting the drain hose from the machine ensure that any blanks or removable ends have been taken off the spigot. If it is placed ...
-
Hotpoint WMEF 742 - page 4
4 GB As the colours of the wires in the lead may not correspond with the colour ed markings identifying the terminals in your plug, proceed as follows: Connect Green & Y ellow wire to terminal marked E or or coloured Gr een or Green & Y ellow . Connect Brown wir e to terminal marked L or coloured Red. Connect Blue wire to terminal marked N ...
-
Hotpoint WMEF 742 - page 5
5 GB T e c h n i c a l d a t a Model WMEF 742 Dimensions width 59.5 cm height 85 cm depth 54 cm Capacity from 1 to 7 kg Electrical connections pl ea se r e fe r t o th e te ch ni ca l da ta p la te f ix ed t o th e ma ch in e W ater con- nections maximum pressur e 1 MPa (10 bar) minimum pressur e 0.05 MPa (0.5 bar) drum capacity 52 litres Spin spee ...
-
Hotpoint WMEF 742 - page 6
6 GB Car e and maintenance Cutting of f the water and electricity supplies • Turn o ff the wate r tap aft er e very wa sh c ycle . Thi s wi ll l imit wear on the hyd raul ic s ystem ins ide the washi ng m achi ne a nd help to pre vent lea ks. • Unplug the washing machine when cleaning it and during all maintenance work. Cleaning the washing mac ...
-
Hotpoint WMEF 742 - page 7
7 GB Pr ecautions and tips ! This washing machine was designed and constructed in accordance with international safety regulations. The following information is provided for safety r easons and must therefor e be read carefully . General safety • This appliance was designed for domestic use only . • Thi s a ppli ance can be use d by chil dr en ...
-
Hotpoint WMEF 742 - page 8
8 GB Description of the washing machine Control panel TEMPERA TURE button W ASH CYCLE SELECTOR KNOB Detergent dispenser drawer ON/OFF button SPIN button ST ART/P AUSE b u t t o n and indicator light DISPLA Y DELA Y TIMER button OPTION button a nd indicator light Detergent dispenser drawer: used to dispense detergents and washing additives ( see “ ...
-
Hotpoint WMEF 742 - page 9
9 GB Display The display is useful when programming the machine and pr ovides a great deal of information. The duration of the available wash cycles and the remaining time of a running cycle appear; if the DELA Y TIMER option has been set, the countdown to the start of the selected wash cycle will appear . Pressing the corr esponding button allows ...
-
Hotpoint WMEF 742 - page 10
10 GB Running a wash cycle 1. SWITCH THE MACHINE ON. Press the button; the START/PAUSE indicator light will flash slowly in a green colour. 2. LOAD THE LAUNDRY. Open the porthole door. Load the laundry, making sure you do not exceed the maximum load value indicated in the table of programmes and wash cycles on the following page. 3. MEASURE OUT THE ...
-
Hotpoint WMEF 742 - page 11
11 GB W ash cycles and options Wa sh o pt io ns Time Saver If you select this option, the wash cycle duration will be reduced by up to 50%, depending on the selected cycle, there by guarante eing simulta neous water and energy savin g. Use this cycle for lightly soiled garments. ! It cannot be used in conjunctio n with wash cycles 1, 2, 6, 7, 8, 9, ...
-
Hotpoint WMEF 742 - page 12
12 GB Deter gents and laundry Detergent dispenser drawer Successful washing results also depend on the corr ect dose of detergent: adding too much detergent will not necessarily result in a mor e efficient wash, and may in fact cause build up on the inside of your appliance and contribute to environmental pollution. ! Use powder detergent for white ...
-
Hotpoint WMEF 742 - page 13
13 GB T r oubleshooting Y our washing machine could occasionally fail to work. Before contacting the T echnical Assistance Service ( see “ Service” ), make sure that the pr oblem cannot be solved easily using the following list. Problem: The machine does not switch on. The wash cycle does not start. The machine does not fill with water or ‘H2 ...
-
Hotpoint WMEF 742 - page 14
14 GB The machine is noisy . The machine wont spin properly . The machine leaks from the dispenser . The machine leaks (other than dispenser). The option lights and the ST ART/ P AUSE indicator light are flash rapidly and an error code appears on the display (eg F-01, F-..). The machine smells. The machine door cannot be opened. Door Seal damaged a ...
-
Hotpoint WMEF 742 - page 15
15 GB Assistance Guarantee 12 Months Parts and Labour Guarantee Y our appliance has the benefit of our manufacturer’ s guarantee, which covers the cost of br eakdown repairs for twelve months from the date of pur chase. This gives you the reassurance that if, within that time, your appliance is pr oven to be defective because of either workmanshi ...
-
Hotpoint WMEF 742 - page 16
16 GB 195104057.01 02/2013 - Xerox Fabriano After Sales Service No one is better placed to care for your Hotpoint appliance during the course of its working life than us - the manufacturer . Essential Contact Information Hotpoint Service We ar e the largest service team in Europe of fering you access to 400 skilled telephone advisors and 1000 fully ...
Do you have a question concerning Hotpoint WMEF 742?
Use the form below
If you did not solve your problem by using a manual Hotpoint WMEF 742, ask a question using the form below. If a user had a similar problem with Hotpoint WMEF 742 it is likely that he will want to share the way to solve it.