English dropdown-ico

Manual PB Heat WBV Series

26 pages 0.67 mb
Download

Go to site of 26

Summary
  • PB Heat WBV Series - page 1

    WB V/WV Boilers Series Oil Installation, Operation & Maintenance Manual As an E NERGY S TA R ® Partner, PB Heat, LLC has determined that certain firing rates of this product meet the E NERGY S TA R ® guidelines for energy efficiency . ...

  • PB Heat WBV Series - page 2

    USING THIS MANUAL 1 A . INST ALLA TION CLEARANCE . . . . . . . . . . . . .1 B . SPECIAL A TTENTION BOXES . . . . . . . . . . . .1 1. PREINST ALLA TION 2 A . CLEARANCES . . . . . . . . . . . . . . . . . . . . . . . .2 B . AIR FOR COMBUSTION AND VENTILA TION . . . . . . . . . . . . . . . . . . . . . . . . .2 C. CHIMNEY / VENT AND DRAFT CONTROL . .3 D ...

  • PB Heat WBV Series - page 3

    1 A. INST ALLA TION CLEARANCE F ollow the installation instructions provided in this manual in the order shown. The order of these instructions has been set in order to provide the installer with a logical sequence of steps that will minimize potential interferences and maximize safety during boiler installation. B. SPECIAL A TTENTION BO XES Throug ...

  • PB Heat WBV Series - page 4

    2 A. CLEARANCES Unit may be installed on combustible flooring, provided the boiler is not set on carpet and a metal drip pan is placed under the appliance. Unit may be installed in a closet with the above clearances. See also Section B, Air for Combustion and V entilation. B. AIR FOR COMBUSTION AND VENTILA TION 1. Be certain adequate facilities are ...

  • PB Heat WBV Series - page 5

    3 C. CHIMNEY / VENT AND DRAFT CONTROL 1. Draft Requirement – Minimum draft r equir ed in the vent system is -.03" to -.06" W .C. depending on boiler model, see T able 7.1 (Section 7). This draft is necessary to provide the necessar y draft over fire of -.01" to -.02" W .C. See discussion in paragraph 5 below regarding draft. 2 ...

  • PB Heat WBV Series - page 6

    4 A. SETTING THE BOILER 1. Provide a level foundation, located as close as possible to the center of the heating system. 2. Refer to Figur es 2.1 and 2.2 for e xploded view of boiler while checking and/or assembling parts of the boiler . 3. On packaged boilers, open burner mounting plate (item 5) at this time to make certain the target wall (item 2 ...

  • PB Heat WBV Series - page 7

    BOILER PLA CEMENT AND ASSEMBL Y (See T able 8.1 for parts identification). Figure 2.1: Steam boiler 5 Figure 2.2: W ater boiler ...

  • PB Heat WBV Series - page 8

    A. PRESSURE TEST BLOCK ASSEMBL Y 1. Make up cold water supply connection to the boiler . 2. Install pressur e gauge or pr essure-temperatur e gauge in tapping provided. See Boiler Dimensional drawing, Figur es 7.1 and 7.2 (Section 7) 3. Plug all open tappings in the boiler and fill with water . Apply approximately thirty (30) psig pressur e. Check ...

  • PB Heat WBV Series - page 9

    7 E. T ANKLESS HEA TER OR CO VERPLA TE 1. If a tankless coil is used (item 9), install as pictured. On water boilers, install in opening in front section. On steam boilers, install in opening in rear section. F or suggested piping of tankless water heaters refer to Figur es 3.3 and 3.4. 2. If not using a tankless coil, cover the heater opening with ...

  • PB Heat WBV Series - page 10

    8 Figure 3.6: Piping with P eerless Indirect Water T ank Figure 3.7: Float Low Water Cut -off PIPING AND CONTROLS Figure 3.5: Piping to Isolate Boiler from Chilled Medium on Chiller Systems ...

  • PB Heat WBV Series - page 11

    9 A. GENERAL All electrical wiring shall be done in accordance with the National Electrical Code and Local Requirements. Single pole switches including those of safety controls or protective devices shall not be wired in a grounded line. B. BURNER WIRING 1. See Section 5 for mounting burner . 2. Install junction box, limit harness, and Heyco bushin ...

  • PB Heat WBV Series - page 12

    10 ELECTRICAL Figure 4.3: Water Boilers, P ackaged Figure 4.2: Water Boilers, Knockdown ...

  • PB Heat WBV Series - page 13

    11 ELECTRICAL Figure 4.5: Steam with Probe Low W ater Cut -off Figure 4.4: Steam with Float Low Water Cut - Off ...

  • PB Heat WBV Series - page 14

    12 ELECTRICAL Figure 4.6: Zoning with Circulators Figure 4.7: Zoning with Zone V alves ...

  • PB Heat WBV Series - page 15

    13 BURNER SETUP & BOILER OPERA TION A. BURNER INST ALLA TION 1. The oil burner is supplied with a mounting flange fixed in position. 2. Mount the burner to the bur ner mounting plate (item 5) with four (4) 5/16" studs and nuts provided. 3. Care must be taken when routing the oil lines so not to interfere with the opening and closing of the ...

  • PB Heat WBV Series - page 16

    14 BURNER SETUP & BOILER OPERA TION E. CLEAN THE BOILER (STEAM BOILERS ONL Y) 1. Clean the boiler within one week after initial start-up. Cleaning will be more effective if boiler operates a day or two to loosen sediment and impurities in system. 2. Boiler must be cleaned to remove any accumulation of oil, grease, sludge, etc. in the system. Th ...

  • PB Heat WBV Series - page 17

    15 BURNER SETUP & BOILER OPERA TION BECKETT BURNER SPECIFIC A TIONS Boiler Model No . Burner Model No . Burner Head Static Plate Nozzle Size Pum p Pressure Start-up Settings Head Setting Air Shutter Air Band WBV -03-085 AFG- F3¹ F3 3-3/8" 0.75 80° B HAGO³ 140 PSI 6.0 1 N/A WBV -03-105 AFG- F4 F4 3-3/8" 0.90 80° B HAGO 140 PSI 6.0 ...

  • PB Heat WBV Series - page 18

    16 MAINTENANCE 6. MAINTENANCE W ARNING Product Saf ety Inf ormation Refractory Ceramic Fiber Product This appliance contains materials made from refractory ceramic fiber s (RCF). Airborne RCF , when inhaled, ha ve been c lassified by the International Agency f or Resear ch on Cancer (IARC), as a possib le carcinogen to humans. After the RCF materia ...

  • PB Heat WBV Series - page 19

    17 MAINTENANCE A. GENERAL 1. Check pipes adjacent to cold walls or in unheated spaces. Insulate and tape them if necessary to be sure they can't fr eeze up. Keeping the water moving at all times will reduce the likelihood of fr eezing. 2. If there is considerable for eign matter in the boiler water , the boiler should be shut down and allowed ...

  • PB Heat WBV Series - page 20

    18 MAINTENANCE 2. T o thoroughly clean the boiler it must be brushed down from the top. Alternatively , for limited space or minimum clearance to combustible installations, cleaning the heat e xchanger from the combustion chamber side is acceptable. If unit is e xtremely dirty , it may be necessary to brush from both directions. The target wall is ...

  • PB Heat WBV Series - page 21

    19 BOILER DIMENSIONS & RA TINGS 7. BOILER DIMENSIONS & RA TINGS Figure 7.1: Boiler Dimensions, Water Boiler Figure 7.2: Boiler Dimensions, Steam Boiler Boiler Model Number Jack et Depth "A" Rear of Jack et to C/L of T op Flue Outlet "B" To p Flue Size "C" WBV -03-085/110 14-1/8" 7-1/16" 6" WBV -0 ...

  • PB Heat WBV Series - page 22

    20 T able 7.1: Boiler Ratings ✸ As an ENERG Y ST AR ® P artner , PB Heat, LLC has determined that these firing rates meet the ENERG Y ST AR guidelines for energy efficiency . ✝ T op venting only . ✚ Nozzles for these firing rates not provided as standard equipment. Consult factory for price and availability . ✪ This firing rate can only be ...

  • PB Heat WBV Series - page 23

    21 R E PA I R PA R T S 8. REP AIR P ARTS Repair par ts are available from your installer or by contacting PB Heat, LLC, 131 S. Church St, Bally , P A 19503. Note: Remember to include boiler model number and serial number when ordering par ts. T able 8.1 Item No .* Stock Code Description Additional Information 1 2 3 4 5 6 7 8 9 10 11 11A 12 13 14 15 ...

  • PB Heat WBV Series - page 24

    22 NOTES ...

  • PB Heat WBV Series - page 25

    23 NOTES ...

  • PB Heat WBV Series - page 26

    PP8046 R26 (8/08-10M) Pri nte d i n U.S.A . ©2008 WB V/WV Boilers Series Oil Installation, Operation & Maintenance Manual TO THE INST ALLER: This manual is the property of the owner and must be affixed near the boiler for future reference. TO THE OWNER: This boiler should be inspected annually by a Qualified Service Agency. HI Division of gama ...

Manufacturer PB Heat Category Boiler

Documents that we receive from a manufacturer of a PB Heat WBV Series can be divided into several groups. They are, among others:
- PB Heat technical drawings
- WBV Series manuals
- PB Heat product data sheets
- information booklets
- or energy labels PB Heat WBV Series
All of them are important, but the most important information from the point of view of use of the device are in the user manual PB Heat WBV Series.

A group of documents referred to as user manuals is also divided into more specific types, such as: Installation manuals PB Heat WBV Series, service manual, brief instructions and user manuals PB Heat WBV Series. Depending on your needs, you should look for the document you need. In our website you can view the most popular manual of the product PB Heat WBV Series.

Similar manuals

A complete manual for the device PB Heat WBV Series, how should it look like?
A manual, also referred to as a user manual, or simply "instructions" is a technical document designed to assist in the use PB Heat WBV Series by users. Manuals are usually written by a technical writer, but in a language understandable to all users of PB Heat WBV Series.

A complete PB Heat manual, should contain several basic components. Some of them are less important, such as: cover / title page or copyright page. However, the remaining part should provide us with information that is important from the point of view of the user.

1. Preface and tips on how to use the manual PB Heat WBV Series - At the beginning of each manual we should find clues about how to use the guidelines. It should include information about the location of the Contents of the PB Heat WBV Series, FAQ or common problems, i.e. places that are most often searched by users in each manual
2. Contents - index of all tips concerning the PB Heat WBV Series, that we can find in the current document
3. Tips how to use the basic functions of the device PB Heat WBV Series - which should help us in our first steps of using PB Heat WBV Series
4. Troubleshooting - systematic sequence of activities that will help us diagnose and subsequently solve the most important problems with PB Heat WBV Series
5. FAQ - Frequently Asked Questions
6. Contact detailsInformation about where to look for contact to the manufacturer/service of PB Heat WBV Series in a specific country, if it was not possible to solve the problem on our own.

Do you have a question concerning PB Heat WBV Series?

Use the form below

If you did not solve your problem by using a manual PB Heat WBV Series, ask a question using the form below. If a user had a similar problem with PB Heat WBV Series it is likely that he will want to share the way to solve it.

Copy the text from the picture

Captcha
New picture

Comments (0)