Manual TERK Technologies TV44

14 pages 1.53 mb
Download

Go to site of 14

Summary
  • TERK Technologies TV44 - page 1

    TV44 Owner’ s Manual Amplified/Outdoor Satellite Dish Clip-on Antenna T4-0048-TV44-OM.qxp 4/28/04 11:31 AM Page 2 ...

  • TERK Technologies TV44 - page 2

    1 Saf ety Pr ecautions W arning! Use e xtr eme caution when ins t alling or r emo ving an outdoor antenna that is l ocated cl ose to o v erhead wir es such as po w er lines, tel ephone lines or cabl e TV lines. If any part of the antenna mak es c ont act with o v erhead po w er lines, t ouching the antenna or the antenna cabl e c an cause el ectr o ...

  • TERK Technologies TV44 - page 3

    2 About y our ne w TV44 outdoor TV antenna The TV44 f eatur es an int ernal amplifier that minimizes signal l oss. The sat ellite r eceiv er po w ers the amplifier, so no additional po w er suppl y is r equir ed. Because TERK’ s antenna el ements ar e manuf actur ed t o be weather-r esis t ant, the y’ll perform at their bes t f or many y ears t ...

  • TERK Technologies TV44 - page 4

    3 Ins t alling the TV44 on a satellit e dish 1. Make sur e all satellite r ec eiver s ar e turned off and unplugged fr om the el ectrical outl et. 2. Unsnap the antenna fr om the back notch of the mounting clamp. See Fig 2. 3. Hold the antenna t o the back of the dish so that the cir cular housing is c enter ed with the TERK l ogo facing out. See F ...

  • TERK Technologies TV44 - page 5

    4 4. Maneuver the clamps o v er or ar ound the edge of the dish one at a time. See Fig 4. 5. Snap the ant enna back into the back notch of the mounting clamp. 6. Tighten the clamps by turning the thumb-wheel scr ew cl ockwise. Not e: W e r ec ommend the use of the enclosed security clips f or any dish 20” or lar ger . Snap the security clips onto ...

  • TERK Technologies TV44 - page 6

    5 Connecting the TV44 Depending on the type of sat ellite dish y ou have, go t o one of the foll o wing five sc enarios to determine how to c onnect the TV44 antenna t o y our satellite dish. A-Singl e LNB (Phase1) Sat ellite Dish 1. Remo v e the LNB fr om the arm of the satellit e dish t o expose the sat ellite c ables. See Fig 6. 2. Disc onnect t ...

  • TERK Technologies TV44 - page 7

    6 4. Slide 2 black 32”antenna cabl es up thr ough the sat ellite arm and connect t o the LNB. See Fig 8. 5. Reconnect the LNB t o the dish arm. See Fig 8. 6. Connect the r emaining end of the 2 black 32” ant enna cables t o the IN 1 and IN 2 terminals on the TV44 ant enna. See Fig 9. 7. Continue t o “Ins t alling the Indoor Dipl ex er s.” F ...

  • TERK Technologies TV44 - page 8

    7 Connecting the TV44 ( c o n t i n u e d ) B - T ripl e LNB (Phase3) Sat ellite Dish 1. Remo v e the LNB fr om the arm of the satellit e dish t o expose the sat ellite c ables. See Fig 10. 2. Disc onnect the satellit e c able(s) fr om the sat ellite dish’ s LNB and pull them out thr ough the bott om of the satellit e dish arm. See Fig 10. 3. Con ...

  • TERK Technologies TV44 - page 9

    8 4. Slide 4 black 32” antenna cabl es up thr ough the satellite arm and connect t o the LNB. See Fig 12. 5. Reconnect the LNB t o the dish arm. See Fig 12. 6. Connect the r emaining end of the 4 black 32” ant enna cables t o the IN 1, IN 2, IN 3 and IN 4 terminals on the TV44 ant enna. See Fig 13. 7. Continue t o “Ins t alling the Indoor Dip ...

  • TERK Technologies TV44 - page 10

    9 Connecting the TV44 ( c o n t i n u e d ) C - Phase 2 Sat ellite Dish 1. Disc onnect the satellit e c ables fr om the “OUTPUT” or “T O RECEIVER” terminals on y our multiswitch. 2. Connect the satellite c ables t o the OUT 1, OUT 2, OUT 3, and OUT 4 terminals on the TV44 ant enna. See Fig 14. 3. Using 4 black 32” antenna cables, c onnect ...

  • TERK Technologies TV44 - page 11

    10 D- Using a Multiswit ch with an Ant enna Input 1. Complete “Sc enario A ” ins tructions. (Page 5) 2. Locat e your multiswit ch and disconnect the sat ellite wir e fr om the 18 volt or Sat ellite A/101 18 v olt terminal. 3. Connect the satellite wir e to the TV/SA T terminal of the dipl ex er . See Fig 16. 4. Use one of the supplied white 12? ...

  • TERK Technologies TV44 - page 12

    11 Connecting the TV44 ( c o n t i n u e d ) E - With Dish 500 Using SW21 Swit ches 1. Locat e your SW21 multiswitches and disc onnect the sat ellit e l eads connected t o the “T O RECIEVER” terminals. See Fig 17. 2. Connect the satellite l eads to the OUT 1 and OUT 2 terminals on the TV44 . See Fig 17. NO TE: Y ou may need to extend the sat el ...

  • TERK Technologies TV44 - page 13

    12 Ins t alling the indoor dipl e xers 1. Disc onnect the satellit e cabl e fr om the “SA T IN” terminal on y our sat ellite r ec eiver . See Fig 19 . 2. Connect the satellite c able t o the terminal mark ed “TV/SA T” on the indoor dipl exer . See Fig 20 . 3. Connect one of the supplied white 12” c onnector c ables fr om the terminal labe ...

  • TERK Technologies TV44 - page 14

    Setting up your TV 1. Ac c ess the menu of y our TV and mak e sur e the TV is in ANT/AIR mode and not C ABLE/C A TV mode. Pl ease r ef er to your TV manual f or the e xact s t eps to change this option. 2. Ac c ess the menu of y our TV and run the “ Auto Pr ogram” option. Pl ease r ef er to your TV manual f or the e xact s t eps t o change this ...

Manufacturer TERK Technologies Category Satellite TV System

Documents that we receive from a manufacturer of a TERK Technologies TV44 can be divided into several groups. They are, among others:
- TERK Technologies technical drawings
- TV44 manuals
- TERK Technologies product data sheets
- information booklets
- or energy labels TERK Technologies TV44
All of them are important, but the most important information from the point of view of use of the device are in the user manual TERK Technologies TV44.

A group of documents referred to as user manuals is also divided into more specific types, such as: Installation manuals TERK Technologies TV44, service manual, brief instructions and user manuals TERK Technologies TV44. Depending on your needs, you should look for the document you need. In our website you can view the most popular manual of the product TERK Technologies TV44.

A complete manual for the device TERK Technologies TV44, how should it look like?
A manual, also referred to as a user manual, or simply "instructions" is a technical document designed to assist in the use TERK Technologies TV44 by users. Manuals are usually written by a technical writer, but in a language understandable to all users of TERK Technologies TV44.

A complete TERK Technologies manual, should contain several basic components. Some of them are less important, such as: cover / title page or copyright page. However, the remaining part should provide us with information that is important from the point of view of the user.

1. Preface and tips on how to use the manual TERK Technologies TV44 - At the beginning of each manual we should find clues about how to use the guidelines. It should include information about the location of the Contents of the TERK Technologies TV44, FAQ or common problems, i.e. places that are most often searched by users in each manual
2. Contents - index of all tips concerning the TERK Technologies TV44, that we can find in the current document
3. Tips how to use the basic functions of the device TERK Technologies TV44 - which should help us in our first steps of using TERK Technologies TV44
4. Troubleshooting - systematic sequence of activities that will help us diagnose and subsequently solve the most important problems with TERK Technologies TV44
5. FAQ - Frequently Asked Questions
6. Contact detailsInformation about where to look for contact to the manufacturer/service of TERK Technologies TV44 in a specific country, if it was not possible to solve the problem on our own.

Do you have a question concerning TERK Technologies TV44?

Use the form below

If you did not solve your problem by using a manual TERK Technologies TV44, ask a question using the form below. If a user had a similar problem with TERK Technologies TV44 it is likely that he will want to share the way to solve it.

Copy the text from the picture

Comments (0)