English dropdown-ico

Manual Snapper RP216018KWV

32 pages 1.86 mb
Download

Go to site of 32

Summary
  • Snapper RP216018KWV - page 1

    Safety Instructions & Operator’s Manual for 21” STEEL DECK WALK MOWERS SERIES 18 MODEL NUMBER EXPLANATION P 21 70 18 B V E SELF-PROPELLED ENGINE OPTION CUTTING WIDTH ENGINE DESIGNATION ENGINE HORSE POWER * SERIES DESIGNATION R – Recycling Model P – Self Propelled Model 18 - Series Designation 21 – 21” Cutting Width 60 – 6.0 HP (En ...

  • Snapper RP216018KWV - page 2

    2 IMPORTANT SAFETY INSTRUCTIONS WARNING: This pow erful cutting machine is capable of amputating hands and feet and can throw objects that can cause injury and damage! Failure to comply w ith the follow ing SAFETY instructions could result in serious injury or death to the operator or other persons. The owner of the machine must understand these in ...

  • Snapper RP216018KWV - page 3

    3 IMPORTANT SAFETY INSTRUCTIONS SAFE HANDLING OF GASOLINE (Continued From Previous Page) 3. DO NOT remove fuel cap or add fuel w ith the engine running. Allow the engine to cool before refueling. 4. DO NOT refuel the machine indoors. 5. DO NOT store the machine or fuel container inside w here there is an open flame, spark or pilot light such as on ...

  • Snapper RP216018KWV - page 4

    4 IMPORTANT SAFETY INSTRUCTIONS MAINTENANCE AND STORAGE (Continued From Previous Page) 9. Mow er blades are sharp and can cut. Wrap the blades or w ear heavy leather glov es and use CAUTION w hen handling them. 10. DO NOT test for spark by grounding spark plug next to spark plug hole; spark plug could ignite gas exiting engine. 11. Have machine ser ...

  • Snapper RP216018KWV - page 5

    5 TABLE OF CONTENTS IMPORTANT SAFETY INSTRUCTIONS ...................................................................... 2 - 4 TABLE OF CO NTENTS ...................................................................................................... 5 SECTION 1 - FAMI LIARIZATI ON...................................................................... ...

  • Snapper RP216018KWV - page 6

    6 Section 1 - FAMILIARIZATION FIGURE 1.1 1.1 INTRODUCTION This manual has been prepared for the operators of the SNAPPER WALK BEHIND MOWERS. Its purpose, aside from recommending operating and routine service requirements, is to promote safety through the use of accepted operating practices. Read, Understand and Follow the “IMPORTANT SAFETY INSTRU ...

  • Snapper RP216018KWV - page 7

    7 Section 2 - OPERATING INSTRUCTIONS 2.1 PRE-START CHECK LIST Make the following checks and perform the service required before each start-up. 2.1.1. Check guards, deflectors, grass bag, adapter and covers to make sure all are in place and securely tightened. 2.1.2. Check blade control, wheel drive control, and engine speed control to insure they w ...

  • Snapper RP216018KWV - page 8

    8 Section 2 - OPERATING INSTRUCTIONS 2.2 STARTING & OPERATION 2. 2. 1. EN GI NE & BLADE (Kawasaki Engine) 1. Make sure fuel valve on engine is open. See Figure 2.5. FIGURE 2.5 2. Move engine speed control past “Fast” detent to “C ho ke ” position. See Figure 2.4 and “FAMILIARIZATION”. 3. Pull blade control against handle. 4. Pul ...

  • Snapper RP216018KWV - page 9

    9 Section 2 - OPERATING INSTRUCTIONS 2. Set all wheels at the same cutting height. The highest cutting position is Notch 6. The lowest cutting position is Notch 1. See Figures 2.8 & 2.9. FIGURE 2.9 2.6 INSTALLATION of GRASS BAG ADAPTER WARNING DO NOT attempt any maintenance, adjustments or service with engine and blade running. STOP engine and ...

  • Snapper RP216018KWV - page 10

    10 Section 2 - OPERATING INSTRUCTIONS WARNING DO NOT attempt any maintenance, adjustments or service with engine and blade running. STOP engine and blade. Disconnect spark plug w ire and secure aw ay from spark plug. Engine and components are HOT. Avoid serious burns, allow sufficient time for all components to cool. 2.8 INSTALLATION of GRASS BAG ( ...

  • Snapper RP216018KWV - page 11

    11 Section 2 - OPERATING INSTRUCTIONS WARNING DO NOT attempt any maintenance, adjustments or service with engine and blade running. STOP engine and blade. Disconnect spark plug w ire and secure aw ay from spark plug. Engine and components are HOT. Avoid serious burns, allow sufficient time for all components to cool. FIGURE 2.16 2.11 INSTALLATION o ...

  • Snapper RP216018KWV - page 12

    12 Section 3 – MAINTENANCE 3.1 INTRODUCTION To retain the quality of the mower, use genuine SNAPPER replacement parts only. Contact a local SNAPPER dealer for parts and service assistance. For the correct part or information for a particular mower, always mention model and serial number. WARNING DO NOT attempt any maintenance, adjustments or serv ...

  • Snapper RP216018KWV - page 13

    13 Section 3 – MAINTENANCE WARNING DO NOT attempt any maintenance, adjustments or service with engine and blade running. STOP engine and blade. Disconnect spark plug w ire and secure aw ay from spark plug. Engine and components are HOT. Avoid serious burns, allow sufficient time for all components to cool. Wear heavy leather gloves w hen handling ...

  • Snapper RP216018KWV - page 14

    14 Section 4 - REPAIR & ADJUSTMENTS WARNING DO NOT attempt any maintenance, adjustments or service with engine and blade running. STOP engine and blade. Disconnect spark plug w ire and secure aw ay from spark plug. Engine and components are HOT. Avoid serious burns, allow sufficient time for all components to cool. Wear heavy leather gloves w h ...

  • Snapper RP216018KWV - page 15

    15 Section 4 - REPAIR & ADJUSTMENTS WARNING DO NOT attempt any maintenance, adjustments or service with engine and blade running. STOP engine and blade. Disconnect spark plug w ire and secure aw ay from spark plug. Engine and components are HOT. Avoid serious burns, allow sufficient time for all components to cool. 4. Sharpen blade on a grindin ...

  • Snapper RP216018KWV - page 16

    16 Section 4 - REPAIR & ADJUSTMENTS WARNING DO NOT attempt any maintenance, adjustments or service with engine and blade running. STOP engine and blade. Disconnect spark plug w ire and secure aw ay from spark plug. Engine and components are HOT. Avoid serious burns, allow sufficient time for all components to cool. 4.3 DRIVEN AND DRIVE DISC SER ...

  • Snapper RP216018KWV - page 17

    17 Section 4 - REPAIR & ADJUSTMENTS WARNING DO NOT attempt any maintenance, adjustments or service with engine and blade running. STOP engine and blade. Disconnect spark plug w ire and secure aw ay from spark plug. Engine and components are HOT. Avoid serious burns, allow sufficient time for all components to cool. 4.3.3. DRIVEN DISC ADJUSTMENT ...

  • Snapper RP216018KWV - page 18

    18 Section 4 - REPAIR & ADJUSTMENTS WARNING DO NOT attempt any maintenance, adjustments or service with engine and blade running. STOP engine and blade. Disconnect spark plug w ire and secure aw ay from spark plug. Engine and components are HOT. Avoid serious burns, allow sufficient time for all components to cool. 4.3.4. Replacing Rubber Drive ...

  • Snapper RP216018KWV - page 19

    19 Section 4 - REPAIR & ADJUSTMENTS WARNING DO NOT attempt any maintenance, adjustments or service with engine and blade running. STOP engine and blade. Disconnect spark plug w ire and secure aw ay from spark plug. Engine and components are HOT. Avoid serious burns, allow sufficient time for all components to cool. 4.3.6. Replacement Of Bearing ...

  • Snapper RP216018KWV - page 20

    20 Section 4 - REPAIR & ADJUSTMENTS WARNING DO NOT attempt any maintenance, adjustments or service with engine and blade running. STOP engine and blade. Disconnect spark plug w ire and secure aw ay from spark plug. Engine and components are HOT. Avoid serious burns, allow sufficient time for all components to cool. 4.4.1. Engine Drive Belt Repl ...

  • Snapper RP216018KWV - page 21

    21 Section 4 - REPAIR & ADJUSTMENTS 4.5. BATTERY SERVICE 4.5.1. NEW BATTERY PREPARATION 1. Remove battery from carton. 2. Place battery in a well ventilated area on a level non-concrete surface. 3. Remove battery cell caps. Fill cells as required with electrolyte (supplied with battery) to proper level. Filling battery with electrolyte will bri ...

  • Snapper RP216018KWV - page 22

    22 TROUBLESHOOTING PROBLEM PROBABLE CAUSE CORRECTIVE ACTION Engine Will Not Start 1. Fuel tank empty. 1. F ill fuel tank w ith fresh fuel. Using Recoil Starter 2. Engine needs choking or priming. 2. Choke/Prime. Check Engine Manual for Instructions. 3. Spark plug wire disconnected. 3. Place spark plug w ire onto spark plug. 4. Kawasaki Engines Only ...

  • Snapper RP216018KWV - page 23

    23 SERVICE SCHEDULE ITEM SERVICE PERFORMED REF. EACH USE 5 HRS 25 HRS 50 HRS 100 HRS EACH SEASON Engine Oil Check Oil Level Page 7 X Initial Oil Change Page 12 X Periodic Oil Change Page 13 X* Air Pre-Cleaner Clean Sponge Element Engine Manual X** Air Cleaner Clean or Replace Engine Manual X** Spark Plug Replace Engine Manual X Engine Cooling Syste ...

  • Snapper RP216018KWV - page 24

    24 2 YEAR LIMITED WARRANTY For two (2) years from purchase date for the orig inal purchaser's residential, non-commercial use, SNAPPER , through any authorized SNAPPER dealer will replace, free of charge (except for taxes where applicable), any part or parts found upon examination by the factory at McDonough, Georgia, to be defective in materi ...

  • Snapper RP216018KWV - page 25

    25 PRIMARY MAINTENANCE ...

  • Snapper RP216018KWV - page 26

    26 PRIMARY MAINTENANCE ...

  • Snapper RP216018KWV - page 27

    27 PRIMARY MAINTENANCE ...

  • Snapper RP216018KWV - page 28

    28 PRIMARY MAINTENANCE ...

  • Snapper RP216018KWV - page 29

    29 SNAPPER PRODUCT REGISTRATION FORM IMPORTANT: KEEP THIS INFORMATION FOR YOUR PERSONAL RECORDS (Complete the following informa tion on your Snapper purchase) Model Number _____________________________________________________________ Serial Number _____________________________________________________________ Date of Pu rchase ______________________ ...

  • Snapper RP216018KWV - page 30

    30 NOTES ___________________________________________________________________ ___________________________________________________________________ ___________________________________________________________________ ___________________________________________________________________ ___________________________________________________________________ _ ...

  • Snapper RP216018KWV - page 31

    31 NOTES ___________________________________________________________________ ___________________________________________________________________ ___________________________________________________________________ ___________________________________________________________________ ___________________________________________________________________ _ ...

  • Snapper RP216018KWV - page 32

    32 Safety Instructions & Operator’s Manual for 21” STEEL DECK WALK BEHIND MOWERS SERIES 18 IMPORTANT Snapper products are built using engines that meet or exceed all applicable emissions requirements on the date manufactured. The labels on those engines contai n very important emissions information and critical safety warnings. Read, Unders ...

Manufacturer Snapper Category Lawn Mower

Documents that we receive from a manufacturer of a Snapper RP216018KWV can be divided into several groups. They are, among others:
- Snapper technical drawings
- RP216018KWV manuals
- Snapper product data sheets
- information booklets
- or energy labels Snapper RP216018KWV
All of them are important, but the most important information from the point of view of use of the device are in the user manual Snapper RP216018KWV.

A group of documents referred to as user manuals is also divided into more specific types, such as: Installation manuals Snapper RP216018KWV, service manual, brief instructions and user manuals Snapper RP216018KWV. Depending on your needs, you should look for the document you need. In our website you can view the most popular manual of the product Snapper RP216018KWV.

Similar manuals

A complete manual for the device Snapper RP216018KWV, how should it look like?
A manual, also referred to as a user manual, or simply "instructions" is a technical document designed to assist in the use Snapper RP216018KWV by users. Manuals are usually written by a technical writer, but in a language understandable to all users of Snapper RP216018KWV.

A complete Snapper manual, should contain several basic components. Some of them are less important, such as: cover / title page or copyright page. However, the remaining part should provide us with information that is important from the point of view of the user.

1. Preface and tips on how to use the manual Snapper RP216018KWV - At the beginning of each manual we should find clues about how to use the guidelines. It should include information about the location of the Contents of the Snapper RP216018KWV, FAQ or common problems, i.e. places that are most often searched by users in each manual
2. Contents - index of all tips concerning the Snapper RP216018KWV, that we can find in the current document
3. Tips how to use the basic functions of the device Snapper RP216018KWV - which should help us in our first steps of using Snapper RP216018KWV
4. Troubleshooting - systematic sequence of activities that will help us diagnose and subsequently solve the most important problems with Snapper RP216018KWV
5. FAQ - Frequently Asked Questions
6. Contact detailsInformation about where to look for contact to the manufacturer/service of Snapper RP216018KWV in a specific country, if it was not possible to solve the problem on our own.

Do you have a question concerning Snapper RP216018KWV?

Use the form below

If you did not solve your problem by using a manual Snapper RP216018KWV, ask a question using the form below. If a user had a similar problem with Snapper RP216018KWV it is likely that he will want to share the way to solve it.

Copy the text from the picture

Captcha
New picture

Comments (0)