Manual American Standard 6067.26X

14 pages 0.75 mb
Download

Go to site of 14

Summary
  • American Standard 6067.26X - page 1

    Installation Instr uctions Installation Instr uctions (In T oronto Area onl y: 1 -905-3061 093) Certified to comply with ASME A112.19.2M © 20 1 0 AS America, Inc. NO TE T O INST ALLER: Please giv e this manual to the cust omer af ter installation. SELECTRONIC™ PROXIMITY TOILET CONCEALED FLUSH V AL VE 1.28 & 1.6 GPF Concealed Flushometer for ...

  • American Standard 6067.26X - page 2

    All American Standar d Products Are W ater T ested At Our Factory . Some Residual Wat er May R emain In The V alve Dur ing Shipping. T hank you for selecting American-Standar d...the benchmark of f ine qualit y f or over 1 00 years. T o ensure that your installation pr oceeds smoothly --please read these instructions c arefully bef ore you begin. U ...

  • American Standard 6067.26X - page 3

    RECOMMENDED T OOLS; F ig. 2 F ig. 2 1. 2. 3. 4. 5. 6. 7. 8. 9. 10 . T eflon T ape Flat Blade Scre wdriver Adjust able W rench T ape Measure Hacksa w T ubing Cutt er File F or Sweat C onnection; Solder and T orch 2.5mm He x W rench 1 .5mm He x W rench 1 2 3 4 5 6 79 1 0 8 PRIOR T O INS T ALLA TION Note: Pr ior to installing the Selectr onic™Flush ...

  • American Standard 6067.26X - page 4

    F ig. 4 Fig. 3a F ig. 5 3 INS T ALL ELECTRIC AL BO X A SSEMBL Y ; F ig. 3 1. Cut a 1 27x1 27mm (5"x 5") opening in finished wall f or ELECTRIC AL BO X (1) at the deminsion shown in F ig.3. 2. Rot ate the 4 MOUNTING T ABS (2) flat against the electrical bo x. Holding the MOUNTING T ABS (2) in position install the ELECTRIC AL BO X (1) into ...

  • American Standard 6067.26X - page 5

    4 F ig. 6 F ig. 6a F ig. 6b F ig. 6c 3 4 INS T ALL V A CUUM BREAKER AND FLUSH CONNECTIONS; Fig. 6 4 1. Place the SPUD FLANGE (1) over the spud on the F ixture . Fig. 6. 2. Thread SPUD COUPLING NUT (2) ont o Spud. Make sure SEAL W ASHER (4) and FRICTION W ASHER (3) are inst alled. Do not tighten full y . Fig. 6. 3 . R emove the COUPLING NUTS (6, 6a) ...

  • American Standard 6067.26X - page 6

    7 9 6 2 5 8 10 F ig. 9 F ig. 8 5 7 1. Inser t the side ADJUS T ABLE T AILPIECE (1) on the FLUSH V AL VE (2) int o the SUPPL Y ST OP (3) . Lubricate the T AILPIECE O-RING (4) with w ater if necessar y . Lightly tighten COUPLING NUT (5) . F ig. 8. Important: Do not use lubricants (other than w ater) or any type of thread sealing past e or tape . INS ...

  • American Standard 6067.26X - page 7

    11 6 1. Remo ve the f our CO VER SCREWS (1) and CO VER from (2) ELECTRIC AL BO X (4) . F ig. 1 0. 2. P ull the CIRCUIT BO ARD (3) out from ELECTRIC AL BO X (4). Fig. 1 0. 3. Knock out lo wer blank in ELECTRIC AL BO X (4) with flat blade sc rewdr ive r . Install from the back of ELECTRIC AL BO X (4) the PO WER SUPPL Y GROMMET (8) . Fig. 1 0a. 4. Att ...

  • American Standard 6067.26X - page 8

    TOP 1. Remo ve the f our CO VER SCREWS (1) and CO VER (2) from ELECTRIC AL BO X (3) . F ig. 1 0. 2. Install BA TTER Y (4) into holder on DC cir cuit board. P ress BA TTER Y (4) down (contacts f acing down ward) in to position until tabs loc k BA TTER Y (4) into place . 3. Att ach the S AFETY CHAIN (5) from the FR ONT P ANEL (6) to the MOUNTING POST ...

  • American Standard 6067.26X - page 9

    8 1 4 2 5 5 6 BLUE HOSE BLACK HOSE 1. P ush the BLACK HOSE (1) int o the BO TTOM HOSE CONNECT OR (2) and the other end into the back of the O VERRIDE SWITCH (3) . 2. P ush the BLUE HOSE (4) into the TOP HOSE CONNECT OR (5) on the valv e and the other end into the BO TT OM CONNECTOR (6) on the O VERRIDE SWITCH (3) . CONNECT O VERRIDE HOSES, A C & ...

  • American Standard 6067.26X - page 10

    FOR A C-VERSION (MUL TI HOOK-UP); F ig. 1 5, 1 5a Unit #1 Unit #1 Unit #2 Unit #3 1 . Remo ve the CO VER SCREWS (1) and CO VER (2) from each ELECTRIC AL BO X (3) . 2. See AC V ersion Electrical Hook-up f or Unit #1 of the Multi hook-up . 3. Install SENSOR WIRE GROMMET (4) and FLUSH V AL VE SENSOR WIRE (5) into the CO VER (2) of each unit. Inser t t ...

  • American Standard 6067.26X - page 11

    3 5 7 6 TOP 1. R emov e FRONT P ANEL. For remo ving front panel see Step 9 f or instr uctions . 2. Remo ve the f our CO VER SCREWS (1) and CO VER (2) from ELECTRIC AL BO X (3) . F ig. 1 6. 3. Disconnect GREY SENSOR WIRE (4) from CIRCUIT BOARD (5) . 4. Remo ve CIRCUI T BOARD (5) from ELECTRIC AL BO X (3) . F ig. 16a. 5. With y our thumbs, spr ead th ...

  • American Standard 6067.26X - page 12

    6 TOP 11 Note: T he detection distance is pr eset and is ideal for most installations . Should an adjustment be requir ed f ollow the steps below . 1. Remo ve FR ONT P ANEL (1) . Se e Step 9 for remo ving front panel instr uctions . 2. Remo ve the f our CO VER SCREWS (2) and CO VER (3) from ELECTRIC AL BO X (4) . F ig. 1 8. 3. Disconnect GREY SENSO ...

  • American Standard 6067.26X - page 13

    12 IS ST OP V AL VE OPEN? L OOK FOR REPEA TED DOUBLE FLASH ON SENSOR YES INST ALL NEW B A TTER Y TR Y MANU AL V AL VE BUTT ON; WILL THE UNIT FLUSH? NO REPLA CE PIST ON KIT INST ALL NEW B A TTER Y or PLUG-IN A C POWER SUPPL Y SEE STEP 1 3, page 1 0 in manual NO REPLA CE SENSOR NO YES NO NO YES YES OPEN V AL VE UNIT WILL ONL Y FLUSH MANU ALL Y L OOK ...

  • American Standard 6067.26X - page 14

    SELECTRONIC™ PROXIMITY TOILET CONCEALED FLUSH V AL VE 1.28 & 1.6 GPF 13 A950223-0071600A SENSOR FOR FLUSH V ALVE WITH 1.6 gpf A950223-0071280A SENSOR FOR FLUSH V ALVE WITH 1.28 gpf A923654-0070A BA TTERY 6VCR-P2 M962664-0070A SOLENOID ASSEMBL Y M962663-0070A PISTON ASSEMBL Y M962752-0020A SLIP JOINT COUPLING M962752-0020A SLIP JOINT COUPLING ...

Manufacturer American Standard Category Plumbing Product

Documents that we receive from a manufacturer of a American Standard 6067.26X can be divided into several groups. They are, among others:
- American Standard technical drawings
- 6067.26X manuals
- American Standard product data sheets
- information booklets
- or energy labels American Standard 6067.26X
All of them are important, but the most important information from the point of view of use of the device are in the user manual American Standard 6067.26X.

A group of documents referred to as user manuals is also divided into more specific types, such as: Installation manuals American Standard 6067.26X, service manual, brief instructions and user manuals American Standard 6067.26X. Depending on your needs, you should look for the document you need. In our website you can view the most popular manual of the product American Standard 6067.26X.

A complete manual for the device American Standard 6067.26X, how should it look like?
A manual, also referred to as a user manual, or simply "instructions" is a technical document designed to assist in the use American Standard 6067.26X by users. Manuals are usually written by a technical writer, but in a language understandable to all users of American Standard 6067.26X.

A complete American Standard manual, should contain several basic components. Some of them are less important, such as: cover / title page or copyright page. However, the remaining part should provide us with information that is important from the point of view of the user.

1. Preface and tips on how to use the manual American Standard 6067.26X - At the beginning of each manual we should find clues about how to use the guidelines. It should include information about the location of the Contents of the American Standard 6067.26X, FAQ or common problems, i.e. places that are most often searched by users in each manual
2. Contents - index of all tips concerning the American Standard 6067.26X, that we can find in the current document
3. Tips how to use the basic functions of the device American Standard 6067.26X - which should help us in our first steps of using American Standard 6067.26X
4. Troubleshooting - systematic sequence of activities that will help us diagnose and subsequently solve the most important problems with American Standard 6067.26X
5. FAQ - Frequently Asked Questions
6. Contact detailsInformation about where to look for contact to the manufacturer/service of American Standard 6067.26X in a specific country, if it was not possible to solve the problem on our own.

Do you have a question concerning American Standard 6067.26X?

Use the form below

If you did not solve your problem by using a manual American Standard 6067.26X, ask a question using the form below. If a user had a similar problem with American Standard 6067.26X it is likely that he will want to share the way to solve it.

Copy the text from the picture

Comments (0)