English dropdown-ico

Manual Directed Electronics 5000

36 pages 0.23 mb
Download

Go to site of 36

Summary
  • Directed Electronics 5000 - page 1

    5000-series Security and Remote Start System Owner's Guide ...

  • Directed Electronics 5000 - page 2

    ...

  • Directed Electronics 5000 - page 3

    iii © 2010 Directed Electronics. All rights reserved. Congratulations Congratulations on the purchase of your state-of-the-art security and remote start system. Reading this Owner’ s Guide prior to using your system will help maximize the use of your system and its many features. For more information please visit us online at: www .directed.com/ ...

  • Directed Electronics 5000 - page 4

    iv © 2010 Directed Electronics. All rights reserved. Important information Government Regulations and Safety information Read the Government Regulations and W arning! Safety First sections of this manual prior to operating this system. W arning! Failure to heed this information can result in death, personal injur y or property damage and may also ...

  • Directed Electronics 5000 - page 5

    Contents Congratulations ............................................................................................... iii What’ s included ............................................................................................... iii Important information .................................................................................... ...

  • Directed Electronics 5000 - page 6

    Arming diagnostics ................................................................................. 18 Disarming diagnostics .............................................................................18 Nuisance Prevention® Circuitr y ................................................................18 Programming options ........................ ...

  • Directed Electronics 5000 - page 7

    3 © 2010 Directed Electronics. All rights reserved. Getting Started System Maintenance The system requires no specific maintenance beyond batter y replace- ment for the remote controls. Y our 1-way remote control is powered by a coin cell batter y (CR-2032) that can be purchased at most retailers. The operating range diminishes as the batter y we ...

  • Directed Electronics 5000 - page 8

    4 © 2010 Directed Electronics. All rights reserved. Basic Commands Arm/Lock Press and release The alarm arms, doors lock (if connected), and the siren/horn sounds and parking lights flash once. If V alet mode* is On, the doors lock. Exit V alet mode to arm/lock the alarm normally . T o Arm/lock and Panic Press and hold The alarm Arms (or Locks in ...

  • Directed Electronics 5000 - page 9

    5 © 2010 Directed Electronics. All rights reserved. For optional function (trunk release) Press and hold Activates the Aux output, such as trunk release or an expansion function that you have added to your system. The auxiliar y output controls: . Remote Start Press and release Activates (or if On, deactivates) the remote starter . The engine and ...

  • Directed Electronics 5000 - page 10

    6 © 2010 Directed Electronics. All rights reserved. Advanced Commands Additional Auxiliary functions. Press and buttons simultaneously Activates an optional auxiliar y convenience or expansion function that you have added to your system. The auxiliar y output controls Press and buttons simultaneously Activates an optional auxiliar y convenience or ...

  • Directed Electronics 5000 - page 11

    7 © 2010 Directed Electronics. All rights reserved. is remote started. When the same procedure is repeated, the defogger activates and the parking lights flash three times. If the vehicle interior temperature is greater than 55°F when the remote start is activated, the rear defogger does not turn on. T emperature Start Mode Press and and buttons ...

  • Directed Electronics 5000 - page 12

    8 © 2010 Directed Electronics. All rights reserved. Remote and System operations Passive arming/locking The system can be programmed to arm/lock itself au to mat i cal ly (called pas sive ar ming/locking). If the system is programmed for passive arming/ locking, it will automatically arm/lock 30 seconds after the ignition is turned of f and the sy ...

  • Directed Electronics 5000 - page 13

    9 © 2010 Directed Electronics. All rights reserved. • Shock Sensor T rigger - Heavy impacts to the vehicle will instantly sound the siren/horn and flash the lights for the programmed dura- tion and report Zone 2. • Door T rigger - I f a door is opened the siren/horn will sound and lights flash for three seconds, then the siren/horn will soun ...

  • Directed Electronics 5000 - page 14

    10 © 2010 Directed Electronics. All rights reserved. lowed by a long chirp. Zone 2 is now bypassed. Press a third time within five seconds. The siren chirps three times followed by a long chirp. Zone 4 is now bypassed. Press a fourth time within five seconds. The siren chirps four times followed by a long chirp. Zones 2 and 4 are now bypassed. P ...

  • Directed Electronics 5000 - page 15

    11 © 2010 Directed Electronics. All rights reserved. If the system is triggered and the siren has been sounding for longer than six seconds, pressing on the remote silences the siren while keeping the system in the armed state. The system does not disarm, but resets. Pressing again after silencing the system will disarm the system. If the system i ...

  • Directed Electronics 5000 - page 16

    12 © 2010 Directed Electronics. All rights reserved. Valet mode Y ou can prevent your system from automatically arming/locking and trig ger ing by using V alet Mode. This is ver y useful when washing the ve hi cle or having it ser viced. In V alet Mode, the system/starter kill will not arm/enable, even with the remote control, but all convenience ...

  • Directed Electronics 5000 - page 17

    13 © 2010 Directed Electronics. All rights reserved. the climate control system. If interior heating or cooling is desired, the climate controls must be preset, and the fan blower must be set to the desired level prior to remote starting the vehicle. W arning! (1) Never remote start your vehicle when the keys are in the ignition, except when perfo ...

  • Directed Electronics 5000 - page 18

    14 © 2010 Directed Electronics. All rights reserved. While the vehicle is running during remote start operation, the system monitors the ve hi cle and automatically shuts down the engine if the system receives any of the following: • The brake pedal is pressed • The hood is opened • The shutdown toggle switch is put into the Off position. ? ...

  • Directed Electronics 5000 - page 19

    15 © 2010 Directed Electronics. All rights reserved. Important! Timer Mode should be used only in open areas. Never start and run the vehicle in an enclosed space such as a garage or carport. Short Run/T urbo Mode Short run turbo mode keeps the engine running after arriving at your destination for a programmable period of 1, 3, 5 or 10 minutes. Th ...

  • Directed Electronics 5000 - page 20

    16 © 2010 Directed Electronics. All rights reserved. Valet T ake-Over The V alet T ake-Over feature allows the vehicle to remain running after the key has been removed from the ignition. This feature is useful for occasions when you wish to exit and lock the vehicle for short periods of time, but would like to leave the motor running and the clima ...

  • Directed Electronics 5000 - page 21

    17 © 2010 Directed Electronics. All rights reserved. Safety features This system has several important safety features to ensure proper op- eration of the motor and prevent accidental damage to the engine or its components. Starter -anti-grind circuitry Whenever the vehicle is remote started, advanced anti-grind circuitr y prevents the starter fro ...

  • Directed Electronics 5000 - page 22

    18 © 2010 Directed Electronics. All rights reserved. Diagnostics The microprocessor at the heart of your system is constantly mon i tor ing all of the switches and sensors connected to it. It is designed to detect any faulty switches and sensors and prevents them from disabling the entire system. The microprocessor will also record and report any ...

  • Directed Electronics 5000 - page 23

    19 © 2010 Directed Electronics. All rights reserved. prevents annoying repetitive trigger sequences due to faulty door pin switches or environmental conditions such as thunder , jackhammers, airport noise, etc. Example: If the alarm triggers three times within a 60-minute period and each time the same sensor or switch triggers the alarm, NPC will ...

  • Directed Electronics 5000 - page 24

    20 © 2010 Directed Electronics. All rights reserved. Zone Description Dealer installed options 1 T runk Pin 2 Instant trigger: a heavier impact detected by the shock sensor 3 Door switch trigger 4 Instant trigger: for optional sensors 5 Ignition trigger 6 Hood Pin Y our system stores the last two triggered zones in memory . If your system has been ...

  • Directed Electronics 5000 - page 25

    Programming options Programming options control your system’ s normal, operational set-up. Most options do not require additional parts, but some may require installation labor . See your authorized Directed dealer for more details. The following is a list of the programmable options, with the factor y settings in Bold. • Active arming (transmi ...

  • Directed Electronics 5000 - page 26

    22 © 2010 Directed Electronics. All rights reserved. • Forced passive arming On or Of f. If your security system is pro- grammed for passive arming and the forced passive arming fea- ture has been programmed on, the system will passively arm after one hour , even if a protected entry has been left open. Forced passive arming ensures that the sys ...

  • Directed Electronics 5000 - page 27

    23 © 2010 Directed Electronics. All rights reserved. Note: If your installer is programming the system with the Bitwrit- er ,® the remote start run time may be programmed for any dura- tion ranging from 1 to 60 minutes. • 3, 6, 9, or 12 minute timer mode run time. Y our system can be programmed to allow the vehicle to run for 3, 6, 9, or 12 min ...

  • Directed Electronics 5000 - page 28

    24 © 2010 Directed Electronics. All rights reserved. Government Regulations This device complies with Part 15 of FCC rules. Operation is subject to the fol- lowing two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including inter ference that may cause undesirable operati ...

  • Directed Electronics 5000 - page 29

    25 © 2010 Directed Electronics. All rights reserved. W arning! Safety First The following safety warnings must be obser ved at all times: Due to the complexity of this system, installation of this product must only be perfor med by an authorized Directed dealer . When properly installed, this system can start the vehicle via a com- mand signal fro ...

  • Directed Electronics 5000 - page 30

    After the remote start module has been installed, contact your autho- rized dealer to have him or her test the remote start module by per form- ing the Safety Check outlined in the product installation guide. If the vehicle starts when per forming the Neutral Safety Shutdown Circuit test, the remote start unit has not been properly installed. The r ...

  • Directed Electronics 5000 - page 31

    27 © 2010 Directed Electronics. All rights reserved. Patent Information This product is covered by one or more of the following U.S. patents: 303,223 345,711 4,383,242 5,103,221 5,534,845 5,907,195 333,633 347,190 4,438,426 5,117,217 5,572,185 5,914,667 333,634 348,622 4,553,127 5,132,660 5,646,591 5,945,936 333,635 352,685 4,584,569 5,193,141 5,6 ...

  • Directed Electronics 5000 - page 32

    28 © 2010 Directed Electronics. All rights reserved. Limited lifetime consumer warranty Directed Electronics. (“Directed”) promises to the original purchaser to repair or replace (at Directed’ s election) with a comparable reconditioned model any Directed unit (hereafter the “unit”), excluding without limitation the siren, the remote tra ...

  • Directed Electronics 5000 - page 33

    29 © 2010 Directed Electronics. All rights reserved. W ARRANTY DOES NOT COVER LABOR COSTS FOR MAINTENANCE, REMOV AL OR REINST ALLA TION OF THE UNIT OR ANY CONSEQUENTIAL DAMAGES OF ANY KIND. IN THE EVENT OF A CLAIM OR A DISPUTE INVOL VING DIRECTED OR ITS SUBSIDIARY , THE VENUE SHALL BE SAN DIEGO COUNTY IN THE ST A TE OF CALIFORNIA. CALIFORNIA ST A ...

  • Directed Electronics 5000 - page 34

    ...

  • Directed Electronics 5000 - page 35

    ...

  • Directed Electronics 5000 - page 36

    The company behind this system is Directed Elec tron ics Since its inception, Directed Electronics has had one purpose, to provide consumers with the finest vehicle security and car stereo products and accessories available. The recipient of nearly 100 patents and Innovations Awards in the field of advanced electronic technology, DIRECTED is ISO 90 ...

Manufacturer Directed Electronics Category Remote Starter

Documents that we receive from a manufacturer of a Directed Electronics 5000 can be divided into several groups. They are, among others:
- Directed Electronics technical drawings
- 5000 manuals
- Directed Electronics product data sheets
- information booklets
- or energy labels Directed Electronics 5000
All of them are important, but the most important information from the point of view of use of the device are in the user manual Directed Electronics 5000.

A group of documents referred to as user manuals is also divided into more specific types, such as: Installation manuals Directed Electronics 5000, service manual, brief instructions and user manuals Directed Electronics 5000. Depending on your needs, you should look for the document you need. In our website you can view the most popular manual of the product Directed Electronics 5000.

Similar manuals

A complete manual for the device Directed Electronics 5000, how should it look like?
A manual, also referred to as a user manual, or simply "instructions" is a technical document designed to assist in the use Directed Electronics 5000 by users. Manuals are usually written by a technical writer, but in a language understandable to all users of Directed Electronics 5000.

A complete Directed Electronics manual, should contain several basic components. Some of them are less important, such as: cover / title page or copyright page. However, the remaining part should provide us with information that is important from the point of view of the user.

1. Preface and tips on how to use the manual Directed Electronics 5000 - At the beginning of each manual we should find clues about how to use the guidelines. It should include information about the location of the Contents of the Directed Electronics 5000, FAQ or common problems, i.e. places that are most often searched by users in each manual
2. Contents - index of all tips concerning the Directed Electronics 5000, that we can find in the current document
3. Tips how to use the basic functions of the device Directed Electronics 5000 - which should help us in our first steps of using Directed Electronics 5000
4. Troubleshooting - systematic sequence of activities that will help us diagnose and subsequently solve the most important problems with Directed Electronics 5000
5. FAQ - Frequently Asked Questions
6. Contact detailsInformation about where to look for contact to the manufacturer/service of Directed Electronics 5000 in a specific country, if it was not possible to solve the problem on our own.

Do you have a question concerning Directed Electronics 5000?

Use the form below

If you did not solve your problem by using a manual Directed Electronics 5000, ask a question using the form below. If a user had a similar problem with Directed Electronics 5000 it is likely that he will want to share the way to solve it.

Copy the text from the picture

Captcha
New picture

Comments (0)