-
PYLE Audio PLR7N - page 1
OWNER ’ ’ S MANUAL PLR7N MOT ORIZED 7 ” ” IN -DASH LCD COLOR MONIT OR WITH AM/FM STEREO RADIO MODEL: ...
-
PYLE Audio PLR7N - page 2
Any changes or modifications in construction of this device which is not expressly approved by the party responsible for compliance could void the user ’ ’ s authority to operate the equipment. ...
-
PYLE Audio PLR7N - page 3
DO NOT DISASSEMBLE OR ALTER KEEP SMALL ARTICLES OUT OF THE REACH OF CHILDREN USE THE CORRECT AMPERE RATING WHEN REPLACING FUSES HALT USE IMMEDIATELY IF A PROBLEM APPEARS DO NOT OPERATE ANY FUNCTION THAT TAKES YOUR ATTENTION AWAY FROM SAFELY DRIVING YOUR VEHICLE Attempts to disassemble or alter may lead to an accident, fire and / or electric shock. ...
-
PYLE Audio PLR7N - page 4
CAUTION The exclamation point within an equilateral triangle and “ “ CAUTION ” ” are intended to alert the user to the presence of important operating instructions. Failure to heed the instructions can result in injury or material damage. DO NOT RAISE THE VOLUME EXCESSIVELY Keep the volume at a level, where you can still hear outside noises ...
-
PYLE Audio PLR7N - page 5
The exclamation point within an equilateral triangle and “ “ CAUTION ” ” are intended to alert the user to the presence of important operating instructions. Failure to heed the instructions can result in injury or material damage. Ope ration of some of the functions of this unit is very complex. Because of this, it was deemed necessary to p ...
-
PYLE Audio PLR7N - page 6
INTRODUCTION MONITOR 4 ⑩ ① ② ⑨ ⑤ ③ ⑥ ⑧ ④ ⑦ ① ① POWER ON/OFF BUTTON ② ② MODE SELECTION BUTTON ③ ③ AS/ATM BUTTON ④ ④ SOUND MUTE BUTTON ⑤ ⑤ VOLUME UP/DOWN ADJUST BUTTON ⑥ ⑥ SEARCH UP/DOWN BUTTON ⑦ ⑦ OPEN/CLOSE BUTTON ⑧ ⑧ TILT UP/DOWN BUTTON ⑨ ⑨ BAND SELECTION BUTTON ⑩ ⑩ MENU SELECTION BUTTON ...
-
PYLE Audio PLR7N - page 7
① ① POWER ON/OFF BUTTON ② ② MODE SELECTION BUTTON ③ ③ AS/ATM BUTTON ④ ④ SOUND MUTE BUTTON ⑤ ⑤ VOLUME UP/DOWN BUTTON ⑥ ⑥ SEARCH UP/DOWN BUTTON ⑦ ⑦ OPEN/CLOSE BUTTON ⑧ ⑧ MANUAL MEMORY BUTTON ⑨ ⑨ CHANNEL UP/DOWN BUTTON ⑩ ⑩ NAVIGATION BUTTON ⑪ ⑪ ASPECT BUTTON ⑫ ⑫ MENU SELECTION BUTTON ① ② ③ ④ ⑤ ...
-
PYLE Audio PLR7N - page 8
REMOTE CONTROL UNIT Replacing battery Applicable battery : Use two “ AAA ” sized dry batteries. 1. Opening the battery cover. Push and slide the cover in the arrow direction, and the cover will be removed. 2. Replacing the battery. Remove the old batteries. Insert new ones matching the (+) and (-) polarities as shown in the diagram inside the u ...
-
PYLE Audio PLR7N - page 9
1. POWER ON 1) Press the POWER button to turn the power on. But the monitor will not open. 2) You can also turn the power on by pressing the OPEN/CLOSE button. The power will be on and the monitor will open. 2. POWER OFF 1) Press the POWER button again to turn the power off. 2) If you turn the power off by pressing the POWER button when the monitor ...
-
PYLE Audio PLR7N - page 10
1. Hold lef t and right upper side of the monitor and set the left and right angle of the monitor parallel with the front of the unit as the picture. 2. Press OPEN/CLOSE button. The monitor will close. CLOSING THE MONITOR 1. If the left and right angle of the monitor is not parallel to the front of the unit, the monitor can not be closed. 2. If the ...
-
PYLE Audio PLR7N - page 11
ADJUSTING THE LEFT/RIGHT VIEWING POSITION The monitor ’ s left/right position can be adjusted for easier viewing by hand-operating. 9 1. Press the MENU button repeatedly on radio or AV mode until the USER SELECTOR menu is selected. 2. Press the SEARCH UP/DOWN button to select MOVE 3. Press the VO LUME ▶ button to select FORWARD. The monitor wil ...
-
PYLE Audio PLR7N - page 12
Press the MODE button to select the desired mode. Each time you press the button, the mode changes as follows. RADIO -> AV1 -> AV2 -> AV3 (CD OR VCD CHANGER) -> AV4 (TV) 1. AV3 has only video input. 2. The CD/VCD changer must be connected to the 8 pin DIN socket on the rear of the unit with 8 pin DIN cable in our CD/VCD changer gift box ...
-
PYLE Audio PLR7N - page 13
11 Each time you press A (ASPECT) button, the picture mode switches between Normal, Full, Zoom and Wide. NORMAL MODE The monitor displays normal picture at the center of the screen with the proportion of 4 to 3. The screen shows a vertical black belt at each side. FULL MODE The monitor displays normal picture wider by stretching out horizontally wi ...
-
PYLE Audio PLR7N - page 14
12 RADIO CONTROL Press the OPEN/CLOSE button to turn the power on and to open the monitor. The monitor shows following picture. MANUAL TUNING MANUAL STORING OF ST A TION Press the CH UP/DOWN button to move downward or upward one step respectively until the desired station frequency is selected. 1. Tune in the desired radio station you wish to store ...
-
PYLE Audio PLR7N - page 15
13 2. Press the SEARCH UP/DOWN button to select RADIO BAND. 3. When RADIO BAND is selected, press CH UP/DOWN button to select the radio band area (EUROPE or USA) for your country. Each time you press the CH UP/DOWN button, the band switches as EUROPE --> USA SELECTING THE BAND AREA FOR YOUR COUNTR Y NOTE On CD changer mode, you can pause or play ...
-
PYLE Audio PLR7N - page 16
14 1. Press the SEARCH UP/DOWN button to select SUB WOOFER. 2. Press the VOLUME ◀ or ▶ button to adjust sub woofer level. 1. Press the SEARCH UP/DOWN button to select TREBLE. 2. Press the VOLUME ◀ or ▶ button to adjust treble level. 1. Press the SEARCH UP/DOWN button to select BASS. 2. Press the VOLUME ◀ or ▶ button to adjust bass level ...
-
PYLE Audio PLR7N - page 17
15 1. C o nnect a NAVIGATION system only to AV1 or AV2 Input terminals on the rear of the unit. 2. Press the MODE button to select radio mode. 3. Press the MENU button to select following picture. NA VIGA TION Do not select the AV mode connected to the NAVIGATION system with the MODE button. If AV Input connected to the NAVIGATION system is selecte ...
-
PYLE Audio PLR7N - page 18
16 1. Connect a Back View Camera video output only to AV1,2 or 3 video Input terminals on the rear of the unit. * When the VCD changer is connected to AV3 Video input, The back view camera can be connected only to AV1 or AV2 video input. 2. Press the MODE button to select radio mode. 3. Press the MENU button to select following picture. NOTE CAMERA ...
-
PYLE Audio PLR7N - page 19
1. Each time the MENU button is pressed on CDC mode, the menu on the screen changes as follows. CD CHANGER -> VOLUME -> USER SELECTOR -> PICTURE -> OSD OFF 17 CD CHANGER CONTROL When a CD (VCD) changer is connected to this unit with 8 pin DIN cable, AV3 mode changes to CDC mode and CDC control menu is displayed on the screen. 1. Press t ...
-
PYLE Audio PLR7N - page 20
18 1. Press the SEARCH UP/DOWN button to select RANDOM . 2. Press the CH UP/DOWN button or the BAND button to select the item. Each time you press the button, the item changes as ONE -> ALL -> OFF INTRO SCAN 1. Press the SEARCH button to select INTRO SCAN. 2. Press the CH UP/DOWN button to select the item. Each time you press the CH UP/DOWN b ...
-
PYLE Audio PLR7N - page 21
19 DIRECT CD CHANGER CONTROL On the CD changer mode, you can directly control CD changer functions just by pressing the buttons on the remote controller for our monitor unit. STOP ■ button : to make the playing of the disc stop. PAUSE button : to stop the playing of the disc . press again to play again. PLAY button : to make the disc play. REW bu ...
-
PYLE Audio PLR7N - page 22
20 VOLUME ADJUSTMENT OF EACH CHANNEL 1. Press the MENU button repeatedly on radio or AV mode until VOLUME MENU is selected The monitor shows following picture. 2. Press the SEARCH UP/DOWN button to select the audio channel that you want to adjust. 3. Press the VOLUME ◀ or ▶ button to adjust the volume level of the selected audio channel. You ca ...
-
PYLE Audio PLR7N - page 23
21 2. Press the SEARCH UP/DOWN button to select the items that you want to adjust. 3. Press the VOLUME ◀ or ▶ button to adjust the level of the selected item. FINE ADJUSTMENT FOR CENTER FREQUENCY AND TILT/SLIDE POSITION 1. Press the MENU button when the monitor shows following picture. The monitor shows following picture. USER SELECTOR TIL T PO ...
-
PYLE Audio PLR7N - page 24
22 2. Press the SEARCH UP/DOWN button to select the items that you want to adjust. 3. Press the VOLUME ◀ or ▶ button to adjust the level of the selected item. SCREEN CONTROL 1. Press the MENU button when the monitor shows following picture. The monitor shows following picture. USER SELECTOR TIL T POSITON 0 MO VE FORW ARD USER SELECTOR MENU PICT ...
-
PYLE Audio PLR7N - page 25
1. Press the SEARCH UP/DOWN button to select COLOR SYSTEM for the video source on PICTURE menu. SELECTING COLOR/SOUND SYSTEM 2. Press the VOLUME ◀ or ▶ button to select PAL or NTSC for the video source. To select the color system for the TV when the TV tuner box is connected to the AV4 input of this unit, 1. Select color system (PAL or NTSC) fo ...
-
PYLE Audio PLR7N - page 26
VOLUME CONTROL ON A V MODE 24 2. Press the SEARCH UP/DOWN button to select the items that you want to adjust. 3. Press the VOLUME ◀ or ▶ button to adjust the audio level of the selected item. To adjust audio level of AV sources on AV mode, 1. Press the VOLUME ◀ or ▶ button. The monitor shows following picture. 1. Each time the MENU button i ...
-
PYLE Audio PLR7N - page 27
25 The monitor shows following warning picture when the parking brake is not set or when driving to prevent traffic accident that may be caused while watching the screen. The monitor shows the warning picture only and does not show any other pictures, but you can enjoy the sound only by adjusting the volume. W ARNING SCREEN ...
-
PYLE Audio PLR7N - page 28
Front View Video Audio Y ello w : Video White : Audio Left Red : Audio Right 26 A V INPUT F ACE PLA TE OF THE UNIT 3.5 Ø AV i nput on the front face of the unit is same input with AV1 input on the rear of the unit. If the sources are connected both input terminals,the 3.5 Ø input has priority in working. NOTE ...
-
PYLE Audio PLR7N - page 29
27 Strap Be sure to use the strap to secure the back of the unit in place to prevent sound cuts or skips. The strap can be bent by hand to the desired angle. Holder After inserting the holder into the dashboard, select the appropriate tabs according to the thickness of the dashboard material and bend them inwards to secure the holder in place. How ...
-
PYLE Audio PLR7N - page 30
28 BASIC CONNECTIONS REMOTE TURN-ON A UTO ANT P ARKING BRAKE ACC BA TTERY (MEMOR Y) SPEAKER FRONT RIGHT SPEAKER REAR RIGHT SPEAKER REAR LEFT SPEAKER FRONT LEFT (Y ellow) (Blue/White) (Red) (Brown) (Blue) (Gray) (Gray/Black) (Violet/Black) (Violet) (Green) (Green/Black) (White/Black) (White) T o amplifier or equalizer T o power antenna T o the parki ...
-
PYLE Audio PLR7N - page 31
CONNECTING TO CD CHANGER AND TV TUNER BOX 29 Red White Red White Ye l l o w ANT . PRE AMP RCA LINE OUT Front Right Front Left Rear Right Rear Left Sub W oofer Right Left Video Red White Y ellow A V -1 INPUT 16P Connector CD (VCD) Changer Ext. Monitor VIDEO in Video out (Y ellow) Video in (Y ellow) V 3 INPUT VIDEO out Y ellow A V2 INPUT Right Left V ...
-
PYLE Audio PLR7N - page 32
30 SPECIFICA TIONS AM SECTION USA BAND Frequency Range 530-1710KHz Frequ ency Step 10KHz EUROPE BAND Frequency Range 522-1620KHz Freq uency Step 9KHz Intermediate Frequency 450 KHz Usable Sensitivity 32 dB Image Rejection Ratio 45dB IF Rejection Ratio 100dB FM SECTION Frequency Range 87.5~108 MHz Frequency Step Manual tuning 50 KHz Se ek tuning 100 ...
-
PYLE Audio PLR7N - page 33
Printed In Korea ...
Do you have a question concerning PYLE Audio PLR7N?
Use the form below
If you did not solve your problem by using a manual PYLE Audio PLR7N, ask a question using the form below. If a user had a similar problem with PYLE Audio PLR7N it is likely that he will want to share the way to solve it.