English dropdown-ico

Manual Cabletron Systems 9T101-04

28 pages 0.32 mb
Download

Go to site of 28

Summary
  • Cabletron Systems 9T101-04 - page 1

    MMAC-Plus ™ 9T101-04 Four Port Token Ring Router User’s Guide ...

  • Cabletron Systems 9T101-04 - page 2

    ...

  • Cabletron Systems 9T101-04 - page 3

    i Notice Notice Cabletron Systems r eserves the right to make changes in specifications and other information contained in this document without prior notice. The reader should in all cases consult Cabletr on Systems to determine whether any such changes have been made. The hardwar e, firmware, or softwar e described in this manual is subject to ...

  • Cabletron Systems 9T101-04 - page 4

    ii Notice FCC Notice This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference r eceived, including interference that may cause undesir ed operation. NOTE: This equipment has been tested and found to c ...

  • Cabletron Systems 9T101-04 - page 5

    iii Notice DOC Notice This digital apparatus does not exceed the Class A limits for radio noise emissions fr om digital apparatus set out in the Radio Interference Regulations of the Canadian Department of Communications. Le présent appareil numérique n’émet pas de br uits radioélectriques dépassant les limites applicables aux appareils num? ...

  • Cabletron Systems 9T101-04 - page 6

    iv Notice ...

  • Cabletron Systems 9T101-04 - page 7

    v Contents Chapter 1 Intr oduction Features........................................................................................................................... 1-1 Related Manuals ............................................................................................................ 1-4 Getting Help ..................................... ...

  • Cabletron Systems 9T101-04 - page 8

    Contents vi ...

  • Cabletron Systems 9T101-04 - page 9

    1-1 Chapter 1 Intr oduction The 9T101-04 T oken Ring Router module, shown in Figure 1-1, is a four port T oken Ring router . Up to four front panel network connections can be made to this module and they can be routed to any other port and to any other MMAC-Plus module via the FNB bus. Features Processor The 9T101-04 is equipped with an advanced ID ...

  • Cabletron Systems 9T101-04 - page 10

    Introduction 1-2 Management Information Base (MIB) Support All concentrator modules provide MIB support including the following: • IETF Source Routing Bridging MIB • IETF MIB II LANVIEW LEDs The 9T101-04 uses LANVIEW: the Cabletr on Systems built-in visual diagnostic and status monitoring system. W ith LANVIEW LEDs, you can quickly identify the ...

  • Cabletron Systems 9T101-04 - page 11

    1-3 F eatures Figure 1-1. The 9T101-04 Module MMAC PLUS ...

  • Cabletron Systems 9T101-04 - page 12

    Introduction 1-4 Related Manuals The manuals listed below should be used to supplement the procedur es and technical data contained in this manual. MMAC-Plus Installation Guide MMAC-Plus Operations Guide MMAC-Plus 9C300-1 Environmental Module User ’ s Guide MMAC-Plus 9C214-1 AC Power Supply User ’ s Guide Cisco Systems R4500 manuals - CRM-DOC o ...

  • Cabletron Systems 9T101-04 - page 13

    2-1 Chapter 2 Installing the MMA C-Plus Module The MMAC-Plus module may be installed into any of the 14 slots that are available. T o install, follow the steps below: 1. Remove the blank panel, covering the slot that the module is being mounted in. All other slots must be covered, if modules ar e not being installed, to ensure pr oper airflow and ...

  • Cabletron Systems 9T101-04 - page 14

    Installing the MMA C-Plus Module 2-2 Figure 2-1. Installing the MMAC-Plus Module 7 FLNK 8 FLNK FLNK 10 FLNK INS 11 FLNK INS 12 RX TX RX TX RX Circuit Card Card Guides Metal Back-Panel Jack for ESD wrist strap Plastic T abs W arning: Ensure that the circuit card is between the card guides . Lock do wn the top and bottom plastic tabs at the same time ...

  • Cabletron Systems 9T101-04 - page 15

    2-3 The Reset Switch The Reset Switch The Reset switch is located on the front panel, under the top plastic tab, as shown in Figure 2-2. It serves two functions: • Pressing the Reset switch twice within thr ee seconds causes the processor to reset. • Pressing and holding the switch on for thr ee or more seconds causes the module to shutdown. Pr ...

  • Cabletron Systems 9T101-04 - page 16

    Installing the MMA C-Plus Module 2-4 T able 2-1. T erminal Setup Requirements Menu Function Selection Display Columns 80 Columns Setup: Controls Interpret Controls Auto Wrap No Auto Wrap Text Cursor Cursor General Mode 7 Bit Control Setup: Cursor Keys Normal Cursor Keys Communications Setup: Transmit Transmit = 9600 Receive Receive = Transmit XOFF ...

  • Cabletron Systems 9T101-04 - page 17

    2-5 Local Management Console An RJ-45 connector provides a CON interface to the management terminal. Figure 2-3 shows the pinouts. Figure 2-3. Console Cable Pinouts Connect the console to the module as follows: 1. Attach the male RJ-45 connector to the CON port of the 9T101-04. 2. Attach the female end (25-pin or 9-pin, as applicable) to the termin ...

  • Cabletron Systems 9T101-04 - page 18

    Installing the MMA C-Plus Module 2-6 ...

  • Cabletron Systems 9T101-04 - page 19

    3-1 Chapter 3 Operation The 9T101-04 T oken Ring Router module is a four port router . Four front panel network connections can be made to this module and they can be routed to any other port and to any other MMAC-Plus module via the FNB bus. Figure 3-1. 9T101-04 Block Diagram Token Ring port CPU Token Ring port FNB-1 or FNB-2 System Diagnostic Con ...

  • Cabletron Systems 9T101-04 - page 20

    Operation 3-2 Fle xible Netw ork Bus (FNB) The FNB consists of two dual FDDI networks, the FNB-1 and FNB-2, providing up to 400 Mbps of data bandwidth. These FDDI networks are 100% ANSI FDDI- compliant, supporting SMT (version 7.3), MAC, PHY , and PMD standards. This allows the FNB to traverse multiple MMAC-Plus hubs, or connect to any ANSI FDDI-co ...

  • Cabletron Systems 9T101-04 - page 21

    3-3 FNB Interf ace FNB Interface MMAC-Plus modules are designed with one of two attachment policies. One allows dual attachment of a module to either FNB-1 or FNB-2; the second allows dual attachment to both FNB-1 and FNB-2. The 9T101-04 has one dual attachment to the FNB backplane, connecting to either FNB-1 or FNB-2. The module can insert into th ...

  • Cabletron Systems 9T101-04 - page 22

    Operation 3-4 ...

  • Cabletron Systems 9T101-04 - page 23

    4-1 Chapter 4 LANVIEW LEDs The front panel LANVIEW LEDs, shown in Figur e 4-1, indicate the status of the module and may be used as an aid in troubleshooting. Figure 4-1. LANVIEW LEDs System Status FNB T ransmit FNB Receive T oken Ring Inser tion Ring speed ...

  • Cabletron Systems 9T101-04 - page 24

    LANVIEW LEDs 4-2 The functions of the System Management Bus (SMB) and CPU LEDs are listed in T able 4-1. * At least one T oken Ring port in both groups 0-1 and 2-3 ar e down. The function of the FNB Receive LED is listed in T able 4-2. The function of the FNB T ransmit LED is listed in T able 4-3. T able 4-1. SMB and CPU LEDs LED Color State Descri ...

  • Cabletron Systems 9T101-04 - page 25

    4-3 LANVIEW LEDs The functions of the T oken Ring Insertion LEDs are listed in T able 4-4. The function of the Ring Speed LEDs are listed in T able 4-5. T able 4-4. T oken Ring Insertion LEDs LED Color State Green Inserted into ring Off Not Inserted T able 4-5. Ring Speed LEDs LED Color State Green 16 mbps Off 4 mbps ...

  • Cabletron Systems 9T101-04 - page 26

    LANVIEW LEDs 4-4 ...

  • Cabletron Systems 9T101-04 - page 27

    5-1 Chapter 5 Specifications Safety This equipment meets the following safety requir ements: • UL 1950 • CSA C22.2 No. 950 • EN 60950 • IEC 950 • EMI Requirements of FCC Part 15 Class A • EN 55022 Class A • VCCI Class I • EMC the following requir ements: EN 50082-1 IEC 801-2 ESD IEC 801-3 Radiated susceptibility IEC 801-4 EFT Servi ...

  • Cabletron Systems 9T101-04 - page 28

    Specifications 5-2 Ph ysical Dimensions 35.0 D x 44.0 H x 3.0 W centimeters (13.8 D x 17.4 H x 1.2 W inches) W eight Unit: 1.36 kg. (3 lb) Shipping: 1.81 kg. (4 lb) En vironment Operating T emperature 5 to 40 ° C Storage T emperature -30 to 90 ° C Relative Humidity 5% to 95% non-condensing ...

Manufacturer Cabletron Systems Category Network Router

Documents that we receive from a manufacturer of a Cabletron Systems 9T101-04 can be divided into several groups. They are, among others:
- Cabletron Systems technical drawings
- 9T101-04 manuals
- Cabletron Systems product data sheets
- information booklets
- or energy labels Cabletron Systems 9T101-04
All of them are important, but the most important information from the point of view of use of the device are in the user manual Cabletron Systems 9T101-04.

A group of documents referred to as user manuals is also divided into more specific types, such as: Installation manuals Cabletron Systems 9T101-04, service manual, brief instructions and user manuals Cabletron Systems 9T101-04. Depending on your needs, you should look for the document you need. In our website you can view the most popular manual of the product Cabletron Systems 9T101-04.

Similar manuals

A complete manual for the device Cabletron Systems 9T101-04, how should it look like?
A manual, also referred to as a user manual, or simply "instructions" is a technical document designed to assist in the use Cabletron Systems 9T101-04 by users. Manuals are usually written by a technical writer, but in a language understandable to all users of Cabletron Systems 9T101-04.

A complete Cabletron Systems manual, should contain several basic components. Some of them are less important, such as: cover / title page or copyright page. However, the remaining part should provide us with information that is important from the point of view of the user.

1. Preface and tips on how to use the manual Cabletron Systems 9T101-04 - At the beginning of each manual we should find clues about how to use the guidelines. It should include information about the location of the Contents of the Cabletron Systems 9T101-04, FAQ or common problems, i.e. places that are most often searched by users in each manual
2. Contents - index of all tips concerning the Cabletron Systems 9T101-04, that we can find in the current document
3. Tips how to use the basic functions of the device Cabletron Systems 9T101-04 - which should help us in our first steps of using Cabletron Systems 9T101-04
4. Troubleshooting - systematic sequence of activities that will help us diagnose and subsequently solve the most important problems with Cabletron Systems 9T101-04
5. FAQ - Frequently Asked Questions
6. Contact detailsInformation about where to look for contact to the manufacturer/service of Cabletron Systems 9T101-04 in a specific country, if it was not possible to solve the problem on our own.

Do you have a question concerning Cabletron Systems 9T101-04?

Use the form below

If you did not solve your problem by using a manual Cabletron Systems 9T101-04, ask a question using the form below. If a user had a similar problem with Cabletron Systems 9T101-04 it is likely that he will want to share the way to solve it.

Copy the text from the picture

Captcha
New picture

Comments (0)