English dropdown-ico

Manual Planar PL1900

28 pages 0.38 mb
Download

Go to site of 28

Summary
  • Planar PL1900 - page 1

    PL1900 ...

  • Planar PL1900 - page 2

    1195 NW Compton Drive Beaverton, OR 97006-1992 www.planar.com Customer Service Planar provides the following technical support services: Internet Support For support available 24/7 visit Planar's Online Technical Support at www.planar.com/support. Our Online Technical Support is where you'll find solutions to many common problems, downloa ...

  • Planar PL1900 - page 3

    1 ...

  • Planar PL1900 - page 4

    2 The information contained in this document is subject to change without notice. This document contains proprietary information that is protected by copyright. All rights are reserved. No part of this document may be reproduced, translated to another language or stored in a retrieval system, or transmitted by any means, electronic, mechanical, pho ...

  • Planar PL1900 - page 5

    3 TABLE OF CONTENTS For Your Safety For Your Safety --------------------------------------------------------------- 4 General Notes Special notes on LCD monitors ------------------------------------------ 6 Before You Operate The Monitor Features ------------------------------------------------------------------------ 7 Checking the content s of th ...

  • Planar PL1900 - page 6

    4 For Your Safety Before operating the monitor, please read this manual thoroughly. This manual should be retained for future reference. FCC Class B Radio Frequency Interference Statement WARNING: (FOR FCC CERTIFIED MODELS) NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of ...

  • Planar PL1900 - page 7

    5 PRECAUTIONS z Do not use the monitor near water, e.g. near a bathtub, washbowl, kitchen sink, laundry tub, swimming pool or in a wet basement. z Do not place the monitor on an unst able cart, stand, or table. If the monitor falls, it can injure a person and cause serious damage to the appliance. Use only a cart or stand recommended by the manufac ...

  • Planar PL1900 - page 8

    6 GENERAL NOTES SPECIAL NOTES ON LCD MONITORS The following symptoms are normal with LCD monitor and do not indicate a problem. NOTES • Due to the nature of the fluore scent light, the screen may flicker during initial use. Turn off the Power Switch and then turn it on again to make sure the flicker disappears. • You may find slightly unev en b ...

  • Planar PL1900 - page 9

    7 BEFORE YOU OPERATE THE MONITOR FEATURES • 48.0cm(19”) TFT Color LCD Monitor • Crisp, Clear Display for Windows • Recommended Resolutions: 1280 X 1024 @60Hz • EPA ENERGY STAR ® • Space Saving, Compact Case Design CHECKING THE CONTENTS OF THE PACKAGE The product package should include the follow i ng items: Monitor Base Landing Strip U ...

  • Planar PL1900 - page 10

    8 Installation Instructions Pow er Source: 1. Make sure that the power cord is the correct type required in your area. 2. This LCD monitor has an External universal power supply that allows operation in either 100/120V AC or 220/240V AC voltage area (No user adjustment is required.) 3. Connect the AC-power cord into your LCD monitor’s External Ad ...

  • Planar PL1900 - page 11

    9 Installation Instructions CABLE CONNECTIONS Connecting the Signal Cable: the LCD monitor comes with a built-in signal cable. Plug the signal cable ′ s 15-pin connector into the computer's VGA port and tighten the two screws on the cable connector. Connecting the Power Cord: Plug the AC-power cord into the External Adapter. Then plug the DC ...

  • Planar PL1900 - page 12

    10 Installation Instructions ADJUSTING THE VIEWING ANGLE • For optimal viewing it is recommended to look at the full face of the monitor, then adjust the monitor’ s angle to your own preference. • Hold the stand so you do not topple the monitor when you change the monitor’s angle. • You are able to adjust the monitor’s angle from -5 ° ...

  • Planar PL1900 - page 13

    11 OPERATING INSTRUCTIONS GENERAL INSTRUCTIONS Press the power button to turn the monitor on or off. The other control buttons are located at front panel of the monitor (See Figure 3). By changing these settings, the picture can be adjusted to your personal preferences. • The power cord should be connected. • Connect the video cable from the mo ...

  • Planar PL1900 - page 14

    12 OPERATING INSTRUCTIONS(cont.) • Pow er Button: Press this button to switch ON/OFF of monitor’s power. • MENU / ENTER : Active OSD menu or function adjust confirm or Exit OSD menu when in Brightness/Contrast OSD status. • Contrast : Adjust contrast or function adjust. • Brightness : Adjust brightness or function adjust. • Auto Adjust ...

  • Planar PL1900 - page 15

    13 OPERATING INSTRUCTIONS (cont.) HOW TO ADJUST A SETTING 1. Press the MENU-button to activate the OSD window (Figure 4). 2. Press or to navigate through the functions. Once the desired function is highlighted, press the MENU-button to activate it. If the function selected has a sub-menu, press or again to navigate through the sub-menu functions. O ...

  • Planar PL1900 - page 16

    14 OPERATING INSTRUCTIONS (cont.) ADJUSTING THE PICTURE The descriptions for function control LEDS Main Menu Item Main Menu Icon Sub Menu Item Sub Menu Icon Description Luminance Contrast Contrast from Digital-register. Brightness Backlight Adjustment. Image Setup Focus Adjust Picture Phase to reduce Horizontal-Line noise. Clock Adjust picture Cloc ...

  • Planar PL1900 - page 17

    15 OPERATING INSTRUCTIONS (cont.) Main Menu Item Main Menu Icon Sub Menu Item Sub Menu Icon Description OSD Setup H.Position Adjust the horizontal position of the OSD. V.Position Adjust the vertical position of the OSD. OSD Timeout Adjust the OSD timeout. Language Language N/A Select the language you like. Information Information N/A Show the resol ...

  • Planar PL1900 - page 18

    16 PLUG AND PLAY Plug & Play DDC 2B Feature This monitor is equipped with VESA DDC 2B capabilities according to the VESA DDC STANDARD. It allows the monitor to inform the host system of its identity and, depending on the level of DDC used, communicate additional information about its display capabilities. The DDC 2B is a bidirectional dat a cha ...

  • Planar PL1900 - page 19

    17 TECHNICAL SUPPORT (FAQ) Problem & Question Possible Solution Power LED is not on *Check if the Power Switch is in the ON position *Power Cord should be connected No Plug & Play *Check if the PC system is Plug & Play compatible *Check if the Video Card is Plug & Play compatible *Check if the D-15 plug pin of Video Cable is bent. P ...

  • Planar PL1900 - page 20

    18 TECHNICAL SUPPORT (FAQ) (cont.) CLOCK (pixel frequency) controls the number of pixels scanned by one horizontal sweep. If the frequency is not correct, the screen shows vertical stripes and the picture has not correct width. FOCUS adjusts the phase of the pixel clock signal. With a wrong phase adjustment the picture has horizontal disturbances i ...

  • Planar PL1900 - page 21

    19 APPENDIX SPECIFICATIONS Driving system TFT Color LCD LCD Panel Size 48.0cm(19") Pixel pitch 0.294mm( H ) × 0.294mm( V ) Video R,G,B Analog Interface Input Separate Sync. H/V TTL H-Frequency 30kHz – 83kHz (Analog) V-Frequency 55-75Hz (Analog) Display Colors 16.7M Colors Dot Clock 135MHz (Analog) Max. Resolution 1280 × 1024 @75Hz(Analog) ...

  • Planar PL1900 - page 22

    20 APPENDIX (cont.) Switch • Auto Adjust Key • Brightness • Contrast • Power Button • MENU External Controls: Functions • Contrast • Brightness • Focus • Clock • H. Position • V. Position • (Warm)Color • (Cool)Color • sRGB • RGB Color temperature • Auto Config • OSD Setup • Language • Information • Reset • ...

  • Planar PL1900 - page 23

    21 APPENDIX (cont.) Preset Display Modes STANDARD RESOLUTION HORIZONTAL FREQUENCY VERTICAL FREQUENCY Dos-mode 720 × 400 31.469kHz 70.0Hz VGA 640 × 480 31.470kHz 60.0Hz 640 × 480 37.500kHz 75.0Hz SVGA 800 × 600 37.879kHz 60.0Hz 800 × 600 46.875kHz 75.0Hz XGA 1024 × 768 48.363kHz 60.0Hz 1024 × 768 56.476kHz 70.0Hz 1024 × 768 60.023kHz 75.0Hz ...

  • Planar PL1900 - page 24

    22 APPENDIX (cont.) CONNECTOR PIN ASSIGNMENT 15 6 10 11 15 15 - Pin Color Display Signal Cable PIN NO. DESCRIPTION PIN NO. DESCRIPTION 1. Red 9. +5V 2. Green 10. Ground 3. Blue 11. Ground 4. Ground 12. DDC-Serial Data 5. Detect Cable 13. H-Sync 6. R-Ground 14. V-Sync 7. G-Ground 15. DDC-Serial Clock 8. B-Ground ...

  • Planar PL1900 - page 25

    ...

  • Planar PL1900 - page 26

    ...

  • Planar PL1900 - page 27

    ...

  • Planar PL1900 - page 28

    Q41G19M1935 1A 1195 NW Compton Drive Beaverton, OR 97006-1992 www.planar.com © 2010 Planar Systems, Inc. Planar is a registered trademark of Planar Systems, Inc. Other brands and names are the property of their respective owners. Technical information in this document is subject to change without notice. ...

Manufacturer Planar Category Car Video System

Documents that we receive from a manufacturer of a Planar PL1900 can be divided into several groups. They are, among others:
- Planar technical drawings
- PL1900 manuals
- Planar product data sheets
- information booklets
- or energy labels Planar PL1900
All of them are important, but the most important information from the point of view of use of the device are in the user manual Planar PL1900.

A group of documents referred to as user manuals is also divided into more specific types, such as: Installation manuals Planar PL1900, service manual, brief instructions and user manuals Planar PL1900. Depending on your needs, you should look for the document you need. In our website you can view the most popular manual of the product Planar PL1900.

Similar manuals

A complete manual for the device Planar PL1900, how should it look like?
A manual, also referred to as a user manual, or simply "instructions" is a technical document designed to assist in the use Planar PL1900 by users. Manuals are usually written by a technical writer, but in a language understandable to all users of Planar PL1900.

A complete Planar manual, should contain several basic components. Some of them are less important, such as: cover / title page or copyright page. However, the remaining part should provide us with information that is important from the point of view of the user.

1. Preface and tips on how to use the manual Planar PL1900 - At the beginning of each manual we should find clues about how to use the guidelines. It should include information about the location of the Contents of the Planar PL1900, FAQ or common problems, i.e. places that are most often searched by users in each manual
2. Contents - index of all tips concerning the Planar PL1900, that we can find in the current document
3. Tips how to use the basic functions of the device Planar PL1900 - which should help us in our first steps of using Planar PL1900
4. Troubleshooting - systematic sequence of activities that will help us diagnose and subsequently solve the most important problems with Planar PL1900
5. FAQ - Frequently Asked Questions
6. Contact detailsInformation about where to look for contact to the manufacturer/service of Planar PL1900 in a specific country, if it was not possible to solve the problem on our own.

Do you have a question concerning Planar PL1900?

Use the form below

If you did not solve your problem by using a manual Planar PL1900, ask a question using the form below. If a user had a similar problem with Planar PL1900 it is likely that he will want to share the way to solve it.

Copy the text from the picture

Captcha
New picture

Comments (0)