English dropdown-ico

Manual Fujitsu ASU18RL

19 pages 0.68 mb
Download

Go to site of 19

Summary
  • Fujitsu ASU18RL - page 1

    KEEP THIS OPERA TION MANUAL FOR FUTURE REFERENCE FUJITSU GENERAL LIMITED P/N9315255013-01 OPERA TING MANUAL MODE D’EMPLOI MANUAL DE FUNCIONAMIENT O English Français Español Indoor Unit ASU18RL Outdoor Unit AOU18RL HEAT&COOLING MODEL (REVERSE CYCLE) ROOM AIR CONDITIONER WALL MOUNTED TYPE 05L256_9315255013-01_Cover 2005.12.6, 9:12 AM 1 ...

  • Fujitsu ASU18RL - page 2

    CONTENTS SAFETY PRECAUTIONS .................................... En-1 FEA TURES AND FUNCTIONS ........................... En-2 NAME OF P AR TS ................................................ En-3 PREP ARA TION .................................................... En-4 OPERA TION ........................................................ En-5 TIMER OP ...

  • Fujitsu ASU18RL - page 3

    CONTENTS SAFETY PRECAUTIONS .................................... En-1 FEA TURES AND FUNCTIONS ........................... En-2 NAME OF P ARTS ................................................ En-3 PREP ARA TION .................................................... En-4 OPERA TION ........................................................ En-5 TIMER OPE ...

  • Fujitsu ASU18RL - page 4

    CONTENTS SAFETY PRECAUTIONS .................................... En-1 FEA TURES AND FUNCTIONS ........................... En-2 NAME OF P ARTS ................................................ En-3 PREP ARA TION .................................................... En-4 OPERA TION ........................................................ En-5 TIMER OPE ...

  • Fujitsu ASU18RL - page 5

    En-2 FEA TURES AND FUNCTIONS INVERTER At the start of operation, a large power is used to bring the room quickly to the desired temperature. Afterwards, the unit automatically switches to a low power setting for eco- nomic and comfortable operation. COIL DRY OPERA TION The Indoor unit can be dried by pressing the COIL DRY but- ton on the Remote Con ...

  • Fujitsu ASU18RL - page 6

    En-3 Fig. 1 Indoor Unit 1 Operating Control Panel (Fig. 2) 2 MANUAL AUTO button ● When kept on pressing the MANUAL AUTO button for more than 10 seconds, the forced cooling operation will start. ● The forced cooling operation is used at the time of installation. Only for authorized service personnel's use. ● When the forced cooling operat ...

  • Fujitsu ASU18RL - page 7

    En-4 PREP ARA TION CAUTION! ● T ake care to prevent infants from accidentally swallowing batteries. ● When not using the Remote Control Unit for an extended period, remove the batteries to avoid possible leakage and damage to the unit. ● If leaking battery fluid comes in contact with your skin, eyes, or mouth, immedi- ately wash with copious ...

  • Fujitsu ASU18RL - page 8

    En-5 T o Select Mode Operation 1 Press the ST ART/STOP button (Fig.6 R ). The indoor unit’ s OPERA TION Indicator Lamp (red) (Fig. 3 5 ) will light. The air conditioner will start operating. 2 Press the MASTER CONTROL button (Fig.6 K ) to se- lect the desired mode. Each time the button is pressed, the mode will change in the following order . AUT ...

  • Fujitsu ASU18RL - page 9

    En-6 T o Stop Operation Press the ST ART/STOP button (Fig. 6 R ). The OPERA TION Indicator Lamp (red) (Fig. 3 5 ) will go out. About AUTO CHANGEOVER Operation AUTO: ● When AUTO CHANGEOVER operation first selected, the fan will oper - ate at very low speed for about one minute, during which time the unit detects the room conditions and selects the ...

  • Fujitsu ASU18RL - page 10

    En-7 TIMER OPERA TION s Before using the timer function, be sure that the Remote Control Unit is set to the correct current time ( ☞ P . 4). T o Use the ON timer or OFF timer 1 Press the ST ART/STOP button (Fig. 6 R ) (if the unit is already operating, proceed to step 2). The indoor unit’ s OPERA TION Indicator Lamp (red) (Fig. 3 5 ) will light ...

  • Fujitsu ASU18RL - page 11

    En-8 SLEEP TIMER OPERA TION Unlike other timer functions, the SLEEP timer is used to set the length of time until air conditioner operate is stopped. To Use the SLEEP Timer While the air conditioner is operating or stopped, press the SLEEP button (Fig. 6 J ). The indoor unit’ s OPERA TION Indicator Lamp (red) (Fig. 3 5 ) lights and the TIMER Indi ...

  • Fujitsu ASU18RL - page 12

    En-9 ADJUSTING THE DIRECTION OF AIR CIRCULA TION V ertical (up-down) direction of airflow is adjusted by pressing the Remote Control Unit’ s SET button. Horizontal (right-left) airflow direction is adjusted manually , by moving the Air Flow Direction Louvers. Whenever making horizontal airflow adjustments, start air conditioner operation and be s ...

  • Fujitsu ASU18RL - page 13

    En-10 SWING OPERA TION MANUAL AUTO OPERA TION ● When the air conditioner is operated with the controls on the Main Unit, it will operate under the same mode as the AUTO mode selected on the Re- mote Control Unit (see page 6). ● The fan speed selected will be “AUTO” and the thermostat setting will be standard.(76 °F ) COIL DRY OPERA TION Th ...

  • Fujitsu ASU18RL - page 14

    En-11 1 2 CLEANING AND CARE ● Before cleaning the air conditioner , be sure to turn it off and disconnect the Power . ● Be sure the Intake Grille (Fig. 1 9 ) is installed securely . ● When removing and replacing the air filters, be sure not to touch the heat exchanger , as per - sonal injury may result. CAUTION! Cleaning the Intake Grille 1. ...

  • Fujitsu ASU18RL - page 15

    En-12 Air Cleaning Filter Installation 1. Open the Intake Grille and remove the Air filters. 2. Install the Air cleaning filter set (set of 2). 1 Set the air cleaning filter into the air cleaning filter frame. 2 Engage the latch at both ends of the filter with the two hooks at the rear of the air cleaning filter frame. T ake care that the air clean ...

  • Fujitsu ASU18RL - page 16

    En-13 TROUBLESHOOTING W ARNING! Symptom Doesn’ t operate immedi- ately: Noise is heard: Smells: Mist or steam are emitted: Airflow is weak or stops: W ater is produced from the outdoor unit: Problem ● If the unit is stopped and then immediately started again, the com- pressor will not operate for about 3 minutes, in order to prevent fuse blowou ...

  • Fujitsu ASU18RL - page 17

    En-14 TROUBLESHOOTING Symptom Doesn’ t operate at all: Poor Cooling performance: The unit operates differently from the Remote Control Unit’ s setting: See Page — 7 - 8 — 5 4 CHECK ONCE MORE Items to check ● Is the Power Supply Plug disconnected its outlet? ● Has there been a power failure? ● Has a fuse blown out, or a circuit breaker ...

  • Fujitsu ASU18RL - page 18

    En-15 OPERA TING TIPS Dry Mode About 14 °F to 115 °F About 64 °F to 90 °F Outdoor temperature Indoor temperature Cooling Mode About 14 °F to 115 °F About 64 °F to 90 °F Heating Mode About 5 °F to 75 °F About 86 °F or less T emperature and Humidity Range ● If the air conditioner is used under higher temperature conditioner than those li ...

  • Fujitsu ASU18RL - page 19

    05L256_9315255013-01_En 2005.12.9, 11:49 AM 16 ...

Manufacturer Fujitsu Category Air Conditioner

Documents that we receive from a manufacturer of a Fujitsu ASU18RL can be divided into several groups. They are, among others:
- Fujitsu technical drawings
- ASU18RL manuals
- Fujitsu product data sheets
- information booklets
- or energy labels Fujitsu ASU18RL
All of them are important, but the most important information from the point of view of use of the device are in the user manual Fujitsu ASU18RL.

A group of documents referred to as user manuals is also divided into more specific types, such as: Installation manuals Fujitsu ASU18RL, service manual, brief instructions and user manuals Fujitsu ASU18RL. Depending on your needs, you should look for the document you need. In our website you can view the most popular manual of the product Fujitsu ASU18RL.

Similar manuals

A complete manual for the device Fujitsu ASU18RL, how should it look like?
A manual, also referred to as a user manual, or simply "instructions" is a technical document designed to assist in the use Fujitsu ASU18RL by users. Manuals are usually written by a technical writer, but in a language understandable to all users of Fujitsu ASU18RL.

A complete Fujitsu manual, should contain several basic components. Some of them are less important, such as: cover / title page or copyright page. However, the remaining part should provide us with information that is important from the point of view of the user.

1. Preface and tips on how to use the manual Fujitsu ASU18RL - At the beginning of each manual we should find clues about how to use the guidelines. It should include information about the location of the Contents of the Fujitsu ASU18RL, FAQ or common problems, i.e. places that are most often searched by users in each manual
2. Contents - index of all tips concerning the Fujitsu ASU18RL, that we can find in the current document
3. Tips how to use the basic functions of the device Fujitsu ASU18RL - which should help us in our first steps of using Fujitsu ASU18RL
4. Troubleshooting - systematic sequence of activities that will help us diagnose and subsequently solve the most important problems with Fujitsu ASU18RL
5. FAQ - Frequently Asked Questions
6. Contact detailsInformation about where to look for contact to the manufacturer/service of Fujitsu ASU18RL in a specific country, if it was not possible to solve the problem on our own.

Do you have a question concerning Fujitsu ASU18RL?

Use the form below

If you did not solve your problem by using a manual Fujitsu ASU18RL, ask a question using the form below. If a user had a similar problem with Fujitsu ASU18RL it is likely that he will want to share the way to solve it.

Copy the text from the picture

Captcha
New picture

Comments (0)