English dropdown-ico

Manual Hand Held Products 3800

20 pages 0.38 mb
Download

Go to site of 20

Summary
  • Hand Held Products 3800 - page 1

    3800 Linear Series QS ...

  • Hand Held Products 3800 - page 2

    1 For localized language vers ions of this document, go to www.handheld.com. Getting Started Turn off computer’s powe r before connecting the scanner, then power up the computer once the scanner is fully connected. USB Connection ...

  • Hand Held Products 3800 - page 3

    2 Keyboard W edge Connection Serial (RS-232) Connection ...

  • Hand Held Products 3800 - page 4

    3 Reading T echniques The view finder projects a red aiming beam that should be centered over the bar code. Hold the scanner over the bar code, pull the trigger, and center the aiming beam on the bar code. The aiming beam is smaller when the scanner is closer to the code and larger when it is farther from the code. Hold the scanner close to smaller ...

  • Hand Held Products 3800 - page 5

    4 To read PDF417 bar codes with a PDF-enabled 3800, hold the trigger down and move the scanner up and down so the aiming line sweeps from the top of the bar code to the bottom, and back up. This ensures that the entire code is scanned. Note: This only applie s to a PDF enabled 3800. Standard Product Defaults The following bar code resets all standa ...

  • Hand Held Products 3800 - page 6

    5 Interface Scan the bar code that describes the PC or interface you are using. AT/PS2 Keyboard Wedge (Default) RS-232 USB Keyboard (PC) Emulate External Keyboard Japan DOS/V ...

  • Hand Held Products 3800 - page 7

    6 Keyboard Country Scan the Program Keyboard Country bar code below, then scan the numeric bar code(s) from page 10, then the Save bar code to program the keyboard for your country. As a general rule, the following characters ar e not supported by the scanner for countries other than the United States: @ | $ # { } [ ] = / ‘ < > ~. Note: F ...

  • Hand Held Products 3800 - page 8

    7 Tr i g g e r The following bar codes will allow you to use the reader in Manual Trigger mode (need to press the trigger to read), Automatic Trigger mode (the beam is always on), or Presentation mode (the reader is activated when it “sees” a bar code). Reread Delay This sets the time peri od before the scanner can read the same bar code a seco ...

  • Hand Held Products 3800 - page 9

    8 Suffix If you want a carriage re turn after the bar code, scan the Add CR Suffix bar code . To add a tab after the bar code, scan the Add T ab Suffix bar code. Otherwise, scan the Remove Suffix bar code to remove the suffixes. Add Code ID Prefix to all Symbologies Scan the following bar code if you wish to add a Code ID prefix to all symbologies ...

  • Hand Held Products 3800 - page 10

    9 Data Format Editor Instructions The following are abbrevi ated instructions for entering a data format. For complete instructions refer to your User’s Guide, available at our website, www.handheld.com . 1. Scan the Enter Data Format symbol. 2. Primary/Alternate Format: scan 0 for Primary Format 3. Terminal Type: scan 99 for any terminal type 4. ...

  • Hand Held Products 3800 - page 11

    10 Programming Chart 0 2 1 4 3 5 6 7 ...

  • Hand Held Products 3800 - page 12

    11 A B C D E F 9 8 Save ...

  • Hand Held Products 3800 - page 13

    12 V isual Menu To obtain access to additi onal features for the 3800, use Visual Menu, available from our website at www.handheld.com . For complete download instructions and descripti ons of Visual Menu’s features, refer to yo ur User’s Guide. V isual Xpress™ To obtain access to additional features for the 3800g, 3800i, or 3800r, use Visual ...

  • Hand Held Products 3800 - page 14

    13 Europe, Middle East, and Africa: Telephone- European Ofc: +31 (0) 40 79 99 393 U.K. Ofc: +44 (0) 1925 24 00 55 E-mail: eutechsupport@handheld.com Asia Pacific: Telephone: +852-3188-3485 or 2511-3050 E-mail: aptechsupport@handheld.com America Latina: Teléfono: (704) 9 98-3998, opción 8 E-mail: latechsupport@handheld.com Online T echnical Assist ...

  • Hand Held Products 3800 - page 15

    14 paid) with a copy of the dated purchase record attached. Contact the appro priate location below to obtain a Return Material Authorization number (RMA #) before returning the product. North America Hand Held Products Corporate Offices Telephone: (800) 782-4263, Option 3 Fax: (704) 566-6015 E-mail: naservice@handheld.com America Latina Hand Held ...

  • Hand Held Products 3800 - page 16

    15 Japan Hand Held Products Japan Telephone: +81-3-5770-6312 Fax: +81-3-5770-6313 E-mail: apservice@handheld.com Online Product Service and Repair Assistance You can also access product service and repair assistance online at www.handheld.com . Limited W arranty Hand Held Products, Inc. ("Hand Held Products") warrants its products to be f ...

  • Hand Held Products 3800 - page 17

    16 This warranty shall extend from the time of shipment for the duration published by Hand Held Products for the product at the time of purchase ("Warranty Period"). Any defective product must be returned (at purchaser’s expense) during the Warranty Period to Hand Held Products factory or authorized service center for inspection. No pro ...

  • Hand Held Products 3800 - page 18

    17 HAND HELD PRODUCTS RESPONSIBILITY AND PURCHASER’S EXCLUSIVE REMEDY UNDER THIS WARRANTY IS LIMITED TO THE REPAIR OR REPLACEMENT OF THE DEFECTIVE PRODUCT. IN NO EVENT SHALL HAND HELD PRODUCTS BE LIABLE FOR INDIRECT, INCIDENT AL, OR CONSEQUENTIAL DAMAGES, AND, IN NO EVENT, SHALL ANY LIABILITY OF HAND HELD PRO DUCTS ARISING IN CONNECTION WITH ANY ...

  • Hand Held Products 3800 - page 19

    18 Disclaimer Hand Held Products, Inc. (“Hand Held Products”) reserves the right to make changes in specifications and other information contained in this document without prior notice, and the reader should in all cases consult Hand Held Products to determine whether any such changes have been made. The informati on in this publication does no ...

  • Hand Held Products 3800 - page 20

    Hand Held Products 700 Visions Drive P.O. Box 208 Skaneateles Falls, NY 13153-0208 Linear-02-QS Rev A 6/06 ...

Manufacturer Hand Held Products Category Barcode Reader

Documents that we receive from a manufacturer of a Hand Held Products 3800 can be divided into several groups. They are, among others:
- Hand Held Products technical drawings
- 3800 manuals
- Hand Held Products product data sheets
- information booklets
- or energy labels Hand Held Products 3800
All of them are important, but the most important information from the point of view of use of the device are in the user manual Hand Held Products 3800.

A group of documents referred to as user manuals is also divided into more specific types, such as: Installation manuals Hand Held Products 3800, service manual, brief instructions and user manuals Hand Held Products 3800. Depending on your needs, you should look for the document you need. In our website you can view the most popular manual of the product Hand Held Products 3800.

Similar manuals

A complete manual for the device Hand Held Products 3800, how should it look like?
A manual, also referred to as a user manual, or simply "instructions" is a technical document designed to assist in the use Hand Held Products 3800 by users. Manuals are usually written by a technical writer, but in a language understandable to all users of Hand Held Products 3800.

A complete Hand Held Products manual, should contain several basic components. Some of them are less important, such as: cover / title page or copyright page. However, the remaining part should provide us with information that is important from the point of view of the user.

1. Preface and tips on how to use the manual Hand Held Products 3800 - At the beginning of each manual we should find clues about how to use the guidelines. It should include information about the location of the Contents of the Hand Held Products 3800, FAQ or common problems, i.e. places that are most often searched by users in each manual
2. Contents - index of all tips concerning the Hand Held Products 3800, that we can find in the current document
3. Tips how to use the basic functions of the device Hand Held Products 3800 - which should help us in our first steps of using Hand Held Products 3800
4. Troubleshooting - systematic sequence of activities that will help us diagnose and subsequently solve the most important problems with Hand Held Products 3800
5. FAQ - Frequently Asked Questions
6. Contact detailsInformation about where to look for contact to the manufacturer/service of Hand Held Products 3800 in a specific country, if it was not possible to solve the problem on our own.

Do you have a question concerning Hand Held Products 3800?

Use the form below

If you did not solve your problem by using a manual Hand Held Products 3800, ask a question using the form below. If a user had a similar problem with Hand Held Products 3800 it is likely that he will want to share the way to solve it.

Copy the text from the picture

Captcha
New picture

Comments (0)