English dropdown-ico

Manual Bazooka CSA150.1

20 pages 3.9 mb
Download

Go to site of 20

Summary
  • Bazooka CSA150.1 - page 1

    ...

  • Bazooka CSA150.1 - page 2

    Dear customer, Congratulations on your purchase of a Bazooka CS high-performance amplifier. At Bazooka, we are fanatics about accurate music reproduction. Your selection of our products for your sound system indicates that quality sound is also important to you too. At SAS, we take great pride in manufacturing revolutionary audio products, and thro ...

  • Bazooka CSA150.1 - page 3

    S AFETY PRECAUTIONS Fuse amplifiers power wire at the battery. Be sure to fuse the power wire within 12” of the car's battery. This will protect the car's battery in case of a short circuit between the power amplifier and battery. THIS IS A MUST, the amplifier's built-in fuse will only protect the power amplifier not the car's ...

  • Bazooka CSA150.1 - page 4

    F EATURES AND BENEFITS DC Offset Protection This circuit protects the output of the amplifier against DC voltage. If for some reason DC voltage is detected at the output stage, the amplifier will shut down protecting the speakers from direct current. Short Circuit Protection The circuit protects the amplifier from damage due to a short found in the ...

  • Bazooka CSA150.1 - page 5

    Bass Boost (CSA150.1 & CSA300.1 Only) For added low frequency performance the amplifiers are equipped with a variable 0~12 dB bass boost @ 45Hz. Line Out (CSA150.1 & CSA300.1 Only) One set of full range line outputs have been provided for convenient connection to additional amplifiers in the system. Power Fusing This protects the amplifier ...

  • Bazooka CSA150.1 - page 6

    M OUNTING LOCATION Before you start the installation, it will be necessary to find a mounting location for the amplifier. Find a location in which the amplifier will receive adequate ventilation in order to dissipate the heat it develops during operation. Two popular mounting locations are in the trunk or under the seat. Select the location in whic ...

  • Bazooka CSA150.1 - page 7

    P OWER CONNECTIONS IMPORTANT! Before making any connections, disconnect the car’s battery until the installation is completed to avoid possible damage to the electrical system. SPEAKER FUSE + - BRIDGED POWER GND REM +12V + L L - + R R - CAR BA TTERY +12V CAR BA TTERY +12V - - + + 94.7 94.7 RADIO'S REMOTE TURN-ON OUTPUT RADIO'S REMOTE TU ...

  • Bazooka CSA150.1 - page 8

    Connect the amplifier to the car's battery. At times, the amplifier will need to draw large levels of current that cannot be provided by any circuit in the car's fuse box. We recommended using an 4 to 8 gauge power wire for your connections depending on the amplifier and length of the wire. Strip one end of the wire to connect to the term ...

  • Bazooka CSA150.1 - page 9

    8 S IGNAL CONNECTIONS Connect the RCA output of the head unit (AM/FM cassette player, CD, or DAT) to the RCA input terminals of the amplifier. To make these connections, we recommend high quality RCA cables, which are available at your local car audio retailer. Run signal wires away from electrical wires to avoid possibility of induced noise from t ...

  • Bazooka CSA150.1 - page 10

    Make the speaker connections using speaker wire that is at least 16 gauge or heavier. As with any audio component, proper phasing of the amplifier and speakers is essential for strong bass response. When connecting, make sure that positive (+) from the amplifier is connected to the positive (+) of the speaker, and the same for negative (-). S PEAKE ...

  • Bazooka CSA150.1 - page 11

    FUSE SPEAKER GND REM +12V + - CSA150.1 & CSA300.1 SPEAKER CONNECTIONS 4 Ohm Speaker (2 Ohm Minimum) 4 Ohm Speaker (2 Ohm Minimum) CSA200.3 SPEAKER CONNECTIONS FUSE SPEAKER POWER GND REM +12V + + + + - - - - CH3 CH4 BRIDGED CH1 CH2 4 Ohm Speaker (2 Ohm Minimum) 4 Ohm Speaker (2 Ohm Minimum) 4 Ohm Speaker (2 Ohm Minimum) 4 Ohm Speaker (2 Ohm Mini ...

  • Bazooka CSA150.1 - page 12

    CSA50.2 BRIDGED SPEAKER CONNECTIONS CSA200.3 BRIDGED SPEAKER CONNECTIONS CSA50.4 BRIDGED SPEAKER CONNECTIONS S PEAKER CONNECTIONS (BRIDGED) The EL amplifiers are capable of being bridged in a mono configuration. This feature allows you the flexibility of using the amplifier to drive a ** subwoofer or a center channel. In this configuration the ampl ...

  • Bazooka CSA150.1 - page 13

    CAUTION! In Tri- mode operation, the amplifier must see a 2 Ohm load or higher for the stereo satellites and no lower than 4 Ohms for the subwoofer(s). Any lower than the above mentioned impedance will cause the amplifier to overheat and possibly cause permanent damage to the amplifier. S PEAKER CONNECTIONS (TRI-MODE) 12 The amplifier is capable of ...

  • Bazooka CSA150.1 - page 14

    R EMOTE BASS CONTROL MODULE (CSA300.1 OPTIONAL) Before connecting the remote, it will be necessary to find a mounting location that will be easy to access for adjustment. Once you select your mounting location, you will need to run the control wire from the remote to the amplifier. To avoid possibility of induced noise from the car's electrica ...

  • Bazooka CSA150.1 - page 15

    . (Please note: If you intend to use the CSA50.2 in the Tri-mode configuration, it is necessary to set the crossover control to the “FLAT” setting in order to receive full range output) The “CS” amplifiers are equipped with a built-in crossover network allowing you to select the crossover type (i.e. Low-Pass or Hi-Pass) and the desired cros ...

  • Bazooka CSA150.1 - page 16

    T ROUBLE SHOOTING THE SYSTEM We have put together this trouble-shooting guide if you experience problems after installing the amplifier. Please keep in mind that the majority of problems incurred are caused by improper installation and not the equipment itself. In addition, there are many components in the system that could cause various signal pro ...

  • Bazooka CSA150.1 - page 17

    S PECIFICATIONS CSA50.2 CSA50.4 CSA200.3 Size (L x W x H) 7 Max Power 200W 400W 400W Output Power @ 14.4 VDC : 4 ohm 50W x 2 50W x 4 50W x 2 + 1 x 100W 2 ohm 75W x 2 75W x 4 75W x 2 + 1 x 150W Bridged 4ohm 150W x 1 150W x 2 N/A Frequency Response + - 1dB 20Hz-30KHz 20Hz-30KHz 20Hz-30KHz S/N Ratio (A-weight) >90dB >90dB >90dB THD with 80k f ...

  • Bazooka CSA150.1 - page 18

    17 LIMITED WARRANTY Southern Audio Services, Inc., warrants all products to be free from defects in material and workmanship for a period of one (1) year from the date of purchase; the Reference Series is warranted for a period of two (2) years from date of purchase. In the event the product is not as warranted, SAS’ sole obligation shall be to r ...

  • Bazooka CSA150.1 - page 19

    18 How to obtain warranty services: 1. You are responsible for delivery of the product to an authorized BAZOOKA® dealer or contact SAS at 1-800-THE TUBE for a Return Authorization number. The Return Authorization number must be clearly written on the outside of the box. Freight must be prepaid to SAS. Warranty replacement parts will be returned fr ...

  • Bazooka CSA150.1 - page 20

    Manual By www.extremeconcepts.com CSA MANUAL REV 1.29.04 ...

Manufacturer Bazooka Category Car Stereo System

Documents that we receive from a manufacturer of a Bazooka CSA150.1 can be divided into several groups. They are, among others:
- Bazooka technical drawings
- CSA150.1 manuals
- Bazooka product data sheets
- information booklets
- or energy labels Bazooka CSA150.1
All of them are important, but the most important information from the point of view of use of the device are in the user manual Bazooka CSA150.1.

A group of documents referred to as user manuals is also divided into more specific types, such as: Installation manuals Bazooka CSA150.1, service manual, brief instructions and user manuals Bazooka CSA150.1. Depending on your needs, you should look for the document you need. In our website you can view the most popular manual of the product Bazooka CSA150.1.

Similar manuals

A complete manual for the device Bazooka CSA150.1, how should it look like?
A manual, also referred to as a user manual, or simply "instructions" is a technical document designed to assist in the use Bazooka CSA150.1 by users. Manuals are usually written by a technical writer, but in a language understandable to all users of Bazooka CSA150.1.

A complete Bazooka manual, should contain several basic components. Some of them are less important, such as: cover / title page or copyright page. However, the remaining part should provide us with information that is important from the point of view of the user.

1. Preface and tips on how to use the manual Bazooka CSA150.1 - At the beginning of each manual we should find clues about how to use the guidelines. It should include information about the location of the Contents of the Bazooka CSA150.1, FAQ or common problems, i.e. places that are most often searched by users in each manual
2. Contents - index of all tips concerning the Bazooka CSA150.1, that we can find in the current document
3. Tips how to use the basic functions of the device Bazooka CSA150.1 - which should help us in our first steps of using Bazooka CSA150.1
4. Troubleshooting - systematic sequence of activities that will help us diagnose and subsequently solve the most important problems with Bazooka CSA150.1
5. FAQ - Frequently Asked Questions
6. Contact detailsInformation about where to look for contact to the manufacturer/service of Bazooka CSA150.1 in a specific country, if it was not possible to solve the problem on our own.

Do you have a question concerning Bazooka CSA150.1?

Use the form below

If you did not solve your problem by using a manual Bazooka CSA150.1, ask a question using the form below. If a user had a similar problem with Bazooka CSA150.1 it is likely that he will want to share the way to solve it.

Copy the text from the picture

Captcha
New picture

Comments (0)