English dropdown-ico

Manual Vulcan-Hart ICM36

12 pages 0.98 mb
Download

Go to site of 12

Summary
  • Vulcan-Hart ICM36 - page 1

    ICM24,36,48,60 AND 72 CHEESE MEL TERS MODEL NO. ICM24 ML-52470, 52476 ICM36 ML-52471, 52477 ICM48 ML-52472, 52478 ICM60 ML-52473, 52479 ICM72 ML-52474, 52480 SER VICE MANUAL MODEL ICM VULCAN-HART COMPANY, P.O. BOX 696, LOUISVILLE, KY 40201-0696, TEL. (502) 778-2791 FORM 30915 (3-95) ...

  • Vulcan-Hart ICM36 - page 2

    — 2 — IMPORT ANT FOR YOUR SAFETY THIS MANUAL HAS BEEN PREPARED FOR PERSONNEL QUALIFIED TO INSTALL GAS EQUIPMENT, WHO SHOULD PERFORM THE INITIAL FIELD START-UP AND ADJUSTMENTS OF THE EQUIPMENT COVERED BY THIS MANUAL. POST IN A PROMINENT LOCATION THE INSTRUCTIONS TO BE FOLLOWED IN THE EVENT THE SMELL OF GAS IS DETECTED. THIS INFORMATION CAN BE OB ...

  • Vulcan-Hart ICM36 - page 3

    — 3 — T ABLE OF CONTENTS Important safety information page 2 Codes and standards information page 3 Manual use information page 3 Data plate information page 3 Tools required for servicing page 3 General appliance information age 3 Section l Service Checks and Adjustments page 4-5 Section ll Removal of Service Parts page 6-10 Section lll Troubl ...

  • Vulcan-Hart ICM36 - page 4

    — 4 — SECTION I SERVICE CHECKS AND ADJUSTMENTS WARNING: SHUT OFF GAS BEFORE SERVICING VENTILATION CHECKS Insure that adequate ventilation has been provided in accordance to all codes as stated on page 3 of this manual. The vent for this appliance should be checked for restrictions every 6 months. GAS SUPPLY CHECKS If the gas supply piping is to ...

  • Vulcan-Hart ICM36 - page 5

    — 5 — PILOT ORIFICE HOOD CHECK 1. Follow steps 1-3 under Removal of Lighter Tube. 2. With a 7 ⁄ 16 " wrench remove the orifice hood. 3. Examine the hood and orifice opening for blockage. 4. If blockage is found, remove it using air or water pressure. 5. If blockage cannot be removed, replace the orifice hood. 6. Reinstall or replace orif ...

  • Vulcan-Hart ICM36 - page 6

    — 6 — SECTION II REMOV AL OF SER VICE P ARTS WARNING: SHUT OFF GAS BEFORE SERVICING. REMOVAL OF TOP 1. Push top back towards wall until the rear top mounting foot hits the stop angle. (Fig. 2) Fig. 2 2. Be sure that the top mounting foot has cleared the front top flange and lift the top off of the appliance. (Fig. 3) Fig. 3 STOP ANGLE REAR MOUN ...

  • Vulcan-Hart ICM36 - page 7

    — 7 — REMOVAL OF BURNER VALVE 1. With a small blade screwdriver loosen the set screw in the valve knob and remove the knob. 2. With a phillips head screwdriver remove (4) screws at each corner of the front panel and remove the panel. (Fig. 4) Fig. 4 3. With a 5 ⁄ 8 " wrench disconnect the elbow compression fitting. (Fig. 5) Fig. 5 PILO T ...

  • Vulcan-Hart ICM36 - page 8

    — 8 — 4. Disconnect the valve from the manifold pipe. (See Fig. 5) NOTE: It may be necessary to remove heat shield to disconnect the valve. 5. Install new valve using pipe dope and reversing steps 1-4. REPLACEMENT OF PILOT ADJUSTMENT VALVE 1. Follow steps 1 and 2 under Removal of Burner Valve. 2. Disconnect the compression nut from the pilot tu ...

  • Vulcan-Hart ICM36 - page 9

    — 9 — 4. Install new pilot valve using pipe dope and reversing steps 1-3. REMOVAL OF BURNER 1. Follow steps 1-2 under Removal of Top. 2. With a 7 ⁄ 16 " wrench remove (2) nuts. (Figs. 8) Figs. 8 3. Lift the burner mounting bracket off the appliance. (Figs. 8) 4. Slide the burner towards the center of the appliance and off the burner nozz ...

  • Vulcan-Hart ICM36 - page 10

    — 10 — BURNER NOZZLE REPLACEMENT 1. To remove the burner nozzle follow steps 1, 2 and 3 under Burner Nozzle Orifice Check. (Fig. 10) Fig. 10 2. Install new nozzle by reversing steps 1, 2, and 3 under Burner Nozzle Orifice Check. ...

  • Vulcan-Hart ICM36 - page 11

    — 11 — REMOVAL OF PILOT LIGHTER VALVE 1. Follow steps 1-3 under Removal of Pilot Lighter Tube. 2. With a 1 ⁄ 2 " wrench disconnect valve fitting from the pilot tube. (Figs. 11) Figs. 11 3. Install new valve fitting and ferrule by reversing steps 1 and 2 above. REMOVAL OF PILOT LIGHTER TUBE 1. With a 3 ⁄ 8 " wrench remove (1) nut h ...

  • Vulcan-Hart ICM36 - page 12

    — 12 — SECTION lll TROUBLE SHOOTING Uneven heating, sides burning A) Temperature too low. B) Improper operation of broiler. C) Fluctuating gas pressure. To much top heat A) Temperature too high. B) Faulty ventilation. C) Excessive heat input. D) Overrated (pressure too high or orifice too large). . Uneven heat side to side A) Appliance not leve ...

Manufacturer Vulcan-Hart Category Fondue Maker

Documents that we receive from a manufacturer of a Vulcan-Hart ICM36 can be divided into several groups. They are, among others:
- Vulcan-Hart technical drawings
- ICM36 manuals
- Vulcan-Hart product data sheets
- information booklets
- or energy labels Vulcan-Hart ICM36
All of them are important, but the most important information from the point of view of use of the device are in the user manual Vulcan-Hart ICM36.

A group of documents referred to as user manuals is also divided into more specific types, such as: Installation manuals Vulcan-Hart ICM36, service manual, brief instructions and user manuals Vulcan-Hart ICM36. Depending on your needs, you should look for the document you need. In our website you can view the most popular manual of the product Vulcan-Hart ICM36.

Similar manuals

A complete manual for the device Vulcan-Hart ICM36, how should it look like?
A manual, also referred to as a user manual, or simply "instructions" is a technical document designed to assist in the use Vulcan-Hart ICM36 by users. Manuals are usually written by a technical writer, but in a language understandable to all users of Vulcan-Hart ICM36.

A complete Vulcan-Hart manual, should contain several basic components. Some of them are less important, such as: cover / title page or copyright page. However, the remaining part should provide us with information that is important from the point of view of the user.

1. Preface and tips on how to use the manual Vulcan-Hart ICM36 - At the beginning of each manual we should find clues about how to use the guidelines. It should include information about the location of the Contents of the Vulcan-Hart ICM36, FAQ or common problems, i.e. places that are most often searched by users in each manual
2. Contents - index of all tips concerning the Vulcan-Hart ICM36, that we can find in the current document
3. Tips how to use the basic functions of the device Vulcan-Hart ICM36 - which should help us in our first steps of using Vulcan-Hart ICM36
4. Troubleshooting - systematic sequence of activities that will help us diagnose and subsequently solve the most important problems with Vulcan-Hart ICM36
5. FAQ - Frequently Asked Questions
6. Contact detailsInformation about where to look for contact to the manufacturer/service of Vulcan-Hart ICM36 in a specific country, if it was not possible to solve the problem on our own.

Do you have a question concerning Vulcan-Hart ICM36?

Use the form below

If you did not solve your problem by using a manual Vulcan-Hart ICM36, ask a question using the form below. If a user had a similar problem with Vulcan-Hart ICM36 it is likely that he will want to share the way to solve it.

Copy the text from the picture

Captcha
New picture

Comments (0)