Manual Hoover S3083-030

20 pages 1.42 mb
Download

Go to site of 20

Summary
  • Hoover S3083-030 - page 1

    HOOVER Model Owner’s i Celebrity II TM .S3083-030 Manual j Cleaner &L ...

  • Hoover S3083-030 - page 2

    Fill in and retain ! The vacuum cleaner you have just purchased is a combination cleaner. It has a motorized power nozzle for carpet and floor cleaning and has cleaning tools for above the floor cleaning. Your cleaner is a model . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ..*.......................... a ...

  • Hoover S3083-030 - page 3

    Importantsafeguards! l Read all instructions. l Warning: Electric shock could occur if used outdoors or on wet surfaces. l Close supervision is necessary when any appliance is used by or near children. Do not allow vacuum cleaner to be used as a toy or to run unattended at any time. l Keep hands, feet, loose clothing, and hair away from rotating ag ...

  • Hoover S3083-030 - page 4

    14 A I 1. FURNITURE GUARD 2. COMBINATION CARPET AND FLOOR ‘POWERMATIC’ NOZZLE Powermatic nozzle automatically adjusts to different carpet pile height. Has setting for “Carpet” and “Bare Floor”. 3. SURFACE SELECTOR INDICATOR Shows “Carpet” or “Bare Floor” setting of Surface Selector Lever. 4. SURFACE SELECTOR LEVER Push lever wit ...

  • Hoover S3083-030 - page 5

    6. WALL/FLOOR BRUSH 7. HOSE CORD CONNECTION TO CLEANER Plug hose cord into cleaner base to receptacle. 8. CASTERS Provide easier towing; pull cleaner using hose to guide the cleaner easily over carpet, throw rugs, and door sills. 9. ON-OFF SWITCH A convenient switch is located near front of cleaner. 10. CORD STORAGE HOOKS II. EXTENSION WANDS Connec ...

  • Hoover S3083-030 - page 6

    TO CONNECT AND REMOVE HOSE To connect hose, insert hose into opening of cleaner lining up the arrow on the hose with the dot on the cleaner. Turn the hose clockwise until it lines up with the bar on the cleaner and latch locks into place. When the hose is attached properly, the hose cord plug will reach to the receptacle on the cleaner. Insert the ...

  • Hoover S3083-030 - page 7

    HOW TO USE HANDLE ADJUSTMENTS The handle has two positions when used with the power nozzle: Storage and Low. Step on the Han- dle Adjustment Latch to lower the handle. Use the low position for reaching under low furniture. Raise the handle straight up for the storage position. CARPET AND RUG CLEANING When using the power nozzle for carpet and rug c ...

  • Hoover S3083-030 - page 8

    FOR HARD SURFACE FLOOR CLEANING The power nozzle can be used for cleaning hard sur- face floors such as wood, linoleum, vinyl, asphalt and rubber tile, sealed cork, concrete and terrazzo as well as carpet. You will find it particularly con- venient when cleaning rugs to adjust the power noz- zle to “Bare Floor” and continue cleaning the sur- ro ...

  • Hoover S3083-030 - page 9

    HOW TO USE THE ‘CELEBRITY II’ CLEANER WITH CLEANING TOOLS CLEANING TOOLS The cleaning tools have many uses. Select the tool best suited for the cleaning task from the descrip- tions below. Adjust the Suction Regulator to select the amount of suction appropriate to the cleaning task. FURNITURE NOZZLE For upholstered furniture, draperies, tapestr ...

  • Hoover S3083-030 - page 10

    TO CLEAN HARD TO REACH AREAS Use the curved wand with the extension wands. The tools attached to the curved wand will enable you to clean many hard to reach areas; especially crown moldings, tops of drapery rods, shelves, and picture frames, etc. TO CLEAN STAIRS Clean stairs by placing the cleaner on its side as pictured in the illustration. Clean ...

  • Hoover S3083-030 - page 11

    When To Replace Check bag from time to time. When the bag is filled with dirt, the cleaner will not operate effectively. Discard used bag. CAUTION: Very fine materials, such as face powder, cornstarch, fire- place ashes or fireplace soot, may seal the throw away bag and may cause it to burst even though it is only partially full of dirt. When the c ...

  • Hoover S3083-030 - page 12

    HOW TO CLEAN SECONDARY FILTER DISCONNECT CLEANER FROM ELECTRICAL OUTLET BEFORE REMOVING FILTER The secondary filter is a foam disc located on top of the motor and protects the motor from dirt par- ticles. When the filter becomes dirty, either clean or replace it. To remove, pull filter from top of motor. Clean by rinsing it in water. When dry, slid ...

  • Hoover S3083-030 - page 13

    To provide space for grasping the agitator, remove end of hose from holder, Fig. 3. Then grip agitator and pull out. Fig. 4. Remove old belt. Place one end of the new belt around agitator pulley with smooth side of belt against the pulley. Fig. 5. 5 Line up metal projection on end of agitator (opposite the belt) with groove on inside wall of nozzle ...

  • Hoover S3083-030 - page 14

    Place a screwdriver under the belt as illus- trated. Fig. 8. 8 Bracing the end of the screwdriver against the end of the motor shaft, slide belt over end of shaft. Fig. 9. Remove screwdriver. Check to be sure belt is not twisted. 9 Rotate the agitator by hand to properly align the belt on the motor shaft. Agitator should rotate freely. Fig. 10. IO ...

  • Hoover S3083-030 - page 15

    NOZZLE HOSE The Nozzle Hose carries the dirt from the nozzle to the extension wand and to the throw away bag. If the hose becomes obstructed, cleaning effectiveness will sharply decrease. Remove bottom plate as de- scribed in preceding section, and slide end of hose out of the holder. Clear hose and reinsert into holder. Replace bottom plate as des ...

  • Hoover S3083-030 - page 16

    LOCATOR Remove brushes by pulling them from agitator with pliers. Slide new brushes into the channels - small ends first - pushing them in as far as possible. (Fig. 4). Replace end plate and shaft, lining up locator on end section with slot in agitator. Replace other end section and end plate and tighten. (Fig. 5). 5 END SECTION WAS BEARIN Should y ...

  • Hoover S3083-030 - page 17

    HOW TO REPLACE THE BOTTOM PLATE BRUSH Disconnect cleaner from electrical outlet and disconnect Powermatic nozzle from extension wand. 1 Put the Surface Selector Lever in the “Carpet” Position. This will allow for easier removal of the brush. Turn Power- matic nozzle over. Remove bottom plate by unscrewing the 2 Phillips head screws at the back ...

  • Hoover S3083-030 - page 18

    USER CHECK LIST This appliance was inspected thoroughly and was in good operating condition when it was shipped from the factory. If a minor problem develops, it usually can be remedied quite easily when the cause is identified. Accordingly, this check list is provided for your convenience. PROBLEM POSSIBLE CAUSE POSSIBLE SOLUTION A. CLEANER 1. Not ...

  • Hoover S3083-030 - page 19

    LUBRICATION The motor is equipped with one ball bearing and one roller bearing. These bearings contain sufficient lubrication for the life of the motor. The addition of lubricant could cause damage. Therefore, do not add lubricant to either motor bearing. The agitator is equipped with two ball bearings that should be lubricated periodically. This s ...

  • Hoover S3083-030 - page 20

    VCMA VACUUM CLEANER MANUFACTURERS ASSOCIATION (HOOVER - AN ASSOCIATION MEMBER) Service To The Consumer Since 19 13 This information has been compiled by the Vacuum Cleaner Manufacturers Associ- ation from Governmental and Private Sources concerned with product safety. These basic guidelines are for your protection and convenience. TO AVOID ELECTRIC ...

Manufacturer Hoover Category Vacuum Cleaner

Documents that we receive from a manufacturer of a Hoover S3083-030 can be divided into several groups. They are, among others:
- Hoover technical drawings
- S3083-030 manuals
- Hoover product data sheets
- information booklets
- or energy labels Hoover S3083-030
All of them are important, but the most important information from the point of view of use of the device are in the user manual Hoover S3083-030.

A group of documents referred to as user manuals is also divided into more specific types, such as: Installation manuals Hoover S3083-030, service manual, brief instructions and user manuals Hoover S3083-030. Depending on your needs, you should look for the document you need. In our website you can view the most popular manual of the product Hoover S3083-030.

A complete manual for the device Hoover S3083-030, how should it look like?
A manual, also referred to as a user manual, or simply "instructions" is a technical document designed to assist in the use Hoover S3083-030 by users. Manuals are usually written by a technical writer, but in a language understandable to all users of Hoover S3083-030.

A complete Hoover manual, should contain several basic components. Some of them are less important, such as: cover / title page or copyright page. However, the remaining part should provide us with information that is important from the point of view of the user.

1. Preface and tips on how to use the manual Hoover S3083-030 - At the beginning of each manual we should find clues about how to use the guidelines. It should include information about the location of the Contents of the Hoover S3083-030, FAQ or common problems, i.e. places that are most often searched by users in each manual
2. Contents - index of all tips concerning the Hoover S3083-030, that we can find in the current document
3. Tips how to use the basic functions of the device Hoover S3083-030 - which should help us in our first steps of using Hoover S3083-030
4. Troubleshooting - systematic sequence of activities that will help us diagnose and subsequently solve the most important problems with Hoover S3083-030
5. FAQ - Frequently Asked Questions
6. Contact detailsInformation about where to look for contact to the manufacturer/service of Hoover S3083-030 in a specific country, if it was not possible to solve the problem on our own.

Do you have a question concerning Hoover S3083-030?

Use the form below

If you did not solve your problem by using a manual Hoover S3083-030, ask a question using the form below. If a user had a similar problem with Hoover S3083-030 it is likely that he will want to share the way to solve it.

Copy the text from the picture

Comments (0)