English dropdown-ico

Manual Lopi 864TRV

26 pages 1.74 mb
Download

Go to site of 26

Summary
  • Lopi 864TRV - page 1

    864T R V F ir ep lace • Operation • Maintenance Tested and Listed by OMNI-Test Laboratories, Inc. Beaverton, Oregon Report # 028-F-59-5 ANSI Z21.88b-2003 WARNING: If the information in these instructions is not followed exactly, a fire or explosion may result causing property damage, personal injury or loss of life. - Do not store or use gasoli ...

  • Lopi 864TRV - page 2

    2 Introduction Travis Industrie s 405081 2 100-011 6 8_001 Introduction We welcome you as a new owner of a 864TRV gas fireplace. This manual details operation and maintenance of this fireplace. Please familiarize yourself with the Owner's Manual before operating your heater and save the manual for future reference. Important Information No oth ...

  • Lopi 864TRV - page 3

    Introduction 3 © Travis Industries 4050812 100-01168_001 Table of Contents Introduction and Important Information Introduction ............................................................. 2 Important Information ............................................... 2 Installation Warnings ................................................ 2 Features .... ...

  • Lopi 864TRV - page 4

    4 Safety Precautions © Travis Industries 4050812 100-01168_001 IF YOU SMELL GAS: * Do not light any appliance * Extinguish any open flame * Do not touch any electrical switch or plug or unplug anything * Open windows and vacate building * Call gas supplier from neighbor's house, if not reached, call fire department This unit must be installed ...

  • Lopi 864TRV - page 5

    Safety Precautions 5 © Travis Industries 4050812 100-01168_001 Do not place clothin g or other flammable items on or near the heater. Because this heater can be controlled by a thermostat there is a possibility of the heater turning on and igniting any items placed on or near it. Li g ht the heater usin g the built- in piezo igniter. Do not use ma ...

  • Lopi 864TRV - page 6

    6 Operation © Travis Industries 4050812 100-01168_001 Before You Begin • Read this entire manual before you use your new fireplace (especially the section "Safety Precautions" on pages 4 & 5). Failure to follow the instructions may result in property damage, bodily injury, or even death. Location of Controls Lift the control cover ...

  • Lopi 864TRV - page 7

    Operation 7 © Travis Industries 4050812 100-01168_001 Starting The Pilot Flame The pilot flame is required to ignite the main burners (it also plays a safety role). It should be left on once lit. It will stay lit unless the gas control valve is turned to "OFF". However, the pilot will go out if the gas is shut off, the propane tank runs ...

  • Lopi 864TRV - page 8

    8 Operation © Travis Industries 4050812 100-01168_001 Starting the Fireplace for the First Time • Burn the heater at a high setting with the blower off for an extended period (up to 48 hours). This will cure the painted surfaces. Fumes from the paint curing and oil burning off the steel will occur. This is normal. We recommend opening a window t ...

  • Lopi 864TRV - page 9

    Operation 9 © Travis Industries 4050812 100-01168_001 Adjusting the Optional Blower Speed The blower helps transfer heat from the heater into the room. It will not turn on until the heater is up to temperature (approximately 10 minutes after starting). See the illustration below for instructions on adjusting the blower speed. OFF Turn the dial all ...

  • Lopi 864TRV - page 10

    10 Maintenance © Travis Industries 4050812 100-01168_001 Maintaining Your Fireplace's Appearance Fingerprints or other marks left on the optional plated surface may become etched in place if they are not wiped clean prior to turning the fireplace on. Clean the plated surface with denatured alcohol and a soft cloth (with the fireplace cool). O ...

  • Lopi 864TRV - page 11

    Maintenance 11 © Travis Industries 4050812 100-01168_001 Grill Installation and Removal Some fireplaces have grills above and below the glass frame. These grills may be installed following the directions below (follow in reverse to remove). Upper Grill Installation Hold the grill at an angle and insert the lower slot over the bushing on the firepl ...

  • Lopi 864TRV - page 12

    12 Maintenance © Travis Industries 4050812 100-01168_001 Face Installation and Removal Some fireplaces have a face that fits over the glass frame. The face can be removed following the directions below. Phillips Screwdriver Four screws hold the face in place. The screws are accessed through the grills on the face. ...

  • Lopi 864TRV - page 13

    Maintenance 13 © Travis Industries 4050812 100-01168_001 Glass Frame Removal and Installation Warning: The appliance must be completely cool before removing the glass. Warning: Do not strike or slam the glass. Based upon the face being used, either: (a) swing the access door down and remove the top grill, (b) remove the face (unscrew or lift off - ...

  • Lopi 864TRV - page 14

    14 Maintenance © Travis Industries 4050812 100-01168_001 Glass Frame Removal and Installation (continued) The latch can come loose from the latch assembly. This occurs only when it is rotated. Follow the directions below to re-install the latch if it comes loose. Top of Firebox Hold the latch at an angle and insert it into the slot on the glass fr ...

  • Lopi 864TRV - page 15

    Maintenance 15 © Travis Industries 4050812 100-01168_001 Log Set Installation Rear Log Installation Place the rear log as shown below. Make sure it is pushed all the way back on the log shelf. The rear log has a slot that straddles the rear burner and pilot assembly ...

  • Lopi 864TRV - page 16

    16 Maintenance © Travis Industries 4050812 100-01168_001 Right Log Installation Place the right log as shown below. The right log has a curved slot that fits over the right side gr a te. The left side of the log should be slid back against this led g e. ...

  • Lopi 864TRV - page 17

    Maintenance 17 © Travis Industries 4050812 100-01168_001 Left Log Installation Place the left log as shown above. Note how the right side of the log comes up, but does not cover, the burner holes.. ...

  • Lopi 864TRV - page 18

    18 Maintenance © Travis Industries 4050812 100-01168_001 Center Log Installation Note how the center log rests on the center grate. The pin on the rear log inserts into the hole on the center log. ...

  • Lopi 864TRV - page 19

    Maintenance 19 © Travis Industries 4050812 100-01168_001 Ember Installation Place the embers along the hearth plate and burner - make sure they do not cover any burner holes or air channels. Use the embers to cover any rivets and to make the firebox more realistic. ...

  • Lopi 864TRV - page 20

    20 Maintenance © Travis Industries 4050812 100-01168 Glass Cleaning The glass may be cleaned with a non- abrasive cleaner. To clean the inside of the glass, simply remove the glass frame, place it on a non-scratching surface, and clean the inside surface. If the outside surface of the glass frame requires cleaning, follow the directions below to r ...

  • Lopi 864TRV - page 21

    Maintenance 21 © Travis Industries 4050812 100-01168_001 Troubleshooting Table Problem: Possible Cause: Don't Call for Service Until You: Pilot Will Not Light A gas shut off valve is turned off The gas control knob isn't turned to "PILOT" The valve control knob isn't pushed in The igniter wasn't pressed repeatedly No ...

  • Lopi 864TRV - page 22

    22 Maintenance © Travis Industries 4050812 100-01168_001 How this Fireplace Works This fireplace was designed with safety as the primary concern. Many of the components inside this fireplace are for safety purposes. Therefore, only certified gas service technicians should service this fireplace. What Turns the Main Burners On and Off This fireplac ...

  • Lopi 864TRV - page 23

    Maintenance 23 © Travis Industries 4050812 100-01168_001 Wiring Diagram Millivolt Wiring (stock configuration) Orange White Piezo Igniter Thermopile Red Thermocouple Copper Co-Axial Wire Red Optional Remote Control Spark Electrode Pilot Hood On/Off Switch Brown Optional Thermostat Optional Blower Wiring Harness 7 4 10 9 1 3 Optional Blowers Green ...

  • Lopi 864TRV - page 24

    24 Limited 7 Year Warranty © Travis Industries 4050812 100-01168_001 To register your TRAVIS INDUSTRIES, INC. 7 Year Warranty, complete the enclosed Warranty card and mail it within ten (10) days of the appliance purchase date to: TRAVIS INDUSTRIES, INC., 4800 Harbour Pointe Blvd. SW, Mukilteo, WA 98275. TRAVIS INDUSTRIES, INC. warrants this gas a ...

  • Lopi 864TRV - page 25

    Optional Equipment 25 © Travis Industries 4050812 100-01168_001 Accessories The accessories listed below are available at your Travis dealer. To locate a dealer, visit: www.travisproducts.com Firebacks There are several styles of decorative ceramic firebacks that fit inside the firebox and enhance the area behind the flames. These firebacks can al ...

  • Lopi 864TRV - page 26

    26 Index © Travis Industries 4050812 100-01168_001 Index Accessories .......................................................2 5 Adjusting the Flame Height ..................................8 Adjusting the Optional Blower Speed ......................9 Before You Begin ...............................................6 Blower Operation (optional) .... ...

Manufacturer Lopi Category Indoor Fireplace

Documents that we receive from a manufacturer of a Lopi 864TRV can be divided into several groups. They are, among others:
- Lopi technical drawings
- 864TRV manuals
- Lopi product data sheets
- information booklets
- or energy labels Lopi 864TRV
All of them are important, but the most important information from the point of view of use of the device are in the user manual Lopi 864TRV.

A group of documents referred to as user manuals is also divided into more specific types, such as: Installation manuals Lopi 864TRV, service manual, brief instructions and user manuals Lopi 864TRV. Depending on your needs, you should look for the document you need. In our website you can view the most popular manual of the product Lopi 864TRV.

Similar manuals

A complete manual for the device Lopi 864TRV, how should it look like?
A manual, also referred to as a user manual, or simply "instructions" is a technical document designed to assist in the use Lopi 864TRV by users. Manuals are usually written by a technical writer, but in a language understandable to all users of Lopi 864TRV.

A complete Lopi manual, should contain several basic components. Some of them are less important, such as: cover / title page or copyright page. However, the remaining part should provide us with information that is important from the point of view of the user.

1. Preface and tips on how to use the manual Lopi 864TRV - At the beginning of each manual we should find clues about how to use the guidelines. It should include information about the location of the Contents of the Lopi 864TRV, FAQ or common problems, i.e. places that are most often searched by users in each manual
2. Contents - index of all tips concerning the Lopi 864TRV, that we can find in the current document
3. Tips how to use the basic functions of the device Lopi 864TRV - which should help us in our first steps of using Lopi 864TRV
4. Troubleshooting - systematic sequence of activities that will help us diagnose and subsequently solve the most important problems with Lopi 864TRV
5. FAQ - Frequently Asked Questions
6. Contact detailsInformation about where to look for contact to the manufacturer/service of Lopi 864TRV in a specific country, if it was not possible to solve the problem on our own.

Do you have a question concerning Lopi 864TRV?

Use the form below

If you did not solve your problem by using a manual Lopi 864TRV, ask a question using the form below. If a user had a similar problem with Lopi 864TRV it is likely that he will want to share the way to solve it.

Copy the text from the picture

Captcha
New picture

Comments (0)