Manual AquaPRO PRO1000

16 pages 1.32 mb
Download

Go to site of 16

Summary
  • AquaPRO PRO1000 - page 1

    HEA T PUMP POOL HEA TER BOMBA DE CALOR P ARA PISCINAS 322802-013 2/07 © 2006 AquaPro Systems PRO400, PRO600, and PRO1000 101 Production Drive, Harrison, OH 45030 877.278.2797 fax 877.289.2963 cs@aquaprosystems.com www.aquaprosystems.com OWNER'S MANUAL  MANUAL DEL USUARIO ...

  • AquaPRO PRO1000 - page 2

    REMINDER: Keep your dated proof of pur c ha s e for warranty purpo s e s ! Atta c h it to thi s manual or file it for s afekeeping. Please read and save these instructions. Read carefully before attempting to assemble, install, operate or maintain the product described. Protect yourself and others by observing all safety information. Failure to com ...

  • AquaPRO PRO1000 - page 3

    Installation Pr ocedures Unit Inspection Inspect your unit very carefully before installing. Make sure there has been no damage to the evaporator fins or there are no punctures or oil-soaked areas on the box. This would indicate damage to the refrigeration system and should be rejected immediately. THE UNIT MUST BE TRANSPORTED IN THE UPRIGHT POSITI ...

  • AquaPRO PRO1000 - page 4

    4 Basic Heat Pump Operation Electrical Connections All wiring and electrical connections must be performed by a qualified electrician. Installations must be in accordance with local and national codes. Overheating, short- circuiting and fire damage will result from inadequate wiring. All units are equipped with an electrical wiring schematic inside ...

  • AquaPRO PRO1000 - page 5

    that power to the unit is on. The RED light indicates that the unit is in heating mode. • The RED light may become illuminated prior to heater start up. The RED light will become lit when the thermostat knob is set at or above the water temperature. • The unit has a built in time delay . Every time the unit turns off there is a five-minute time ...

  • AquaPRO PRO1000 - page 6

    Application Guidelines (Continued) Maintenance (Continued) If you decide to rinse down the evaporator coils yourself, disconnect all power to the entire equipment pad before you rinse it. This must be done in order to prevent possible electrical shock. Condensation All heat pump pool heaters will have condensation. It is typical to have as much as ...

  • AquaPRO PRO1000 - page 7

    LIMITED WARRANTY For five (5) years from the date of purchase for the PRO400, PRO600 & PRO1000, Wayne Water Systems, d/b/a AquaPro Systems (“AquaPro”) will repair or replace, at its option, for the original owner any parts of its Heat Pumps (“Product”) which are found upon examination by AquaPro to be defective in materials or workmansh ...

  • AquaPRO PRO1000 - page 8

    Índice Importantes instrucciones de seguridad . . . . . . . . . . . . . . . . . . . .14 Química de la Piscina y Garantía . . . .14 Procedimientos de instalación . . . . .15 Inspección de la unidad . . . . . . . .15 Ubicación de la unidad . . . . . . . . .15 Plomería . . . . . . . . . . . . . . . . . . . . .16 Funcionamiento básico de la bom ...

  • AquaPRO PRO1000 - page 9

    Guías de seguridad (Continuación) la hipertermia incluyen: desconocimiento del peligro inminente, falta de percepción del calor; falta de reconocimiento de la necesidad de salir de la piscina o de la tina, incapacidad física para salir de la piscina o de la tina, daño al feto en mujeres embarazadas, e inconsciencia que puede tener como resulta ...

  • AquaPRO PRO1000 - page 10

    Transformador de 240V-24V Azul Azul Azul Azul Azul Luz roja Luz verde Rojo Rojo Gris Gris Condensador Compresor Presión alta Presión baja Presión de agua Termostato Nuet Cal. En. Sal. Negro Negro Negro Negro Negro Amarillo Amarillo Amarillo Motor del ventilador Interruptor automático Línea Línea Anaranjado Marrón Marrón/blanco Sensor de T e ...

  • AquaPRO PRO1000 - page 11

    4. Vea la figure 5 para el diagrama de cableado con el sistema remoto de 3 cables 5. Conecte el cable de baja (o piscina) a la posición 4 en el bloque terminal. 6. Conecte los cables de alta (o hidromasaje) a la posición 6 del bloque terminal. 7. Conecte el cable normal a la posición 5 del bloque terminal. Contr oles de temperatura manuales Desc ...

  • AquaPRO PRO1000 - page 12

    retardo. No gire la perilla del termostato durante este tiempo de retardo. Si gira la perilla durante este ciclo se podría reiniciar el tiempo de retardo, provocando que la unidad demore cinco minutos adicionales antes de comenzar a funcionar. Punto de ajuste de la temperatura del agua • El rango del punto de ajuste de la temperatura es de 45ºF ...

  • AquaPRO PRO1000 - page 13

    Guía de diagnóstico y r esolución de problemas Si el calentador no está funcionando durante el encendido inicial, verifique para ver si se ha instalado correctamente, según este manual del propietario. Asegúrese de que el disyuntor se haya medido correctamente. Las siguientes son condiciones a verificar antes de llamar a Aqua Pro Systems para ...

  • AquaPRO PRO1000 - page 14

    GARANTÍA LIMIT ADA Durante 5 (cinco) años a partir de la fecha de compra del PRO400, PRO600 y PRO1000, Wayne Water Systems, cuyo nombre comercial es AquaPro Systems (“AquaPro”) reparará o cambiará, a su propio criterio, para el propietario original, cualquier pieza de sus bombas de calor (“Producto”) que AquaPro determine, luego de exam ...

  • AquaPRO PRO1000 - page 15

    15 Notes Notas PRO400, PRO600, PRO1000 1-877-AQUASYS ...

  • AquaPRO PRO1000 - page 16

    Operating Instructions Manual de Instrucciones 16 Notes Notas PRO400, PRO600, PRO1000 1-877-AQUASYS ...

Manufacturer AquaPRO Category Swimming Pool Heater

Documents that we receive from a manufacturer of a AquaPRO PRO1000 can be divided into several groups. They are, among others:
- AquaPRO technical drawings
- PRO1000 manuals
- AquaPRO product data sheets
- information booklets
- or energy labels AquaPRO PRO1000
All of them are important, but the most important information from the point of view of use of the device are in the user manual AquaPRO PRO1000.

A group of documents referred to as user manuals is also divided into more specific types, such as: Installation manuals AquaPRO PRO1000, service manual, brief instructions and user manuals AquaPRO PRO1000. Depending on your needs, you should look for the document you need. In our website you can view the most popular manual of the product AquaPRO PRO1000.

Similar manuals

A complete manual for the device AquaPRO PRO1000, how should it look like?
A manual, also referred to as a user manual, or simply "instructions" is a technical document designed to assist in the use AquaPRO PRO1000 by users. Manuals are usually written by a technical writer, but in a language understandable to all users of AquaPRO PRO1000.

A complete AquaPRO manual, should contain several basic components. Some of them are less important, such as: cover / title page or copyright page. However, the remaining part should provide us with information that is important from the point of view of the user.

1. Preface and tips on how to use the manual AquaPRO PRO1000 - At the beginning of each manual we should find clues about how to use the guidelines. It should include information about the location of the Contents of the AquaPRO PRO1000, FAQ or common problems, i.e. places that are most often searched by users in each manual
2. Contents - index of all tips concerning the AquaPRO PRO1000, that we can find in the current document
3. Tips how to use the basic functions of the device AquaPRO PRO1000 - which should help us in our first steps of using AquaPRO PRO1000
4. Troubleshooting - systematic sequence of activities that will help us diagnose and subsequently solve the most important problems with AquaPRO PRO1000
5. FAQ - Frequently Asked Questions
6. Contact detailsInformation about where to look for contact to the manufacturer/service of AquaPRO PRO1000 in a specific country, if it was not possible to solve the problem on our own.

Do you have a question concerning AquaPRO PRO1000?

Use the form below

If you did not solve your problem by using a manual AquaPRO PRO1000, ask a question using the form below. If a user had a similar problem with AquaPRO PRO1000 it is likely that he will want to share the way to solve it.

Copy the text from the picture

Comments (0)