Manual hussman IGSS-FMSS-0301

20 pages 0.37 mb
Download

Go to site of 20

Summary
  • hussman IGSS-FMSS-0301 - page 1

    /Chino FMSS Case-fr ont Self Ser vice Re v .0301 Installation & Operation Manual FMSS Case-fr ont Self Ser vice Refrigerated Mer chandiser p/n IGSS-FMSS-0301 INST ALLA TION & O P E R A T I ON GUIDE ...

  • hussman IGSS-FMSS-0301 - page 2

    IGSS-FMSS-0301 2 /Chino A publication of Hussmann ® Chino 13770 Ramona Aven ue • Chino , California 91710 (909) 628-8942 F AX (909) 590-4910 (800) 395-9229 K eep this booklet with the case at all times for futur e r efer ence. THIS BOOKLET CONT AINS INFORMA TION ON: FMSS-Remote The FMSS is a single-deck, refrigerated, self-ser vice mer - chandis ...

  • hussman IGSS-FMSS-0301 - page 3

    Rev.0 301 3 Cut & Plan Vie ws F a n FMSS Remote Self-Service Shown with Optional Special Height Scale = 1" *24" *26" *Dimensions adjust at these points to match service case height 13 1 / 2 " 12 1 / 4 " 6 1 / 8 " *10 1 / 2 " 16" FMSS Fr ont-Mount Self-Service case. Can be ordered to mount in front of ANY ...

  • hussman IGSS-FMSS-0301 - page 4

    IGSS-FMSS-0301 4 LOCA TION The refrigerated mer chandisers ha ve been designed f or use only in air conditioned stor es wher e temperatur e and humidity ar e maintained at or below 75°F and 55% r ela- tive humidity . DO NO T allow air conditioning, electric fans, ov ens, open doors or windows (etc.) to cr eate air cur - r ents ar ound the merchand ...

  • hussman IGSS-FMSS-0301 - page 5

    Rev.0 301 5 WASTE OUTLET AND P-TRAP The waste outlet is located at the left hand end of these fixtures allo wing drip piping to be run under the fixtur e lengthwise. A 1" P-trap and thr eaded adapter ar e supplied with each fixture. The P-trap must be installed to pr e vent air leakage and insect entrance into the fixtur e. INST ALLING CONDENS ...

  • hussman IGSS-FMSS-0301 - page 6

    IGSS-FMSS-0301 6 Refrigeration REFRIGERANT TYPE The standard r efrigerant will be R-404 unless otherwise specified on the customer order . Check the serial plate on the case for information. Piping for mor e than one case on a condensing unit is run undergr ound with either common suction and liquid lines fr om the machine r oom or individual sucti ...

  • hussman IGSS-FMSS-0301 - page 7

    Rev.0 301 7 WIRING COLOR CODE GREEN GROUND PURPLE ANTI-SWEA T ORANGE LIGHTS YELLOW RECEPT ACLE RED / BLACK T -ST A T /SOLENOID 230V BLACK / WHITE T - S TAT / S O L E N O I D 115V BRO WN F AN MOT ORS CASE MUST BE GROUNDED NOTE: Refer to label affixed to case to determine the actual configuration as checked in the “TYPE INSTALLED” boxes. Electric ...

  • hussman IGSS-FMSS-0301 - page 8

    IGSS-FMSS-0301 8 Wiring Diagram DATE: PROJECT TITLE: DW G #: DRAWN BY: PRODUC TION ORDER #: DRAWING TITLE: DATE: REVISIONS: #: DESCR IPTION: CHECKED BY: BY: FILE LOCATION : ADRIAN E. CR ISCI AEC PAGE OF HUSSMANN® CORPORATION 13770 RAMONA AVENUE CHINO, CA.91710 (909) 90- 910 LIC.#: 6 06 1 2 3 11 07/29/02 H:WIRESCHEMATICSNE W- WIRING FMSS CASES W1 ...

  • hussman IGSS-FMSS-0301 - page 9

    Rev.0 301 9 DATE: PROJECT TITLE: DW G #: DRAWN BY: PRODUC TION ORDER #: DRAWING TITLE: DATE: REVISIONS: #: DESCR IPTION: CHECKED BY: BY: FILE LOCATION : ADRIAN E. CR ISCI AEC PAGE OF HUSSMANN® CORPORATION 13770 RAMONA AVENUE CHINO, CA.91710 (909) 590-4910 L IC.#: 644406 1 2 3 11 07/29/02 H:WIRESCHEMATICSNE W- WIRING FMSS CASES W1400001 6' C ...

  • hussman IGSS-FMSS-0301 - page 10

    IGSS-FMSS-0301 10 DATE: PROJECT TITLE: DW G #: DRAWN BY: PRODUC TION ORDER #: DRAWING TITLE: DATE: REVISIONS: #: DESCR IPTION: CHECKED BY: BY: FILE LOCATION : ADRIAN E. CR ISCI AEC PAGE OF HUSSMANN® CORPORATION 13770 RAMONA AVENUE CHINO, CA.91710 (909) 590-4910 L IC.#: 644406 1 2 3 11 07/29/02 H:WIRESCHEMATICSNE W- WIRING FMSS CASES W1400002 8&a ...

  • hussman IGSS-FMSS-0301 - page 11

    Rev.0 301 11 DATE: PROJECT TITLE: DW G #: DRAWN BY: PRODUC TION ORDER #: DRAWING TITLE: DATE: REVISIONS: #: DESCR IPTION: CHECKED BY: BY: FILE LOCATION : ADRIAN E. CR ISCI AEC PAGE OF HUSSMANN® CORPORATION 13770 RAMONA AVENUE CHINO, CA.91710 (909) 590-4910 L IC.#: 644406 1 2 3 11 07/29/02 H:WIRESCHEMATICSNE W- WIRING FMSS CASES W1400003 10' ...

  • hussman IGSS-FMSS-0301 - page 12

    IGSS-FMSS-0301 12 DATE: PROJECT TITLE: DW G #: DRAWN BY: PRODUC TION ORDER #: DRAWING TITLE: DATE: REVISIONS: #: DESCR IPTION: CHECKED BY: BY: FILE LOCATION : ADRIAN E. CR ISCI AEC PAGE OF HUSSMANN® CORPORATION 13770 RAMONA AVENUE CHINO, CA.91710 (909) 590-4910 L IC.#: 644406 1 2 3 11 07/29/02 H:WIRESCHEMATICSNE W- WIRING FMSS CASES W1400004 12& ...

  • hussman IGSS-FMSS-0301 - page 13

    Rev.0 301 13 User Information STOCKING Improper temperatur e and lighting will cause serious prod- uct loss. Discoloration, deh ydration and spoilage can be contr olled with pr oper use of the equipment and handling of pr oduct. Pr oduct temperature should al wa ys be main- tained at a constant and pr oper temperatur e. This means that fr om the ti ...

  • hussman IGSS-FMSS-0301 - page 14

    IGSS-FMSS-0301 14 Soap and hot w ater are not enough to kill this bacteria. A sanitizing solution must be included with each c leaning pro- cess to eliminate this bacteria. 1. Scrub thor oughly , cleaning all surfaces, with soap and hot water . 2. Rinse with hot water , but do not flood. 3. Apply the sanitizing solution accor ding to Hussmann’ s ...

  • hussman IGSS-FMSS-0301 - page 15

    Rev.0 301 15 Specifications FMSS Medium T emp TEMPERATURE DISCHG. TYPE & FAN SIZE DEFROST Max 115 V. ELECTRICAL CIRCUITS SELF CONTAINED BTU AVG AIR T-STAT/ MAKE & FREQ. Low Pressure REQ’D EVAP PROD DISC VELOC CUT IN EVAP. NUMBER & STD. Control & PER FT. TMP TMP TMP @FPM SETTINGS COIL OF MOTORS DURATION FANS Warmers LIGHTS Settings ...

  • hussman IGSS-FMSS-0301 - page 16

    IGSS-FMSS-0301 16 APPENDIX A. – Temperature Guidlines The refrigerators should be operated according to Hussmann’s published engineering specifications for entering air temperatures for specific equipment applications. Table 1 shows the typical temperature of the air entering the food zone one hour before the start of defrost and one hour after ...

  • hussman IGSS-FMSS-0301 - page 17

    Rev.0 301 17 only in Fahrenheit shall be accurate to 2°F. The thermometer should be checked for proper calibration. (It should read 32°F when the stem is immersed in an ice water bath). b) LOCATION – The probe or sensing element of the thermometer should be located in the airstream where the air first enters the display or storage area, and not ...

  • hussman IGSS-FMSS-0301 - page 18

    IGSS-FMSS-0301 18 ...

  • hussman IGSS-FMSS-0301 - page 19

    Rev.0 301 19 Limited W arranty This warranty is made to the original user at the original installation site and is not transf erable . Hussmann merchandisers ar e war ranted to be free fr om def ect in material and workmanship under normal use and ser vice for a period of one (1) y ear fr om the date of original installation (not to exceed fifteen ...

  • hussman IGSS-FMSS-0301 - page 20

    IGSS-FMSS-0301 20 The MODEL NAME and SERIAL NUMBER is required in or der to provide y ou with the correct parts and information for y our particular unit. They can be found on a small metal plate on the unit. Please note them below for futur e refer ence. MODEL: SERIAL NUMBER: /Chino Additional copies of this publication ma y be obtained b y contac ...

Manufacturer hussman Category Range

Documents that we receive from a manufacturer of a hussman IGSS-FMSS-0301 can be divided into several groups. They are, among others:
- hussman technical drawings
- IGSS-FMSS-0301 manuals
- hussman product data sheets
- information booklets
- or energy labels hussman IGSS-FMSS-0301
All of them are important, but the most important information from the point of view of use of the device are in the user manual hussman IGSS-FMSS-0301.

A group of documents referred to as user manuals is also divided into more specific types, such as: Installation manuals hussman IGSS-FMSS-0301, service manual, brief instructions and user manuals hussman IGSS-FMSS-0301. Depending on your needs, you should look for the document you need. In our website you can view the most popular manual of the product hussman IGSS-FMSS-0301.

A complete manual for the device hussman IGSS-FMSS-0301, how should it look like?
A manual, also referred to as a user manual, or simply "instructions" is a technical document designed to assist in the use hussman IGSS-FMSS-0301 by users. Manuals are usually written by a technical writer, but in a language understandable to all users of hussman IGSS-FMSS-0301.

A complete hussman manual, should contain several basic components. Some of them are less important, such as: cover / title page or copyright page. However, the remaining part should provide us with information that is important from the point of view of the user.

1. Preface and tips on how to use the manual hussman IGSS-FMSS-0301 - At the beginning of each manual we should find clues about how to use the guidelines. It should include information about the location of the Contents of the hussman IGSS-FMSS-0301, FAQ or common problems, i.e. places that are most often searched by users in each manual
2. Contents - index of all tips concerning the hussman IGSS-FMSS-0301, that we can find in the current document
3. Tips how to use the basic functions of the device hussman IGSS-FMSS-0301 - which should help us in our first steps of using hussman IGSS-FMSS-0301
4. Troubleshooting - systematic sequence of activities that will help us diagnose and subsequently solve the most important problems with hussman IGSS-FMSS-0301
5. FAQ - Frequently Asked Questions
6. Contact detailsInformation about where to look for contact to the manufacturer/service of hussman IGSS-FMSS-0301 in a specific country, if it was not possible to solve the problem on our own.

Do you have a question concerning hussman IGSS-FMSS-0301?

Use the form below

If you did not solve your problem by using a manual hussman IGSS-FMSS-0301, ask a question using the form below. If a user had a similar problem with hussman IGSS-FMSS-0301 it is likely that he will want to share the way to solve it.

Copy the text from the picture

Comments (0)