Manual Bunn VPR APS

12 pages 0.51 mb
Download

Go to site of 12

Summary
  • Bunn VPR APS - page 1

    OPERA TING & SER VICE MANU AL BUNN-O-MA TIC CORPORA TION OF CANAD A 280 INDUSTRIAL P ARKW A Y SOUTH, A URORA, ONT ARIO , L4G 3T9 PHONE: (905) 841-2866 F AX: (905) 841-2775 39064.7000A 05/09 ©2006 Bunn-O-Matic Corporation www .bunn.com VPR TC VPR APS ...

  • Bunn VPR APS - page 2

    Page 2 INTR ODUCTION This equipment will brew a half-gallon batch of coff ee into an awaiting dispenser . It is only for indoor use on a sturdy counter or shelf . 39064 042806 BUNN-O-MA TIC COMMERCIAL PR ODUCT W ARRANTY Bunn-O-Matic Corporation of Canada (“Bunn”) warrants equipment manufactured by it as follows: 1) Airpots, thermal carafes, dec ...

  • Bunn VPR APS - page 3

    Page 3 USER NOTICES Carefully read and follow all notices in this manual and on the equipment. All labels on the equipment should be kept in good condition. Replace any unreadable or damaged labels. W A TER ON L Y E A U SEULEMEN T #00833.7001 39064 042806 Artwork for P/N: 00658.7000 Artwork Rev: G Updated by: RN Date: 02/16/10 Colors: P ANTONE 1375 ...

  • Bunn VPR APS - page 4

    Page 4 ELECTRICAL REQUIREMENTS CAUTION - The brewer must be disconnected from the power source until specified in Initial Set-Up. The brewer has an attached cordset and requires 2-wire grounded service rated 120 volts ac, 15 amp, single phase, 60 Hz. INITIAL SET -UP CAUTION - The brewer must be disconnected from the power source throughout the ini ...

  • Bunn VPR APS - page 5

    Page 5 TROUBLESHOOTING A troubleshooting guide is provided to suggest probable causes and remedies for the most likely problems encountered. If the problem remains after exhausting the troubleshooting steps, contact the Bunn-O-Matic T echnical Service Department. • Inspection, testing, and repair ofelectrical equipmentshou ...

  • Bunn VPR APS - page 6

    Page 6 TROUBLESHOOTING (cont.) PROBLEM Dripping from sprayhead Beverage overflows dispenser Weak beverage PROBABLE CAUSE REMEDY 1. Lime Build-up CAUTION - T ank and tank com- ponents should be delimed regularly depending on local water conditions. Excessive min- eral build-up on stainless steel surfaces can initiate corrosive reactions resulting i ...

  • Bunn VPR APS - page 7

    Page 7 TROUBLESHOOTING (cont.) PROBLEM Dry coffee grounds remain in the funnel Brewer is making unusal noises PROBABLE CAUSE REMEDY 1. Funnel Loading 1. T ank Heater The BUNN ® paper filter must be centered in the funnel and the bed of grounds leveled by gently shaking. Remove and clean lime off the tank heater . See page 10 39064 042806 ...

  • Bunn VPR APS - page 8

    Page 8 FIG. 3 CONTROL THERMOST A T CONTROL THERMOST A T SERVICE This section provides procedures for testing and replacing various major components used in this brewer should service become necessar y . Refer to T roubleshooting for assistance in determining the cause of any problem. WARNING - Inspection, testing, and repair of electri- cal equipme ...

  • Bunn VPR APS - page 9

    Page 9 Location: The control thermostat is located inside the hood on the left end of the mounting bracket. T est Procedures: 1. Disconnect the brewer from the power source. 2. Locate the black wire on the control thermo- stat. 3. Check voltage across the black wire on the control thermostat and the white wire on the tank heater with a voltmeter . ...

  • Bunn VPR APS - page 10

    Page 10 FIG. 6 LIMIT THERMOST A T TERMINALS SERVICE (cont.) LIMIT THERMOST A T Location: The limit thermostat is located inside the hood on the right side of the tank lid. T est Procedures: 1. Disconnect the brewer from the power source. 2. Disconnect the blue/black and black wires from the limit thermostat. 3. Check for continuity across the limit ...

  • Bunn VPR APS - page 11

    Page 11 SERVICE (cont.) If continuity is present as described, reconnect the wires, the tank heater is operating properly . If continuity is not present as described, replace the tank heater . NOTE- If the tank heater r emains unable to heat, remove and inspect heater for cracks in the sheath. Removal and Replacement: 1. Remove the tank inlet fitt ...

  • Bunn VPR APS - page 12

    Page 12 L1 BLK T ANK HEA TER WHI LOWER WARMER "KEEP WARM" HEA TER WHI BLK SCHEMA TIC WIRING DIAGRAM VPR, VPR TC & VPR APS GREEN N WHI WHI BLK 33769.0000C 03/06 © 2001 BUNN-O-MA TIC CORPORA TION UPPER WARMER WHI BLK 120 VOL TS A C 2 WIRE SINGLE PHASE 60 HZ WHI/RED VIO LIMIT THERMOS TAT BLU/BLK SW . & THERMOS TAT ON/OFF SWITCH ON/O ...

Manufacturer Bunn Category Coffeemaker

Documents that we receive from a manufacturer of a Bunn VPR APS can be divided into several groups. They are, among others:
- Bunn technical drawings
- VPR APS manuals
- Bunn product data sheets
- information booklets
- or energy labels Bunn VPR APS
All of them are important, but the most important information from the point of view of use of the device are in the user manual Bunn VPR APS.

A group of documents referred to as user manuals is also divided into more specific types, such as: Installation manuals Bunn VPR APS, service manual, brief instructions and user manuals Bunn VPR APS. Depending on your needs, you should look for the document you need. In our website you can view the most popular manual of the product Bunn VPR APS.

Similar manuals

A complete manual for the device Bunn VPR APS, how should it look like?
A manual, also referred to as a user manual, or simply "instructions" is a technical document designed to assist in the use Bunn VPR APS by users. Manuals are usually written by a technical writer, but in a language understandable to all users of Bunn VPR APS.

A complete Bunn manual, should contain several basic components. Some of them are less important, such as: cover / title page or copyright page. However, the remaining part should provide us with information that is important from the point of view of the user.

1. Preface and tips on how to use the manual Bunn VPR APS - At the beginning of each manual we should find clues about how to use the guidelines. It should include information about the location of the Contents of the Bunn VPR APS, FAQ or common problems, i.e. places that are most often searched by users in each manual
2. Contents - index of all tips concerning the Bunn VPR APS, that we can find in the current document
3. Tips how to use the basic functions of the device Bunn VPR APS - which should help us in our first steps of using Bunn VPR APS
4. Troubleshooting - systematic sequence of activities that will help us diagnose and subsequently solve the most important problems with Bunn VPR APS
5. FAQ - Frequently Asked Questions
6. Contact detailsInformation about where to look for contact to the manufacturer/service of Bunn VPR APS in a specific country, if it was not possible to solve the problem on our own.

Do you have a question concerning Bunn VPR APS?

Use the form below

If you did not solve your problem by using a manual Bunn VPR APS, ask a question using the form below. If a user had a similar problem with Bunn VPR APS it is likely that he will want to share the way to solve it.

Copy the text from the picture

Comments (0)