English dropdown-ico

Manual Faria Instruments Commander

22 pages 5.12 mb
Download

Go to site of 22

Summary
  • Faria Instruments Commander - page 1

    ISO128E ECR#4851 08/04 IS0128 Copyright 2004 by the Thomas G. Faria Corporation, Uncasville CT No part of this publication may by reproduced in any form, in an electronic retrieval system or otherwise, without the prior written permission of the company . Faria® is the trademark of the Thomas G. Faria Corporation SystemCheck®, Evinrude®, Johnson ...

  • Faria Instruments Commander - page 2

    H ar ness HN0 3 58 S mall C onnect or S y ste mC heck® a da p t or Small connector (CN0082) T o Small Connector Socket SystemCheck® Harness SystemCheck® Harness Deutsch Connector Purple Not Used T a n/Orange T a n T a n/Black Black Gray T a n/Y ellow Pin A Purple +14 Ignition Pin B T an/Orange Check Engine Pin C Black Ground Pin D Gray T achomet ...

  • Faria Instruments Commander - page 3

    Installation: CAUTION: Disconnect the battery during installation. T ighten nuts on the backclamp only slightly more than you can tighten with your fingers. Six inch- pounds of torque are sufficient. Over- tightening could result in damage to the instrument and may void your warranty . 1. Cut a 3-3/8” diameter hole in the dash and mount the gau ...

  • Faria Instruments Commander - page 4

    H ar ness HN0 3 56 S mall C onnect or Small Plug (CN0082) T o Commander Shrink T ubing or Wrap Black Purple Gray Pin A Purple +12 Ignition Power Pin B Purple +12 Ignition Power Pin C Black Groun d Pin D Gray T achometer Input ECR 1903 12/21/01 (Ignition) (T ach Signal) (Ground) Page 16 Descript ion Th e C omma nder ha s three push butt ons; Th ese ...

  • Faria Instruments Commander - page 5

    Setup Mode T achometer settings and the fuel level sender type can be changed using the Setup Mode (see Figure 2, T able 1, and T a ble 2). Use this option only if you have reason to believe that your settings are wrong. Setting an incorrect value in these menus can result in extremely inaccurate performance o f the tachometer and fuel level sender ...

  • Faria Instruments Commander - page 6

    T achometer Full S cale Selection R ef er to F i gure 3 f or an ex pl a nati on of eac h o f the tachometer full sc ale select ions . This i s nor mall y a fac tory setting that n eeds no adju stment. Th e sett i ng ad justs the “full sc ale ” op erat i ng ra ng e of the tac hometer to match the di al on the instr ument. Us i ng the “Up ” a ...

  • Faria Instruments Commander - page 7

    I MP OR T AN T Alw ays ins tall the Fu el F low T ra nsdu cer AFTE R th e p rima ry fi lter . Th e p rima ry fi lter mu st b e a goo d qua lity w ater s epa rato r type w ith a m ini mum fil trat ion of 30 mi cron s or bet ter . (10 o r 2 mic ron. The l ower the mi cron rati ng the finer the fil trat ion) Fail ure to prov ide t his le vel of ? ...

  • Faria Instruments Commander - page 8

    Ambi e nt A i r an d W at er T e mper at ur e Descr iption Th e F aria Commander T achometer/ W ater - Ai r T e mp e r at ur e/ Fue l L e vel/ E ngi ne Ho u r me te r com bi n es th e fea tu r es of sev er al i n str ume nts i n to on e un it . T h e L CD disp la y s the inf or mati on f or the other instr uments: 1) W ater T emp erature - D ispla ...

  • Faria Instruments Commander - page 9

    causes th e dis play to ch a nge to the “ sett i ng s ” s ubmenu (see Fi g ure 1) . F u el Used “Set tings ” Menu T h ere ar e two i tems i n th e Fuel U sed “Se tt i ngs ” M en u ; Rese t a n d F ue l Cali brati on. Briefly p res sing the “Mo de ” butt on c y cle s thr ough the menu items . T he micr oproces sor will aut omatic al ...

  • Faria Instruments Commander - page 10

    If t h e en gin e st ops running , but t h e k e y s witch remains on, the unit will aut omatic ally g o to “Dia gnosti c ” mode . Diagnost ic mode : S imple dia gnosti cs can be don e with t h e ke y on, engine of f . Th e in tent is t o aid t h e serv ice tec hnic ian in troub leshoot i ng wiri ng or sensor prob lems . It can als o be used to ...

  • Faria Instruments Commander - page 11

    This alarm may be set t o w ar n y ou when th ere is o nl y a c er t ai n a mo unt of fu el re mai n i ng a ccordi ng to th e Fuel F low us ag e c alcu lat ion . Pre ss ing t h e “Up” or “Down ” bu tton s wil l change the Fu el R emai ni n g A larm settin g . F u el Le v el Th e Fue l Le v el di spl a y show s the amount o f fuel i n the fu ...

  • Faria Instruments Commander - page 12

    This alarm may be set t o w ar n y ou when th ere is o nl y a c er t ai n a mo unt of fu el re mai n i ng a ccordi ng to th e Fuel F low us ag e c alcu lat ion . Pre ss ing t h e “Up” or “Down ” bu tton s wil l change the Fu el R emai ni n g A larm settin g . F u el Le v el Th e Fue l Le v el di spl a y show s the amount of fuel in the fuel ...

  • Faria Instruments Commander - page 13

    If t h e en gin e st ops running , but t h e k e y s witch remains on, the unit will aut omatic ally g o to “Dia gnosti c ” mode . Diagnost ic mode : S imple dia gnosti cs can be don e with t h e ke y on, engine of f . Th e in tent is t o aid t h e serv ice tec hnic ian in troub leshoot i ng wiri ng or sensor prob lems . It can als o be used to ...

  • Faria Instruments Commander - page 14

    Ambi e nt A i r an d W at er T e mper at ur e Descr iption Th e F aria Commander T achometer/ W ater - Ai r T e mp e r at ur e/ Fue l L e vel/ E ngi ne Ho u r me te r com bi n es th e fea tu r es of sev er al i n str ume nts i n to on e un it . T h e L CD disp la y s the inf or mati on f or the other instr uments: 1) W ater T emp erature - D ispla ...

  • Faria Instruments Commander - page 15

    I MP OR T AN T Alw ays ins tall the Fu el F low T ra nsdu cer AFTE R th e p rima ry fi lter . Th e p rima ry fi lter mu st b e a goo d qua lity w ater s epa rato r type w ith a m ini mum fil trat ion of 30 mi cron s or bet ter . (10 o r 2 mic ron. The l ower the mi cron rati ng the finer the fil trat ion) Fail ure to prov ide t his le vel of ? ...

  • Faria Instruments Commander - page 16

    T achometer Full S cale Selection R ef er to F i gure 3 f or an ex pl a nati on of eac h o f the tachometer full sc ale select ions . This i s nor mall y a fac tory setting that n eeds no adju stment. Th e sett i ng ad justs the “full sc ale ” op erat i ng ra ng e of the tac hometer to match the di al on the instr ument. Us i ng the “Up ” a ...

  • Faria Instruments Commander - page 17

    Setup Mode T achometer settings and the fuel level sender type can be changed using the Setup Mode (see Figure 2, T able 1, and T a ble 2). Use this option only if you have reason to believe that your settings are wrong. Setting an incorrect value in these menus can result in extremely inaccurate performance o f the tachometer and fuel level sender ...

  • Faria Instruments Commander - page 18

    H ar ness HN0 3 56 S mall C onnect or Small Plug (CN0082) T o Commander Shrink T ubing or Wrap Black Purple Gray Pin A Purple +12 Ignition Power Pin B Purple +12 Ignition Power Pin C Black Groun d Pin D Gray T achometer Input ECR 1903 12/21/01 (Ignition) (T ach Signal) (Ground) Page 16 Descript ion Th e C omma nder ha s three push butt ons; Th ese ...

  • Faria Instruments Commander - page 19

    Installation: CAUTION: Disconnect the battery during installation. T ighten nuts on the backclamp only slightly more than you can tighten with your fingers. Six inch- pounds of torque are sufficient. Over- tightening could result in damage to the instrument and may void your warranty . 1. Cut a 3-3/8” diameter hole in the dash and mount the gau ...

  • Faria Instruments Commander - page 20

    H ar ness HN0 3 58 S mall C onnect or S y ste mC heck® a da p t or Small connector (CN0082) T o Small Connector Socket SystemCheck® Harness SystemCheck® Harness Deutsch Connector Purple Not Used T a n/Orange T a n T a n/Black Black Gray T a n/Y ellow Pin A Purple +14 Ignition Pin B T an/Orange Check Engine Pin C Black Ground Pin D Gray T achomet ...

  • Faria Instruments Commander - page 21

    Fuel Flow T ransducer H ar ness HN0 3 58 Lar g e connect or S y ste mC heck® T o Large Connecto r Socket Red Black Whit e White Shield Boat Ground T an (Over T emperature) T an/Black (Lo Oil Sensor ) T a n/Y ellow (No Oil Sensor) Large connector (CN0083) Pin A Red Fuel T ransducer Power Pin B T a n Over T emperature Pin C White Fuel T ransducer Si ...

  • Faria Instruments Commander - page 22

    ISO128E ECR#4851 08/04 IS0128 Copyright 2004 by the Thomas G. Faria Corporation, Uncasville CT No part of this publication may by reproduced in any form, in an electronic retrieval system or otherwise, without the prior written permission of the company . Faria® is the trademark of the Thomas G. Faria Corporation SystemCheck®, Evinrude®, Johnson ...

Manufacturer Faria Instruments Category Automobile Parts

Documents that we receive from a manufacturer of a Faria Instruments Commander can be divided into several groups. They are, among others:
- Faria Instruments technical drawings
- Commander manuals
- Faria Instruments product data sheets
- information booklets
- or energy labels Faria Instruments Commander
All of them are important, but the most important information from the point of view of use of the device are in the user manual Faria Instruments Commander.

A group of documents referred to as user manuals is also divided into more specific types, such as: Installation manuals Faria Instruments Commander, service manual, brief instructions and user manuals Faria Instruments Commander. Depending on your needs, you should look for the document you need. In our website you can view the most popular manual of the product Faria Instruments Commander.

Similar manuals

A complete manual for the device Faria Instruments Commander, how should it look like?
A manual, also referred to as a user manual, or simply "instructions" is a technical document designed to assist in the use Faria Instruments Commander by users. Manuals are usually written by a technical writer, but in a language understandable to all users of Faria Instruments Commander.

A complete Faria Instruments manual, should contain several basic components. Some of them are less important, such as: cover / title page or copyright page. However, the remaining part should provide us with information that is important from the point of view of the user.

1. Preface and tips on how to use the manual Faria Instruments Commander - At the beginning of each manual we should find clues about how to use the guidelines. It should include information about the location of the Contents of the Faria Instruments Commander, FAQ or common problems, i.e. places that are most often searched by users in each manual
2. Contents - index of all tips concerning the Faria Instruments Commander, that we can find in the current document
3. Tips how to use the basic functions of the device Faria Instruments Commander - which should help us in our first steps of using Faria Instruments Commander
4. Troubleshooting - systematic sequence of activities that will help us diagnose and subsequently solve the most important problems with Faria Instruments Commander
5. FAQ - Frequently Asked Questions
6. Contact detailsInformation about where to look for contact to the manufacturer/service of Faria Instruments Commander in a specific country, if it was not possible to solve the problem on our own.

Do you have a question concerning Faria Instruments Commander?

Use the form below

If you did not solve your problem by using a manual Faria Instruments Commander, ask a question using the form below. If a user had a similar problem with Faria Instruments Commander it is likely that he will want to share the way to solve it.

Copy the text from the picture

Captcha
New picture

Comments (0)