English dropdown-ico

Manual Smeg CIR60X3

24 pages 1.17 mb
Download

Go to site of 24

Summary
  • Smeg CIR60X3 - page 1

    Index 1. INSTRUCTIONS FOR SAFE AND PROPER USE ________________ 4 2. POSITIONING OF HOB ____________________________________ 6 3. GAS CONNECTION ______________________________________ 11 4. ELECTRICAL CONNECTION ______________________________ 12 5. ADAPTATION TO DIFFERENT TYPES OF GAS _______________ 13 6. FINAL OPERATIONS __________________________ ...

  • Smeg CIR60X3 - page 2

    Introduction 1. INSTRUCTIONS FOR SA FE AND PR OPER USE THIS MANUAL IS AN INTEGRAL PART OF THE APPLIANCE AND THEREFORE MUST BE KEPT IN ITS ENTIRETY AND IN AN ACCESSIBLE PLACE FOR THE WHOLE WORKING LIFE OF THE COOKING HOB. WE ADVISE READING THIS MANUAL AND ALL THE INSTRUCTIONS THEREIN BEFORE USING THE COOKING HOB. ALSO KEEP TH E SERIES OF NOZZLES SUP ...

  • Smeg CIR60X3 - page 3

    Introduction THE IDENTIFICATION PLATE, WITH TECHNICAL DATA, SERIAL NUMBER AND MARKING IS CLEARLY VISIBLE UNDER TH E CASING. THE PLATE ON THE CASING MUST NOT BE R EMOVED. BEFORE CONNECTING THE DEVICE, MAKE SURE THAT IT HAS BEEN REGULATED FOR THE TYPE OF GAS THAT WILL FEED IT, CHECKING THE LABEL UNDER THE CASING. DO NOT PUT PANS WITHOUT PERFECTLY SMO ...

  • Smeg CIR60X3 - page 4

    Instructions for the installer 6 2. POSITIONING OF HOB It is the law that all gas appliances are installed by authorised persons . Clearance around the appl iance must comply with the requirements of AS5601. The following op eration requires building and/or c arpentry work so must be carried out by a competent tradesman. Installation can be carried ...

  • Smeg CIR60X3 - page 5

    Instructions for the installer In case of installation on a hollo w compartment with doors, a separating panel has to be placed under the hob. Keep a minimum distance of 10 mm between the bottom of the uni t and the panel surface. The panel has to be easily removable to allow a ccess in the event of te chnical service. Overall dimensions: location ...

  • Smeg CIR60X3 - page 6

    Instructions for the installer 8 2.2 Clearance above and around domestic appliances Extract from AS5601 REQUIREMENTS 1 Overhead clearances – (Measureme nt A ) Range hoods and exha ust fans shall be installed in accor dance with the manufacturer’s instructions. Howev er, in no case shall the clearance between the highest part of the hob of the c ...

  • Smeg CIR60X3 - page 7

    Instructions for the installer Where B , measured from the periphery of the n earest burner to any vertical com bustible surface , is less than 200 mm , the surface shall be protected in accorda nce with Clause 5.12.1.2 to a height C of not less than 150 mm above the hob for th e full dimension (width or depth) of the cooking surfac e area. Where t ...

  • Smeg CIR60X3 - page 8

    Instructions for the installer 10 2.3 Room ventilation Caution – This hob may o nly be installed and operated in rooms permanently ventilated in accordance with current regulations. For proper operation of a gas a ppliance it is essential for the air nec essary for combustion of the gas to be able to flow naturally into t he room. Air must flow d ...

  • Smeg CIR60X3 - page 9

    Instructions for the installer 3. GAS CONNECTION This appliance is suita ble for installation with Natural Gas or LPG (propa ne). Refer to pa ge 12 for the relevant burner press ure and appropriate injector sizes. When th e appliance is to be connected to Natura l Gas then the pressure regulator supplied m ust be fitted to the gas inlet. A test poi ...

  • Smeg CIR60X3 - page 10

    Instructions for the installer 12 4. ELECTRICAL CONNECTION Make sure that the voltage and capacity of the power line conform to the data shown on the plate locat ed under the casing. Do not remove this plate for any reason. The plug on the end of the supply cable and the wall socket must be the same type and conform to the curr ent electrical syste ...

  • Smeg CIR60X3 - page 11

    Instructions for the installer 5. AD APT A TION T O DIF FERENT TYPES OF GAS Before performing any cleaning or maintenance work, detach the appliance from the electrical socket. The hob has been inspected for NG natural gas at a pressure of 1.0 kPa. For functioning with other types of gas the nozzles must be r eplaced and the primary air adjusted. T ...

  • Smeg CIR60X3 - page 12

    Instructions for the installer 14 5.2 Regulation for LPG Loosen screw A and push supp ort B all the way. Use a double head wrench to remove nozzle C and assemble the suitable one, followin g the instructions indicated in the reference charts, with respect to the type of gas to use. The screwing torque of the nozzle should nev er exceed 3 Nm . Repos ...

  • Smeg CIR60X3 - page 13

    Instructions for the installer 5.3 Regulation for natural gas The hob has been adjusted for natural gas at a pressure o f 1.0kPa. To allow the unit to work back with this ty pe of gas, after it has been adjusted for LPG, perform t he same operations described in paragraph “ 6.2 Regulation for LPG ”, but refer to the following table for the prop ...

  • Smeg CIR60X3 - page 14

    Instructions for the installer 16 6. FINAL OPERA TIONS Having carried out the abov e adjustments, reassemble the applianc e following, backwards, the instructions in paragraph “ 6.1 Removing the hob ”. 6.1 Regulation of minimum for natural gas Replace the compon ents on the burner and slide the knobs on the gas tap pins. Light the burner and se ...

  • Smeg CIR60X3 - page 15

    Instructions for the installer 6.3 Arrangement of burners on hob BURNERS 1 Auxiliary 2 Semi-rapid 3 Rapid 4 Rapid 5 WOK 6.4 Lubrification of gas taps After a while, the gas tap may become hard to turn or lock. If this happens, it has to be cleaned inside and re-gr eased. This must be done by a qualified techn ician. 17 ...

  • Smeg CIR60X3 - page 16

    Instructions for the user 18 7. USING THE HOB Before turning on the burners, make sure that the burner rings, caps and grids have been fitted correctly. In the ultrarapid burner, notch A must be aligned with pin B . Grid C provided is intended for use with woks (Chinese pan s). Adapter D comes only with open grids models and is int ended for use wi ...

  • Smeg CIR60X3 - page 17

    Instructions for the user 7.2 Practical advice for usin g the burners For better burner performance an d minimum gas consumption, flat bottomed, even recipie nts must be used, with covers and proportiona l in size to the burners (see paragraph “ 7.3 Diameter of containers ”). To avoid overcooking or damage to the surface top w hile cooking, all ...

  • Smeg CIR60X3 - page 18

    Instructions for the user 20 7.4.2 Using the electric elements The electric elements are ideal for ultrarapid cooking. The settings shown in the table are merely indicativ e. POSITION HEAT INTENSITY POSSIBLE COOKING - 0 Off To melt butter, chocolate, etc. 1 Weak To heat small amounts of liquid. 2 Soft To heat larger amounts of liquid. To defrost fr ...

  • Smeg CIR60X3 - page 19

    Instructions for the user 8. CLEANING AND MAINTENANCE Before any intervention, disconnect the power supply of the device. 8.1 Cleaning Clean the cooking top regularly every time you use it, obviously after it has cooled. Never use a steam jet to clean the appliance. 8.1.1 Regular daily cleaning of the hob In order to clean and preserve the su rface ...

  • Smeg CIR60X3 - page 20

    Instructions for the user 22 8.2 Cleaning of cooking hob componen ts CAUTION: do not wash these components in a dishwasher. In normal use of the hob, the stainless steel burner caps and pan-stands tend to be burnished by the high temp erature. Clean these parts using very fine abrasive sponges or similar c ommercial products. Then use a specific pa ...

  • Smeg CIR60X3 - page 21

    Instructions for the user 8.3 Preventive maintenance This appliance does not need any special maintena nce. However, a few simple operations hav e to be carried out periodically to prevent malfunctioning: Burners: the burners must be cleaned after every use to e nsure correct combustion; make sure that all the open ings and flame ports are clean an ...

  • Smeg CIR60X3 - page 22

    Instructions for the user 24 9. PROBLEMS AND CA USES Each of the following cases is caused by an abnormal op eration of the appliance and shoul d be dealt with by a authorised persons: please contact your local dealer or Service Center in case you detect any of these malfunctioning. PROBLEM CAUSE WHAT TO DO The flame is very long with bright yellow ...

  • Smeg CIR60X3 - page 23

    ...

  • Smeg CIR60X3 - page 24

    914773400/ B ...

Manufacturer Smeg Category Range

Documents that we receive from a manufacturer of a Smeg CIR60X3 can be divided into several groups. They are, among others:
- Smeg technical drawings
- CIR60X3 manuals
- Smeg product data sheets
- information booklets
- or energy labels Smeg CIR60X3
All of them are important, but the most important information from the point of view of use of the device are in the user manual Smeg CIR60X3.

A group of documents referred to as user manuals is also divided into more specific types, such as: Installation manuals Smeg CIR60X3, service manual, brief instructions and user manuals Smeg CIR60X3. Depending on your needs, you should look for the document you need. In our website you can view the most popular manual of the product Smeg CIR60X3.

Similar manuals

A complete manual for the device Smeg CIR60X3, how should it look like?
A manual, also referred to as a user manual, or simply "instructions" is a technical document designed to assist in the use Smeg CIR60X3 by users. Manuals are usually written by a technical writer, but in a language understandable to all users of Smeg CIR60X3.

A complete Smeg manual, should contain several basic components. Some of them are less important, such as: cover / title page or copyright page. However, the remaining part should provide us with information that is important from the point of view of the user.

1. Preface and tips on how to use the manual Smeg CIR60X3 - At the beginning of each manual we should find clues about how to use the guidelines. It should include information about the location of the Contents of the Smeg CIR60X3, FAQ or common problems, i.e. places that are most often searched by users in each manual
2. Contents - index of all tips concerning the Smeg CIR60X3, that we can find in the current document
3. Tips how to use the basic functions of the device Smeg CIR60X3 - which should help us in our first steps of using Smeg CIR60X3
4. Troubleshooting - systematic sequence of activities that will help us diagnose and subsequently solve the most important problems with Smeg CIR60X3
5. FAQ - Frequently Asked Questions
6. Contact detailsInformation about where to look for contact to the manufacturer/service of Smeg CIR60X3 in a specific country, if it was not possible to solve the problem on our own.

Do you have a question concerning Smeg CIR60X3?

Use the form below

If you did not solve your problem by using a manual Smeg CIR60X3, ask a question using the form below. If a user had a similar problem with Smeg CIR60X3 it is likely that he will want to share the way to solve it.

Copy the text from the picture

Captcha
New picture

Comments (0)