English dropdown-ico

Manual AEG 222D

20 pages 0.65 mb
Download

Go to site of 20

Summary
  • AEG 222D - page 1

    222 D Fume Extractor Hood Installation and Operating Instructions ...

  • AEG 222D - page 2

    2 Printed on recycled paper. AEG  putting words into action. ...

  • AEG 222D - page 3

    3 Contents Introduction 4 Extraction mode 4 Recirculation mode 5 Electrical connections 6 Technical details 7 Installation 8 Safety warnings for kitchen unit installer 8 Wall unit mounting 10 Wall mounting 1 1 Hood operation 12 Safety warnings for user 13 Maintenance and care 14 Opening the grid 14 Grease filter 14 Carbon filter 15 Changing the lig ...

  • AEG 222D - page 4

    4 2 Introduction Extraction mode ● The hood is supplied as an extractor unit and can also be used with a filtering function by fitting activated carbon filters (available as an accessory). ● The unit features two outlet holes, one of which A is located on the top of the unit while the other B is located on the rear. ● To connect up the hose, ...

  • AEG 222D - page 5

    5 ● Move the lever L to position A  Fig. 3 . ● When connecting up the hood using a telescopic wall pipe, you should use an uninflammable outlet hose ABS 120 (120 mm Ø) available as an accessory. Recirculation mode ● The air is filtered and recirculated through the front grid. ● Move the lever L to position F  Fig. 3 . You will need a ...

  • AEG 222D - page 6

    6 Electrical connection 220-240 V - using fixed power supply line with plug. (The unit should only be connected up by an authorized electrician). Your appliance must be connected to fixed wiring via the use of a double pole swiched fused spur outlet with or without pilot lamp. We strongly recommend the appliance is connected by a qualified electric ...

  • AEG 222D - page 7

    7 Technical details Dimensions Height x Width x Depth (in cm) 13 x 59,9 x 51 Weight N e t : 6,9 kg Gross: 7, 8 k g Maximum absorbed power: 205 W Motor absorption 1 x 125 W Lighting: 2 x 4 0 W Length of the cable: 110 cm Fan powers (speed), speed in compliance with DIN 44971 Extraction mode Speed 1 115 m 3 /h Speed 2 145 m 3 /h Speed 3 180 m 3 /h In ...

  • AEG 222D - page 8

    8 Installation Safety warnings for kitchen unit installer ● When used as an extractor unit, the hood must be fitted with a 120mm diameter hose. ● If the fumes must be forced out through the wall, you must obtain a MKZ sizable wall exhaust pipe (with external exhaust and air intake), E-Nr.- 610 899 004 (Ø 120 mm) which is one of our optional pa ...

  • AEG 222D - page 9

    9 ● The national decree on fuel-burning systems specifies a maximum depression of 0.04 bar in such rooms. ● Hoods can only be used safely with appliances connected to a chimney if the room and/or flat (air/environment combination) is ventilated from outside using a suitable ventilation hole approxi- mately 500-600 cm 2 large to avoid the possib ...

  • AEG 222D - page 10

    10 Wall unit mounting ● Make the holes on the bottom of the cupboard, using the drilling template . ● From inside the cupboard, insert the 4 supplied screws and tighten them in the appropriate holes on the appliance.  Fig. 4. 4 ...

  • AEG 222D - page 11

    11 Wall mounting ● Fix the drilling template to the wall. ● Make 3 Ø 8mm holes in the wall 2 at points I , 1 as desired at points L . ● Insert the three Ø 8mm expansion plugs into the wall. ● Insert 2 5x45 screws at points I but do not tighten them completely. ● Adjust the unit so that it is positioned at a right angle to the wall by tu ...

  • AEG 222D - page 12

    12 Hood Operation ● The hood is fitted with a variable speed motor. The most effective use of the hood is obtained by switching it on a few minutes before you start cooking and leaving it on a for approximately 15 minutes after you have finished, thus ensuring all cooking odours are eliminated. The control switches are located on the units fro ...

  • AEG 222D - page 13

    13 ● Never leave a cooking hob or ring on without a pot or pan on top of it, to avoid the possibility of excess heat damaging the unit. Gas, oil in particular should never be left uncovered. ● Special care should be taken when using deep fat fryers since the oil in them can overheat and burst into flames. ● The risk of a fat fire increases wh ...

  • AEG 222D - page 14

    14 6 Maintenance and care ● The hood must always be disconnected from the mains power supply before beginning any maintenance work. Opening the grid ● Open the latch L and swing the grille downwards.  Fig. 6. ● To remove the grid, pull it forwards from the right and release it. Grease filter ● The purpose of the grease filters is to aspi ...

  • AEG 222D - page 15

    15 8 Removing the filter Open the grid and remove the stops M to take out the filter. See Fig. 7. Carbon filter ● The activated carbon filter should only be used if you want to use the hood in its filtering function. ● To do this you will need an original AEG activated carbon filter (see special accessories). ● This filter cannot be cleaned o ...

  • AEG 222D - page 16

    16 Warning ● Failure to observe the instructions on cleaning the unit and changing the filters will cause a fire hazard. You are therefore strongly recommended to follow these instructions. Changing the light bulb ● Disconnect the unit from the mains power supply. ● Remove the grid. ● Replace the old light bulb with a new light bulb (40 W m ...

  • AEG 222D - page 17

    17 What to do if If your appliance fails to work properly please carry out the following checks. Symptom Solution The cooker hood will not start... Check that: The hood is connected to the electricity supply. Check that the fan speed control is set to 1, 2 or 3. The cooker hood is not working Chec k that: effectively.. The fan speed is set high eno ...

  • AEG 222D - page 18

    18 Service and spare parts In the event of your appliance requiring service, or if you wish to purchase spare parts, contact your local AEG Service Force Centre by telephoning 08705 929 929 Y our call will be automatically routed to the Service Centre covering your post code area. For the address of your local Service Force Centre and further infor ...

  • AEG 222D - page 19

    19 ...

  • AEG 222D - page 20

    LI02GB Ed. 05/02 AEG Hausgeräte GmbH Postfach 1036 D-90327 Nürnberg http:/ /www .aeg.hausgeraete.de © Copyright by AEG ...

Manufacturer AEG Category Ventilation Hood

Documents that we receive from a manufacturer of a AEG 222D can be divided into several groups. They are, among others:
- AEG technical drawings
- 222D manuals
- AEG product data sheets
- information booklets
- or energy labels AEG 222D
All of them are important, but the most important information from the point of view of use of the device are in the user manual AEG 222D.

A group of documents referred to as user manuals is also divided into more specific types, such as: Installation manuals AEG 222D, service manual, brief instructions and user manuals AEG 222D. Depending on your needs, you should look for the document you need. In our website you can view the most popular manual of the product AEG 222D.

Similar manuals

A complete manual for the device AEG 222D, how should it look like?
A manual, also referred to as a user manual, or simply "instructions" is a technical document designed to assist in the use AEG 222D by users. Manuals are usually written by a technical writer, but in a language understandable to all users of AEG 222D.

A complete AEG manual, should contain several basic components. Some of them are less important, such as: cover / title page or copyright page. However, the remaining part should provide us with information that is important from the point of view of the user.

1. Preface and tips on how to use the manual AEG 222D - At the beginning of each manual we should find clues about how to use the guidelines. It should include information about the location of the Contents of the AEG 222D, FAQ or common problems, i.e. places that are most often searched by users in each manual
2. Contents - index of all tips concerning the AEG 222D, that we can find in the current document
3. Tips how to use the basic functions of the device AEG 222D - which should help us in our first steps of using AEG 222D
4. Troubleshooting - systematic sequence of activities that will help us diagnose and subsequently solve the most important problems with AEG 222D
5. FAQ - Frequently Asked Questions
6. Contact detailsInformation about where to look for contact to the manufacturer/service of AEG 222D in a specific country, if it was not possible to solve the problem on our own.

Do you have a question concerning AEG 222D?

Use the form below

If you did not solve your problem by using a manual AEG 222D, ask a question using the form below. If a user had a similar problem with AEG 222D it is likely that he will want to share the way to solve it.

Copy the text from the picture

Captcha
New picture

Comments (0)