Manual Graco Hydra-Clean 2545

22 pages 1.35 mb
Download

Go to site of 22

Summary
  • Graco Hydra-Clean 2545 - page 1

    INSTRUCTIONS-PARTS LIST 0-0 This mUal contains IMPORTANT WARNINGS and INSTRUCTIONS READ AND RETAIN FOR REFERENCE HYDRA-CLEAN @ 2545,3040,3235 Pressure Washers HYDRA-CLEAN 2545 PIN 800-701, Series A, 11 HP IIC ENGINE PIN 800-702, Series A, 12.5 HP OHV ENGINE 2900psl(200 bar) MAXIMUM WORKING PRESSURE 2500 psi (1 72 bar) OPERATING PRESSURE HYDRA-CLEAN ...

  • Graco Hydra-Clean 2545 - page 2

    HIGH PRESSURE SPRAY CAN CAUSE SERIOUS INJURY. FOR PROFESSIONAL USE ONLY. OBSERVE ALL WARNINGS. Read and understand all instruction manuals before operating equipment. FLUID INJECTION HAZARD General Safety This pressure washer generates very high fluid pressure. Spray from the gun, leaks or ruptured components can inject fluid through your skin and ...

  • Graco Hydra-Clean 2545 - page 3

    FUEL AND EMISSION HAZARDS NEVER flll the fuel tank while the unit is wnning or hot. NEVER alter the throttle settlng, which Is factory set. The fuel used in this unit is combustible and when Tampering with this adjustment can damage the spilled on a hot surface can ignite and cause a fire. ALWAYS fill tank slowly to avoid spilling. pressure washer ...

  • Graco Hydra-Clean 2545 - page 4

    TERMS WARNING: Alerts user to avoid or correct conditions NOW. Identifies helpful procedures and Information. that could cause bodily injury. CAUTION: Alerts user to avoid or comect conditions that could cause damage to the equipment. IMPORTANT standards-particularly the General Standards, Part 1910, and the Construction Standards, Part 1926-should ...

  • Graco Hydra-Clean 2545 - page 5

    __ ~~ INSTALLATION Flgure 1 Check for Shipping Damage Check the unit for any damage that may have occurred any damage. in shipping. Notlfy the carrier Immediately if there is Set Up between the pump unloader and the high pressure If you are using a downstream chemical injector, install it hose, using the quick couplers provided. Connect the high pr ...

  • Graco Hydra-Clean 2545 - page 6

    ~ ~~ STARTUP Always use this start-up procedure to ensure that the unit is started safely and properly. 1. Check oil levels. Engine: Add SA€ 30 or low-30 weigM detergent oil as necessary. as necessary, or use genuine CAT@ pump oil. Pump: Add SAE 20 or 30 weight non-detergent oil NO= All units are equipped with a low-oil sensor that shuts the engi ...

  • Graco Hydra-Clean 2545 - page 7

    Trigger Safety Latch WARNING To reduce the risk of serious bodily injury, on the skin, ALWAYS engage the trigger safely including fluid injection, splashing in the eyes or moment. latch whenever spraying stops, even for a prevents the gun from being triggered in the engaged position, the trigger safety latch bumped. Be sure the latch is pushed full ...

  • Graco Hydra-Clean 2545 - page 8

    SHUTDOWN, FLUSHING AND STORAGE WARNING Pressure Rellef Procedure To reduce the risk of serious bodily injury, including fluid injection and splashing in the eyes, .or on the skin, always follow this than 10 minutes, when shutting down, and procedure whenever you stop spraylngformore before checking or repairing any part of the system. 1. Engage the ...

  • Graco Hydra-Clean 2545 - page 9

    TROUBLESHOOTING CHART WARNING To reduce the risk of serious bodily injury, including fluid injection, splashing in the eyes or on the skin or injury tom moving palls, always follow the Pressure Relief Procedure Warnlng before proceeding. 1 PROBLEM Engine will not stail or is hard to start Engine misses or lacks power Low pressure and101 pump runs r ...

  • Graco Hydra-Clean 2545 - page 10

    PARTS DRAWING 800-701 and 800-702 ...

  • Graco Hydra-Clean 2545 - page 11

    PARTS LIST 800-701 and 800-702 Hydra-Clean@ 2545 Pressure Washer REF NO. 1 2 3 4 5 7 6 8 10 9 11 12 13 15 14 16 17 18 20 19 21 22 23 24 25 26 27 28 29 30 32 31 33 35 34 36 37 38 39 NO. PART 800-392 100-023 801 -941 803-926 801 -539 803-534 800-676 100-188 801 -550 100-21 4 801-612 801 -020 801-556 800-678 801 -546 801 -569 803-303 800-1 60 803-925 ...

  • Graco Hydra-Clean 2545 - page 12

    PARTS DRAWING 800-703 and 800-704 Hydra-Clean@ 3040 Pressure Washer ...

  • Graco Hydra-Clean 2545 - page 13

    PARTS LIST 800-703 and 800-704 Hydra-Cleano 3040 Pressure Washer 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 18 17 20 19 22 21 23 24 25 26 27 28 29 30 32 31 34 33 35 36 37 38 39 . ..... 800-392 NO. 100-023 801 -941 801 -539 803-926 803-534 800-676 100-214 100-188 801 -61 2 801 -550 801 -020 801 -556 800-678 801 -546 801 -569 803-161 800-1 60 803-925 801-5 ...

  • Graco Hydra-Clean 2545 - page 14

    PARTS DRAWING 800-705 Hydra-Clea 14 308-531 ...

  • Graco Hydra-Clean 2545 - page 15

    1 2 3 4 5 7 6 8 10 9 11 12 13 15 14 16 17 18 20 19 21 22 23 25 26 28 27 29 30 32 31 ""~. 800-392 NO. 100-023 801-941 801 -539 803-926 803-534 800-676 PARTS LIST 800-705 Hydra-Cleano 3235 Pressure Washer REF PART REF PART NO. ...... NO. DESCRIPTION QN 1 00-188 100-21 4 801 -550 801 -61 2 801 -om 801 -556 800-678 801 -546 801 -569 803-904 8 ...

  • Graco Hydra-Clean 2545 - page 16

    PARTS DRAWING Pump Assembly 16 308-531 ...

  • Graco Hydra-Clean 2545 - page 17

    ~ PARTS LIST Pump Assembly 2 1 4 3 5 6 7 8 10 9 11 12 13 14 15 16 17 18 20 19 21 22 23 25 24 26 27 28 29 30 31 32 33 34 35 37 36 REF PART NO. NO. DESCRIPTION 804-093 KEY 804-154 801 -028 804-1 89 804-181 804-1 55 804-171 804-1 50 802-189 804-089 804-237 804-224 804-080 804-109 804-124 804-1 93 804-1 37 804-21 3 804-219 804-223 804-1 26 804-121 801- ...

  • Graco Hydra-Clean 2545 - page 18

    PUMP SERVICE Servicing the Valves 1. Remove the hex valve plug. 2. Examine the O-ring under the plug for cuts or distortion and replace if wom. Lubricate new O-ring before installing. 3. Grasp valve retainer by tab at the top with pliers and remove from valve chamber. Valve parts usually separate during removal. Note: A special tool will be needed ...

  • Graco Hydra-Clean 2545 - page 19

    Reassembly: V-Packlng Models: 1. Lubricate high pressure packing area in manifold. 2. Insert male adapter with notches down and "v" side UP. 3. Lubricate v-packings and install one-at-a-time with grooved side down. 4. Next install female adapter with grooved side down. 5. Examine seal case O-ring and replace if wom. Lubricate new O-ring b ...

  • Graco Hydra-Clean 2545 - page 20

    ACCESSORIES (Must be purchased separately) DOWNSTREAM CHEMICAL INJECTOR KIT WATER SANDBLASTING KIT 800-120 800-1 17 & 800-649 For injecting harsh cleaning chemicals downstream For abrasive cleaning of stubborn dirt and paint. from the pump. 800-649 is stainless steel construction. Requires a spray tip which is not included in kit (2545 uses 801 ...

  • Graco Hydra-Clean 2545 - page 21

    TECHNICAL DATA Model 800-701 800-702 800-705 800-704 800-703 "Id Model Model Model Engine 11 HP B ' gs & pressure 6 quarts (5.7 liter) 24 qwls (23 lir) 6 quarts (5.7 lir) 24 quarts (23 li) 6 quarts (5.7 liter) 3200 psi (221 bar) 3wo psi (207 bar) 3wo psi (207 bar) 25M) psi (172 bar) 2500 psi (172 bar) Water Pump Maximum Working Gasoli ...

  • Graco Hydra-Clean 2545 - page 22

    THE GRACO WARRANTY WARRANTYAND DISCLAIMERS Grawwanantsallequipmentmanutacturedbyit~baeringitsnama~obehaelmmde~~inrnaterial andwarkmanshiponthedateofsalebyanauthorizedGracodistributortotheoriginalpumhaserforuse. Aspumhaser'ssoleremactyforbreachofmiswarranty,Gracowiil,foraperiodoftwentyfourmonthsfmm dateofsale,repairorreplacaanypartdtheequipment ...

Manufacturer Graco Category Pressure Washer

Documents that we receive from a manufacturer of a Graco Hydra-Clean 2545 can be divided into several groups. They are, among others:
- Graco technical drawings
- Hydra-Clean 2545 manuals
- Graco product data sheets
- information booklets
- or energy labels Graco Hydra-Clean 2545
All of them are important, but the most important information from the point of view of use of the device are in the user manual Graco Hydra-Clean 2545.

A group of documents referred to as user manuals is also divided into more specific types, such as: Installation manuals Graco Hydra-Clean 2545, service manual, brief instructions and user manuals Graco Hydra-Clean 2545. Depending on your needs, you should look for the document you need. In our website you can view the most popular manual of the product Graco Hydra-Clean 2545.

Similar manuals

A complete manual for the device Graco Hydra-Clean 2545, how should it look like?
A manual, also referred to as a user manual, or simply "instructions" is a technical document designed to assist in the use Graco Hydra-Clean 2545 by users. Manuals are usually written by a technical writer, but in a language understandable to all users of Graco Hydra-Clean 2545.

A complete Graco manual, should contain several basic components. Some of them are less important, such as: cover / title page or copyright page. However, the remaining part should provide us with information that is important from the point of view of the user.

1. Preface and tips on how to use the manual Graco Hydra-Clean 2545 - At the beginning of each manual we should find clues about how to use the guidelines. It should include information about the location of the Contents of the Graco Hydra-Clean 2545, FAQ or common problems, i.e. places that are most often searched by users in each manual
2. Contents - index of all tips concerning the Graco Hydra-Clean 2545, that we can find in the current document
3. Tips how to use the basic functions of the device Graco Hydra-Clean 2545 - which should help us in our first steps of using Graco Hydra-Clean 2545
4. Troubleshooting - systematic sequence of activities that will help us diagnose and subsequently solve the most important problems with Graco Hydra-Clean 2545
5. FAQ - Frequently Asked Questions
6. Contact detailsInformation about where to look for contact to the manufacturer/service of Graco Hydra-Clean 2545 in a specific country, if it was not possible to solve the problem on our own.

Do you have a question concerning Graco Hydra-Clean 2545?

Use the form below

If you did not solve your problem by using a manual Graco Hydra-Clean 2545, ask a question using the form below. If a user had a similar problem with Graco Hydra-Clean 2545 it is likely that he will want to share the way to solve it.

Copy the text from the picture

Comments (0)