English dropdown-ico

Manual Kenmore 3948598A

16 pages 1.67 mb
Download

Go to site of 16

Summary
  • Kenmore 3948598A - page 1

    Coin-Operated Commercial Automatic Washer 3948598A Sears Roebuck and Co., Hoffman Estates, IL 60179 U.S.A. www.sears.com ...

  • Kenmore 3948598A - page 2

    TABLE OF CONTENTS PRODUCT RECORD ...................................................................... 2 WASHER SAFETY ........................................................................... 2 INSTALLATION REQUIREMENTS ................................................ 3 Tools and Parts ........................................................... ...

  • Kenmore 3948598A - page 3

    IMPORTANT SAFETY INSTRUCTIONS WARNING: To reduce the risk of fire, electric shock, or injury to persons when using the washer, follow basic precautions, including the following: • Read all instructions before using the washer. • Do not wash articles that have been previously cleaned in, washed in, soaked in, or spotted with gasoline, dry-cleani ...

  • Kenmore 3948598A - page 4

    Alternate Parts Parts listed are available from your local Sears store or Sears Service Center. For further information, call 1-800-4-MY-HOME ® (1-800-469-4663). If You Have: You Will Need to Buy: Floor drain Siphon break, Part Number 285320; additional drain hose, Part Number 3357090 and connector kit, Part Number 285442 Drain hose too Drain hose ...

  • Kenmore 3948598A - page 5

    Laundry tub drain system (view C) The laundry tub needs a minimum 20 gal. (76 L) capacity. The top of the laundry tub must be at least 39" (99 cm) above the floor and no higher than 96" (244 cm) from the bottom of the washer. Floor drain system (view D) The floor drain system requires a siphon break that may be purchased separately. See & ...

  • Kenmore 3948598A - page 6

    INSTALLATION INSTRUCTIONS Excessive Weight Hazard Use two or more people to move and install washer. Failure to do so can result in back or other injury. • To avoid floor damage, set the washer onto cardboard before moving across floor. • Move the washer to within approximately 3 ft (90 cm) of its final location. Removing the shipping strap is ...

  • Kenmore 3948598A - page 7

    For standpipe or laundry tub drain systems: 1. Open yellow, single-wire clamp with pliers and slide over hooked end of drain hose to secure the rubber and corrugated sections together. 2, A. Hooked end B. Drain hose Put hooked end of drain hose into laundry tub or standpipe. Rotate hook to eliminate kinks. To keep drain water from going back into t ...

  • Kenmore 3948598A - page 8

    1. Drape the power cord over the console. 2. Remove any cardboard used to move washer. 3. Locate the remaining portion of shipping strap (not the end with the cotter pins) from Step 3 of "Remove Shipping Strap," 4= Remaining portion of shipping strap Wrap the drain hose to the laundry tub leg or standpipe with the tie strap. Push fastener ...

  • Kenmore 3948598A - page 9

    g= After the washer is in the final location and level, use a %6" (14 mm) open-end wrench to turn the nuts on the feet tightly against the washer cabinet. IMPORTANT: If the nuts are not tight against the washer cabinet, the washer may vibrate. f. Check the electrical requirements. Be sure that you have the correct electrical supply and the rec ...

  • Kenmore 3948598A - page 10

    NOTE: You do not have to disconnect the timer. Electrical Shock Hazard Disconnect power before servicing. Replace all parts and panels before operating. Failure to do so can result in death or electrical shock. Removing Cabinet 1. Unplug washer or disconnect power. 2. Remove 2 screws on console at left and right side on bottom. A 3. 4. A. Screws Pu ...

  • Kenmore 3948598A - page 11

    3. Remove slide return spring. 4. Place coin(s) in coin slot(s) and push forward all the way. 5. Remove buffer. 6. Turn coin chute upside down and install or remove required number of block-out keys. Remove keys to increase vend, add keys to lower vend. 7. Reassemble buffer. 8. Pull slide back to original position and reassemble slide return spring ...

  • Kenmore 3948598A - page 12

    Typical Full Load Chart Load Loading Load Loading Type Suggestion Type Suggestion Mixed 2 double or Heavy Load 1 king size sheet Work 4 pillowcases Clothes 6 T-shirts 6 pair shorts 2 boy's shirts 2 blouses 6 handkerchiefs 2 pair work pants 3 work shirts 1 coverall 3 pair jeans WASHER CARE LUBRICATING Every Kenmore Automatic Washer is thoroughl ...

  • Kenmore 3948598A - page 13

    TROUBLESHOOTING First try the solutions suggested hers and possibly avoid the cost of a service call... NOTE: Washer will not operate with the lid open. Noisy Is the load balanced, and is the washer level? The wash load should be balanced and not overloaded, The washer must be level, The front feet should be properly installed and the nuts tightene ...

  • Kenmore 3948598A - page 14

    Washer stops, won't fill, rinse or agitate Electrical Shock Hazard Plug into a grounded (earthed) outlet. Do not remove ground prong. Do not use an adapter. Do not use an extension cord. Failure to follow these instructions can result in death, fire, or electrical shock. • Checkthe following: Is the power cord plugged into a grounded 3 prong ...

  • Kenmore 3948598A - page 15

    %JS<_ Load too wet • Did you use the right cycle for the load being washed? Select a cycle with a higher spin speed (if available). • Did you use a cold rinse? Cold rinses leave loads wetter than warm rinses. This is normal. Residue or lint on load • Did you sort properly? Sort lint givers (towels, chenille) from lint takers (corduroy, syn ...

  • Kenmore 3948598A - page 16

    Your Home For repair-in your home-of all major brand appliances, lawn and garden equipment, or heating and cooling systems, no matter who made it, no matter who sold it! For the replacement parts, accessories and owner's manuals that you need to do-it-yourself. For Sears professional installation of home appliances and items like garage door o ...

Manufacturer Kenmore Category Washer

Documents that we receive from a manufacturer of a Kenmore 3948598A can be divided into several groups. They are, among others:
- Kenmore technical drawings
- 3948598A manuals
- Kenmore product data sheets
- information booklets
- or energy labels Kenmore 3948598A
All of them are important, but the most important information from the point of view of use of the device are in the user manual Kenmore 3948598A.

A group of documents referred to as user manuals is also divided into more specific types, such as: Installation manuals Kenmore 3948598A, service manual, brief instructions and user manuals Kenmore 3948598A. Depending on your needs, you should look for the document you need. In our website you can view the most popular manual of the product Kenmore 3948598A.

Similar manuals

A complete manual for the device Kenmore 3948598A, how should it look like?
A manual, also referred to as a user manual, or simply "instructions" is a technical document designed to assist in the use Kenmore 3948598A by users. Manuals are usually written by a technical writer, but in a language understandable to all users of Kenmore 3948598A.

A complete Kenmore manual, should contain several basic components. Some of them are less important, such as: cover / title page or copyright page. However, the remaining part should provide us with information that is important from the point of view of the user.

1. Preface and tips on how to use the manual Kenmore 3948598A - At the beginning of each manual we should find clues about how to use the guidelines. It should include information about the location of the Contents of the Kenmore 3948598A, FAQ or common problems, i.e. places that are most often searched by users in each manual
2. Contents - index of all tips concerning the Kenmore 3948598A, that we can find in the current document
3. Tips how to use the basic functions of the device Kenmore 3948598A - which should help us in our first steps of using Kenmore 3948598A
4. Troubleshooting - systematic sequence of activities that will help us diagnose and subsequently solve the most important problems with Kenmore 3948598A
5. FAQ - Frequently Asked Questions
6. Contact detailsInformation about where to look for contact to the manufacturer/service of Kenmore 3948598A in a specific country, if it was not possible to solve the problem on our own.

Do you have a question concerning Kenmore 3948598A?

Use the form below

If you did not solve your problem by using a manual Kenmore 3948598A, ask a question using the form below. If a user had a similar problem with Kenmore 3948598A it is likely that he will want to share the way to solve it.

Copy the text from the picture

Captcha
New picture

Comments (0)