English dropdown-ico

Manual Pelco C2429M

16 pages 0.27 mb
Download

Go to site of 16

Summary
  • Pelco C2429M - page 1

    BB5HD Series Heavy-Duty Spectra ® Back Box Installation Manual C2429M (3/01) P elco • 3500 P elco Wa y • Clovis , CA 93612-5699 USA • www .pelco .com In Nor th America and Canada: T el (800) 289-9100 • F AX (800) 289-9150 International Customers: T el +1(559) 292-1981 • F AX +1(559) 348-1120 00546 ...

  • Pelco C2429M - page 2

    2 Pelco Installation Manual C2429M (3/01) CONTENTS IMPORT ANT SAFEGUARDS AND WARNINGS ......................................................................................................... 3 DESCRIPTION ................................................................................................................................................ ...

  • Pelco C2429M - page 3

    Pelco Installation Manual C2429M (3/01) 3 IMPOR T ANT SAFEGUARDS AND W ARNINGS Prior to installation and use of this product, the following W ARNINGS should be observed. CAUTION: RISK OF ELECTRIC SHOCK. DO NOT OPEN. 1. Installation and servicing should only be done by qualified service personnel and conform to all local codes. 2. Unless the unit is ...

  • Pelco C2429M - page 4

    4 Pelco Installation Manual C2429M (3/01) DESCRIPTION The Heavy-duty Spectra is perf ect for installations where structural integ r ity and v andalism are a pr iority . The system f eatures barrel ke y locks , heavy-duty construction and a thick acr ylic low er dome. The in-ceiling model has a reinforced brac ket mounting system f or installation i ...

  • Pelco C2429M - page 5

    Pelco Installation Manual C2429M (3/01) 5 b. Tu rn the thumbscrew and open the hinged door to the back bo x. Pull wiring into the back bo x through the conduit fitting. Ref er to T ab les A and B in the Appendix for wiring distances. 00535 c. Compress the spring clips on the back box and push it through the hole, until the clips spring back. Tighte ...

  • Pelco C2429M - page 6

    6 Pelco Installation Manual C2429M (3/01) STEP 4 - WIRE CIRCUIT BOARD Attach the wiring to the circuit board inside the back box. When finished, close the door to the back bo x and turn on the power . The red LED will light. IMPORT ANT : If the LED does not light, refer to the T rouble- shooting section . NOTE: Aux 1 - Maximum 2A at low voltage (&l ...

  • Pelco C2429M - page 7

    Pelco Installation Manual C2429M (3/01) 7 INST ALLA TION PENDANT MODELS STEP 1 - MOUNT AND INST ALL THE BACK BOX NOTE: If installing outdoors make sure the installation is properly sealed to keep moisture out. a. Install the mount for the pendant dome. Refer to the instruc- tions supplied with the mount. Bring the wiring for the dome through the mo ...

  • Pelco C2429M - page 8

    8 Pelco Installation Manual C2429M (3/01) STEP 3 - INST ALL DOME DRIVE TO USE YOUR DOME, REFER TO THE OPERA TION AND PROGRAMMING MANUAL. b. Line up the green and red tabs with the green and red labels. Push in on the tabs. Insert the side with the green tab, then the side with red tab. Continue pushing on the ends of the tabs until both sides click ...

  • Pelco C2429M - page 9

    Pelco Installation Manual C2429M (3/01) 9 TROUBLESHOOTING PROBLEM POSSIBLE CAUSE SOLUTION Unit does not operate. The controller is not communicating with the Spectra unit. Fan does not operate. Ve r tical roll on monitor when switching between cameras. DOME 1 POWER DOME 2 POWER DOME 3 POWER Check to see if the red LED on the circuit board in the ba ...

  • Pelco C2429M - page 10

    10 Pelco Installation Manual C2429M (3/01) APPENDIX Ta b le A. Video Coaxial Cable Wir ing Distances Cable T ype* Maximum Distance RG59/U 750 ft (229 m) RG6/U 1,000 ft (305 m) RG11/U 1,500 ft (457 m) * Minimum cable requirements: 75 ohms impedance. All-copper center conductor . 95% braided copper shield. Ta b le B. 24 V A C Wiring Distances The fol ...

  • Pelco C2429M - page 11

    Pelco Installation Manual C2429M (3/01) 11 Ta b le D. Switch Settings f or SW2 – P-T ype Control NO TE: F or Coaxitron controls, SW2 is not used; set all s witches OFF . For D-type control systems , refer to T able E. Baud Rate Switch Setting SW2-6 SW2-7 SW2-8 2400 OFF OFF OFF 4800 ON OFF OFF 9600 OFF ON OFF Receiver Switch Setting Address SW2-1 ...

  • Pelco C2429M - page 12

    12 Pelco Installation Manual C2429M (3/01) Ta b le E. Switch Settings for SW2 – D-T ype Control (continued) (Continued on next page) Receiver Switch Setting Address SW2-1 SW2-2 SW2-3 SW2-4 SW2-5 SW2-6 SW2-7 SW2-8 49 ON OFF OFF OFF ON ON OFF OFF 50 OFF ON OFF OFF ON ON OFF OFF 51 ON ON OFF OFF ON ON OFF OFF 52 OFF OFF ON OFF ON ON OFF OFF 53 ON OF ...

  • Pelco C2429M - page 13

    Pelco Installation Manual C2429M (3/01) 13 Ta b le E. Switch Settings for SW2 – D-T ype Control (continued) Receiver Switch Setting Address SW2-1 SW2-2 SW2-3 SW2-4 SW2-5 SW2-6 SW2-7 SW2-8 161 ON OFF OFF OFF OFF ON OFF ON 162 OFF ON OFF OFF OFF ON OFF ON 163 ON ON OFF OFF OFF ON OFF ON 164 OFF OFF ON OFF OFF ON OFF ON 165 ON OFF ON OFF OFF ON OFF ...

  • Pelco C2429M - page 14

    14 Pelco Installation Manual C2429M (3/01) SPECIFICA TIONS MECHANICAL Construction Back box: Aluminum Dome drive: Aluminum, ABS plastic Lower dome: Acrylic Cable Entry In-Ceiling: .75-inch (1.91 cm) conduit fitting Pendant: Through 1.5-inch (3.81 cm) NPT pendant mount Pan Movement: 360 ° continuous pan rotation Ve r tical Tilt: Unobstructed +2 ° ...

  • Pelco C2429M - page 15

    Pelco Installation Manual C2429M (3/01) 15 GENERAL Environment In-Ceiling: Indoor only Pendant: Indoor/outdoor Operating Range In-Ceiling: 32 to 140 ° F (0 to 60 ° C) intermittent operation; 32 to 122 ° F (0 to 50 ° C) continuous operation Pendant Without Heater: 32 to 140 ° F (0 to 60 ° C) absolute maximum operating temperature; 32 to 122 ° ...

  • Pelco C2429M - page 16

    16 Pelco Installation Manual C2429M (3/01) REVISION HISTOR Y Manual # Date Comments C2429M 3/01 Original version. P elco, the P elco logo, Camclosure, Esprit, Gene x, Legacy , and Spectra are registered trademarks of P elco. Endura and ExSite are trademarks of P elco. Loctite is a registered trademark of Loctite Corporation. ©Copyright 2000, P elc ...

Manufacturer Pelco Category Wheelchair

Documents that we receive from a manufacturer of a Pelco C2429M can be divided into several groups. They are, among others:
- Pelco technical drawings
- C2429M manuals
- Pelco product data sheets
- information booklets
- or energy labels Pelco C2429M
All of them are important, but the most important information from the point of view of use of the device are in the user manual Pelco C2429M.

A group of documents referred to as user manuals is also divided into more specific types, such as: Installation manuals Pelco C2429M, service manual, brief instructions and user manuals Pelco C2429M. Depending on your needs, you should look for the document you need. In our website you can view the most popular manual of the product Pelco C2429M.

Similar manuals

A complete manual for the device Pelco C2429M, how should it look like?
A manual, also referred to as a user manual, or simply "instructions" is a technical document designed to assist in the use Pelco C2429M by users. Manuals are usually written by a technical writer, but in a language understandable to all users of Pelco C2429M.

A complete Pelco manual, should contain several basic components. Some of them are less important, such as: cover / title page or copyright page. However, the remaining part should provide us with information that is important from the point of view of the user.

1. Preface and tips on how to use the manual Pelco C2429M - At the beginning of each manual we should find clues about how to use the guidelines. It should include information about the location of the Contents of the Pelco C2429M, FAQ or common problems, i.e. places that are most often searched by users in each manual
2. Contents - index of all tips concerning the Pelco C2429M, that we can find in the current document
3. Tips how to use the basic functions of the device Pelco C2429M - which should help us in our first steps of using Pelco C2429M
4. Troubleshooting - systematic sequence of activities that will help us diagnose and subsequently solve the most important problems with Pelco C2429M
5. FAQ - Frequently Asked Questions
6. Contact detailsInformation about where to look for contact to the manufacturer/service of Pelco C2429M in a specific country, if it was not possible to solve the problem on our own.

Do you have a question concerning Pelco C2429M?

Use the form below

If you did not solve your problem by using a manual Pelco C2429M, ask a question using the form below. If a user had a similar problem with Pelco C2429M it is likely that he will want to share the way to solve it.

Copy the text from the picture

Captcha
New picture

Comments (0)