English dropdown-ico

Manual Winegard MV-4002

12 pages 0.76 mb
Download

Go to site of 12

Summary
  • Winegard MV-4002 - page 1

    1 Movin’ View TM Digital Satellite Mobile Antenna for Two Receivers for Use While Stationary or In-Motion Model MV-4002 Made in the U.S.A. U.S. Patent Nos. 6,023,247; 6,188,300 Winegard Company • 3000 Kirkwood St. • Burlington, IA 52601-2000 319/754-0600 • FAX 319/754-0787 • www.winegard.com Printed in U.S.A. © Winegard Company 2005 2452 ...

  • Winegard MV-4002 - page 2

    2 DIRECTV ® is an official trademark of DIRECTV , a unit of GM Hughes Electronics Corporation. DISH Network TM is an official trademark of EchoStar Communications Corporaton. DIGITAL BROADCAST SYSTEM SATELLITE(S) Introduction Congratulations! Y ou have purchased one of Winegard’s latest developments in the mobile satellite reception product line ...

  • Winegard MV-4002 - page 3

    3 2. Determine which programming you will be using. This will determine how you set your switches. For DISH Network set switches to 1 19° . For ExpressV u ® , set switches to 091° . NOTICE! This model is PRESET for DIRECTV ® receivers. If you have a DISH Network ® or ExpressVu ® (Canada) receiver, you must change the numbered switches inside ...

  • Winegard MV-4002 - page 4

    4 Operation 1. T urn on receiver and television set. The MV -4002 must be connected to a receiver that is plugged into 120 V AC. 2. V erify that you are getting the receiver ’ s menu screens on the television. These screens are avail- able with or without the dish finding the signal. 3. T urn the power switch on for the MV -4002. The dish should ...

  • Winegard MV-4002 - page 5

    5 To toggle between satellites when subscribing to multi-satellite programming— While in Sleep Mode , the MV -4002 will toggle be- tween the primary and seconday satellites for either DISH Network or DIRECTV . Both have program- ming on more than one satelite. When a channel is selected on the remote control and is not on the satellite currently ...

  • Winegard MV-4002 - page 6

    6 1 . Open box and remove packing material. 2. Lift unit out of box vertically . Do not turn box and “roll” out, or turn upside down to remove. 1 large yellow spade connector 2 small red spade connectors All required screws and washers 1 base with electronics, dish, single LNBF 30’ power cable and 30’ coaxial cable ! USE 2 PEOPLE when remov ...

  • Winegard MV-4002 - page 7

    7 Base Diagram FIGURE 2 CONTROL BOX (DETAIL BELOW) COAX CABLE AT CONTROL BOX CONTROL BOX TO LNBF AZ MOTOR GPS ANTENNA FOOT MUST BE PARALLEL TO THE CENTER LINE OF THE VEHICLE LNBF VOLTAGE +12VDC POWER CABLE REFLECTOR SWITCH LOCATION (SIDE OF BOX, SEE PAGE 3) EL MOTOR CONTROL BOX DETAIL LNBF RECEIVER P4 ELEV A TION P3 AZIMUTH (#1 represents Switch DO ...

  • Winegard MV-4002 - page 8

    8 Installation IMPORT ANT! Do not install this system in the rain, or under any wet conditions . Mois- ture may affect electronics and void your warranty! 1. For best performance and to reduce signal ac- quisition time, park vehicle on a level surface; level the R V . 2. Select a level spot on your roof for installation. Using the chart, determine ...

  • Winegard MV-4002 - page 9

    9 1. Decide the best location for the cables to enter the vehicle, and the location of the switch and receiver (see “Installing the switch and receiver”on page 10). Drill a 1/2” hole in the roof, push wires inside. Make proper connections. Y ou must have filtered +12 VDC power source . 2. Place cable-entry plate over hole and cables. Screw in ...

  • Winegard MV-4002 - page 10

    10 Installation • Wiring Initializing — 1. Be sure vehicle is in a location free of all obstruc- tions and with a clear view of the southern sky . 2. DO NOT MOVE VEHICLE during the first initialization. Power up unit, turn on receiver . FOR THE FIRST TIME ONL Y , the unit may take up to 10 minutes to initially find the satellite signal. The GPS ...

  • Winegard MV-4002 - page 11

    11 Troubleshooting The MV -4002 does not attempt to find a satellite or it never moves. The MV -4002 turns on and moves for a few seconds then stops and never moves again. The dish never stops on any of the signals that it sees. 1. Check your Power switch to verify that it is in the ON position. 2. Make sure that the receiver is plugged in and the ...

  • Winegard MV-4002 - page 12

    12 Winegard Company • 3000 Kirkwood S treet • Burlington, IA 52601 • 319/754-0600 Fax 319/754-0787 • www .winegard.com Printed in U.S.A. © 2005 Winegard Company 2452062 Rev . 5/05 TWO YEAR LIMITED WARRANTY Winegard Company warrants this Winegard product (excluding receiver) against any defects in materials or workmanship within two (2) yea ...

Manufacturer Winegard Category TV Antenna

Documents that we receive from a manufacturer of a Winegard MV-4002 can be divided into several groups. They are, among others:
- Winegard technical drawings
- MV-4002 manuals
- Winegard product data sheets
- information booklets
- or energy labels Winegard MV-4002
All of them are important, but the most important information from the point of view of use of the device are in the user manual Winegard MV-4002.

A group of documents referred to as user manuals is also divided into more specific types, such as: Installation manuals Winegard MV-4002, service manual, brief instructions and user manuals Winegard MV-4002. Depending on your needs, you should look for the document you need. In our website you can view the most popular manual of the product Winegard MV-4002.

Similar manuals

A complete manual for the device Winegard MV-4002, how should it look like?
A manual, also referred to as a user manual, or simply "instructions" is a technical document designed to assist in the use Winegard MV-4002 by users. Manuals are usually written by a technical writer, but in a language understandable to all users of Winegard MV-4002.

A complete Winegard manual, should contain several basic components. Some of them are less important, such as: cover / title page or copyright page. However, the remaining part should provide us with information that is important from the point of view of the user.

1. Preface and tips on how to use the manual Winegard MV-4002 - At the beginning of each manual we should find clues about how to use the guidelines. It should include information about the location of the Contents of the Winegard MV-4002, FAQ or common problems, i.e. places that are most often searched by users in each manual
2. Contents - index of all tips concerning the Winegard MV-4002, that we can find in the current document
3. Tips how to use the basic functions of the device Winegard MV-4002 - which should help us in our first steps of using Winegard MV-4002
4. Troubleshooting - systematic sequence of activities that will help us diagnose and subsequently solve the most important problems with Winegard MV-4002
5. FAQ - Frequently Asked Questions
6. Contact detailsInformation about where to look for contact to the manufacturer/service of Winegard MV-4002 in a specific country, if it was not possible to solve the problem on our own.

Do you have a question concerning Winegard MV-4002?

Use the form below

If you did not solve your problem by using a manual Winegard MV-4002, ask a question using the form below. If a user had a similar problem with Winegard MV-4002 it is likely that he will want to share the way to solve it.

Copy the text from the picture

Captcha
New picture

Comments (0)