Manual Stovax PR0731

26 pages 0.83 mb
Download

Go to site of 26

Summary
  • Stovax PR0731 - page 1

    Linea Balanced Flue Convector Fire Instructions for Use, Installation and Servicing For use in GB, IE (Great Britain and Eire) PR0731 Issue 9 (September 2007) IMPORTANT Do not attempt to burn rubbish in this appliance. This appliance must only be operated with the glass door secured firmly in position. The front casing of this appliance will become ...

  • Stovax PR0731 - page 2

    2 CONTENTS COVERING THE FOLLOWING MODELS 8651EC P8651EC PAGE APPLIANCE COMMISSIONING CHECKLIST 3 USER INSTRUCTIONS 4 INSTALLATION INSTRUCTIONS 8 Technical Specifications 8 Site Requirements 9 Installation 12 Commissioning 15 SERVICING INSTRUCTIONS 16 Servicing Requirements 16 Fault Finding 16 How to replace parts 18 Basic spare parts list 24 Servic ...

  • Stovax PR0731 - page 3

    3 FLUE CHECK PASS FAIL 1. Flue is correct for appliance 2. Flue flow test N/A 3. Spillage test N/A GAS CHECK 1. Gas soundness & let by test 2. Standing pressure test mb 3. Appliance working pressure (on High Setting) mb NB All other gas appliances must be operating on full 4. Gas rate m 3 /h 5. Does ventilation meet appliance requirements N/A 6 ...

  • Stovax PR0731 - page 4

    4 USER INSTRUCTIONS 1. GENERAL 1.1 A competent person must carry out installation and servicing. 1.2 In all correspondence, please quote the appliance type and serial number, which can be found on the data badge located on a plate under the control valve. 1.3 Ensure that curtains are not positioned above the appliance and there is at least 300mm be ...

  • Stovax PR0731 - page 5

    5 Turning the Linea Off • Pressthe Offbutton toextinguish thepilot 2.3 TEMP MODE The display shows the current room temperature.  Toincrease ordecrease thefire’s output:  • Pressthe SETbutton toselect eitherthe DAY TEMP  or the NIGHT TEMP mode by briefly ...

  • Stovax PR0731 - page 6

    EMERGENCY SHUT OFF If the batteries fail during use of the fire:  • Movethe emergencyshut offswitch tothe OFF(O) position This emergency switch is located behind the slotted lower panel on the underside of the appliance: 3 AR1341 Underside of appliance Access to switch  • Usea ballpoint pen? ...

  • Stovax PR0731 - page 7

    7 USER INSTRUCTION 8. INSTALLATION DETAILS 8.1 To assist in any future correspondence, your installer should have completed the commissioning sheet at the front of this book, this records the essential installation details of the appliance. In all correspondence always quote the Model number and Serial number. 9. HOT SURFACES 9.1 Parts of this appl ...

  • Stovax PR0731 - page 8

    8 INSTALLATION INSTRUCTIONS TECHNICAL SPECIFICATION COVERING THE FOLLOWING MODELS 8651EC P8651EC Efficiency Class I Flue Outlet Size 100 Ø / 152mm Ø Gas Inlet Connection Size 8mm Ø  WallThickness -Minimum =100mm (4")Maximum = 500mm  LineaReplacement Batteries- 4x 'AA' Cells  ...

  • Stovax PR0731 - page 9

    9 INSTALLATION INSTRUCTIONS SITE REQUIREMENTS 1. FLUE AND CHIMNEY REQUIREMENTS NOTE: This appliance can only be installed in conjunction with the flue supplied. 1.1 The flue must be sited in accordance with BS5440: Part 1 (latest edition). See diagram 1. 1.2 Any terminal which is less than 2 metres above any access (level ground, balcony or above a ...

  • Stovax PR0731 - page 10

    10 TIMBER FRAMED BUILDINGS 1.5 It will be necessary to provide additional clearance when the flue passes through a wall containing any combustible materials so as to prevent a fire hazard. 1.6 The hole through which the flue will pass, must have a steel sleeve which is positioned so that an air gap of at least 25mm is maintained between the outer s ...

  • Stovax PR0731 - page 11

    11 INSTALLATION INSTRUCTIONS SITE REQUIREMENTS 4.4 All combustible materials must be removed from behind the appliance. See diagram 6. 4.5 The Linea may be mounted at any height, however, there must be a minimum clearance of 150mm (6") between the bottom edge of the appliance and the floor. To achieve this, the minimum flue height for each fro ...

  • Stovax PR0731 - page 12

    12 IMPORTANT: BEFORE THE APPLIANCE CAN BE OPERATED THE REMOTE HANDSET MUST BE TUNED TO THECONTROL BOXSITUATED UNDER THEAPPLIANCE. IF THIS PROCEDURE IS OMITTED THE APPLIANCE CAN ONLY BE LIT USING THE TOUCH PAD, SEE USER INSTRUCTIONS, 2B TOUCH PAD CONTROL. ENSURE THAT THE APPLIANCE IS CORRECTLY ADJUSTED FOR THE GAS TYPE AND CATEG ...

  • Stovax PR0731 - page 13

    2.7 The flue can now be cut to size. Measure the thickness of the wall, then deduct 12mm. This is the length required when measuring from the line on the flue label. See diagram 3. AR0630 3 2.8 Attach the flue to the appliance and seal using the aluminium tape. See diagram 4. 4 AR1335 2.9 Place the sealing ring over the flue and position it up agai ...

  • Stovax PR0731 - page 14

    14 INSTALLATION INSTRUCTIONS INSTALLATION  • automaticallyregulates theroom temperatureduring the set periods TOUCH PAD CONTROL 10 AR1885  • Pressthe ON-OFFbutton tolight theappliance, (upto   30 seconds)  • Pressthe UPbutton toincrease theflame ...

  • Stovax PR0731 - page 15

    15 INSTALLATION INSTRUCTIONS COMMISSIONING Each of the four switches can be set to either one of two positions, in any combination.  Tore-code thehandset:  • Changethe combinationof howthe DIPswitchesare set, Diagram 12 12 AR1936 Once the handset has a new code the control box needs to be reprogramm ...

  • Stovax PR0731 - page 16

    REPLACE BATTERIES BEFORE ATTEMPTING TO RECTIFY ANY FAULTS. IF THE FIRE DOES NOT WORK, BUT HAS WORKED IN THE PAST: • CHECK THEEMERGENCY SHUTOFF SWITCH  ON THE BOTTOM OF THE APPLIANCE IS SWITCHED ON, SEE USER SECTION, PAGE 6 16 SERVICING INSTRUCTIONS SERVICING / FAULT FINDING CHARTS IGNITION FUNCTIONAL CHECK 1 PILOTWIL ...

  • Stovax PR0731 - page 17

    17 SERVICING INSTRUCTIONS FAULT FINDING CHARTS IGNITION FUNCTIONAL CHECK 2 NOSPARK Ensure there is no debris around the pilot assembly, (e.g. soot etc.) which could short the spark, clean the area. Consult the users instructions, retry. From Ignition Fault Finding Chart 1 Is the gap between electrode and thermocouple 4.0mm? Has ignition lead bec ...

  • Stovax PR0731 - page 18

    18 2.4 Raise the burner from the slot in the bracket, pull the burner forward and slide to the left to clear the injector. Take care not to lose the spring. 2.5 Replace in reverse order ensuring the spring is located over the stud on the burner and the tab on the bracket. 3. PILOT UNIT The main frame, glass frame and main burner need only be remove ...

  • Stovax PR0731 - page 19

    19 4.7 Reassemble in reverse order and replace the pilot gasket with a new one. 4.8 Check for gas leaks. 5. PILOT INJECTOR 5.1 To gain access to the pilot pipe, it is easier if the thermocouple is removed first. To do this follow section 7. 5.2 Undo the pilot pipe from the gas valve and from under side of the pilot burner. See diagram 5 arrow B. 5. ...

  • Stovax PR0731 - page 20

    20 8 AR1994 C 7.3 Undo the thermocouple nut in the back of the pilot burner by half a turn. This will release the thermocouple. 7.4 Whenreplacing thethermocouple intothe pilotburner ensure the component is pushed fully into the hole. There is a stop on the thermocouple to set the height. 7.5 Lock the retaining nut just en ...

  • Stovax PR0731 - page 21

    appliance. Note the orientation of the injector on the pipe. 10.7 Reassemble in reverse order and check for gas leaks. 11. CONTROL BOX 11.1 Remove the lower panel, Diagram 6 11.2 Pr ess on/off swit ch retaining cli ps in and pop p ut the switch. Turn the switch to pass it through the retaining bracket. 11.3 Remove the two screws holding the control ...

  • Stovax PR0731 - page 22

    22 SERVICING INSTRUCTIONS REPLACING PARTS 12. GAS VALVE 12.1 To change the gas valve:  • Disconnectthe inletpipe  • Disconnectthe feedpipe  • Disconnectthe pilotpipe  • Disconnectthe thermocouple,thermo currentwires and the interrupter block  • Removethe? ...

  • Stovax PR0731 - page 23

    23 SERVICING INSTRUCTIONS REPLACING PARTS 19 AR1345 14.7 Disconnect the touch pad from the harness (DESIGNIO FRAME ONLY) 14.8 Disconnect the ignition lead from the electrode. 14.9 Remove the thermocouple. See diagram 20 arrow C. 14.10 Remove the pilot pipe and ensure the pilot injector is kept safe, Diagram 20, Arrow D 20 AR1994 D C F E F 14.11 Rem ...

  • Stovax PR0731 - page 24

    24 SERVICING INSTRUCTIONS REPLACING PARTS 15. SHORT SPARES LIST Component NG LPG Propane Butane Burner Unit GC0104 GC0105 GC0106 Main Injector IN0053 IN0052 Pilot Injector PI0069 PI0070 Thermocouple PI0071 PI0072 Control Box GC0129 Gas Valve GC0123 Mag Unit GC0092 IGN Lead GC0125 Spark Electrode PI10073 Ceramic Rear Panel CE0474 Window Frame Assemb ...

  • Stovax PR0731 - page 25

    25 SERVICE RECORDS 1ST SERVICE Date of Service:........................................................................... Next Service Due:....................................................................... Signed:........................................................................................ Dealer's Stamp/CORGI Registration Num ...

  • Stovax PR0731 - page 26

    Gazco Limited, Osprey Road, Sowton Industrial Estate, Exeter, Devon, England EX2 7JG Tel: (01392) 261999 Fax: (01392) 444148 E-mail: info@gazco.com A member of the Stovax Group ...

Manufacturer Stovax Category Electric Heater

Documents that we receive from a manufacturer of a Stovax PR0731 can be divided into several groups. They are, among others:
- Stovax technical drawings
- PR0731 manuals
- Stovax product data sheets
- information booklets
- or energy labels Stovax PR0731
All of them are important, but the most important information from the point of view of use of the device are in the user manual Stovax PR0731.

A group of documents referred to as user manuals is also divided into more specific types, such as: Installation manuals Stovax PR0731, service manual, brief instructions and user manuals Stovax PR0731. Depending on your needs, you should look for the document you need. In our website you can view the most popular manual of the product Stovax PR0731.

A complete manual for the device Stovax PR0731, how should it look like?
A manual, also referred to as a user manual, or simply "instructions" is a technical document designed to assist in the use Stovax PR0731 by users. Manuals are usually written by a technical writer, but in a language understandable to all users of Stovax PR0731.

A complete Stovax manual, should contain several basic components. Some of them are less important, such as: cover / title page or copyright page. However, the remaining part should provide us with information that is important from the point of view of the user.

1. Preface and tips on how to use the manual Stovax PR0731 - At the beginning of each manual we should find clues about how to use the guidelines. It should include information about the location of the Contents of the Stovax PR0731, FAQ or common problems, i.e. places that are most often searched by users in each manual
2. Contents - index of all tips concerning the Stovax PR0731, that we can find in the current document
3. Tips how to use the basic functions of the device Stovax PR0731 - which should help us in our first steps of using Stovax PR0731
4. Troubleshooting - systematic sequence of activities that will help us diagnose and subsequently solve the most important problems with Stovax PR0731
5. FAQ - Frequently Asked Questions
6. Contact detailsInformation about where to look for contact to the manufacturer/service of Stovax PR0731 in a specific country, if it was not possible to solve the problem on our own.

Do you have a question concerning Stovax PR0731?

Use the form below

If you did not solve your problem by using a manual Stovax PR0731, ask a question using the form below. If a user had a similar problem with Stovax PR0731 it is likely that he will want to share the way to solve it.

Copy the text from the picture

Comments (0)