English dropdown-ico

Manual Jonsered CS 2121 EL

16 pages 0.7 mb
Download

Go to site of 16

Summary
  • Jonsered CS 2121 EL - page 1

    GB Operator’ s Manual 115 02 33-26 ...

  • Jonsered CS 2121 EL - page 2

    ENGLISH 2 SYMBOLS USED IN OPERA T OR’S MANU AL: Do not use a coiled extension cord. Minimum wire cross-section: 1,5 mm ² Maximum cable length: 30 m V oltage: 230 V CAUTION! Chain saws are danger ous! Careless or impr oper use can result in sever e or fatal injury . Noise emission to the environment according to the European Community’ s Direct ...

  • Jonsered CS 2121 EL - page 3

    ENGLISH 3 Symbols 2 Important! Read before using chain saw 2 Contents 3 EC declaration of conformity 3 T echnical speci fi cations 4 Chain saw parts 5 Safe use 5 Starting and stopping 7 Daily inspection and maintenance 7 Kickback prevention 8 Chain brake with kickback guard 9 - Kickback guard inspection 9 - Manual chain brake function check 9 - In ...

  • Jonsered CS 2121 EL - page 4

    ENGLISH 4 Motor 1700 2000 Rated voltage V AC 220-240 230 Rated output W 1700 2000 Frequency Hz 50/60 50 Slip clutch Y es Y es Electronic start contr ol - Y es Electronic speed contr ol - Y es Electronic overload pr otection - Y es W eight Without guide bar and chain kg 4,4 4,4 With 14” guide bar and chain kg 5,1 5,1 Chain lubrication Oil tank vol ...

  • Jonsered CS 2121 EL - page 5

    ENGLISH 5 1. Rear handle 2. Power trigger lockout 3. Front handle 4. Serial No. plate 5. Chain tensioner 6. Chain oil reservoir 7. Chain oil level 8. V entilation slots 9. Power cable 10. Power trigger 11. Chain 12. Guide bar 13. Chain brake release button 14. Kickback guard 15. Chain drive cover 16. Right hand guard - pr otects right hand in case ...

  • Jonsered CS 2121 EL - page 6

    ENGLISH 6 • See to it that others keep their distance as long as the chain is in motion. Keep onlookers, children and animals away from the work ar ea. Do not let inexperienced persons handle the chainsaw or power cable. • Keep work ar ea clear and well-lighted. Do not operate chain saw under wet or humid conditions, around water or in rain or ...

  • Jonsered CS 2121 EL - page 7

    ENGLISH 7 D AIL Y INSPECTION AND MAINTENANCE CAUTION! Always disconnect the power before cleaning or performing maintenance. Here ar e a few general instructions for maintaining your hand- saw . If you are in doubt on any of these points, contact your service dealer . 1. Inspect power cable and plug for defects. A damaged power cable or plug must b ...

  • Jonsered CS 2121 EL - page 8

    ENGLISH 8 • T ake extreme car e when cutting with the top chain (on the underside of a log). The force of the chain action pushes the saw backwards, and if the operator does not maintain fi rm control, the kickback danger zone may move far enough back into the kerf to produce a kickback. Cutting with the bottom chain (on the top side of the log) ...

  • Jonsered CS 2121 EL - page 9

    ENGLISH 9 • The chain brake may be activated manually or by the force of inertia depending on the strength of the kickback and the position of the saw in relation to the object which made contact with the kickback danger zone. - If the kickback is suffi ciently violent and the left hand is too far from the kickback guar d, the chain brake is act ...

  • Jonsered CS 2121 EL - page 10

    ENGLISH 10 6. Replace the chain drive cover and screw the mounting nut hand tight. 7. T ension the chain by screwing the tensioning screw clockwise using the screwdriver tip on the combination tool. 8. Tighten chain fi rmly but not so hard that it does not turn easily by hand force. Push the button to r elease the chain brake. T o avoid contact be ...

  • Jonsered CS 2121 EL - page 11

    ENGLISH 11 • Ensure that the cutter teeth are always correctly sharpened! Follow our instructions and use the recommended fi ling guide. A chain which is damaged or improperly maintained incr eases the risk of accident. • Maintain the correct depth-gauge height. W orn depth gauges increase the risk of kickback. • Keep chain properly tensione ...

  • Jonsered CS 2121 EL - page 12

    ENGLISH 12 Checking chain wear • Inspect chain every day for: - Visible cracks in rivets or links - Stiffness - Abnormal wear in rivets or links - Min. 3 mm (1/8”) horizontal cutter length - Any deviation on any of these points indicates a worn chain which must be discarded - Check the guide bar’ s oil passage and clean if necessary . - Check ...

  • Jonsered CS 2121 EL - page 13

    ENGLISH 13 See «T echnical Specifi cations» for the details which apply to your chain. It is very diffi cult to fi le a chain saw correctly with- out the proper aids. W e recommend the use of a fi le guide to ensure maximum cutting effi ciency with the least tendency to kickback. Filing cutters To fi le cutters correctly , a ROUND FILE and ...

  • Jonsered CS 2121 EL - page 14

    ENGLISH 14 • Cutting a log supported at one end. The log is more than likely to splinter if cut straight through fr om the top down. - Make an initial cut from below (appr ox. 1/3 of the diameter) - Finish the cut from above. • Cutting a log supported at both ends. The saw is more than likely to jam in the kerf if cut straight through fr om abo ...

  • Jonsered CS 2121 EL - page 15

    ENGLISH 15 Danger zone A danger zone surrounds the tr ee to a distance of 2 1/2 times the height of the tree. See to it that no one is standing within this zone while you are felling the tree. Felling direction When felling a tree, one always aims to place it wher e neither objects nor diffi cult terrain will hamper limbing and cutting. Unobstruct ...

  • Jonsered CS 2121 EL - page 16

    ´®z+R7@¶6T¨ ´®z+R7@¶6T¨ 115 02 33-26 www .jonsered.com T røskenveien 36 P .O.B. 10 N - 1708 Sarpsbor g Norway 2006W11 ...

Manufacturer Jonsered Category Chainsaw

Documents that we receive from a manufacturer of a Jonsered CS 2121 EL can be divided into several groups. They are, among others:
- Jonsered technical drawings
- CS 2121 EL manuals
- Jonsered product data sheets
- information booklets
- or energy labels Jonsered CS 2121 EL
All of them are important, but the most important information from the point of view of use of the device are in the user manual Jonsered CS 2121 EL.

A group of documents referred to as user manuals is also divided into more specific types, such as: Installation manuals Jonsered CS 2121 EL, service manual, brief instructions and user manuals Jonsered CS 2121 EL. Depending on your needs, you should look for the document you need. In our website you can view the most popular manual of the product Jonsered CS 2121 EL.

Similar manuals

A complete manual for the device Jonsered CS 2121 EL, how should it look like?
A manual, also referred to as a user manual, or simply "instructions" is a technical document designed to assist in the use Jonsered CS 2121 EL by users. Manuals are usually written by a technical writer, but in a language understandable to all users of Jonsered CS 2121 EL.

A complete Jonsered manual, should contain several basic components. Some of them are less important, such as: cover / title page or copyright page. However, the remaining part should provide us with information that is important from the point of view of the user.

1. Preface and tips on how to use the manual Jonsered CS 2121 EL - At the beginning of each manual we should find clues about how to use the guidelines. It should include information about the location of the Contents of the Jonsered CS 2121 EL, FAQ or common problems, i.e. places that are most often searched by users in each manual
2. Contents - index of all tips concerning the Jonsered CS 2121 EL, that we can find in the current document
3. Tips how to use the basic functions of the device Jonsered CS 2121 EL - which should help us in our first steps of using Jonsered CS 2121 EL
4. Troubleshooting - systematic sequence of activities that will help us diagnose and subsequently solve the most important problems with Jonsered CS 2121 EL
5. FAQ - Frequently Asked Questions
6. Contact detailsInformation about where to look for contact to the manufacturer/service of Jonsered CS 2121 EL in a specific country, if it was not possible to solve the problem on our own.

Do you have a question concerning Jonsered CS 2121 EL?

Use the form below

If you did not solve your problem by using a manual Jonsered CS 2121 EL, ask a question using the form below. If a user had a similar problem with Jonsered CS 2121 EL it is likely that he will want to share the way to solve it.

Copy the text from the picture

Captcha
New picture

Comments (0)