-
Orion Car Audio HCCA-D600 - page 1
HCCA-D600 HCCA-D600 ...
-
Orion Car Audio HCCA-D600 - page 2
CONTENTS Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .2 What’ s in the Box . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 Practice Safe Sound™ . . . . . . . . . . . . . . . . . . . . . . ...
-
Orion Car Audio HCCA-D600 - page 3
INTRODUCTION Thank you for your purchase of Orion's HCCA-D600 power amplifier . Each Orion amplifier is designed to be the leader in its class offering the most power , advanced features, and extreme ease of use. In high-end sound systems or high SPL systems, Orion amplifiers will give you years of trouble-free performance. ● HCCA-D600 - 600 ...
-
Orion Car Audio HCCA-D600 - page 4
RECORD YOUR SERIAL NUMBER AND DA TE T o ensure your warranty (see back cover), please record the following information regard- ing your new amplifier . Model: __________________________________________________ Serial Number: __________________________________________________ Date of Purchase: __________________________________________________ Purch ...
-
Orion Car Audio HCCA-D600 - page 5
END P ANEL LA YOUTS 1. RCA Input - accepts RCA input from a head unit, preamplifier , or equalizer . 2. RCA Line Output - provides easy connection to additional amplifiers. 3. Master/Slave Switch - controls whether the amplifier is a slave or master when connected in combined amplifier configurations. (Refer to the Line Output Configurations sectio ...
-
Orion Car Audio HCCA-D600 - page 6
5 © 2005 Directed Electr onics—all rights reserved tem battery . WARNING: Always protect this power wire by installing a fuse or circuit breaker of the appropriate size within 12 inches of the battery terminal connection. 3. REM - this terminal turns on the amplifier when (+) 12 volt is applied. Connect it to the remote turn on lead of the head ...
-
Orion Car Audio HCCA-D600 - page 7
6 © 2005 Directed Electr onics—all rights reserved SPECIFICA TIONS 1. Continuous 4 W load 20Hz to 250Hz, < 1% THD, with input voltage at 14.4VDC. 2. Continuous 1 W load 20Hz to 250Hz, < 1% THD, with input voltage at 14.4VDC. Amplifier Section HCCA-D600 Power Output 4 W (Watts) 1 150 x 1 Power Output 2 W (Watts) 2 200 x 1 Power Output 1 W ( ...
-
Orion Car Audio HCCA-D600 - page 8
7 © 2005 Directed Electr onics—all rights reserved AMPLIFIER SETTINGS Signal Input and Output Configurations The input section of the amplifier consists of a phase switch that sets the output configura- tion, gain controls, and RCA inputs. The input section makes it easy to adapt this amplifier to most system configurations. Input Gain The Orion ...
-
Orion Car Audio HCCA-D600 - page 9
8 © 2005 Directed Electr onics—all rights reserved WARNING! DO NOT set crossover frequencies lower than the speakers recommended operating range. This can cause driver failure that is not covered by the man- ufacturer's warranty . Low-Pass Crossover The low-pass crossover adjusts the upper crossover of the filter and is continuously variabl ...
-
Orion Car Audio HCCA-D600 - page 10
9 © 2005 Directed Electr onics—all rights reserved Infinite Baffle Example High-Pass Set at 30Hz By removing low frequency signal that the woofer cannot produce, the woofer can play its capable range louder . The first example is an infinite baffle situation. The left graph displays the frequency response of a 12-inch woofer in an infinite baffl ...
-
Orion Car Audio HCCA-D600 - page 11
10 © 2005 Directed Electr onics—all rights reserved Sealed Example High-Pass Set at 20Hz This sealed example is the same 12-inch woofer in the recommended sealed enclosure. Up to 6 dB of boost is capable if 20 Hz was used. With +6dB of boost, the woofer has more out- put down to 15 Hz. Sealed Example High-Pass Set at 30Hz In this example, the fr ...
-
Orion Car Audio HCCA-D600 - page 12
11 © 2005 Directed Electr onics—all rights reserved Remote Gain Operation NOTE: Do not use the Remote Gain control when you have an expanded system installed (see Line Ouput Configurations ). The Slave amplifier(s) gain will not be controlled. The remote gain port provides easy remote access to the internal gain structure of the HCCA power ampli ...
-
Orion Car Audio HCCA-D600 - page 13
12 © 2005 Directed Electr onics—all rights reserved Bridging For bridging into a single speaker load, this amplifier has the ability to be bridged with another amplifier (must be the same model). T o do this you must utilize the MASTER/SLAVE and PHASE switch settings. On the master amplifier , set the switch setting to MASTER. The signal is then ...
-
Orion Car Audio HCCA-D600 - page 14
13 © 2005 Directed Electr onics—all rights reserved NOTE: The wiring connections to the power , remote and speaker terminals should be accomplished before the amplifier is mounted. NOTE: Mounting amplifiers upside down is not recommended and may cause premature thermal shutdown. WARNING! Do not mount any amplifier in the engine compartment. Ampl ...
-
Orion Car Audio HCCA-D600 - page 15
14 © 2005 Directed Electr onics—all rights reserved Orion amplifiers generate a certain amount of heat as part of normal operation. Be sure the area around the amplifier is unobstructed to allow adequate air circulation. Remember , beach blankets, last week's laundry , school books and homework papers located on top of the amplifier do not ...
-
Orion Car Audio HCCA-D600 - page 16
15 © 2005 Directed Electr onics—all rights reserved Controls and Speaker Connections sections of this guide for correct wiring instructions. Step 9 Mount the amplifier . Make sure the amplifier is mounted on a flat surface. If this is not possible, do not over tighten the screws so that the chassis of the amplifier is twisted or bent. Step 10 Re ...
-
Orion Car Audio HCCA-D600 - page 17
16 © 2005 Directed Electr onics—all rights reserved Connections and the T roubleshooting Tips sections of this manual to solve your installation problems. Step 6 Check to make sure the output for each channel is correct. If the active crossovers are used, check to make sure that each output is correct from the amplifier . When using active cross ...
-
Orion Car Audio HCCA-D600 - page 18
17 © 2005 Directed Electr onics—all rights reserved T roubleshooting Tips Symptom Probable Cause Action T o T ake No output Low or no remote turn-on Check remote turn-on voltage at voltage amplifier and repair as needed. Fuse blown Check power wire's integrity and check for speaker shorts. Fix as needed and replace fuse. Power wires not con ...
-
Orion Car Audio HCCA-D600 - page 19
18 © 2005 Directed Electr onics—all rights reserved Symptom Probable Cause Action T o T ake Distorted output Internal crossover not set Readjust crossovers. Refer to the properly for speakers Internal Crossover Configuration section of this guide for detailed instructions. Speakers are blown Check system with known work ing speakers and fix or r ...
-
Orion Car Audio HCCA-D600 - page 20
NOTES ____________________________________________________ ____________________________________________________ ____________________________________________________ ____________________________________________________ ____________________________________________________ ____________________________________________________ __________________________ ...
-
Orion Car Audio HCCA-D600 - page 21
W arranty LIMITED TWO YEAR CONSUMER WARRANTY : Directed Electronics promises to the original purchaser , to replace this product should it prove to be defective in workmanship or material under normal use, for a period of two years from the date of purchase by the dealer as indicated by the date code marking of the product PROVIDED the product was ...
Do you have a question concerning Orion Car Audio HCCA-D600?
Use the form below
If you did not solve your problem by using a manual Orion Car Audio HCCA-D600, ask a question using the form below. If a user had a similar problem with Orion Car Audio HCCA-D600 it is likely that he will want to share the way to solve it.