Manual FMI GL36STP

20 pages 1.38 mb
Download

Go to site of 20

Summary
  • FMI GL36STP - page 1

    For more information, visit www .fmiproducts.com NA TURAL GAS MODELS (V)GL36ST AND (V)GL36STE PROP ANE/LP GAS MODELS (V)GL36STP AND (V)GL36STEP 2-SIDED (SEE-THROUGH), VENTED DECORA TIVE GAS APPLIANCE OWNER’S OPERA TION AND INST ALLA TION MANU AL FOR YOUR SAFETY — Do not store or use gasoline or any other ammable ...

  • FMI GL36STP - page 2

    www .fmiproducts.com 55173H 2 W ARNING: Improper installation, adjustment, altera - tion,service ormaintenancecan causeinjury orprop - erty damage. Refer to this manual for correct installation and operational procedures. For assistance or addi- tional information consult a ...

  • FMI GL36STP - page 3

    www .fmiproducts.com 55173H 3 SAFETy INFORMA TION W ARNING: This product c o n t a i n s a n d / o r g e n e r a t e s chemicals known to the State of California to cause cancer or birth defects or other reproduc - tiveharm. IMPORTANT: Read this owner’s man ual care ful ly and compl ete ly bef ...

  • FMI GL36STP - page 4

    www .fmiproducts.com 55173H 4 11. Keep the area around your replace clear of combustible materials, gasoline and other ammable vapor and liquids. Do not run re- place where these are used or stored. Do not place items such as clothing or decorations on or around replace. 12. Do not use this replace to cook food or burn paper or other ...

  • FMI GL36STP - page 5

    www .fmiproducts.com 55173H 5 Figure 2 - T ypical T wo-Sided Fireplace Installation INTRODUCTION Models (V)GL36ST/P and (V)GL36STE/EP are decorative gas appliances that use a millivolt gas control and piezo pilot or an electronic gas control valve with an electronic ignition system respectively . These systems require a 6", B-type venting syst ...

  • FMI GL36STP - page 6

    www .fmiproducts.com 55173H 6 Figure 3 - Clearances from T op V iew Figure 4 - Clearances from Side V iew MANTEL CLEARANCES W oodwork, such as wood trims, mantel s and other comb ustib le materia ls, should not be placed within 7" of the opening of this appliance (see Figure 5). Combustible material above the fireplace projecting more than 1 1 ...

  • FMI GL36STP - page 7

    www .fmiproducts.com 55173H 7 FIREPLACE INST ALLA TION Continued FRAMING Construct framing using dimensions shown if Figures 6, 7 and 8. (Use the gure applicable to your application.) Figure 6 shows the framing dimensions prior to having the appliance in place. Once the unit has been tted, bring studs in agains t nailing anges located on t ...

  • FMI GL36STP - page 8

    www .fmiproducts.com 55173H 8 FIREPLACE INST ALLA TION Continued OPTIONAL OUTSIDE AIR KIT (MODEL AK-4) The installation of an outside air kit should be completed during the rough framing of the re- place due to the nature of it's location. Outside combustion air is accessed through a vented crawl space. CAUTION: Air inlet ducts must not? ...

  • FMI GL36STP - page 9

    www .fmiproducts.com 55173H 9 FIREPLACE INST ALLA TION Continued GAS SUPPL Y TESTING Note: This section is intended as a guide for quali - ed technicians installing gas to this appliance. CAUTION: Do not connect appliancebefore pressuretest - ing gas piping. Damage to gas valvemayresultandanunsafe con ...

  • FMI GL36STP - page 10

    www .fmiproducts.com 55173H 10 T o install: 1. Remove gas line cover plate from appliance’ s outer surround at the location to be used. 2. Remove insulation from inside the gas line conduit sleeve. 3. Run gas line through sleeve. 4. Prepare incoming black iron gas line with T eon tape or pipe joint compound. (Check local codes as to the use of ...

  • FMI GL36STP - page 11

    www .fmiproducts.com 55173H 11 FIREPLACE INST ALLA TION Continued MANTELS Mantels, combustible or non-combustible, may be constructed as long as proper clearances are observed (see Figure 2, page 6 and Clearances , page 6). PILOT ASSEMBL Y ADjUSTMENT The pilot assembly is factory preset for the proper ame height. Alteration to factory settings m ...

  • FMI GL36STP - page 12

    www .fmiproducts.com 55173H 12 OPTIONAL GLASS DOOR Glass doors are optional with this gas appliance (see Replacement Parts and Accessories , page 19). Installing Glass Door 1. Be sure top spring clip hole is aligned with hole in replace frame (see Figure 21). Fit glass door top pin into aligned holes. 2. Swing inner end of bottom clip out away f ...

  • FMI GL36STP - page 13

    www .fmiproducts.com 55173H 13 OPERA TING FIREPLACE MILLIV OL T MODELS FOR YOUR SAFETY READ BEFORE LIGHTING W ARNING: If you do not fol- low these instructions exactly , a re or explosion may result causing property damage, per - sonalinjuryorlossoflife. A. This appliance has a pilot which mu ...

  • FMI GL36STP - page 14

    www .fmiproducts.com 55173H 14 TO TURN OFF GAS TO APPLIANCE 1. T urn off the wall switch. 2. T urn off all electric power to the appliance if service is to be performed. 3. Remove control access panel. 4. Pus h in gas con tr ol knob and tur n clock wis e to “OFF”. Do not force. 5. Replace control access panel. OPERA TING FIREPLACE Continued Fig ...

  • FMI GL36STP - page 15

    www .fmiproducts.com 55173H 15 CLEANING AND MAINTENANCE W ARNING: Installation and repair should be done by a qualied service person. The applianceshouldbeinspected before each use and at least annuallyby a qualiedservice person. More frequent clean- in g ma y be ...

  • FMI GL36STP - page 16

    www .fmiproducts.com 55173H 16 DO NOT CONNECT N.C.SW HE A T LIMIT SWITCH TH/TP TP TH WA LL SWITCH (SUPPLIED) TO 120V THERMOPILE PILOT IGNI TO R O F F P I L O T O N PILO T SAFET Y WIRE MAIN GAS INCOMING SUPPL Y MILLIVOL T WIRING DIAGRAM STEP DOWN TRANSFORMER EV2 SUPPL Y INCOMING MAIN GAS EV1 TO GAS LINE BURNER 24V AC N.C.SW HEA T LIMIT SWITCH 120V A ...

  • FMI GL36STP - page 17

    www .fmiproducts.com 55173H 17 TROUBLESHOO TING MILLIVOL T SYSTEM Note: Before troubleshooting the system, make sure the gas shutoff valve is ON. The two most common causes of a malfunctioning gas appliance are: 1. Loose wiring connections 2. Construction debris clogging the pilot and/or gas control valve lter OBSERVED PROBLEM Pilot will not lig ...

  • FMI GL36STP - page 18

    www .fmiproducts.com 55173H 18 TROUBLESHOO TING ELECTRONIC IGNITION SYSTEM Note: Before troubleshooting the system, make sure the gas shutoff valve is ON. The two most common causes of a malfunctioning gas appliance are: 1. Loose wiring connections 2. Construction debris clogging the pilot and/or gas control valve lter OBSERVED PROBLEM Pilot wil ...

  • FMI GL36STP - page 19

    www .fmiproducts.com 55173H 19 REPLACEMENT P ARTS AND ACCESSORIES Purchase these replace replacement parts and accessories from your local dealer . If they can not supply these parts, call FMI PRODUCTS, LLC at 1-866-328-4537 for referral information. Y ou can also write to the address listed on the back page of this manual. Before ordering, plea ...

  • FMI GL36STP - page 20

    55173 Rev . H 09/09 WARRANTy KEEP THIS WARRANTy FMI PRODUCTS, LL C LIMITED WARRANTIES NewProducts Standard Warranty: FMI PRODUCTS, LLC warrants this new product and any parts thereof to be free from defects in material and workmanship for a period of two (2) year from the date of rst purchase from an authorized dealer provided the product has ...

Manufacturer FMI Category Gas Heater

Documents that we receive from a manufacturer of a FMI GL36STP can be divided into several groups. They are, among others:
- FMI technical drawings
- GL36STP manuals
- FMI product data sheets
- information booklets
- or energy labels FMI GL36STP
All of them are important, but the most important information from the point of view of use of the device are in the user manual FMI GL36STP.

A group of documents referred to as user manuals is also divided into more specific types, such as: Installation manuals FMI GL36STP, service manual, brief instructions and user manuals FMI GL36STP. Depending on your needs, you should look for the document you need. In our website you can view the most popular manual of the product FMI GL36STP.

Similar manuals

A complete manual for the device FMI GL36STP, how should it look like?
A manual, also referred to as a user manual, or simply "instructions" is a technical document designed to assist in the use FMI GL36STP by users. Manuals are usually written by a technical writer, but in a language understandable to all users of FMI GL36STP.

A complete FMI manual, should contain several basic components. Some of them are less important, such as: cover / title page or copyright page. However, the remaining part should provide us with information that is important from the point of view of the user.

1. Preface and tips on how to use the manual FMI GL36STP - At the beginning of each manual we should find clues about how to use the guidelines. It should include information about the location of the Contents of the FMI GL36STP, FAQ or common problems, i.e. places that are most often searched by users in each manual
2. Contents - index of all tips concerning the FMI GL36STP, that we can find in the current document
3. Tips how to use the basic functions of the device FMI GL36STP - which should help us in our first steps of using FMI GL36STP
4. Troubleshooting - systematic sequence of activities that will help us diagnose and subsequently solve the most important problems with FMI GL36STP
5. FAQ - Frequently Asked Questions
6. Contact detailsInformation about where to look for contact to the manufacturer/service of FMI GL36STP in a specific country, if it was not possible to solve the problem on our own.

Do you have a question concerning FMI GL36STP?

Use the form below

If you did not solve your problem by using a manual FMI GL36STP, ask a question using the form below. If a user had a similar problem with FMI GL36STP it is likely that he will want to share the way to solve it.

Copy the text from the picture

Comments (0)