Manual American Power Conversion 1000 VA

15 pages 0.32 mb
Download

Go to site of 15

Summary
  • American Power Conversion 1000 VA - page 1

    990 - 2794, 10/2005 User Manual English APC Server and Network UPS 1000 VA 120 Vac 2U Tower/Rack - Mount Uninterruptible Power Supply ...

  • American Power Conversion 1000 VA - page 2

    ...

  • American Power Conversion 1000 VA - page 3

    1 Introduction The APC Uninterruptible Power Supply (UPS) is designed to prevent blackouts, brow n outs, sags, and surges from rea ching your equipment. The uninterruptible power supply (UPS) filters small uti l- ity line fluctuations and isolates your equipment from large disturbances by internally disconnecting from the utility line. The UPS prov ...

  • American Power Conversion 1000 VA - page 4

    2 Tower Configuration Note: Illustrations in this document may appear different than the actual hardware. Œ • Ž • Mount the UPS in a Two - Post Rack Œ • Remove battery bracket screws, battery bracket, and b a t tery. ...

  • American Power Conversion 1000 VA - page 5

    3 Ž • Note: For information on the four - post rack - mounting kit, see www.apc.com . • Reinstall battery, battery bracket, and screws. ‘ ...

  • American Power Conversion 1000 VA - page 6

    4 2: S TART UP Connect Equipment to the UPS Rear Panel • Note: A laser printer draws significantly more power than other types of equipment and may ove r load the UPS. Connect the UPS to the Network (if Applicable) Network Connectors Serial Port Modem/Telephone/Fax Ports Network Surge Suppre s sion Ports Use only interface kits a p proved by APC. ...

  • American Power Conversion 1000 VA - page 7

    5 Start the UPS 1. Plug the UPS into a two - pole, three - wire, gr ounded receptacle only. Avoid using exte n sion cords. The power cord is attached to the UPS. The input plug is a NEMA 5 - 15P. 2. Check the site wiring fault LED located on the rear panel. It will be ill u minated if the UPS is plugged into an improperly wired u tility power outle ...

  • American Power Conversion 1000 VA - page 8

    6 3: O PERATION Front Display Panel I NDICATOR D ESCRIPTION On L ine The UPS is supplying utility power to the connected equipment. On Ba t tery The UPS is supplying ba ttery power to the connected equipment. Ove r load The connected loads are drawing more than the UPS power rating. Replace Ba t tery/ Battery Disco n nected The battery is disconnec ...

  • American Power Conversion 1000 VA - page 9

    7 4: U SER C ONFIGURABLE I TEMS N OTE : S ETTINGS ARE ADJUSTED THROUGH P OWER C HUTE SOFTWARE F UNCTION F ACTORY D E FAULT U SER S E LECTABLE C HOICES D ESCRIPTIO N Self - Test Every 14 days (336 hours) Every 7 days (168 hours), Every 14 days (336 hours), On Startup Only, No Self - Test Set the inte r val at which the UPS will execute a self - test ...

  • American Power Conversion 1000 VA - page 10

    8 N OTE : S ETTINGS ARE ADJUSTED THROUGH P OWER C HUTE SOFTWARE F UNCTION F ACTORY D E FAULT U SER S E LECTABLE C HOICES D ESCRIPTIO N Low Battery War n ing 2 minutes PowerChute Business Edition sof t ware provides automatic, una t- tended shutdown when approx i- mately 2 mi n utes of battery ope r- ated runtime r e- mains. 2, 5, 7, 10 mi n utes (T ...

  • American Power Conversion 1000 VA - page 11

    9 5: S TORAGE AND M AINTENANCE Storage Store the UPS covered in a cool, dry location, wi th the ba t tery fully charged. At - 15 to +30 ° C (+5 to +86 ° F), charge the UPS ba t tery every six months. At +30 to +45 ° C (+86 to +113 ° F), charge the UPS ba t tery every three months. Battery Replacement The UPS battery life differs based on usage ...

  • American Power Conversion 1000 VA - page 12

    10 6: T ROUBLESHOOTING , S HIPPING , AND S ERVICE Use the chart below to solve minor UPS installation and oper ation problems. Refer to www.apc.com with co m plex UPS problems. P ROBLEM AND / OR P OSSIBLE C AUSE S OLUTION UPS WILL NOT TURN ON UPS not connected to utility power supply. Check that the power cord from the UPS to the util ity power sup ...

  • American Power Conversion 1000 VA - page 13

    11 P ROBLEM AND / OR P OSSIBLE C AUSE S OLUTION THE OVERLOAD LED IS ILLUMINATED AND THE UPS EMITS A SU S TAINED ALARM TONE The UPS is overloaded. The connected equipment is dra w- ing more V A than the UPS can sustain. The connected equipment exceeds the specified “maximum load.” The alarm remains on until the overload is removed. Disconnect no ...

  • American Power Conversion 1000 VA - page 14

    12 Shipping and Service Prepare the UPS for shipping: Shutdown and disconnect any equipment attached to the UPS. Shut down the UPS, and di s connect the UPS f rom the utility power outlet. Disconnect the battery. If the UPS requires service do not return it to the dealer. Follow these steps: 1. Review the problems discussed in Troubleshooting to el ...

  • American Power Conversion 1000 VA - page 15

    13 7: R EGULATORY AND W ARRANTY I NFORMATION Regulatory Information This equipment has b een tested and found to comply with the limits for a Class A digital device, pu r suant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial enviro n ...

Manufacturer American Power Conversion Category Power Supply

Documents that we receive from a manufacturer of a American Power Conversion 1000 VA can be divided into several groups. They are, among others:
- American Power Conversion technical drawings
- 1000 VA manuals
- American Power Conversion product data sheets
- information booklets
- or energy labels American Power Conversion 1000 VA
All of them are important, but the most important information from the point of view of use of the device are in the user manual American Power Conversion 1000 VA.

A group of documents referred to as user manuals is also divided into more specific types, such as: Installation manuals American Power Conversion 1000 VA, service manual, brief instructions and user manuals American Power Conversion 1000 VA. Depending on your needs, you should look for the document you need. In our website you can view the most popular manual of the product American Power Conversion 1000 VA.

A complete manual for the device American Power Conversion 1000 VA, how should it look like?
A manual, also referred to as a user manual, or simply "instructions" is a technical document designed to assist in the use American Power Conversion 1000 VA by users. Manuals are usually written by a technical writer, but in a language understandable to all users of American Power Conversion 1000 VA.

A complete American Power Conversion manual, should contain several basic components. Some of them are less important, such as: cover / title page or copyright page. However, the remaining part should provide us with information that is important from the point of view of the user.

1. Preface and tips on how to use the manual American Power Conversion 1000 VA - At the beginning of each manual we should find clues about how to use the guidelines. It should include information about the location of the Contents of the American Power Conversion 1000 VA, FAQ or common problems, i.e. places that are most often searched by users in each manual
2. Contents - index of all tips concerning the American Power Conversion 1000 VA, that we can find in the current document
3. Tips how to use the basic functions of the device American Power Conversion 1000 VA - which should help us in our first steps of using American Power Conversion 1000 VA
4. Troubleshooting - systematic sequence of activities that will help us diagnose and subsequently solve the most important problems with American Power Conversion 1000 VA
5. FAQ - Frequently Asked Questions
6. Contact detailsInformation about where to look for contact to the manufacturer/service of American Power Conversion 1000 VA in a specific country, if it was not possible to solve the problem on our own.

Do you have a question concerning American Power Conversion 1000 VA?

Use the form below

If you did not solve your problem by using a manual American Power Conversion 1000 VA, ask a question using the form below. If a user had a similar problem with American Power Conversion 1000 VA it is likely that he will want to share the way to solve it.

Copy the text from the picture

Comments (0)