Manual Vinotemp WM-650SCU

25 pages 0.51 mb
Download

Go to site of 25

Summary
  • Vinotemp WM-650SCU - page 1

    WINE-MATE Split System Installation, Operation & Care Manual VINO-1500SSL VINO-2500SSL VINO-4500SSL VINO-6500SSL V V i i n n o o t t e e m m p p I I n n t t e e r r n n a a t t i i o o n n a a l l C C o o r r p p . . w w w w w w . . w w i i n n e e m m a a t t e e . . c c o o m m RE AD A ND SAVE THESE I NSTRUCTIONS ...

  • Vinotemp WM-650SCU - page 2

    - 1 - TABLE OF CONTENTS Important Safety Info rmation…..........................................2 Feature Description…………………………….……………..3 Cellar Construction.…………………………….……………..6 Installer’s Instruction…………….…..….……..……………..7 Temperature Control & Hu ...

  • Vinotemp WM-650SCU - page 3

    - 2 - Important Safety Information • DO NOT USE A GROUND FAUL T INTERRUPTER (GFI). • A DEDICATED 20 AMP CIRCUIT IS HIGHLY RECOMMENDED. ...

  • Vinotemp WM-650SCU - page 4

    - 3 - Feature Description • Wine-Mate split cooling system s VINO1500-6500SSL are designed and used to provide a cold temperature between 50~65 ° F for a properly insulated wine room at a normal environment. • The wine room will maintain hum idity of 50~70% RH even when the environment becomes dry and humid. These temperatures and humilities a ...

  • Vinotemp WM-650SCU - page 5

    - 4 - Fig. 1.1 WM15-25SFCL Evaporator Unit Fig. 1.2 WM45-65SFCL Evaporator Unit NOTES: LIQUID AND SUCTION LIN ES MAY DIFFER FROM WHAT ARE SHOWN HERE, PLEASE CHECK ON THE UNITS FOR PROPER INSTALLATION. ...

  • Vinotemp WM-650SCU - page 6

    - 5 - Fig. 1.3 WM150-450SCU Condensing Unit Fig. 1.4 WM-650SCU Condensing Unit ...

  • Vinotemp WM-650SCU - page 7

    - 6 - Cellar Construction This is only a guide and shall be c onsidered as minimum requirements. All interior walls and floors shall have a vapor barrier and a minimum of R11 insulation. All exterior walls and ceiling shall have a vapor barrier and a minimum of R19 insulation. The vapor barrier s hall be installed on the warm side of the insulation ...

  • Vinotemp WM-650SCU - page 8

    - 7 - Installer’s Instruction Federal law requires that WINE--M ATE split cooling systems be installed by an EPA certified refrigeration technician. WINE-MATE split system is shipped as components and is ready for use only after a certified refrigeration technician has properly installed, charged and tested the system. Proper installation is crit ...

  • Vinotemp WM-650SCU - page 9

    - 8 - 1. Condensing Unit • Place the condensing units WM150- 650SCU in a properly ventilated location. If it is not, heat exhaust ed by the condensing unit will build up and the cooling system will not operate properly. • Leave minimum 5 feet clearance for the exhaust side and leave minimum 1 foot clearance for the fresh air intake side. • Co ...

  • Vinotemp WM-650SCU - page 10

    - 9 - • High side pressure: 130 -150 psig at 75 -90 ° F ambient temperatures The line sizes and refrigerant charges are listed as follows. MODEL REFRIGERATION LINES LIQUID LINE SUCTION LINE DRAIN LINE CHARGE VINO-1500SSL < 50 FT 1/4" OD 3/8” OD 1/2” OD R134a/ 15 OZ VINO-2500SSL < 50 FT 1/4" OD 3/8” OD 1/2” OD R134a/ 20 OZ ...

  • Vinotemp WM-650SCU - page 11

    - 10 - 6. Valve Operation SPINDLE BACK POSITION SPINDLE FRONT POSITION SPINDLE MIDDLE POSITION Fig. 2.2 Valve Operation Back Position : Process and manometer port closed for normal operation Front Position : Main connection to liquid or suction line closed Middle Position : All ports open for vacuum, charge and measurement 7. Electrical Wiring Fig. ...

  • Vinotemp WM-650SCU - page 12

    - 11 - Fig. 2.4 VINO1500-4500SSL Wiring Diagram (DIGITAL CONTROLLER) Fig. 2.5 VINO6500SSL Electrical Wiring Diagram (VTSTAT) ...

  • Vinotemp WM-650SCU - page 13

    - 12 - Fig. 2.6 VINO6500SSL Electrical Wiri ng Diagram (DIGITAL CONTROLLER) 8. Use of the adjustable low pr essure control (if applicable) Cut out = 5 psig; Cut in = 25 psig; Differential = 20 psig It may need to adjust the setting in the field to get the right cycle time. Fig. 2.7 Adjustable Pressure Control ...

  • Vinotemp WM-650SCU - page 14

    - 13 - 9. Condensing Unit Troubleshooting Unit not running a. Incorrect power supply b. Incorrect or loose wiri ng s c. Failed components d. Liquid refrigerant in the compressor e. Low pressure switch shutting down the system a. Check for proper voltage b. Check all wirings a nd co nnections c. Check start relay, start ca pacitor, overload protecto ...

  • Vinotemp WM-650SCU - page 15

    - 14 - Temperature Control & Humidity Adjustment 1. Temperature Setting • Set the temperature at 55 ° F for the optimum aging of wine • On initial start-up, the time required to reach the desired temperature will vary, depending on the quantit y of bottles, temperature setting and surrounding temperature. • Allow 24 hours to stabilize th ...

  • Vinotemp WM-650SCU - page 16

    - 15 - Dip-switch description (See detail in VSTAT instruction ) 1, 2 differential: added to the Set Point, es tablishes the temperature threshold, measured by the regulation probe, beyond which the co mpressor is activated; 3 compressor safety function: OFF - function disabled; ON - function enabled; 4 temperature display: OFF - display ed in °C; ...

  • Vinotemp WM-650SCU - page 17

    - 16 - If the function is enabled, the compressor is not energized for three minutes after controller power up. The function is also active in hot-gas defrost mode. 5) LED & Display Messages 1. LED off 2. LED on 3. LED blinking 0.5s on/0.5s off 4. LED blinking 0.5s on/1.5s off 5. Display A1 6. Display A2 1. Compressor and defrost deactivated 2. ...

  • Vinotemp WM-650SCU - page 18

    - 17 - 2) Alarm Signals 2.1 Code Description 2.2 Alarm Recovery Probe alarms P1”, start a few seconds afte r the fault in the re lated probe; they automatically stop a few seconds afte r the probe restarts normal operation. Check connections before replacing the probe. Temperature alarms “HA”, “LA” automatically stops as soon as the tem p ...

  • Vinotemp WM-650SCU - page 19

    - 18 - 2. The value of the set point will be di splayed and the “°C” or “°F” LED starts blinking; 3. To change the Set value, push the o or n arrows within 10s. 4. To memorize the new set point value, push the SET key again or wait 10s. 4) Humidity Adjustment The parameter Fon is used to adjust the humidity in the wine cabinet. The higher ...

  • Vinotemp WM-650SCU - page 20

    - 19 - Care Guide In general, always unplug system or di sconnect power while doing care. 1. Coil Cleaning • Clean the condenser coil regularly. Coil may need to be cleaned at least every 6 months. • Unplug the system or disconnect power. • Use a vacuum cleaner with an extended attachment to clean the coil when it is dusty or dirty. • Plug ...

  • Vinotemp WM-650SCU - page 21

    - 20 - User’s Troubleshooting This Troubleshooting Chart is not prepared to replace the training required for a professional refrigeration servic e person, not is it comprehensive Troubleshooting Chart Complaint Possible Causes Response 1.Unit not running a. No power b. Power cord unplugged c. Setting higher than ambient temperature d. Defrost li ...

  • Vinotemp WM-650SCU - page 22

    - 21 - e. Malfunctioning fans f. Improper evaporator or condenser airflow g. Dir ty C ondenser h. Iced evaporator i. Refrigeration system restriction j. Sealed system problem k. Undercharge or overcharge intake side e. Check for both evaporator and condenser fans f. Check for air re strictions g. Clean condenser h. Defrost and reset temperature i. ...

  • Vinotemp WM-650SCU - page 23

    - 22 - Customer Support If you still have problems, please contact us at: Vinotemp International 17631 South Susana Road Rancho Dominguez, CA 90221 Tel: (310) 886-3332 Fax: (310) 886-3310 Email: info@vinotemp.com ...

  • Vinotemp WM-650SCU - page 24

    - 23 - Warranty Thank you for choosing a Vinotemp cooling unit. Please enter the complete model and se rial numbers in the space provided: Model_____________ _________________________ __ _________________ Serial No.___________________ ___________________ ________________ Attach your purchase receipt to this owner’s manual. 1. Limited Warranty VIN ...

  • Vinotemp WM-650SCU - page 25

    - 24 - VINOTEMP will, at its discret ion, repair or replace the unit and return it free of charge to the original retail customer. If the unit is found to be in good working order, or beyond the initial twelve month period, it will be returned freight collect. 2. Limitation of Implied Warranty VINOTEMP’S SOLE LIABI LITY FOR ANY DEFECTIVE PRODUCT ...

Manufacturer Vinotemp Category Refrigerator

Documents that we receive from a manufacturer of a Vinotemp WM-650SCU can be divided into several groups. They are, among others:
- Vinotemp technical drawings
- WM-650SCU manuals
- Vinotemp product data sheets
- information booklets
- or energy labels Vinotemp WM-650SCU
All of them are important, but the most important information from the point of view of use of the device are in the user manual Vinotemp WM-650SCU.

A group of documents referred to as user manuals is also divided into more specific types, such as: Installation manuals Vinotemp WM-650SCU, service manual, brief instructions and user manuals Vinotemp WM-650SCU. Depending on your needs, you should look for the document you need. In our website you can view the most popular manual of the product Vinotemp WM-650SCU.

Similar manuals

A complete manual for the device Vinotemp WM-650SCU, how should it look like?
A manual, also referred to as a user manual, or simply "instructions" is a technical document designed to assist in the use Vinotemp WM-650SCU by users. Manuals are usually written by a technical writer, but in a language understandable to all users of Vinotemp WM-650SCU.

A complete Vinotemp manual, should contain several basic components. Some of them are less important, such as: cover / title page or copyright page. However, the remaining part should provide us with information that is important from the point of view of the user.

1. Preface and tips on how to use the manual Vinotemp WM-650SCU - At the beginning of each manual we should find clues about how to use the guidelines. It should include information about the location of the Contents of the Vinotemp WM-650SCU, FAQ or common problems, i.e. places that are most often searched by users in each manual
2. Contents - index of all tips concerning the Vinotemp WM-650SCU, that we can find in the current document
3. Tips how to use the basic functions of the device Vinotemp WM-650SCU - which should help us in our first steps of using Vinotemp WM-650SCU
4. Troubleshooting - systematic sequence of activities that will help us diagnose and subsequently solve the most important problems with Vinotemp WM-650SCU
5. FAQ - Frequently Asked Questions
6. Contact detailsInformation about where to look for contact to the manufacturer/service of Vinotemp WM-650SCU in a specific country, if it was not possible to solve the problem on our own.

Do you have a question concerning Vinotemp WM-650SCU?

Use the form below

If you did not solve your problem by using a manual Vinotemp WM-650SCU, ask a question using the form below. If a user had a similar problem with Vinotemp WM-650SCU it is likely that he will want to share the way to solve it.

Copy the text from the picture

Comments (0)