-
MK Sound K-10 - page 1
Miller & Kreisel Sound Corporation 9351 Deering Avenue Chatsworth, CA 91311-5858 USA (818) 701-7010 fax (818) 701-0369 www.mksound.com ©2002 Miller & Kreisel Sound Corp. operation manual K-11 K-10 K-9 powered subwoofer ...
-
MK Sound K-10 - page 2
page 2 powered subwoofers T ABLE OF CONTENTS 1 . SAFETY INSTRUCTIONS...............................................................................................................3 2 . INTRODUCTION..................................................................................................................4 3. WHERE TO LOCATE YOUR SUBWOOFER.... ...
-
MK Sound K-10 - page 3
pa ge 3 powered subwoofers 1. SAFETY INSTRUCTIONS 1. READ INSTRUCTIONS - All safety and operating instructions should be read before this product is operated. 2. RETAIN INSTRUCTIONS - The safety and operating instructions should be retained for future reference. 3. HEED WARNINGS - All warnings on this product and in the operating instructions shoul ...
-
MK Sound K-10 - page 4
page 4 powered subwoofers 2. INTR ODUCTION Congratulations! You have just made perhaps the most exciting and dramatic addition that you could make to your audio or multichannel audio/video system. The new dimension of deep and powerful bass provided by your M&K K-series powered subwoofer will thrill and excite you. We encourage you to read this ...
-
MK Sound K-10 - page 5
pa ge 5 powered subwoofers A simple rule to remember is that you get more bass when you move the Subwoofer towards any wall or corner. Moving it away from a wall or corner gives you less bass. Remember that the floor also loads the Subwoofer, and that maximum bass is found with the woofer on the floor in a corner. In some rooms, a corner location m ...
-
MK Sound K-10 - page 6
page 6 powered subwoofers WIRING WITH THE RCA JACK INPUTS The "INPUT" RCA jacks on the back panel of your Subwoofer allow you to directly connect the Subwoofer to preamp-level components such as surround sound processors, preamplifiers, integrated amps and receivers with preamp outputs, Electronic High-Pass filters, crossovers, etc. This ...
-
MK Sound K-10 - page 7
pa ge 7 powered subwoofers FIGURE 2 - CONNECTING TO A STEREO AMP OR PREAMP USING SPEAKER WIRE CONNECTIONS Some M&K subwoofer owners hook up their Subwoofer by connecting it to their receiver or amplifier using speaker wires. To do so, you make the same kind of connections that you would use for your Satellite (or main) speakers, except that bot ...
-
MK Sound K-10 - page 8
page 8 powered subwoofers If your receiver or amp has two sets of speaker outputs, you may connect the Satellite speakers to one set of outputs and the Subwoofer to the other set. FIGURE 3 - TO AN AMP OR RECEIVER USING SPEAKER WIRES IMPORTANT NOTE FOR DOLBY PRO LOGIC SURROUND SYSTEMS: (NOT DOLBY DIGITAL 5.1) When the Subwoofer is connected to the L ...
-
MK Sound K-10 - page 9
pa ge 9 powered subwoofers 2. For convenience, you can also connect the Satellite speakers to the Subwoofer. Both sets of wires will be connected to the same terminals on the Subwoofer. Connect both the Amplifier's Left channel Positive (+) terminal and the Left Satellite's Positive (+) terminal to the Subwoofer Left RED (+) "FROM AM ...
-
MK Sound K-10 - page 10
page 10 powered subwoofers If you want to experiment further, you can move the Satellite speakers either towards or away from your listening position, making changes in small increments. This will focus the system's sound to its optimum. When you hear the best balance between stereo image localization and maximum impact and output in the mid-b ...
-
MK Sound K-10 - page 11
pa ge 11 powered subwoofers If you already own a K-10 and would like to upgrade your subwoofer performance, you don't need to trade your subwoofer in for a new model. The K-11 upgrade path will give you the full benefit of a push-pull dual-driver subwoofer, with its even-order harmonic distortion cancellation and higher output capability. 10. ...
-
MK Sound K-10 - page 12
page 12 powered subwoofers e. Make sure that the input cables are OK. Double check your connections. If necessary, replace any defective cables or speaker wires. 2. If, after operating the woofer at high volume levels for a long time, the woofer cuts out or becomes intermittent: Your Subwoofer has a protection circuit that protects it from overheat ...
-
MK Sound K-10 - page 13
pa ge 13 powered subwoofers Remove the fuse cap. If the fuse cap has an arrow printed on it, push the cap in and turn it counterclockwise. If the fuse cap has a slot in it, use a flat head screwdriver to turn it counterclockwise. Look carefully at the fuse. If the wire filament inside the glass is broken, replace the fuse ONLY with one of the ident ...
-
MK Sound K-10 - page 14
page 14 powered subwoofers Here are the instructions for speaker setup. 1. Locate the front speakers. The left, right, and center speakers should be equidistant from the main listening position. Try to set up the speakers so that they are reasonably symmetrical to room surfaces. A tape measure may be very helpful. 2. Locate the subwoofer. A. The be ...
-
MK Sound K-10 - page 15
pa ge 15 powered subwoofers D. THX Dolby Digital units have an adjustable limiter for the subwoofer feed, called “Bass Peak Level Management”. Turn it off, or set it for the highest possible level. M&K subwoofers do not need this limiter. 7. If you have a Pro-Logic only processor/receiver, follow these instructions . SPECIAL NOTE: Always ch ...
-
MK Sound K-10 - page 16
page 16 powered subwoofers 14. SPECIFICA TIONS K-9 ENCLOSURE TYPE: Sealed Box WOOFER: Single 8" Driver POWER RATING: 75 watts RMS (150watts MAX) FREQUENCY RESPONSE: 35Hz - 200Hz ± 3dB WEIGHT: 21 lbs. K-10 ENCLOSURE TYPE: Sealed Box WOOFER: Single 8" Long-Throw (MX-700) Driver POWER RATING: 75 watts RMS (150watts MAX) FREQUENCY RESPONSE: ...
Do you have a question concerning MK Sound K-10?
Use the form below
If you did not solve your problem by using a manual MK Sound K-10, ask a question using the form below. If a user had a similar problem with MK Sound K-10 it is likely that he will want to share the way to solve it.