English dropdown-ico

Manual Winegard RTS-80B

12 pages 0.85 mb
Download

Go to site of 12

Summary
  • Winegard RTS-80B - page 1

    1 RoadT rip ® Minimax TM Stationary Automatic Satellite TV Antenna Model RT8000S (white dome) Model RT8035S (black dome) WINEG ARD ® Winegard Company • 3000 Kirkwood St. • Burlington, IA 52601-2000 800/788-4417 • F AX 319/758-5854 • www .winegard.com Printed in U.S.A. © Winegard Company 2009 2452185 REV3 1/10 Made in the U.S.A. PRODUCT R ...

  • Winegard RTS-80B - page 2

    2 Parts Included • T ools Needed • Unpacking the Unit 1 Dome 1 base with electronics, dish, dual LNBF *Aftermarket versions also include all mounting hardware and cabling required for a single receiver installation P ARTS INCLUDED*: USE 2 PEOPLE when removing the unit from the carton. ! DO NOT P AINT DOME! Painting dome will cause signal degrad ...

  • Winegard RTS-80B - page 3

    3 DISH NETWORK HYBRID 1 2 3 4 5 6 7 8 0 = UP 1 = DOWN KEY BELL TV 1 2 3 4 5 6 7 8 FIGURE 1 4. After selecting location for unit (see Step 2), place the unit on the centerline of the vehicle. 5. Position base so that cables exit toward the rear of vehicle. The distance from the edge of the roof to the rear cor- ner of any foot should be at least 12? ...

  • Winegard RTS-80B - page 4

    4 7. Clean roof area where the base feet will be attached to the roof. Do not erase your marks! 8. Put approved sealant in the areas marked for the base feet. Place base feet on top of the sealant and screw down with the (3) #10 screws for each foot. 9. After all base feet are secured to roof, put sealant around edge of feet and over screws. 6. Pla ...

  • Winegard RTS-80B - page 5

    5 STEPS 2 & 3 TWO GROUND WIRES 1 FROM VEHICLE 1 BLACK WIRE FROM SA TELLITE DISH STEPS 4 & 5 RED POWER WIRE FROM DISH STEPS 6 &7 +12 V FROM VEHICLE ON/OFF ROCKER SWITCH WITH LIGHT ( Shown in OFF position. ) FIGURE 7 Connecting TWO receivers 1. Connect the coax cable coming from the antenna to the “SA TELLITE IN” input on the primary ...

  • Winegard RTS-80B - page 6

    6 Basic RoadT rip Minimax Antenna Wiring TV RECEIVER 120V POWER SA T IN POWER 12VDC RoadT rip Minimax ANTENNA COAX COAX DIRECTV must be set to the “two” satellite, oval dish setting. In some cases, the two satellite option may not be available. When this happens, use the three satellite option. Refer to your receiver manual for more information ...

  • Winegard RTS-80B - page 7

    7 If a switch other than SW64 appears, or you have an X in one of the boxes below the satellites, repeat Check Switch Steps. 5. Y our system is now set up to toggle between satellites. It will automatically move to the correct satellite when a channel is selected with your remote control. NOTE: Once these steps are completed, you won’t have to pe ...

  • Winegard RTS-80B - page 8

    8 The RoadT rip Minimax antenna does not attempt to nd a satellite or it never moves. The dish never stops on any of the signals that it sees. 1. Check +12 V wires at unit to verify the quick disconnect is locked into the socket. 2. Make sure the RoadT rip Minimax antenna is plugged in. PROBLEM SOLUTION 1. Make sure that your receiver is set up ...

  • Winegard RTS-80B - page 9

    9 Appendix A Satellite Coverage Maps and Receiver Compatibility A.1 DISH NETWORK PROGRAMMING The RoadT rip Minimax antenna will operate with most DISH Network receivers. Winegard does not recommend using receivers with hard drives not recommended by the manufactuer for mobile applications. Winegard recommends using a standard DISH Network receiver ...

  • Winegard RTS-80B - page 10

    10 DISH Network satellite 129 ° coverage area (Dotted area indicates coverage).* DISH Network satellite 61.5 ° coverage area (Dotted area indicates coverage).* *Coverage maps are for reference only and do not guarantee coverage. *Coverage maps are for reference only and do not guarantee coverage. DISH NETWORK ® EASTERN ARC DISH NETWORK 72° SA T ...

  • Winegard RTS-80B - page 11

    11 A.2 DIRECTV PROGRAMMING The RoadT rip Minimax antenna will operate with most DIRECTV receivers. The antenna will locate and continually track satellites 101° and 1 19°. However , the RoadTrip Minimax is not compatible with the DIRECTV 1 10° satellite or the KA band satellites 99° and 103°. Winegard does not recommend using receivers with ha ...

  • Winegard RTS-80B - page 12

    12 Features and specications • One button operation • Supports up to 2 single or 1 dual receiver . • Depending on receiver type and location, you can access satellites DISH Network 129°, 1 19°, 1 10° or 61.5° DIRECTV 1 19° or 101° BELL TV 91° or 82° • Depending on programming, can access DISH NETWORK’s East Coast local feeds. ? ...

Manufacturer Winegard Category TV Antenna

Documents that we receive from a manufacturer of a Winegard RTS-80B can be divided into several groups. They are, among others:
- Winegard technical drawings
- RTS-80B manuals
- Winegard product data sheets
- information booklets
- or energy labels Winegard RTS-80B
All of them are important, but the most important information from the point of view of use of the device are in the user manual Winegard RTS-80B.

A group of documents referred to as user manuals is also divided into more specific types, such as: Installation manuals Winegard RTS-80B, service manual, brief instructions and user manuals Winegard RTS-80B. Depending on your needs, you should look for the document you need. In our website you can view the most popular manual of the product Winegard RTS-80B.

Similar manuals

A complete manual for the device Winegard RTS-80B, how should it look like?
A manual, also referred to as a user manual, or simply "instructions" is a technical document designed to assist in the use Winegard RTS-80B by users. Manuals are usually written by a technical writer, but in a language understandable to all users of Winegard RTS-80B.

A complete Winegard manual, should contain several basic components. Some of them are less important, such as: cover / title page or copyright page. However, the remaining part should provide us with information that is important from the point of view of the user.

1. Preface and tips on how to use the manual Winegard RTS-80B - At the beginning of each manual we should find clues about how to use the guidelines. It should include information about the location of the Contents of the Winegard RTS-80B, FAQ or common problems, i.e. places that are most often searched by users in each manual
2. Contents - index of all tips concerning the Winegard RTS-80B, that we can find in the current document
3. Tips how to use the basic functions of the device Winegard RTS-80B - which should help us in our first steps of using Winegard RTS-80B
4. Troubleshooting - systematic sequence of activities that will help us diagnose and subsequently solve the most important problems with Winegard RTS-80B
5. FAQ - Frequently Asked Questions
6. Contact detailsInformation about where to look for contact to the manufacturer/service of Winegard RTS-80B in a specific country, if it was not possible to solve the problem on our own.

Do you have a question concerning Winegard RTS-80B?

Use the form below

If you did not solve your problem by using a manual Winegard RTS-80B, ask a question using the form below. If a user had a similar problem with Winegard RTS-80B it is likely that he will want to share the way to solve it.

Copy the text from the picture

Captcha
New picture

Comments (0)