Manual Advantech PCL-849

33 pages 0.32 mb
Download

Go to site of 33

Summary
  • Advantech PCL-849 - page 1

    PCL-849 4-Port RS-232 Interface Card ...

  • Advantech PCL-849 - page 2

    Copyright Notice This documentation and the software included with this product are copyrighted 2001 by Advantech Co., Ltd. All rights are reserved. Advantech Co., Ltd. reserves the right to make improvements to the products described in this manual at any time without notice. No part of this manual or software may be reproduced, copied, translated ...

  • Advantech PCL-849 - page 3

    Contents Chapter 1: Introduction ....................................................... 5 Description ............................................................................. 6 Feature s .................................................................................. 7 Specifications ......................................................... ...

  • Advantech PCL-849 - page 4

    1 Introduction CHAPTER ...

  • Advantech PCL-849 - page 5

    6 PCL-849 User's Manual Description The PCL-849 series are four port serial communication interface cards. Each port can be configured individually to RS-232 using on- board jumpers. PCL-849A/849B serial ports are implemented using 16C554 UARTs which make serial I/O more reliable. For higher performance, 16C654 UARTs can be installed in place ...

  • Advantech PCL-849 - page 6

    Chapter 1 Introduction 7 Features v Four independent RS-232 serial ports v Transmission speeds up to 307.2 kbps v Independent I/O addresses and independent/shared IRQ settings for each of 4 serial ports v W ide IRQ selection: 3, 4, 5, 6, 7, 9, 10, 1 1, 12, 15 v Supports Standard DOS COM1, COM2, COM3, and COM4 v Supports DOS/W indows 3.1, W indows 9 ...

  • Advantech PCL-849 - page 7

    8 PCL-849 User's Manual · UAR T : 1 × 16C554 (PCL-849A/849B) 1 × 16C654 (PCL-849+) · Speed: 50 ~ 921.6 kbps (PCL-849A) 50 ~ 307.2 kbps (PCL-849B/849+) · Connectors: 30-cm male DB-37 to 4 × DB25 male (DTE) · Data signals: TxD, RxD, RTS, CTS, DTR, DSR, DCD, RI, GND · Surge protection: 3000 V DC (PCL-849B/849+) · Power requirement: 250 m ...

  • Advantech PCL-849 - page 8

    Chapter 1 Introduction 9 Figure 1-1: Switch and jumper layout ...

  • Advantech PCL-849 - page 9

    10 PCL-849 User's Manual ...

  • Advantech PCL-849 - page 10

    2 Hardware Installation CHAPTER ...

  • Advantech PCL-849 - page 11

    12 PCL-849 User's Manual Initial Inspection Depending on the option you ordered, in addition to this manual, you should find the following items inside the shipping container: • PCL-849(A/B/+) 4-port RS-232 Card • One 30-cm male DB-37 to four male DB-25 cable • One diskette with ICOM utility software We have carefully inspected the PCL-8 ...

  • Advantech PCL-849 - page 12

    Chapter 2 Hardware Installation 13 Card Installation W arning! T ur n off y our PC’ s po w er supply whenev er y ou install or remov e the PCL-849 or its cab les . Static electr icity can easily damage computer equipment. Ground y ourself b y touching the chassis of the computer (metal) bef ore y ou touch an y boards . 1. Turn off the computer. T ...

  • Advantech PCL-849 - page 13

    14 PCL-849 User's Manual Card Configuration Each port on the PCL-849 card has a jumper and a DIP switch which require configuring prior to use. The DIP switch sets the port to the appropriate I/O address and speed mode. The jumpers set the port's IRQ. Default Settings The board is shipped with default settings. If you need to change these ...

  • Advantech PCL-849 - page 14

    Chapter 2 Hardware Installation 15 S tandard Mode In this mode, each of the four ports is assigned an address, as shown below. Port 1 Ch1 base address 3F8 Port 2 Ch2 base address 2F8 Port 3 Ch3 base address 3E8 Port 4 Ch4 base address 2E8 Enhanced Mode In this mode, the address for each of the four ports is assigned according to the card base addre ...

  • Advantech PCL-849 - page 15

    16 PCL-849 User's Manual Default Settings Mode Enhanced Mode Port 1 IRQ12 Address 300H Port 2 IRQ12 Address 308H Port 3 IRQ12 Address 310H Port 4 IRQ12 Address 318H The following example shows how to set the base address to 2F8. The switch sum is set to 2F8: 200 + 80 + 40 + 20 + 10 + 8 (HEX). Note: On the PCL-849 addr ess line A9 does not appe ...

  • Advantech PCL-849 - page 16

    Chapter 2 Hardware Installation 17 Independent IRQ Mode (JP1-JP4) In this mode, the IRQ level for each of the four ports is set individual- ly. For each port, select an IRQ which is not already in use by another card in the system. The correspondence of jumpers to ports is shown below. Port 1 à JP1 Port 2 à JP2 Port 3 à JP3 Port 4 à JP4 Shared ...

  • Advantech PCL-849 - page 17

    18 PCL-849 User's Manual switch S1 designates the card's interrupt status register address, as shown in the following figure and table. Interrupt Status Register S1 Bit Function 0 Port 1 1 Port 2 2 Port 3 3 Port 4 4 Not Used 5 Not Used 6 Not Used 7 Not Used The user may change the interrupt status register address via S1. Please note that ...

  • Advantech PCL-849 - page 18

    Chapter 2 Hardware Installation 19 T able 2-1: DIP switch settings for S1 A4 A5 A6 A 7 A8 I n ter ru pt R egister O N ON O N O N O N 200H O FF O N O N ON O N 210H ON O FF ON ON O N 220H O FF O FF O N O N O N 230H ON ON O FF O N O N 240H O FF O N OFF O N ON 250H ON O FF O FF ON ON 260H O FF O FF O FF ON O N 270H ON O N O N O FF O N 280H O FF O N O N ...

  • Advantech PCL-849 - page 19

    20 PCL-849 User's Manual Speed Mode selection The PCL-849 employs a unique speed option that allows the user to choose either normal speed mode (1x) or high speed mode (8x). This high speed mode is selected at S2. Normal Speed Mode To select the baud rate commonly associated with COM ports , such as 2400, 4800, 9600. . .115.2 kbps, place the s ...

  • Advantech PCL-849 - page 20

    3 Software Installation CHAPTER ...

  • Advantech PCL-849 - page 21

    22 PCL-849 User's Manual Operating Environment Selection Set jumper 15 (JP15) to correspond with your desired software operating environment. Connect the left two pins of JP15 to operate in DOS or Windows 3.1 mode, as shown below. Connect the right two pins to operate in Windows 95/98 or Windows NT mode . JP15 JP15 DOS, Windows 3.1 Windows 95/ ...

  • Advantech PCL-849 - page 22

    Chapter 3 Software Installation 23 Following completion of installation, please r estar t your system as prompted. Once the board and driver have been installed and the system restarts successfully, users can execute any ready-made applica- tions, such as HyperTerminal to transmit/receive data, or Remote Access Service to provide dial-up networking ...

  • Advantech PCL-849 - page 23

    24 PCL-849 User's Manual Share IRQ: 3, 4, 5, 6, 7, 9, 10, 11, 12, 15 Vector Address: 200H ~ 3F0H After you finish the installation, you can click [ Exit ] and restart your system. Unless the system is restarted, the latest configuration will not take effect. ...

  • Advantech PCL-849 - page 24

    Chapter 4 Wiring 2 5 4 Wiring CHAPTER ...

  • Advantech PCL-849 - page 25

    26 PCL-849 User's Manual Connector Pin Assignments The following diagrams show the pin assignments for DB-37 and DB- 25 connectors for RS-232. PCL-849: DB-37 Four Port Connectors: DB-25 PCL-849 Pin assignments for RS-232 ...

  • Advantech PCL-849 - page 26

    Chapter 4 Wiring 2 7 Wiring RS-232 signal wiring Since the RS-232 interface is not strictly defined, many devices have their own connection methods which may ignore some signal lines or define reserved lines for other functions. It is best to refer to the user’s manual for your device for installation instructions. You may find the following help ...

  • Advantech PCL-849 - page 27

    28 PCL-849 User's Manual Modem connections DB-25 Male: PCL-849 Modem (DCE) Pin Signal Pin Signal 2 TxD 2 RxD 3 RxD 3 TxD 4 RTS 4 CTS 5 CTS 5 RTS 6 DSR 6 DTR 7 GND 7 GND 20 DTR 20 DSR 8 DCD 8 DCD For DTE to DCE connections, use straight through cable (i.e., you don't have to reverse lines 2 and 3, lines 4 and 5, and lines 6 and 20 since, i ...

  • Advantech PCL-849 - page 28

    Appendix A PC I/O Address Assignments 2 9 A PC I/O Address Reference APPENDIX ...

  • Advantech PCL-849 - page 29

    30 PCL-849 User's Manual PC I/O Address Usage The following table indicates the PC I/O address usage assignments. To prevent the PCL-849 card settings from conflicting with other device or I/O card settings, we recommend you refer to this table. I/O Address Device 000 - 00F DMA (8237A) 020 - 021 8259A IRQ Controller 040 - 043 8253/8254 T imer/ ...

  • Advantech PCL-849 - page 30

    Appendix B Quick Reference 3 1 B Quick Reference APPENDIX ...

  • Advantech PCL-849 - page 31

    32 PCL-849 User's Manual Ø Jumper Setting · IRQ Mode DIP 1 ( MODE 0 ) of S1 is used to set the IRQ mode of this card. DIP1 : ON (Upper) position è Shared IRQ mode DIP1 : OFF (Lower) position è Independent IRQ mode · STANDARD/ ENHANCED Mode DIP 2 ( MODE 1 ) of S1 is used to set the standard/enhanced mode of this card. DIP1 : ON (Upper) pos ...

  • Advantech PCL-849 - page 32

    Appendix B Quick Reference 3 3 STANDARD MODE: In this mode, the I/O addresses and the IRQ levels for each port are set to default as shown below, (Disable BIOS setting of on-board COM1 ~ COM4) ENHANCED MODE: In this mode, the I/O addresses and the IRQ levels for each port are set as shown below, (Make sure that the I/O address on the BIOS setting o ...

  • Advantech PCL-849 - page 33

    34 PCL-849 User's Manual ...

Manufacturer Advantech Category Network Card

Documents that we receive from a manufacturer of a Advantech PCL-849 can be divided into several groups. They are, among others:
- Advantech technical drawings
- PCL-849 manuals
- Advantech product data sheets
- information booklets
- or energy labels Advantech PCL-849
All of them are important, but the most important information from the point of view of use of the device are in the user manual Advantech PCL-849.

A group of documents referred to as user manuals is also divided into more specific types, such as: Installation manuals Advantech PCL-849, service manual, brief instructions and user manuals Advantech PCL-849. Depending on your needs, you should look for the document you need. In our website you can view the most popular manual of the product Advantech PCL-849.

Similar manuals

A complete manual for the device Advantech PCL-849, how should it look like?
A manual, also referred to as a user manual, or simply "instructions" is a technical document designed to assist in the use Advantech PCL-849 by users. Manuals are usually written by a technical writer, but in a language understandable to all users of Advantech PCL-849.

A complete Advantech manual, should contain several basic components. Some of them are less important, such as: cover / title page or copyright page. However, the remaining part should provide us with information that is important from the point of view of the user.

1. Preface and tips on how to use the manual Advantech PCL-849 - At the beginning of each manual we should find clues about how to use the guidelines. It should include information about the location of the Contents of the Advantech PCL-849, FAQ or common problems, i.e. places that are most often searched by users in each manual
2. Contents - index of all tips concerning the Advantech PCL-849, that we can find in the current document
3. Tips how to use the basic functions of the device Advantech PCL-849 - which should help us in our first steps of using Advantech PCL-849
4. Troubleshooting - systematic sequence of activities that will help us diagnose and subsequently solve the most important problems with Advantech PCL-849
5. FAQ - Frequently Asked Questions
6. Contact detailsInformation about where to look for contact to the manufacturer/service of Advantech PCL-849 in a specific country, if it was not possible to solve the problem on our own.

Do you have a question concerning Advantech PCL-849?

Use the form below

If you did not solve your problem by using a manual Advantech PCL-849, ask a question using the form below. If a user had a similar problem with Advantech PCL-849 it is likely that he will want to share the way to solve it.

Copy the text from the picture

Comments (0)