-
Echo SHC-225S - page 1
H e d g e C l i p p e r O p e r a t O r ' s M a n u a l 1 W ARNING Read rules for safe operation and instructions carefully . ECHO provides an Operator's Manual and a Safety Manual. Both must be read and understood for proper and safe operation. Failure to do so could result in serious injury . Shaft Hedge Clipper Operator's Manual M ...
-
Echo SHC-225S - page 2
2 Copyright© 2010 By Echo, Incorporated All Rights Reserved. I n t r o d u c t I o n W elcome to the ECHO family . This ECHO product was designed and manufactured to provide long life and on-the-job dependability . Read and understand this manual and the SAFETY MANUAL you found in the same package. Y ou will nd both easy to use and full of help ...
-
Echo SHC-225S - page 3
H e d g e C l i p p e r O p e r a t O r ' s M a n u a l 3 I n t e r n a t I o n a l s y m b o l s Symbol description/application Symbol form/shape Symbol description/application Symbol form/shape Hot Surface Carburetor adjust- ment - Idle speed Carburetor adjust- ment - High speed mixture Symbol description/application Symbol form/shape Symbol ...
-
Echo SHC-225S - page 4
4 Physical Condition Y our judgment and physical dexterity may not be good: • if you are tired or sick, • if you are taking medication, • if you have taken alcohol or drugs. Operate unit only if you are physically and mentally well. Eye Protection Eye protection that meets ANSI Z87.1 or CE requirements must be worn whenever you operate the un ...
-
Echo SHC-225S - page 5
H e d g e C l i p p e r O p e r a t O r ' s M a n u a l 5 DANGER Do not operate this product indoors or in inadequately ventilated areas. Engine exhaust contains poisonous emissions and can cause serious injury or death. Read the Manuals • Provide all users of this equipment with the Operator’ s Manual and Safety Manual for instructions on ...
-
Echo SHC-225S - page 6
6 Emission Control Label (located on Engine) (EXAMPLE ONL Y , information on label varies by F AMIL Y). e q u I p m e n t W ARNING Use only ECHO approved attachments. Serious injury may result from the use of a non-approved attachment com- bination. ECHO, INC. will not be responsible for the failure of cutting devices, attachments, or accessories w ...
-
Echo SHC-225S - page 7
H e d g e C l i p p e r O p e r a t O r ' s M a n u a l 7 d e s c r I p t I o n Locate these safety decals on your unit. Make sure the decals are legible and that you understand and follow the instruc- tions on them. If a decal cannot be read, a new one can be ordered from your ECHO dealer . See P AR TS ORDERING instructions for specic info ...
-
Echo SHC-225S - page 8
8 1. POWER HEAD - Includes the Engine, Clutch, Fuel System, Ignition System and Recoil Starter . 2. THROTTLE HANDLE - FOR RIGHT HAND - Contains Stop Switch, Throttle Lockout, and Throttle T rigger . 3. THROTTLE TRIGGER LOCKOUT - This lever must be held during starting. Operation of the throttle trigger is prevented unless throttle trigger lockout l ...
-
Echo SHC-225S - page 9
H e d g e C l i p p e r O p e r a t O r ' s M a n u a l 9 c o n t e n t s The ECHO product you have purchased has been factory pre-assembled for your convenience. After opening the carton, check for damage. Immediately notify your retailer or ECHO Dealer of damaged or missing parts. Use the contents list to check for missing parts. ____ 1 - Po ...
-
Echo SHC-225S - page 10
10 f r o n t h a n d l e NOTE Label shows minimum spacing for front handle location. 1. Position front handle in comfortable operating position and tighten screws. MIN SP ACING f u e l NOTICE: Use of unmixed, improperly mixed, or fuel older than 90 days, (stale fuel), may cause hard starting, poor performance, or severe engine damage and void the p ...
-
Echo SHC-225S - page 11
H e d g e C l i p p e r O p e r a t O r ' s M a n u a l 11 Mixing Instructions 1. Fill an approved fuel container with half of the required amount of gasoline. 2. Add the proper amount of 2-stroke oil to gasoline. 3. Close container and shake to mix oil with gasoline. 4. Add remaining gasoline, close fuel container , and remix. IMPOR T ANT Spi ...
-
Echo SHC-225S - page 12
12 s t a r t I n g c o l d e n g I n e W ARNING Hedge Clipper blades are very sharp. T ouching them may lead to severe personal injury . A void touching blades whenever possible, and always wear gloves to protect hands. NOTE The blade cover is used for transportation and storage. Remove blade cover before using the unit. W ARNING The attachment wil ...
-
Echo SHC-225S - page 13
H e d g e C l i p p e r O p e r a t O r ' s M a n u a l 13 W ARNING The blades must not move at idle, otherwise serious personal in- jury may result. Periodic carburetor adjustment may be necessary to assure blades do not move at idle. If blades move, readjust carburetor according to “Carburetor Ad- justment” instructions in this manual or ...
-
Echo SHC-225S - page 14
14 s t o p p I n g e n g I n e 1. Thr ottle Release throttle and allow engine to return to idle before shutting off engine. 2. Stop Switch Move stop switch button (A) backward to STOP position. W ARNING If engine does not stop when stop switch is moved to STOP posi- tion, close choke - COLD ST AR T position - to stall engine. Have your ECHO dealer ...
-
Echo SHC-225S - page 15
H e d g e C l i p p e r O p e r a t O r ' s M a n u a l 15 m a I n t e n a n c e I n t e r v a l s W ARNING Moving parts can amputate ngers or cause severe injuries. Keep hands, clothing and loose objects away from all openings. Always stop engine, disconnect spark plug, and make sure all moving parts have come to a complete stop before rem ...
-
Echo SHC-225S - page 16
16 a I r f I l t e r Level 1. T ools r equir ed: 25 - 50 mm (1 - 2 in.) Cleaning Brush Parts r equir ed: REPOWER TM AIR & FUEL FIL TER KIT . 1. Close choke (Cold Start Position [ ]). This prevents dirt from entering the carburetor throat when the air lter is removed. Brush accumulated dirt from air cleaner area. 2. Remove air lter cover . ...
-
Echo SHC-225S - page 17
H e d g e C l i p p e r O p e r a t O r ' s M a n u a l 17 s p a r k p l u g Level 2. T ools Requir ed: T -W rench, feeler gauge, soft metal brush Parts Requir ed: REPOWER TM T une-Up Kit IMPOR T ANT Use only NGK BPM-8Y spark plug (BPMR-8Y in Canada) other - wise severe engine damage may occur . 1. Remove spark plug and check for fouling, worn ...
-
Echo SHC-225S - page 18
18 IMPOR T ANT DO NOT use a metal scraper to remove dirt from the cylinder ns. 4. Remove ignition wires from clip for cleaning. 5. Use brush to remove dirt from the cylinder ns. 6. Remove grass and leaves from the grid between the recoil starter and fuel tank. 7. Assemble components in reverse order . e x h a u s t s y s t e m Spark Arrestor ...
-
Echo SHC-225S - page 19
H e d g e C l i p p e r O p e r a t O r ' s M a n u a l 19 Exhaust Port Cleaning Level 2. T ools r equir ed: T orx T27 L-W rench, W ood or plastic scraper Parts Requir ed: As needed: Heat Shield 1. Remove spark plug lead from spark plug, and remove engine cover (2 screws). 2. Place piston at top dead center . Remove mufer (A) and heat shiel ...
-
Echo SHC-225S - page 20
20 c a r b u r e t o r a d j u s t m e n t Engine Break-In New engines must be operated a minimum duration of two tanks of fuel break-in before carburetor adjustments can be made. During the break- in period your engine performance will increase and exhaust emissions will stabilize. Idle speed can be adjusted as required. High Altitude Operation Th ...
-
Echo SHC-225S - page 21
H e d g e C l i p p e r O p e r a t O r ' s M a n u a l 21 l u b r I c a t I o n Blades Level 1. T ools Requir ed: Clean rag, cleaning brush, oil can Parts Requir ed: 20W Engine Oil (lubrication), 50-50 mixture of kerosene and 20W oil (cleaning) W ARNING Hedge Clipper blades are very sharp. T ouching them may lead to severe personal injury . A ...
-
Echo SHC-225S - page 22
22 Drive Shaft Assembly Level 1. NOTE Hedge Clipper drive shaft should be greased every 25 hours of operation. T ools r equir ed: T orx T27 L-W rench, screwdriver , clean rag, small brush Parts r equir ed: POWER BLENDX TM 14 oz. cartridge or Lithium Based Grease W ARNING Hedge Clipper blades are very sharp. T ouching them may lead to severe persona ...
-
Echo SHC-225S - page 23
H e d g e C l i p p e r O p e r a t O r ' s M a n u a l 23 1. Disconnect spark plug wire from spark plug. 2. Slide blades to allow le clearance using slots (A) on bottom of blades. Do not pry against cutting edges. 3. Follow the original shape, and le each cutting edge carefully to avoid damage to adjacent teeth. Maintain 6 mm (.25 in.) ...
-
Echo SHC-225S - page 24
24 DANGER Fuel vapors are extremely ammable and may cause re and/or explosion. Never test for ignition spark by ground- ing spark plug near cylinder plug hole, otherwise serious personal injury may result. t r o u b l e s h o o t I n g T R A H C G N I T O O H S E L B U O R T M E L B O R P E N I G N E m e l b o r P k c e h C s u t a t S e s u ...
-
Echo SHC-225S - page 25
H e d g e C l i p p e r O p e r a t O r ' s M a n u a l 25 IMPOR T ANT Always store and transport hedge clippers in a stable, horizontal position. Support gear case and cutting blades to prevent excessive exing, which may cause damage to these components. Always install blade cover when transport - ing or storing unit. s t o r a g e W ARNIN ...
-
Echo SHC-225S - page 26
26 s p e c I f I c a t I o n s MODEL ---------------------------------------------------- SHC-225, SHC-225S Length (SHC-225) --------------------------------------- 1758 mm (69.21 in.) Length (SHC-225S) -------------------------------------- 1480 mm (58.27 in.) W idth (SHC-225) ----------------------------------------- 246 mm (9.69 in.) W idth (SHC ...
-
Echo SHC-225S - page 27
H e d g e C l i p p e r O p e r a t O r ' s M a n u a l 27 ECHO LIMITED W ARRANTY ST A TEMENT FOR PRODUCT SOLD IN USA AND CANADA BEGINNING 01/01/2010 ECHO'S RESPONSIBILITY ECHO Incorporated’s Limited W arranty , provides to the original purchaser that this ECHO product is free from defects in material and workmanship . Under normal use ...
-
Echo SHC-225S - page 28
H e d g e C l i p p e r O p e r a t O r ' s M a n u a l 28 PURCHASED REP AIR P ARTS, SHORT BLOCKS AND ACCESSORIES ? ...
-
Echo SHC-225S - page 29
H e d g e C l i p p e r O p e r a t O r ' s M a n u a l 29 ECHO INCORPORA TED EMISSION CONTROL W ARRANTY ST A TEMENT FOR ECHO AND SHINDAIW A BRANDS The Environmental Protection Agency (EP A) and the California Air Resources Board (C.A.R.B.) and ECHO Incorporated (ECHO Inc.) are pleased to explain the emission control system warranty on your 20 ...
-
Echo SHC-225S - page 30
H e d g e C l i p p e r O p e r a t O r ' s M a n u a l 30 NOTES ...
-
Echo SHC-225S - page 31
H e d g e C l i p p e r O p e r a t O r ' s M a n u a l 31 NOTES ...
-
Echo SHC-225S - page 32
CONSUMER PRODUCT SUPPORT 1-800-673-1558 8:30 - 4:30 Mon - Fri C.S.T . ECHO, INCORPORA TED 400 O a k w O O d R O a d L a k e Z u R i c h , iL 60047 www .echo-usa.com DEALER? Call 1-800-432-ECHO 1-800-432-3246 or www .echo-usa.com S8541 1001 144/S8541 1999999 S85312002871/S85312999999 (S) S861 1 1001677/S861 11999999 (S) S86012006190/S86012999999 s e ...
Do you have a question concerning Echo SHC-225S?
Use the form below
If you did not solve your problem by using a manual Echo SHC-225S, ask a question using the form below. If a user had a similar problem with Echo SHC-225S it is likely that he will want to share the way to solve it.