-
Rheem AP15121-1 - page 1
W a t e r H e a t e r s E l e c t r i c R e s i d e n t i a l H e a t P u m p The purpose of this manual is twofold: one, to provide the installer with the basic directions and recommendations for the proper installation and adjustment of the water heater; and two, for the owner–operator , to explain the features, operation, safety precautions, m ...
-
Rheem AP15121-1 - page 2
C a r e a nd Cl ea ni ng D r a i n i n g ................ 1 7 M ai nt en an ce . . . . . . . . . . . . . 17 Ex te nd ed Sh ut -D ow n . . . . . 1 8 S a fe ty In fo rm at io n S af et y P re ca ut io ns . . . . . . . 3 , 4 I n st al la ti on In st ru ct io ns L o c a t i o n ................. 5 W a te r C on ne ct io ns . . . . . . . . 6 Re li ef V ...
-
Rheem AP15121-1 - page 3
The chart shown above may be used as a guide in determining the proper water temperature for your home. ! DANGER: Households with small children, disabled, or elderly persons may require a 120°F or lower thermostat setting to prevent contact with “HOT” water . The temperature of the water in the heater is regulated by the water heater interfac ...
-
Rheem AP15121-1 - page 4
4 I M P O R T A N T S A F E T Y I N F O R M A T I O N . R E A D A L L I N S T R U C T I O N S B E F O R E U S I N G . W A R N I NG ! For your safety , the information in this manual must be followed to minimize the risk of fire or explosion, electric shock, or to prevent property damage, personal injury , or loss of life. Be sure to read and unders ...
-
Rheem AP15121-1 - page 5
I n s t a l l i n g th e w a t e r h e a t er . The location chosen for the water heater must take into consideration the following: Local Installation Regulations This water heater must be installed in accordance with these instructions, local codes, utility codes, utility company requirements or , in the absence of local codes, the latest edition ...
-
Rheem AP15121-1 - page 6
I n s t a l l i n g th e w a t e r h e a t er . 6 Thermal Expansion Det erm ine if a chec k valv e exi sts in the inl et water line. Check with your loc al wat er uti lit y . It ma y have been insta lled in the cold water line as a separ ate back flow pre ven ter , or it may be part of a press ure red uci ng valve , wate r met er or water sof ten e ...
-
Rheem AP15121-1 - page 7
! W A RN I N G: T h e p r e ss u r e rating of the relief valve must not exceed 150 PSI, the maximum working pressure of the water heater as marked on the rating plate. A new combination temperature and pressure relief valve, complying with the Standard for Relief V alves and Automatic Gas Shut-Off Devices for Hot W ater Supply Systems, ANSI Z21.22 ...
-
Rheem AP15121-1 - page 8
8 I n s t a l l i n g th e w a t e r h e a t er . Electrical Connections T o Fill the W ater Heater Make certa in the drain valve is compl etely closed. Open the shut-off valve in the cold water supply line. Open each hot water faucet slowly to allow the air to vent from the water heater and piping. A st ead y fl ow of wa te r fro m the hot wa ter ...
-
Rheem AP15121-1 - page 9
Insulation blankets, available to the general public, for external use on electric water heaters are not necessary . The purpose of an insulation blanket is to reduce the standby heat loss encountered with storage tank heaters. This water heater meets or exceeds the National Appliance Energy Conservation Act standards with respect to insulation and ...
-
Rheem AP15121-1 - page 10
10 I n s t a l l i n g th e w a t e r h e a t er . Please install the insulation on the cold water supply inlet and the hot water outlet as shown in the illustration. Hot and Cold Pipe Insulation Installation For increased energy efficiency , this water heater has been supplied with two 2-3/8” sections of pipe insulation. Please install the insul ...
-
Rheem AP15121-1 - page 11
I n s t a l l a t i on C h e c k l i st 1 1 A. W ater Heater Location ❑ Clo se to a re a of he ate d wat er de man d. ❑ Ind oor s an d pro tec te d fro m moi stu re , we t con dit io ns an d fre ezi ng te mpe ra tur es . ❑ Are a fr ee of fl am mab le vap ors . ❑ 1,0 00 cu. ft unc ond iti on ed in doo r sp ace . ❑ Pro vis io ns mad e to p ...
-
Rheem AP15121-1 - page 12
The water heater is equipped with a tem perat ure limiting control (ECO) that is located above the upper heating element in contact wi th the ta nk su rfa ce . If fo r any re as on th e water temperature becomes excessively high, the temperature limiting control (ECO) breaks the power circuit to the heating element. Once the control opens , it must ...
-
Rheem AP15121-1 - page 13
13 For the most efcient operation of the heat pump water heater , the "Energy Saver" mode is recommended. Press the key on the control pad labeled "En- ergy Saver". The corresponding LED will light up upon activation. If the "Energy Saver" setting does not supply enough hot water or additional hot water is needed, u ...
-
Rheem AP15121-1 - page 14
14 C a r e a n d c l e a n in g o f t he w a t e r h e a t e r . Draining the W ater Heater CAUTION: Shut off power to the water heater before draining water . DANGER: Before manually operating the relief valve, make certain no one will be exposed to the hot water released by the valve. The water drained from the tank may be hot enough to present a ...
-
Rheem AP15121-1 - page 15
15 V acation and Extended Shut-Down If the wate r heat er is to rem ain idle for an extended period of time, the power and water to the appliance should be turned off to conserve energy and prevent a build-up of dangerous hydrogen gas. The water heater and piping should be drained if they might be subjected to freezing temperatures. After a long sh ...
-
Rheem AP15121-1 - page 16
16 B e f o r e Y o u C a l l F o r S er v i c e … T roubleshooting Tips Save time and money! Review the chart on this page first and you may not need to call for service. Problem Possible Causes What to Do Rumbling noise W ater conditions in your home caused a build up of scale or mineral deposits in the water heater . ● Allow a few quarts of w ...
-
Rheem AP15121-1 - page 17
17 1 4 0 1 3 0 1 2 0 1 10 1 0 0 9 0 T H E R M - O - D I S C Air Filter T emperature & Pressure Relief V alve Drain V alve R e p l a c e m e n t P a r t s . For 50 gallon Heat Pump W ater Heaters. Instructions For Placing a Parts Order Address parts orders to the distributor or store where the heater was purchased. All parts orders should includ ...
-
Rheem AP15121-1 - page 18
18 C a v i t y I n s e rt I n s t r u c ti o n s The following instructions are intended for qualified service personnel ONL Y , and should only be done when necessary . In order to replace the ECO,thermistor or heating element, remove the cavity insert crossbar by following the instructions below: T urn off the power to the water heater . Remove t ...
-
Rheem AP15121-1 - page 19
19 W i r in g D i a g r a m ...
-
Rheem AP15121-1 - page 20
20 h e a d I F Y O U N E E D S E R V I C E 1. Sh ou ld y ou ha ve an y qu es ti on s ab ou t y our ne w w at er hea te r , o r i f it re qu ire s a dj us tme nt , re pai r , or ro ut ine ma in te na nc e, i t is su gg es te d t ha t yo u fi rs t co nt ac t yo ur ins ta lle r , p lum bi ng c on tra ct or o r pr ev iou sl y ag ree d u pon se rv ice a ...
Do you have a question concerning Rheem AP15121-1?
Use the form below
If you did not solve your problem by using a manual Rheem AP15121-1, ask a question using the form below. If a user had a similar problem with Rheem AP15121-1 it is likely that he will want to share the way to solve it.