English dropdown-ico

Manual Gorenje IT640-ORA-W

20 pages Not applicable
Download

Go to site of 20

Summary
  • Gorenje IT640-ORA-W - page 1

    Ceramic glass induction hob MT Instructions for use, installation, and connection IE GB ...

  • Gorenje IT640-ORA-W - page 2

    243971 The built-in ceramic-glass cooktop is intended for household use only . Materials used for packaging are nature friendly and may be recycled, deposited or destroyed without any threats to the environment. In order to recognize these features, all packing materials are marked with relevant symbols. Once your appliance has become obsolete and ...

  • Gorenje IT640-ORA-W - page 3

    243971 • The appliance may be built-in and connected to the power supply only by a quali fi ed technician. • Particular areas of the cooktop surface (adjacent to the hotplates) are hot during operation. Prevent the children to hang around the appliance and warn them properly against the danger of burns. • Hot oil ignites readily , so be sure ...

  • Gorenje IT640-ORA-W - page 4

    243971 A ON/OFF sensor B Hotplate power or remaining heat displays B1 Decimal dot on the power displays: - On : hotplate power control is possible - Off : hotplate power control is not possible C Hotplate selection and ON/OFF sensors (+) (hotplate number varies with different models) D Child lock ON/OFF sensor E Sensor (-) F Extra strong power sett ...

  • Gorenje IT640-ORA-W - page 5

    243971 • Ceramic glass hob is fi tted with four hotplates. Hob surface is completely fl at and smooth, without edges to accumulate dirt. • The hob is fi tted with high power induction hotplates. Heat is generated directly at the bottom of the dish, where it is most needed, without any losses through the ceramic glass surface. This way the re ...

  • Gorenje IT640-ORA-W - page 6

    243971 Magnet test Use small magnet to test if the dish bottom is magnetic. Only dishes where magnet sticks to the bottom are suitable for induction cooking. Dish recognition One of great advantages of the induction hotplate is dish recognition. Even if there are no dishes upon the hotplate, or the dish diameter is smaller than the diameter of the ...

  • Gorenje IT640-ORA-W - page 7

    243971 • When buying cookware be careful in selecting size: pot diameter usually refers to the top edge of the dish, which is often larger than the dish bottom. • Steam-pressure pots (economic pots), which use pressure in tightly sealed interior , are especially economic, and save both time and energy . Shorter cooking time leaves more vitamins ...

  • Gorenje IT640-ORA-W - page 8

    243971 • After turning the ceramic glass hob on all displays come on for a moment. The hob is ready for operation. • The hob is fi tted with electronic sensors which are switched on if you touch the relevant circle for at least one second. • Each sensor activation is followed by a sound signal. • Avoid placing any objects on sensor surface ...

  • Gorenje IT640-ORA-W - page 9

    243971 Fast deactivation • Selected hotplate must be activated, decimal dot (B1) is on. • Press both (+) and (-) (C and E) sensors simultaneously , and the hotplate is immediately switched off. • The hob can be switched off any time by pressing the ON/OFF sensor (A). By activating the child lock protection you can stop the operation of the ap ...

  • Gorenje IT640-ORA-W - page 10

    243971 During the time extra power is activated, the power of other hotplates is limited. This is indicated on the power display by intermittently showing the selected cooking level and limited power . Activating extra powerful setting • First select the hotplate by touching its relevant sensor , and immediately after press the sensor “P”. Ex ...

  • Gorenje IT640-ORA-W - page 11

    243971 Hint • If the power selection knob remains at level 0 three seconds after the automatic fast heating is activated, that is if you fail to select the power setting for regular cooking, the fast heating function is switched off. • If you remove the dish from the hotplate and then within the next ten minutes return it on the hotplate, the f ...

  • Gorenje IT640-ORA-W - page 12

    243971 Example: Set the hotplate to power level 6 and leave it operate for some time. If you do not change the above setting, the safety mechanism will switch the hotplate off after one hour and a half. Protection from overheating Induction hotplate is also fi tted with safety device against overheating which protects electronic parts from damages ...

  • Gorenje IT640-ORA-W - page 13

    243971 Remaining cooking time Y ou can display the remaining cooking time by touching the hotplate ON/OFF sensor (C). Switching the timer off When the preset time expires a beep is heard which you can either turn off by touching any sensor or leave it to turn of f automatically after 2 minutes. Switching the timer of prior expiry of preset time: ? ...

  • Gorenje IT640-ORA-W - page 14

    243971 • During the time the alarm is activated, timer can not be preset for any hotplate (to enable timer setting function, alarm must be switched off). The hob is equipped with the overheat safety sensors. When they are activated they turn off the hotplates nearest to the control board. Error , possible cause, remedy • Constant sound signal o ...

  • Gorenje IT640-ORA-W - page 15

    243971 Major stains are removed with special ceramic-glass cleansers. Follow strictly the manufacturer ’s instructions. Be careful to remove any remains of cleansing agent from the hob surface, otherwise they will be heated during the next use and can damage the hob ( fi g. 3). Stubborn and burnt stains are removed with special ceramic- glass sc ...

  • Gorenje IT640-ORA-W - page 16

    243971 Before inserting the appliance into the opening in the kitchen worktop, the supplied foam gasket must be attached to the lower side of the glass ceramic (glass) cooking hob (see fi gure above). Do not install the appliance without the foam gasket! The gasket should be attached to the appliance in the following way: - Remove the protective ? ...

  • Gorenje IT640-ORA-W - page 17

    243971 empty and no objects may be stored or kept there. • Rear side of the kitchen element must also have a 140 mm high opening along the entire width of the element, and the front part must have an opening of no less than 6 mm. • Incorporation of the oven under the induction hob is permissible for all EVP4, EVP2…, oven types, equipped with ...

  • Gorenje IT640-ORA-W - page 18

    243971 • The connection should be selected in accordance with the declared charge capacity of the mains and the fuse power . • Such appliances are allowed to be mounted on one side next to a high kitchen cabinet, the height of which may exceed that of the appliance. On the opposite side however , only a kitchen cabinet of equal height as the ap ...

  • Gorenje IT640-ORA-W - page 19

    WE RESERVE THE RIGHT TO AL TER THE SPECIFICA TIONS WITH NO INFLUENCE T O THE OPERA TION OF THE APPLIANCE. 243971 T echnical information Rating plate A Serial number B Code C Model D T ype E T rademark F T echnical information G Compliance indications / symbols 19 ...

  • Gorenje IT640-ORA-W - page 20

    SIVK - ORA ITO 243971/en (04-10) ...

Manufacturer Gorenje Category Stove

Documents that we receive from a manufacturer of a Gorenje IT640-ORA-W can be divided into several groups. They are, among others:
- Gorenje technical drawings
- IT640-ORA-W manuals
- Gorenje product data sheets
- information booklets
- or energy labels Gorenje IT640-ORA-W
All of them are important, but the most important information from the point of view of use of the device are in the user manual Gorenje IT640-ORA-W.

A group of documents referred to as user manuals is also divided into more specific types, such as: Installation manuals Gorenje IT640-ORA-W, service manual, brief instructions and user manuals Gorenje IT640-ORA-W. Depending on your needs, you should look for the document you need. In our website you can view the most popular manual of the product Gorenje IT640-ORA-W.

Similar manuals

A complete manual for the device Gorenje IT640-ORA-W, how should it look like?
A manual, also referred to as a user manual, or simply "instructions" is a technical document designed to assist in the use Gorenje IT640-ORA-W by users. Manuals are usually written by a technical writer, but in a language understandable to all users of Gorenje IT640-ORA-W.

A complete Gorenje manual, should contain several basic components. Some of them are less important, such as: cover / title page or copyright page. However, the remaining part should provide us with information that is important from the point of view of the user.

1. Preface and tips on how to use the manual Gorenje IT640-ORA-W - At the beginning of each manual we should find clues about how to use the guidelines. It should include information about the location of the Contents of the Gorenje IT640-ORA-W, FAQ or common problems, i.e. places that are most often searched by users in each manual
2. Contents - index of all tips concerning the Gorenje IT640-ORA-W, that we can find in the current document
3. Tips how to use the basic functions of the device Gorenje IT640-ORA-W - which should help us in our first steps of using Gorenje IT640-ORA-W
4. Troubleshooting - systematic sequence of activities that will help us diagnose and subsequently solve the most important problems with Gorenje IT640-ORA-W
5. FAQ - Frequently Asked Questions
6. Contact detailsInformation about where to look for contact to the manufacturer/service of Gorenje IT640-ORA-W in a specific country, if it was not possible to solve the problem on our own.

Do you have a question concerning Gorenje IT640-ORA-W?

Use the form below

If you did not solve your problem by using a manual Gorenje IT640-ORA-W, ask a question using the form below. If a user had a similar problem with Gorenje IT640-ORA-W it is likely that he will want to share the way to solve it.

Copy the text from the picture

Captcha
New picture

Comments (0)