Manual Redring 600

12 pages 2.3 mb
Download

Go to site of 12

Summary
  • Redring 600 - page 1

    SHOWER HANDBOOK IMPORTANT: Please retain this booklet for future reference ...

  • Redring 600 - page 2

    CONTENTS Page How to use your shower …………… 2 How your shower works …………… 3 What to do if things go wrong …………… 5 Installation instructions ………….... 6 How to maintain your shower …………… 10 Guarantee …………… 12 How to use your shower 1. Ensure the electricity and water are turned on to the unit 2 ...

  • Redring 600 - page 3

    Model 620 - Press button “C”. Th e electricity to the elements is then switched off, water will continue to flow for approximately 5 seconds before switching off. This reduces the temperature of the water in the unit. Switch the electricity off at the ceiling switch or local isolator. 10. Your shower is designed to stabilise temperature changes ...

  • Redring 600 - page 4

    throughout the year from 5 to 20 ° C. This means that in Wi nter, the flow rate will be less than in the Summer to achieve the same outlet temperature. In summer the ‘MED (medium)’ or ‘LOW’ power setti ng may give adequate hot water. The heaters are only switched on when sufficient water is flowing. This is done automatically with a switch ...

  • Redring 600 - page 5

    Check the spray plate is then free to rotate to give the three settings. In some winter conditions, when the incoming mains water is particularly cold it may be necessary to select the inner or outer spra y pattern only. This will ensure correct operation of the shower with a slightly lower water flow rate Note: After use it is normal for some wate ...

  • Redring 600 - page 6

    a) Water too HOT Water flow restricted by blockage in filter of solenoid valve. Switch o ff water and undo plastic nut on elbow, loosen br ass nut to swing elbow away from solenoid. Remove filter in solenoid with long nosed pliers and flush clean. b) Water too COLD Check circuit through thermal cut-out Check circuit through microswitch on the press ...

  • Redring 600 - page 7

    c) The handset must not be able to come into contact with any used water in the bath or basin. If it can, even after the hose has been retained by the hose retainer (see diagram 13) , then a vacuum breaker must be fitted. It should be noted that these devices are liable to minor leakage so they must be positioned so that any drips are not detriment ...

  • Redring 600 - page 8

    1. It is recommended that a WRAS (Water Regul ations Advisory Scheme) listed isolating valve is fitted between the rising main and the unit. This will allow the unit to be serviced or exchanged without having to turn off t he water at the mains stop valve. 2. The heater can be fed from a header tank provided this has a minimum head height of 10.5 m ...

  • Redring 600 - page 9

    You may be able to use 6mm² cable if Method 1 (clipped direct) is used. Remember to up-rate the cable if it runs in thermal insulation in a loft, or for a longer distance. 3. A means for disconnection in all poles must be incorporated in the fixed wiring in accordance with the wiring rules. We recommend ceiling switches. 4. Cut back cable as in di ...

  • Redring 600 - page 10

    d) That the holes in the sp ray plate are not blocked. e) Water flow can be adjusted by knob B. 9. DEMONSTRATE OPERATION TO USER 10. LEAVE THESE INSTRUCTIONS WITH THE USER FOR FUTURE REFERENCE. How to maintain your shower It is recommended that the shower unit, riser rail, hose etc. can be cleaned using a soft cloth and that the use of an abrasive ...

  • Redring 600 - page 11

    Diagram 13 11 ...

  • Redring 600 - page 12

    Full details of terms and conditions are available on request from: - APPLIED ENERGY PRODUCTS LTD. MORLEY WAY, PETERBOROUGH. PE2 9JJ. Tel +44 (0)1733 456789 Fax: +44 (0) 1733 310606 Website: www.redring.co.uk 555.2067.01A 12 ...

Manufacturer Redring Category Outdoor Shower

Documents that we receive from a manufacturer of a Redring 600 can be divided into several groups. They are, among others:
- Redring technical drawings
- 600 manuals
- Redring product data sheets
- information booklets
- or energy labels Redring 600
All of them are important, but the most important information from the point of view of use of the device are in the user manual Redring 600.

A group of documents referred to as user manuals is also divided into more specific types, such as: Installation manuals Redring 600, service manual, brief instructions and user manuals Redring 600. Depending on your needs, you should look for the document you need. In our website you can view the most popular manual of the product Redring 600.

A complete manual for the device Redring 600, how should it look like?
A manual, also referred to as a user manual, or simply "instructions" is a technical document designed to assist in the use Redring 600 by users. Manuals are usually written by a technical writer, but in a language understandable to all users of Redring 600.

A complete Redring manual, should contain several basic components. Some of them are less important, such as: cover / title page or copyright page. However, the remaining part should provide us with information that is important from the point of view of the user.

1. Preface and tips on how to use the manual Redring 600 - At the beginning of each manual we should find clues about how to use the guidelines. It should include information about the location of the Contents of the Redring 600, FAQ or common problems, i.e. places that are most often searched by users in each manual
2. Contents - index of all tips concerning the Redring 600, that we can find in the current document
3. Tips how to use the basic functions of the device Redring 600 - which should help us in our first steps of using Redring 600
4. Troubleshooting - systematic sequence of activities that will help us diagnose and subsequently solve the most important problems with Redring 600
5. FAQ - Frequently Asked Questions
6. Contact detailsInformation about where to look for contact to the manufacturer/service of Redring 600 in a specific country, if it was not possible to solve the problem on our own.

Do you have a question concerning Redring 600?

Use the form below

If you did not solve your problem by using a manual Redring 600, ask a question using the form below. If a user had a similar problem with Redring 600 it is likely that he will want to share the way to solve it.

Copy the text from the picture

Comments (0)