English dropdown-ico

Manual Hotpoint WM67

20 pages 5.31 mb
Download

Go to site of 20

Summary
  • Hotpoint WM67 - page 1

    Instruction Manual F or Models WM80, WM79, WM77, WM69, WM68, WM67, WM66 and WM60 Congratulations on the pur chase of your new W ashing Machine. IMPORT ANT INFORMA TION Please read this instruction book thoroughly before installing and using your appliance for the first time . ...

  • Hotpoint WM67 - page 2

    W ARNING: This appliance must be earthed. F uses Y our appliance comes fitted with a plug and a 13A fuse. If you need to replace the fuse , only those rated at 13A and AST A approv ed to BS1362 should be used.T o change fuse, lif t holder to vertical position and lift the fuse out. T o replace , insert fuse and push fuse holder down into locked pos ...

  • Hotpoint WM67 - page 3

    Electricity Supply ...................................... 2 Recycling & Disposal Information .............. 3 Installation Instructions 1. Choose a L ocation................................ 4 2. Remo ve T ransit Bracket ....................... 5 3. C onnect to the W ater Supply ................ 6 4. C onnect to a Drainage System 5. A djust the ...

  • Hotpoint WM67 - page 4

    1. Choose a Loc ation... The choice of location f or your appliance will influence its pe rformance. ● Position wher e possible on a solid floor . Vibration may occur wi th a wooden floor . ● T ake care with vinyl floor coverings. The weight of the appliance may cause indenta tions in some vinyl floor co verings. ● F or your safety and to com ...

  • Hotpoint WM67 - page 5

    W ARNINGS ● Before using appliance, remove tr ansit bracket , clamp and screws Retain parts for future transportation. ● Do not remove concrete weight. Replace work top lid and 3 screws. Remove 2 screws and transit bracket, retain. Remove 1 screw and clamp , retain. Fr om rear of appliance, grip sides of work top lid , lift, slide and pull towa ...

  • Hotpoint WM67 - page 6

    3. Connect to the W ater Supply ... ● Incoming hot and cold water pr essure should be between 3 and 150 psi (21 - 1034 Kpa). ● The temperatur e of the incoming household hot water supply shou ld ideally be 60°C and no higher than 70°C as this c ould cause damage to both your laundr y and appliance . ● The water supply taps must be easily ac ...

  • Hotpoint WM67 - page 7

    4. Connect to a Dr ainage Syst em... ● Do not remove hooked end support from drainage hose. ● Do not position standpipe near an electrical outlet. ● F or drainage into a standard work top sink ensure outlet pipe has a minimum bore of 32 mm. T o avoid syphoning ensure the end of the drainage hose is above the wat er level in the sink. If your ...

  • Hotpoint WM67 - page 8

    G etting t o K now Y our Applianc e Index Fro n t 1. Door Locked Indicator 2. Mains On/Off Button. 3. W ash Dial 4. V ariable Spin Speed Dial 5. Optional Wash F eature Buttons 2 available on Models WM80, WM 69, WM66 & WM60 4 available on Models WM79 WM77, WM68 & WM67 6. Interlocking Door & Release Button 7. Detergent/F abric Conditioner ...

  • Hotpoint WM67 - page 9

    Button Selection T o selec t, press button and button comes out. T o cancel, press again and button is flush with console. Interlocking Door System T o Open... Grip the door handle and press the button whilst pulling open the door (Fig 2). T o Close... Apply pressure at the 3 o ’clock position (Fig 3) un til the door clicks. Start of W ash, Final ...

  • Hotpoint WM67 - page 10

    IMPORT ANT INFORMA TION: Before selecting a programme, ensure the ma ins button is in the ‘OFF’ position. Add detergen t and or conditioner to the dispenser drawer , see pages 14-15. Ref er to detergent manufacturer’ s dosage instructions. Select required wash programme by turning the wash dial clockwise, you will hear a click as the pointer ...

  • Hotpoint WM67 - page 11

    40 60 95 C A 40 95 3kg to 5.5kg 5.5kg ****1200rpm ***1150rpm **1100rpm *1000rpm 15 - 25 120 - 130 400rpm Prewash B D F E G J K H IMPORT ANT INFORMA TION: The temperature of the inc oming water sup ply or selection of wash features: ie. Economy , Super Rinse etc, will a ffect programme times. Choosing a W ash Pr ogr amme Hotpoint recommend the Persi ...

  • Hotpoint WM67 - page 12

    Button Selection T o selec t an optional wash f eature, press button and a colour ba nd will become visible. Press again t o cancel. Option Buttons Economy W ash (for Models WM80, WM79, WM77, WM69, WM68, WM67 WM66 & WM60) Save money and time on lightly soiled loads. Lightly soiled clothes are washed at the temper ature of the incoming household ...

  • Hotpoint WM67 - page 13

    W eight of W ash Load T wo examples of typical wash loads for different types of fabric C OT T ON 2 Bath T owels 5 Shirts 6 Blouses 1 Set of Pyjamas 4 Sets of Under wear = 5.5kg SYNTHETIC 2 Children ’ s Dresses 4 Shirts 4 Blouses 1 Set of Pyjamas 4 Sets of Under wear = 3kg W ashcar e Tips Before washing laundry :- ● Pre-tr eat stains. ● Close ...

  • Hotpoint WM67 - page 14

    The Dispenser Dr awer Choose a Suitable Detergent ● Hotpoint recommend the P ersil range of detergent products. ● Select ‘low suds’ automatic powder , designed specifically for aut oma tic washing machines or washer/dryers. ● F ollow manufacturer ’ s dosage recommendations. Do not under dose, you will not achiev e a clean wash for your ...

  • Hotpoint WM67 - page 15

    T o obtain claimed energy label wash performance for a 60°C cotton wash, dispense powder detergent in a dosing ball, placed in an upright position in the centre of the wash load (F ig 5). T o receive a ‘FREE’ dosing ball, phone: UK 0800 243 131 or Republic of Ireland: 1800 386 386 Dispensing P owder Detergent T o achieve optimum wash results w ...

  • Hotpoint WM67 - page 16

    Removing and Cleaning the Dispenser Draw er & Compartments Note: It is advisable to clean the dispenser drawer regularly . Re-locate dispenser drawer and push firmly back into place. W ARNING ● Do not clean any par t of your appliance with abrasive cleaners , scouring agents, acids, chlorine based bleach or metal polish as they may cause dama ...

  • Hotpoint WM67 - page 17

    T roubleshooting ... If the appliance is still not working contact: Ser vice UK: 08709 066 066 Republic of Ireland:1850 302 200 you will be asked for the follo wing information:- ● Name, address and post code ● T elephone number ● Model/serial number and colour , which can be found on the inside of the door ● Date of purchase ● Clear and ...

  • Hotpoint WM67 - page 18

    18 Hotpoint appliances carry for the first 12 months a fully inclusive parts and labour guarantee plus FREE replacement parts for the first 5 years provided tha t they are fitted by our own Ser vice Engineer . When the 12 months parts and labour guarantee expires we off er two after sale service options: Repair Ser vice UK: 08709 066 066 or Republi ...

  • Hotpoint WM67 - page 19

    Fr om the moment your appliance is delivered , Hotpoint guarantees it f or five years. ● Hotpoint appliances carry a fully inclusive 12 months parts and labour guarantee plus FREE replacement parts for the first five years provided tha t they are fitted by our own Service Engineer (evidence will be required of date and place of purchase). ● All ...

  • Hotpoint WM67 - page 20

    Key C ontac ts Ser vice UK: 08709 066 066 Republic of Ireland: 1850 302 200 Y ou will be asked to quote the Model Number and Serial Number, which can be found on the inside of the door . Genuine Parts & Accessories Mail Order Hotline UK: 08709 077 077 Republic of Ireland: (01) 842 6836 Extended W arranty T o join: UK 08709 088 088 Republic of I ...

Manufacturer Hotpoint Category Washer

Documents that we receive from a manufacturer of a Hotpoint WM67 can be divided into several groups. They are, among others:
- Hotpoint technical drawings
- WM67 manuals
- Hotpoint product data sheets
- information booklets
- or energy labels Hotpoint WM67
All of them are important, but the most important information from the point of view of use of the device are in the user manual Hotpoint WM67.

A group of documents referred to as user manuals is also divided into more specific types, such as: Installation manuals Hotpoint WM67, service manual, brief instructions and user manuals Hotpoint WM67. Depending on your needs, you should look for the document you need. In our website you can view the most popular manual of the product Hotpoint WM67.

Similar manuals

A complete manual for the device Hotpoint WM67, how should it look like?
A manual, also referred to as a user manual, or simply "instructions" is a technical document designed to assist in the use Hotpoint WM67 by users. Manuals are usually written by a technical writer, but in a language understandable to all users of Hotpoint WM67.

A complete Hotpoint manual, should contain several basic components. Some of them are less important, such as: cover / title page or copyright page. However, the remaining part should provide us with information that is important from the point of view of the user.

1. Preface and tips on how to use the manual Hotpoint WM67 - At the beginning of each manual we should find clues about how to use the guidelines. It should include information about the location of the Contents of the Hotpoint WM67, FAQ or common problems, i.e. places that are most often searched by users in each manual
2. Contents - index of all tips concerning the Hotpoint WM67, that we can find in the current document
3. Tips how to use the basic functions of the device Hotpoint WM67 - which should help us in our first steps of using Hotpoint WM67
4. Troubleshooting - systematic sequence of activities that will help us diagnose and subsequently solve the most important problems with Hotpoint WM67
5. FAQ - Frequently Asked Questions
6. Contact detailsInformation about where to look for contact to the manufacturer/service of Hotpoint WM67 in a specific country, if it was not possible to solve the problem on our own.

Do you have a question concerning Hotpoint WM67?

Use the form below

If you did not solve your problem by using a manual Hotpoint WM67, ask a question using the form below. If a user had a similar problem with Hotpoint WM67 it is likely that he will want to share the way to solve it.

Copy the text from the picture

Captcha
New picture

Comments (0)