English dropdown-ico

Manual Swisher E4-S3000

20 pages 4.31 mb
Download

Go to site of 20

Summary
  • Swisher E4-S3000 - page 1

    SWISH ER OWNER'S/OPERATOR'S MAN UAL E4--$3000 FR|MMER E4-$3000 Minimize the risk of injury to yourself and others! Read this manual and familiarize yourself with the contents. Always wear eye and hearing protection when operating this unit. Part Number 81950 Rev.12/07 ...

  • Swisher E4-S3000 - page 2

    introduction The Swisher E4-$3000 hand held power equipment has been designed and built to deliver superior performance and reliability without compromise to quality, comfort, safety or durability. Swisher engines represent the leading edge of high-performance engine technology, deliv- ering exceptionally high power with remarkably low displacement ...

  • Swisher E4-S3000 - page 3

    General Safety Instructions Work Safely Swisher trimmers operate at very high speeds and can do serious damage or injury if they are misused or abused. Never allow a person without la_ainingor insh_uction to operate this unit! lk WARNING! Never make unauthorized attachment installations. Do not use attachments not approved by Swisher for use on thi ...

  • Swisher E4-S3000 - page 4

    Be Aware of the Working Environment Avoid long-term operation in very hot or very cold weather. Reduce the risk of bystanders being by flying debris. Make sure no one is within 50 feet (15 meters)--that's about 16 paces--of an operating attachment. Make sure bystanders or observers outside the 50-foot "danger zone" wear eye protectio ...

  • Swisher E4-S3000 - page 5

    Product Description Outer Tube Cutting Attachment Shield E4-$3000 TRIMMER Throttle Interlock Fuel Tank Gear Case Throttle Trigger Ignition Switch Handle Using the accompanying illustrations as a guide, familiarize yourself with this unit and its various components. See Figure 4. Understanding your unit helps ensure top performance, long service lif ...

  • Swisher E4-S3000 - page 6

    Assemb|y and Adjustments Handle 1. Position the handle on the outer tube as shown. See Figure 3. 2. Install the mounting bracket with the socket head cap screws. Tighten the screws finger-tight ONLY at this time. 3. Ix)care the handle in the best position for operator comfort (usually about 10 inches ahead of the throttle assembly). 4. Secure the h ...

  • Swisher E4-S3000 - page 7

    Assembly and Adjustments Cutting Attachment Shield Head Cap __ Screw Bracket __-_-i Outer Tube E4-$3000 Cutting Attachment Shield Shim __ Nuts I Cutting Attachment Retaining Mounting Plate Nut Figure 9 Shim Line Cutter Figure 9A Scre ws Install the Cutting Attachment Shield E4-$3000 1. Insert the cutting attachment shield between the outer tube and ...

  • Swisher E4-S3000 - page 8

    Install the Trimmer Head _ WARNING! A standard grass trimmer machine should NEVER be oper- ated with blade-type attachments. 1. Turn the trimmer over so that the gearcase output shaft faces UR See Figure 5. 2. Remove and discard the plastic retain- ing plug. 3. Position the tool holder as shown, and slide the holder onto the output shaft. See Figur ...

  • Swisher E4-S3000 - page 9

    Starting the Engine ,_ WARNING! The cutting attachment may rotate when the engine is started! _ WARNING! Never start the engine with- out the tool assembly and cutting attachments installed to the engine. Failure to do so could damage the engine and increase unexpected risk to the operator and any bystander. _h_ ARN|NG! Never start the engine from ...

  • Swisher E4-S3000 - page 10

    Stopping the Engine OFF ure 21 E4-$3000 Idle the engine briefly before stopping (about 2 minutes), then slide the ignition switch to the "O" (Engine OFF) position. Adjusting Engine |die __lJ Figure 22 Idle The engine must return to idle speed whenever the throttle lever is released. Idle speed is adjustable, and must be set low enough to ...

  • Swisher E4-S3000 - page 11

    Shoulder Strap Operating With A Trimmer Head Although a shoulder strap accessory is not required for use with a grass trimmer, a shoulder strap can increase operator comfort during extended periods of operation. See Figure 23. Adjust the shoulder strap so the shoulder pad rests comfortably on the off-side shoulder and the cutting path of the cuttin ...

  • Swisher E4-S3000 - page 12

    General Maintenance MAINTENANCE, REPLACEMENT OR RE-PAIR OF EMISSION CONTROL DEVICES AND SYSTEMS MAY BE PER- FORMED BYANY REPAIR ESTABLISH- MENT OR INDIVIDUAL; HOWEVER, WARRANTY REPAIRS MUST BE PER- FORMED BYA DEALER OR SERVICE CENTER AUTHORIZED BY SWISHER. THE USE OF PARTS THATARE NOT EQUIVALENT IN PERFORMANCE AND DURABILITY TO AUTHORIZED PARTS MAY ...

  • Swisher E4-S3000 - page 13

    10/15-Hour Maintenance 0.024-0.028 inch (0.6-0. 7 mm) Clean the spark plug and check the gap at the electrode. Figure 29 Every 10 to 15 hours of operation: Remove and clean the spark plug. Adjust the spark plug electrode gap to 0.024 - 0.028 inch (0.6 - 0.7 ram). If the spark plug must be replaced, use only an NGK CMR5H or equivalent resistor type ...

  • Swisher E4-S3000 - page 14

    139/150-Hour Maintenance Maintenance after first 139-hours, then every 150-hours thereafter. Combustion chamber should be decar- bonized, and the valve clearance should be adjusted. It is highly recommended that this is done by a Swisher-trained service technician. Valve Adjustment 1. Remove cylinder cover, rocker arm cover, and spark plug. Rotate ...

  • Swisher E4-S3000 - page 15

    Long Term Storage Whenever the unit will not be used for 30 days or longer, use the following proce- dures to prepare it for storage: II Clean external parts thoroughly. II Drain all the fuel from the fuel tank. All stored fuels should be stabilized with a fuel stabilizer such as STA-BIL TM, if Swisher E4 Engine Oil with fuel stabilizer is not used ...

  • Swisher E4-S3000 - page 16

    Troub|eshootin Guide What To Check Does the engine crank? YES 1 Good compression? YES Does the tank contain fresh fuel of the proper grade? Possible Cause _ aulty recoil starter. Flnkt in the crankcase. Internal damage. I NO I Ix)ose spark plug. Excess wear on cylinder, piston, rings. / Valves not seating. YES Jr NO I Fuelincorrect, stale or contam ...

  • Swisher E4-S3000 - page 17

    Troubleshooting Guide (continued) Symptom Poor acceleration. Engine stops abruptly. [Engine difficult to shut off._ Possible Cause Clogged air filter, Clogged fuel filter, Lean fuel/air mixture. Idle speed set too low. Switch turned off. Fuel tank empty, Clogged fuel filter, Water in the fuel, Shorted spark plug or loose terminal, Ignition failure. ...

  • Swisher E4-S3000 - page 18

    NOTES 18 ...

  • Swisher E4-S3000 - page 19

    NOTES 19 ...

  • Swisher E4-S3000 - page 20

    Emission System Warranty Statement (Administered by Shindaiwa Corporation) Your Warranty Rights and Obligations The California Air Resources Board, the U.S. Environmental Protection Agency and Shindaiwa Corporation are pleased to explain the exhaust and evaporative emission control system war- ranty on your new small off-road (non-road) engine. In ...

Manufacturer Swisher Category Trimmer

Documents that we receive from a manufacturer of a Swisher E4-S3000 can be divided into several groups. They are, among others:
- Swisher technical drawings
- E4-S3000 manuals
- Swisher product data sheets
- information booklets
- or energy labels Swisher E4-S3000
All of them are important, but the most important information from the point of view of use of the device are in the user manual Swisher E4-S3000.

A group of documents referred to as user manuals is also divided into more specific types, such as: Installation manuals Swisher E4-S3000, service manual, brief instructions and user manuals Swisher E4-S3000. Depending on your needs, you should look for the document you need. In our website you can view the most popular manual of the product Swisher E4-S3000.

Similar manuals

A complete manual for the device Swisher E4-S3000, how should it look like?
A manual, also referred to as a user manual, or simply "instructions" is a technical document designed to assist in the use Swisher E4-S3000 by users. Manuals are usually written by a technical writer, but in a language understandable to all users of Swisher E4-S3000.

A complete Swisher manual, should contain several basic components. Some of them are less important, such as: cover / title page or copyright page. However, the remaining part should provide us with information that is important from the point of view of the user.

1. Preface and tips on how to use the manual Swisher E4-S3000 - At the beginning of each manual we should find clues about how to use the guidelines. It should include information about the location of the Contents of the Swisher E4-S3000, FAQ or common problems, i.e. places that are most often searched by users in each manual
2. Contents - index of all tips concerning the Swisher E4-S3000, that we can find in the current document
3. Tips how to use the basic functions of the device Swisher E4-S3000 - which should help us in our first steps of using Swisher E4-S3000
4. Troubleshooting - systematic sequence of activities that will help us diagnose and subsequently solve the most important problems with Swisher E4-S3000
5. FAQ - Frequently Asked Questions
6. Contact detailsInformation about where to look for contact to the manufacturer/service of Swisher E4-S3000 in a specific country, if it was not possible to solve the problem on our own.

Do you have a question concerning Swisher E4-S3000?

Use the form below

If you did not solve your problem by using a manual Swisher E4-S3000, ask a question using the form below. If a user had a similar problem with Swisher E4-S3000 it is likely that he will want to share the way to solve it.

Copy the text from the picture

Captcha
New picture

Comments (0)