-
Powerware 3110 - page 1
POWERWARE ® 3110 250 VA600 VA User's Guide www.powerware.com B ...
-
Powerware 3110 - page 2
Powerware is a registered trademark of Powerware Corporation. Copyright 2001 Powerware Corporation, Raleigh, NC, USA. All rights reserved. No part of this document may be reproduced in any way without the express written approval of Powerware Corporation. ...
-
Powerware 3110 - page 3
i Powerware ® 3110 User's Guide 05147486 B (English) Uncontrolled Copy T ABLE OF C ONTENTS 1 Installation 1 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Inspecting the Equipment 1 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ...
-
Powerware 3110 - page 4
Table of Contents ii Powerware ® 3110 User's Guide 05147486 B (English) Uncontrolled Copy ...
-
Powerware 3110 - page 5
1 Powerware ® 3110 User's Guide 05147486 B (English) Uncontrolled Copy C H A P T E R 1 I NSTALLATION This section explains: Equipment inspection Safety precautions UPS installation UPS top and side panels Inspecting the Equipment If any equipment has been damaged during shipment, keep the shipping cartons and packing mater ...
-
Powerware 3110 - page 6
Installation 2 Powerware ® 3110 User's Guide 05147486 B (English) Uncontrolled Copy To reduce the risk of fire or electric shock, install this UPS in a temperature and humidity controlled, indoor environment, free of conductive contaminants. Ambient temperature must not exceed 40°C (104°F). Do not operate near water or excessive hum ...
-
Powerware 3110 - page 7
Installation 3 Powerware ® 3110 User's Guide 05147486 B (English) Uncontrolled Copy 3. Start the UPS by pressing the switch as shown in Figure 3 or Figure 4 on page 4. The Power indicator illuminates indicating that power is available from the UPS output receptacles. The units beeps and the front panel LEDs illuminate several times. The g ...
-
Powerware 3110 - page 8
Installation 4 Powerware ® 3110 User's Guide 05147486 B (English) Uncontrolled Copy Fault Indicator Output Receptacles (Battery and Surge Protection) Output Receptacles (Surge Protection Only) Power Indicator Figure 2. 230V Model Top Panel Circuit Breaker Power Cord Network Transient Protector Communication Port On/Standby Switch Figure 3 ...
-
Powerware 3110 - page 9
5 Powerware ® 3110 User's Guide 05147486 B (English) Uncontrolled Copy C H A P T E R 2 F EATURES This section covers: Using the communication port Starting the UPS on battery Communication Port Powerware Corporation offers an accessory interface kit that allows you to connect many types of computer systems to the UPS communication ...
-
Powerware 3110 - page 10
Features 6 Powerware ® 3110 User's Guide 05147486 B (English) Uncontrolled Copy Battery Start Feature The Battery Start feature allows you to turn on the UPS when utility power is not available. The battery-start range is up to about 40% of nominal input; otherwise, the UPS displays an input voltage fault and the alarm beeps. Network Tran ...
-
Powerware 3110 - page 11
7 Powerware ® 3110 User's Guide 05147486 B (English) Uncontrolled Copy C H A P T E R 3 UPS M AINTENANCE This section explains how to: Care for the UPS and batteries Replace the batteries Recycle used batteries UPS and Battery Care For the best preventive maintenance, keep the area around the UPS clean and dustfree. If the a ...
-
Powerware 3110 - page 12
UPS Maintenance 8 Powerware ® 3110 User's Guide 05147486 B (English) Uncontrolled Copy C A U T I O N The 230V Models require replacement by qualified service personnel. 1. Contact your service representative to order a replacement battery. It must be the same type and rating as the original battery (see Table 3 on page 12). 2. Switch off ...
-
Powerware 3110 - page 13
UPS Maintenance 9 Powerware ® 3110 User's Guide 05147486 B (English) Uncontrolled Copy 10. Replace the battery cover by pushing the cover until it snaps into place securely. Replace any battery cover screws that were removed to access the battery. 11. Turn the UPS right side up. Reconnect the UPS power cord and turn the unit on. 12. Recon ...
-
Powerware 3110 - page 14
UPS Maintenance 10 Powerware ® 3110 User's Guide 05147486 B (English) Uncontrolled Copy ...
-
Powerware 3110 - page 15
11 Powerware ® 3110 User's Guide 05147486 B (English) Uncontrolled Copy C H A P T E R 4 S PECIFICATIONS Powerware Corporation reserves the right to change specifications without prior notice. Table 2. Electrical 120V Model 230V Model Nominal Voltage 120V 230V Power Factor 0.67 Voltage Range Online: 90152V On Battery: 0100V and 152? ...
-
Powerware 3110 - page 16
Specifications 12 Powerware ® 3110 User's Guide 05147486 B (English) Uncontrolled Copy Table 3. Battery Configuration 250 VA: (1) 12V or (2) 6V, 4.2 Ah internal battery(s) 425 VA: (1) 12V, 7 Ah internal battery 600 VA: (1) 12V, 9 Ah internal battery Voltage 12 Vdc Type Sealed, maintenancefree, valveregulated, leadacid Charging 8 ...
-
Powerware 3110 - page 17
13 Powerware ® 3110 User's Guide 05147486 B (English) Uncontrolled Copy C H A P T E R 5 T ROUBLESHOOTING The front panel LEDs and an audible beep indicate the UPS status (see Table 6). The UPS beeps whenever the unit is on battery power or an alarm is present. Table 6. Troubleshooting Alarm or Condition Possible Cause What to Do Normal op ...
-
Powerware 3110 - page 18
Troubleshooting 14 Powerware ® 3110 User's Guide 05147486 B (English) Uncontrolled Copy What to Do Possible Cause Alarm or Condition 1 beep every half second. Power requirements exceed the UPS capacity. Remove some of the equipment from the UPS. You may need to obtain a larger capacity UPS. Output short circuit. Turn off or unplug the equ ...
Do you have a question concerning Powerware 3110?
Use the form below
If you did not solve your problem by using a manual Powerware 3110, ask a question using the form below. If a user had a similar problem with Powerware 3110 it is likely that he will want to share the way to solve it.