English dropdown-ico

Manual JBL S4800

20 pages 0.93 mb
Download

Go to site of 20

Summary
  • JBL S4800 - page 1

    S4 800 3- WA Y FLOORST ANDING SPEAKER SYSTEM ® OWNER’S GUIDE S4800 OM 10/11/05 1:51 PM Page 1 ...

  • JBL S4800 - page 2

    3 PREF ACE 4 CHAPTER 1 – THE S4800 LOUDSPEAKER: A TRIUMPH IN ACOUSTICS AND TECHNOLOGY 8 CHAPTER 2 – UNP ACKING THE S4800 SYSTEM 8 CHAPTER 3 – SELECTING CABLE 9 CHAPTER 4 – AMPLIFIER RECOMMENDA TIONS 10 CHAPTER 5 – PLACEMENT AND SETUP CONSIDERA TIONS 11 CHAPTER 6 – S4800 SWITCH OPERA TIONS 11 CONTROLS AND CONNECTIONS 15 CHAPTER 7 – CAR ...

  • JBL S4800 - page 3

    PREF ACE T hank you for selecting a JBL ® S4800 loudspeaker system. It represents the sum total of our research and developmental efforts in sound reproduction over the last half-century . We have labored to create a loudspeaker system with no acoustical or elec- trical limitations whatsoever . While the S4800 loudspeaker is itself a new developme ...

  • JBL S4800 - page 4

    The new S4800 employs a 3-way , three-driver design, incorporating an ultrahigh- frequency (UHF) com- p ression driver a nd horn to repro- duce high frequencies up to 40kHz. With the UHF handling the ultrahigh frequencies, the high-frequency (HF) transducer could then be upgraded to a new design using a 3-inch diaphragm for better repro- duction of ...

  • JBL S4800 - page 5

    The following sections describe the primary features and compo- nents of the S4800 loudspeaker system. The enclosure of the S4800 is specially designed to transfer unwanted mechanical energy away from any acoustically active surfaces, virtually eliminating coloration. The massive enclosure, along with its specially designed brass modular feet, coup ...

  • JBL S4800 - page 6

    is attached to a die-cast alu- minum-alloy frame. This provides accurate, rigid support for the motor and cone mounting points, as well as doubling as a massive heatsink by providing a huge sur - face area for heat dissipation. The 1500FE has a central cooling duct that effectively cools the voice coil and reduces the likeli - hood of hot spots. By ...

  • JBL S4800 - page 7

    045TI PURE-TIT ANIUM DIAPHRAGM/ NEOD YMIUM MAGNET UL TRAHIGH-FREQUENCY COMPRESSION DRIVER See Figure 5. The 045T i utilizes the same princi- ples as the 435AL, in a smaller foot - print so that a frequency response up to 40kHz can be achieved. INTERNAL CROSSOVER NETWORK Each loudspeaker unit has two internal dividing networks, one for the LF transd ...

  • JBL S4800 - page 8

    CHAPTER 2 – UNP ACKING THE S4800 SYSTEM All components of the S4800 sys- tem have been very carefully packed for maximum protection against damage. As with any superior audio product, i t is advisable to keep the original packing materials in case it is n ecessary to transport the S4800 system. Because of the bulk and weight of this loudspeaker , ...

  • JBL S4800 - page 9

    CHAPTER 4 – AMPLIFIER RECOMMENDA TIONS No single type of amplifier is specified for use with the S4800 system. The speakers are highly efficient and will operate ade- qu at ely with an amplifier or receiver of 70–100 watts. However , the transient response a nd audio definition of a high-end system such as the S4800 will pick up all inefficienc ...

  • JBL S4800 - page 10

    C HAPTER 5 – PLACEMENT AND SETUP CONSIDERA TIONS The S4800 loudspeaker system is designed to be less affected by room acoustics than conventional imaging systems. However , it is very sensitive to overall symmetry , and proximity to walls, ceilings and c orners. I deally , any listening room should contain a combination of live sur- faces (e.g., ...

  • JBL S4800 - page 11

    The S4800 has an HF trim switch mounted on the network panel on the rear of the enclosure. The HF T rim Switch £ adjusts the high-frequency level over the range of approximately 1000Hz to 10kHz. The +1dB position gives the h ighest HF output and measures the most level. 0dB reduces the HF level by 1dB, and the – 1dB position reduces the HF level ...

  • JBL S4800 - page 12

    SHORTING STRAPS T he S4800 is shipped with shorting straps installed between its low- f requency and high-frequency terminals. Please see Figure 8. T o prepare the S4800 for bi-wire o peration, these straps must be removed by completely unscrewing each binding-post knob, removing the straps, and replacing the knob. Speaker wires can then be con- ne ...

  • JBL S4800 - page 13

    13 Mod el S 4800 HF - UHF HF - T RIM LF INP UT JBL In cor por ate d, Nor thr idg e, Cal ifo rni a U SA +1d B +0d B –1d B – – Figure 10. Connecting speaker wires using banana plugs. (Passive Connection Method) Mod el S 4800 HF - UHF HF - T RIM LF INP UT JBL In cor por ate d, Nor thr idg e, Cal ifo rni a U SA +1d B +0d B –1d B – – Figure ...

  • JBL S4800 - page 14

    I n all cases, the left and right amplifiers for each section must be identical. Make sure that the input sensitivity of the amplifier for each section is equal, or that input level controls are provided to maintain the proper low-to-mid/high bal- ance. If two identical stereo ampli- fiers are used, one may be located near each loudspeaker and driv ...

  • JBL S4800 - page 15

    CHAPTER 7 – CARE AND MAINTENANCE The S4 80 0 loudspeaker system is sprayed in a polyurethane finish and requires no maintenance o ther than an occasional dusting with a soft, dry , lint-free cotton cloth. The horns may also be wiped with a soft cloth. T reat the surface very carefully to avoid scratching the finish. T o remove fingerprints and sm ...

  • JBL S4800 - page 16

    C HAPTER 8 – TROUBLESHOOTING AND SERVICE GUIDE S4 80 0 loudspeakers are designed to provide years of trouble-free service. If you are experiencing difficul- ties, we suggest you check these p ossibilities before contacting your J BL specialist dealer for a ssistance. IF THERE IS NO SOUND FROM ANY OF THE SPEAKERS: • Check that the receiver/ampli ...

  • JBL S4800 - page 17

    17 S 4800 SPECIFICA TIONS POWER HANDLING: 300W (RMS)* FREQUENCY RESPONSE: 55Hz – 40kHz (– 6dB) LOW-FREQUENCY EXTENSION: 28Hz (–10dB) SENSITIVITY : 93dB (2.83V/1m) NOMINAL IMPEDANCE: 8 Ohms CROSSOVER FREQUENCIES: 900Hz, 8kHz LOW-FREQUENCY DRIVER: 15" (380mm) Kevlar ® -composite- cone woofer (1500FE) HIGH-FREQUENCY DRIVER: 3" (75mm) ...

  • JBL S4800 - page 18

    JBL, Harman International and Bi-Radial are trademarks of Harman International Industries, Incorporated, registered in the United States and/or other countries. SonoGlass, Symmetrical Field Geometry (SFG) and Pro Sound Comes Home are trademarks of Harman International Industries, Incorporated. Monster Cable is a registered trademark of Monster Cabl ...

  • JBL S4800 - page 19

    19 N OTES: S4800 OM 10/11/05 1:51 PM Page 19 ...

  • JBL S4800 - page 20

    PRO SOUND COMES HOME ™ JBL Consumer Products 250 Crossways Park Drive Woodbury , NY 11797 USA 2 route de T ours 72500 Chateau du Loir , France 516.255.4JBL (USA only) www .jbl.com © 2005 Harman International Industries, Incorporated. All rights reserved. Part No. 361054-001 ® S4800 OM 10/11/05 1:51 PM Page 20 ...

Manufacturer JBL Category Speaker

Documents that we receive from a manufacturer of a JBL S4800 can be divided into several groups. They are, among others:
- JBL technical drawings
- S4800 manuals
- JBL product data sheets
- information booklets
- or energy labels JBL S4800
All of them are important, but the most important information from the point of view of use of the device are in the user manual JBL S4800.

A group of documents referred to as user manuals is also divided into more specific types, such as: Installation manuals JBL S4800, service manual, brief instructions and user manuals JBL S4800. Depending on your needs, you should look for the document you need. In our website you can view the most popular manual of the product JBL S4800.

Similar manuals

A complete manual for the device JBL S4800, how should it look like?
A manual, also referred to as a user manual, or simply "instructions" is a technical document designed to assist in the use JBL S4800 by users. Manuals are usually written by a technical writer, but in a language understandable to all users of JBL S4800.

A complete JBL manual, should contain several basic components. Some of them are less important, such as: cover / title page or copyright page. However, the remaining part should provide us with information that is important from the point of view of the user.

1. Preface and tips on how to use the manual JBL S4800 - At the beginning of each manual we should find clues about how to use the guidelines. It should include information about the location of the Contents of the JBL S4800, FAQ or common problems, i.e. places that are most often searched by users in each manual
2. Contents - index of all tips concerning the JBL S4800, that we can find in the current document
3. Tips how to use the basic functions of the device JBL S4800 - which should help us in our first steps of using JBL S4800
4. Troubleshooting - systematic sequence of activities that will help us diagnose and subsequently solve the most important problems with JBL S4800
5. FAQ - Frequently Asked Questions
6. Contact detailsInformation about where to look for contact to the manufacturer/service of JBL S4800 in a specific country, if it was not possible to solve the problem on our own.

Do you have a question concerning JBL S4800?

Use the form below

If you did not solve your problem by using a manual JBL S4800, ask a question using the form below. If a user had a similar problem with JBL S4800 it is likely that he will want to share the way to solve it.

Copy the text from the picture

Captcha
New picture

Comments (0)