Manual Husky Baby Carrier

19 pages 0.57 mb
Download

Go to site of 19

Summary
  • Husky Baby Carrier - page 1

    Husky User Guide P2219_R03.qxd 8/18/2004 11:04 AM Page 1 ...

  • Husky Baby Carrier - page 2

    T able of Contents Safety W arnings . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 Safety Information . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 Child Restraint Features . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6 V ehicle Safety Belts . . . . . . . . . . ...

  • Husky Baby Carrier - page 3

    3 2 • Use only with children who weigh between 22 and 80 pounds (10 and 36 kg) and whose height is 53 inches (134 cm) or less. • Snugly adjust the belts provided with this child restraint ar ound your child. A snug strap should not allow any slack. It lies in a relatively straight line without sagging. It does not press on the child’ s flesh ...

  • Husky Baby Carrier - page 4

    5 4 Safety Information Safety Information • This child restraint system conforms to all applicable Federal motor vehicle safety standards. This Restraint is Not Certified for Use in Aircraft. • Fill out the registration card and mail it in today! Child restraints could be recalled for safety r easons. Y ou must register this restraint to be r e ...

  • Husky Baby Carrier - page 5

    7 6 Child Restraint Features Child Restraint Features 1 2 5 3 4 7 8 9 10 13 11 11 6 12 1 Cover 2 Harness Slots 3 Harness 4 Comfort Pads 5 Harness Retainer 6 Chest Clip 7 HUGS™ Shoulder Pads 8 Buckle 9 Belly Pad 10 Harness Release Lever (under flap) 2 14 15 17 11 18 16 11 LA TCH Connector 12 Perma-Book™ (under cover) 13 Harness Adjuster Strap 14 ...

  • Husky Baby Carrier - page 6

    8 V ehicle Seating Positions V ehicle Safety Belts NOTE: The information in this section only applies to installation with vehicle seat belts. IMPORT ANT : Some vehicles have no seating positions which are compatible with this child restraint, or any other child restraint. If in doubt, contact your vehicle manufacturer for assistance. The following ...

  • Husky Baby Carrier - page 7

    10 11 Installation LA TCH Installation Figure A illustrates a typical LA TCH installation. 1 V erify that your vehicle is equipped with LA TCH anchors. • If LATCH anchors are not installed, you must use standard vehicle belt installation methods. 2 Insert recline bar into holes on rear of restraint ( see page 20 ) . 3 If stored, remove LA TCH con ...

  • Husky Baby Carrier - page 8

    13 12 Installation 5 V erify that the vehicle belt is not twisted, then buckle ( Fig. D ) . 6 While kneeling on the restraint to push it firmly into the vehicle backrest, remove all slack from the vehicle belt. • First remove slack from the lap portion of the vehicle belt, then the shoulder portion (Fig. E & F). 7 V erify that the vehicle bel ...

  • Husky Baby Carrier - page 9

    4 V erify that the vehicle belt is not twisted, then buckle ( Fig. D ) . 5 While kneeling on the restraint to push it firmly into the vehicle backrest, remove all slack fr om the vehicle belt. • First remove slack from the lap portion of the vehicle belt, then the shoulder portion (Fig. E). 6 V erify that the vehicle belt is tight and the child r ...

  • Husky Baby Carrier - page 10

    17 16 Installation Installation Lap Belt Installation Short Route Figure A illustrates a typical short route lap belt installation. W ARNING: • Always use recline bar when installing restraint in vehicle using short route with vehicle lap belt. • Do not install this restraint using a non-locking ELR vehicle belt, unless a belt shortening clip i ...

  • Husky Baby Carrier - page 11

    19 18 V ersa-T ether ® V ersa-T ether ® W ARNING: A TT ACH THE VERSA-TETHER ONL Y TO TETHER ANCHORS IDENTIFIED BY YOUR VEHICLE MANUF ACTURER AS TETHER ANCHORAGE POINTS. USE OF OTHER LOCA TIONS IS NOT APPROVED OR PERMITTED. • AL W A YS USE THE VERSA-TETHER FOR CHILDREN WEIGHING MORE THAN 50 POUNDS (22.6 KG). • Britax ® recommends that the tet ...

  • Husky Baby Carrier - page 12

    21 20 Using Restraint Features Using the Buckle Fastening the Buckle 1 Hold the buckle with one hand. 2 Use your other hand to insert one tongue at a time into the buckle. Proper connection is confirmed with a positive click, after inserting the second buckle tongue ( Fig. C ) . Releasing the Buckle 1 Brace the rear of the buckle with hand. 2 Use t ...

  • Husky Baby Carrier - page 13

    23 22 Securing Y our Child Securing Y our Child Once the child restraint has been installed in the vehicle, follow these instructions to secure your child in the child restraint. IMPORT ANT : Before securing your child in the restraint, always check the adjuster area for debris (e.g. food, coins, toys, etc.). If debris is present, it must be remove ...

  • Husky Baby Carrier - page 14

    The buckle has two positions and should be adjusted to fit your child ( Fig. D ). Select the slot closest to, but not under , the child. W ARNING: Do not use position two (2) until child exceeds 50 pounds (22.6 kg)! Remove the buckle, then rethread in appropriate position. See page 28 for buckle removal and rethr eading instructions. 25 24 Harness ...

  • Husky Baby Carrier - page 15

    27 26 Care and Maintenance Care and Maintenance Cover Removal 1 Loosen the harness, by lifting the harness release lever while pulling the shoulder straps forward as far as possible. 2 Unhook the shoulder straps from the yoke, on the rear of child restraint. 3 Pull upper harness straps through the shell and cover , to the front of the restraint. 4 ...

  • Husky Baby Carrier - page 16

    29 28 Care and Maintenance Care and Maintenance Cleaning the Buckle If your child eats and drinks while in the restraint, you may need to check the buckle periodically and wash out any accumulated debris or dried liquids. THOROUGHL Y RINSE, using warm water ( Fig. B ). SOAK, overnight if possible, using warm water to loosen hardened drinks or food. ...

  • Husky Baby Carrier - page 17

    30 W arranty This child restraint was manufactured by Britax ® . Britax Child Safety , Inc. (“Britax”) warrants this product to the original retail purchaser as follows: LIMITED ONE-YEAR W ARRANTY This product is warranted against defective materials or workmanship for one year from the date of original purchase. Proof of purchase is r equired ...

  • Husky Baby Carrier - page 18

    P2219_R03.qxd 8/18/2004 11:05 AM Page 34 ...

  • Husky Baby Carrier - page 19

    P2219_R03.qxd 8/18/2004 11:05 AM Page 36 ...

Manufacturer Husky Category Baby Carrier

Documents that we receive from a manufacturer of a Husky Baby Carrier can be divided into several groups. They are, among others:
- Husky technical drawings
- Baby Carrier manuals
- Husky product data sheets
- information booklets
- or energy labels Husky Baby Carrier
All of them are important, but the most important information from the point of view of use of the device are in the user manual Husky Baby Carrier.

A group of documents referred to as user manuals is also divided into more specific types, such as: Installation manuals Husky Baby Carrier, service manual, brief instructions and user manuals Husky Baby Carrier. Depending on your needs, you should look for the document you need. In our website you can view the most popular manual of the product Husky Baby Carrier.

Similar manuals

A complete manual for the device Husky Baby Carrier, how should it look like?
A manual, also referred to as a user manual, or simply "instructions" is a technical document designed to assist in the use Husky Baby Carrier by users. Manuals are usually written by a technical writer, but in a language understandable to all users of Husky Baby Carrier.

A complete Husky manual, should contain several basic components. Some of them are less important, such as: cover / title page or copyright page. However, the remaining part should provide us with information that is important from the point of view of the user.

1. Preface and tips on how to use the manual Husky Baby Carrier - At the beginning of each manual we should find clues about how to use the guidelines. It should include information about the location of the Contents of the Husky Baby Carrier, FAQ or common problems, i.e. places that are most often searched by users in each manual
2. Contents - index of all tips concerning the Husky Baby Carrier, that we can find in the current document
3. Tips how to use the basic functions of the device Husky Baby Carrier - which should help us in our first steps of using Husky Baby Carrier
4. Troubleshooting - systematic sequence of activities that will help us diagnose and subsequently solve the most important problems with Husky Baby Carrier
5. FAQ - Frequently Asked Questions
6. Contact detailsInformation about where to look for contact to the manufacturer/service of Husky Baby Carrier in a specific country, if it was not possible to solve the problem on our own.

Do you have a question concerning Husky Baby Carrier?

Use the form below

If you did not solve your problem by using a manual Husky Baby Carrier, ask a question using the form below. If a user had a similar problem with Husky Baby Carrier it is likely that he will want to share the way to solve it.

Copy the text from the picture

Comments (0)